Emmanuel Rinnert

Detection of polycyclic aromatic hydrocarbon (PAH) compounds in artificial sea-water using surface-enhanced Raman scattering (SERS)

This paper reports an accurate synthesis of surface-enhanced Raman scattering (SERS) active substrates, based on gold colloidal monolayer, suitable for in situ environmental analysis. Quartz substrates were functionalized by silanization with (3-mercaptopropyl)trimethoxysilane (MPMS) or (3-aminopropyl)trimethoxysilane (APTMS) and they subsequently reacted with colloidal suspension of gold metal nanoparticles: respectively, the functional groups SH and NH(2) bound gold nanoparticles. Gold nanoparticles were prepared by the chemical reduction of HAuCl(4) using sodium tricitrate and immobilized onto silanized quartz substrates. Active substrate surface morphology was characterized with scanning electron microscopy (SEM) measurements and gold nanoparticles presented a diameter in the range 40-100 nm. Colloidal hydrophobic films, allowing nonpolar molecule pre-concentration, were obtained. The surfaces exhibit strong enhancement of Raman scattering from molecules adsorbed on the films. Spectra were recorded for two PAHs, naphthalene and pyrene, in artificial sea-water (ASW) with limits of detection (LODs) of 10 ppb for both on MPMS silanized substrates.

RF sputtered amorphous chalcogenide thin films for surface enhanced infrared absorption spectroscopy

The primary objective of this study is the development of transparent thin film materials in the IR enabling strong infrared absorption of organic compounds in the vicinity of metal nanoparticles by the surface plasmon effect. For developing these optical micro-sensors, hetero-structures combining gold nanoparticles and chalcogenide planar waveguides are fabricated and adequately characterized. Single As2S3 and Ge25Sb10Se65 amorphous chalcogenide thin films are prepared by radio-frequency magnetron sputtering. For the fabrication of gold nanoparticles on a chalcogenide planar waveguide, direct current sputtering is employed. Fabricated single layers or hetero-structures are characterized using various techniques to investigate the influence of deposition parameters. The nanoparticles of gold are functionalized by a self-assembled monolayer of 4-nitrothiophenol. Finally, the surface enhanced infrared absorption spectra of 4-nitrothiophenol self-assembled on fabricated Au/Ge-Sb-Se thin films hetero-structures are measured and analyzed. This optical component presents a ~24 enhancement factor for the detection of NO2 symmetric stretching vibration band of 4-nitrothiophenol at 1336 cm−1.

A semi-automated Raman micro-spectroscopy method for morphological and chemical characterizations of microplastic litter

Every step of microplastic analysis (collection, extraction and characterization) is time-consuming, representing an obstacle to the implementation of large scale monitoring. This study proposes a semi-automated Raman micro-spectroscopy method coupled to static image analysis that allows the screening of a large quantity of microplastic in a time-effective way with minimal machine operator intervention. The method was validated using 103 particles collected at the sea surface spiked with 7 standard plastics: morphological and chemical characterization of particles was performed in <3h. The method was then applied to a larger environmental sample (n=962 particles). The identification rate was 75% and significantly decreased as a function of particle size. Microplastics represented 71% of the identified particles and significant size differences were observed: polystyrene was mainly found in the 2-5mm range (59%), polyethylene in the 1-2mm range (40%) and polypropylene in the 0.335-1mm range (42%).

Selenide sputtered films development for MIR environmental sensor

A micro-sensor based on selenide glasses for evanescent wave detection in mid-infrared spectral range was designed and fabricated. Ge-Sb-Se thin films were successfully deposited by radio-frequency magnetron sputtering. In order to characterize them spectroscopic ellipsometry, atomic force microscopy and contact angle measurements were employed to study near and middle infrared refractive index, surface roughness and the wettability, respectively. Selenide sputtered films were micro-patterned by means of reactive ion etching with inductively coupled plasma process enabling single-mode propagation at a wavelength of 7.7 µm for a waveguide width between 8 and 12 µm. Finally, optical waveguide surface was functionalized by deposition of a hydrophobic polymer, which will permit detection of organic molecules in water. Thus, the optical transducer is a ridge waveguide composed by cladding and guiding Ge-Sb-Se sputtered layers exhibiting a tailored refractive index contrast and a polymer layer onto its surface ready for environmental detections in middle infrared.

First Steps of in situ Surface-Enhanced Raman Scattering during Shipboard Experiments

It is shown that the surface-enhanced Raman scattering (SERS) technique can be applied to detect organic molecules during in situ experiments. To this purpose, we used trans-1,2-bis(4-pyridyl)ethylene (BPE) as a target molecule. Adsorbed on the SERS chemosensor surface and excited under laser, the vibration modes of the molecules can be identified. SERS chemosensors are based on quartz substrates functionalized by silanization and partially coated with gold nanoparticles. SERS measurements during shipboard experiments were made with a home-made in situ Raman spectrometer connected to a marinized micro-fluidic system. The device was designed to host chemosensors in order to ensure measurements with a flow cell. A theoretical limit of detection was estimated in the range of picomolar (pM) concentrations based on Freundlich isotherm calculations.

Investigation of aromatic hydrocarbon inclusion into cyclodextrins by Raman spectroscopy and thermal analysis.

Among various cavitand molecules, cyclodextrins are extensively studied due to their ability to form host-guest complexes with small hydrophobic molecules. Aiming to explore cyclodextrin implementation on the scopes related to the environmental pollution monitoring or remediation, extensive studies for understanding the cyclodextrin-based host-guest complex formation with selected targeted substances are conducted. In this context, two polycyclic aromatic hydrocarbons, naphthalene and fluoranthene as well as toluene as a member of volatile organic compounds, were studied regarding their ability to encapsulate into cyclodextrin cavities. Synthesised complexes were examined by thermogravimetric analysis combined with Raman spectroscopy. The obtained results demonstrated that the size between targeted molecules and the cyclodextrin cavities strongly correlates with its ability to engage in complexation. Thus, this latter parameter plays an important role in the inclusion complex formation as well as in the strength of the interaction between the molecules.

Diazonium Salt-Based Surface-Enhanced Raman Spectroscopy Nanosensor: Detection and Quantitation of Aromatic Hydrocarbons in Water Samples

Here, we present a surface-enhanced Raman spectroscopy (SERS) nanosensor for environmental pollutants detection. This study was conducted on three polycyclic aromatic hydrocarbons (PAHs): benzo[a]pyrene (BaP), fluoranthene (FL), and naphthalene (NAP). SERS substrates were chemically functionalized using 4-dodecyl benzenediazonium-tetrafluoroborate and SERS analyses were conducted to detect the pollutants alone and in mixtures. Compounds were first measured in water-methanol (9:1 volume ratio) samples. Investigation on solutions containing concentrations ranging from 10−6 g L−1 to 10−3 g L−1 provided data to plot calibration curves and to determine the performance of the sensor. The calculated limit of detection (LOD) was 0.026 mg L−1 (10−7 mol L−1) for BaP, 0.064 mg L−1 (3.2 × 10−7 mol L−1) for FL, and 3.94 mg L−1 (3.1 × 10−5 mol L−1) for NAP, respectively. The correlation between the calculated LOD values and the octanol-water partition coefficient (Kow) of the investigated PAHs suggests that the developed nanosensor is particularly suitable for detecting highly non-polar PAH compounds. Measurements conducted on a mixture of the three analytes (i) demonstrated the ability of the developed technology to detect and identify the three analytes in the mixture; (ii) provided the exact quantitation of pollutants in a mixture. Moreover, we optimized the surface regeneration step for the nanosensor.

Experimental design approach for deposition optimization of RF sputtered chalcogenide thin films devoted to environmental optical sensors

The development of the optical bio-chemical sensing technology is an extremely important scientific and technological issue for diagnosis and monitoring of diseases, control of industrial processes, environmental detection of air and water pollutants. Owing to their distinctive features, chalcogenide amorphous thin films represent a keystone in the manufacture of middle infrared integrated optical devices for a sensitive detection of biological or environmental variations. Since the chalcogenide thin films characteristics, i.e. stoichiometric conformity, structure, roughness or optical properties can be affected by the growth process, the choice and control of the deposition method is crucial. An approach based on the experimental design is undoubtedly a way to be explored allowing fast optimization of chalcogenide film deposition by means of radio frequency sputtering process. Argon (Ar) pressure, working power and deposition time were selected as potentially the most influential factors among all possible. The experimental design analysis confirms the great influence of the Ar pressure on studied responses: chemical composition, refractive index in near-IR (1.55 µm) and middle infrared (6.3 and 7.7 µm), band-gap energy, deposition rate and surface roughness. Depending on the intended application and therefore desired thin film characteristics, mappings of the experimental design meaningfully help to select suitable deposition parameters.

Surface enhanced infrared absorption by nanoantenna on chalcogenide glass substrates

In recent years, nanowires have been proven efficient to enhanced IR absorption of molecules and opened prospects of new ultrasensitive IR sensors. The development of integrated components requires the use of special IR glasses such as chalcogenide or silver halide glasses. In this study, we report the fabrication of a surface enhanced IR absorption substrate composed of nanowires deposited onto a chalcogenide glass slide. It enabled us to detect 4-nitrophenol at the femtomolar level and enhancement factor close to 106 was calculated.

Towards in situ detection of PAH trace in seawater using SERS-active sensors

This paper reports the development of a sensor based on surface-enhanced Raman scattering (SERS) for analyses in seawater. Polycyclic aromatic hydrocarbons (PAHs) are targeted by these sensors and their detection in situ summons up chemical synthesis and optical development. Firstly, a relevant synthesis of SERS active substrates based on gold nanostructures is presented. Different kinds of substrates have been synthesized under variable experimental conditions to modify some parameters such as i) gold shape, size and distribution and such as ii) chemical functionalization: (i) gold nanoparticles were prepared either by chemical reduction of HAuCl4 or by physical deposition. (ii) Substrates were functionalized by hydrophobic films to allow nonpolar molecules pre-concentration. Low concentration from ppb to ppm of PAHs were detected with a Raman microscope designed for lab experiments. Sensors exhibit strong enhancement of Raman scattering from molecules adsorbed on the films. Spectra were recorded for two PAHs (naphthalene and pyrene) in artificial sea-water with limits of detection of 10ppb for both with a short integration time (10s) and a low incident laser power (~0.1mW). Active substrate surface morphology was characterized with scanning electron microscopy (SEM) measurements. Secondly, an home-made in situ Raman spectrometer was developed and has been connected to a micro-fluidic system. This system was designed to host SERS-active sensors in order to ensure measurements with a flow cell. This original configuration of in situ Raman spectroscopy was then achieved. Such a device is now ready to use to confirm the PAH detection at ppb levels during the offshore experiments thanks to SERS sensors.