Eugene A. Kapustin

Water harvesting from air with metal-organic frameworks powered by natural sunlight

Solar heat helps harvest humidity Atmospheric humidity and droplets constitute a huge freshwater resource, especially at the low relative humidity (RH) levels typical of arid environments. Water can be adsorbed by microporous materials such as zeolites, but often, making these materials release the water requires too much energy to be practical. Kim et al. used a metal-organic framework (MOF) material that has a steep increase in water uptake over a narrow RH range to harvest water, using only ambient sunlight to heat the material. They obtained 2.8 liters of water per kilogram of MOF daily at 20% RH. Science, this issue p. 430 Efficient extraction is enabled by a steep increase in water uptake within a narrow range of relative humidity. Atmospheric water is a resource equivalent to ~10% of all fresh water in lakes on Earth. However, an efficient process for capturing and delivering water from air, especially at low humidity levels (down to 20%), has not been developed. We report the design and demonstration of a device based on a porous metal-organic framework {MOF-801, [Zr6O4(OH)4(fumarate)6]} that captures water from the atmosphere at ambient conditions by using low-grade heat from natural sunlight at a flux of less than 1 sun (1 kilowatt per square meter). This device is capable of harvesting 2.8 liters of water per kilogram of MOF daily at relative humidity levels as low as 20% and requires no additional input of energy.

Coordinative alignment of molecules in chiral metal-organic frameworks

Stop wiggling and hold that pose X-ray crystallography can be the definitive method for determining the structure and chirality of small organic molecules, but orientational disorder in the crystal can limit its resolution. Lee et al. used a chiral metal-organic framework containing formate ligands that can bind and align molecules covalently to reduce this motion (see the Perspective by Öhrström). The structure and absolute configuration—i.e., which spatial arrangement of atoms is the R or S isomer—of several organic molecules can thus be measured. These range from small molecules, such as methanol, to complex plant hormones, such as gibberellins that have eight stereocenters or jasmonic acid, whose absolute configuration had not previously been directly established. Science, this issue p. 808; see also p. 754 The x-ray structural disorder of small molecules is reduced by covalent binding in a metal-organic framework. A chiral metal-organic framework, MOF-520, was used to coordinatively bind and align molecules of varying size, complexity, and functionality. The reduced motional degrees of freedom obtained with this coordinative alignment method allowed the structures of molecules to be determined by single-crystal x-ray diffraction techniques. The chirality of the MOF backbone also served as a reference in the structure solution for an unambiguous assignment of the absolute configuration of bound molecules. Sixteen molecules representing four common functional groups (primary alcohol, phenol, vicinal diol, and carboxylic acid), ranging in complexity from methanol to plant hormones (gibberellins, containing eight stereocenters), were crystallized and had their precise structure determined. We distinguished single and double bonds in gibberellins, and we enantioselectively crystallized racemic jasmonic acid, whose absolute configuration had only been inferred from derivatives.

The Chemistry of CO2 Capture in an Amine-Functionalized Metal–Organic Framework under Dry and Humid Conditions

The use of two primary alkylamine functionalities covalently tethered to the linkers of IRMOF-74-III results in a material that can uptake CO2 at low pressures through a chemisorption mechanism. In contrast to other primary amine-functionalized solid adsorbents that uptake CO2 primarily as ammonium carbamates, we observe using solid state NMR that the major chemisorption product for this material is carbamic acid. The equilibrium of reaction products also shifts to ammonium carbamate when water vapor is present; a new finding that has impact on control of the chemistry of CO2 capture in MOF materials and one that highlights the importance of geometric constraints and the mediating role of water within the pores of MOFs.

Reticular Electronic Tuning of Porphyrin Active Sites in Covalent Organic Frameworks for Electrocatalytic Carbon Dioxide Reduction

The electronic character of porphyrin active sites for electrocatalytic reduction of CO2 to CO in a two-dimensional covalent organic framework (COF) was tuned by modification of the reticular structure. Efficient charge transport along the COF backbone promotes electronic connectivity between remote functional groups and the active sites and enables the modulation of the catalytic properties of the system. A series of oriented thin films of these COFs was found to reduce CO2 to CO at low overpotential (550 mV) with high selectivity (faradaic efficiency of 87%) and at high current densities (65 mA/mg), a performance well beyond related molecular catalysts in regard to selectivity and efficiency. The catalysts are stable for more than 12 h without any loss in reactivity. X-ray absorption measurements on the cobalt L-edge for the modified COFs enable correlations between the inductive effects of the appended functionality and the electronic character of the reticulated molecular active sites.

Molecular Retrofitting Adapts a Metal–Organic Framework to Extreme Pressure

Despite numerous studies on chemical and thermal stability of metal–organic frameworks (MOFs), mechanical stability remains largely undeveloped. To date, no strategy exists to control the mechanical deformation of MOFs under ultrahigh pressure. Here, we show that the mechanically unstable MOF-520 can be retrofitted by precise placement of a rigid 4,4′-biphenyldicarboxylate (BPDC) linker as a “girder” to afford a mechanically robust framework: MOF-520-BPDC. This retrofitting alters how the structure deforms under ultrahigh pressure and thus leads to a drastic enhancement of its mechanical robustness. While in the parent MOF-520 the pressure transmitting medium molecules diffuse into the pore and expand the structure from the inside upon compression, the girder in the new retrofitted MOF-520-BPDC prevents the framework from expansion by linking two adjacent secondary building units together. As a result, the modified MOF is stable under hydrostatic compression in a diamond-anvil cell up to 5.5 gigapascal. The increased mechanical stability of MOF-520-BPDC prohibits the typical amorphization observed for MOFs in this pressure range. Direct correlation between the orientation of these girders within the framework and its linear strain was estimated, providing new insights for the design of MOFs with optimized mechanical properties.

A Synthetic Route for Crystals of Woven Structures, Uniform Nanocrystals, and Thin Films of Imine Covalent Organic Frameworks

Developing synthetic methodology to crystallize extended covalent structures has been an important pursuit of reticular chemistry. Here, we report a homogeneous synthetic route for imine covalent organic frameworks (COFs) where crystallites emerge from clear solutions without forming amorphous polyimine precipitates. The key feature of this route is the utilization of tert-butyloxycarbonyl group protected amine building blocks, which are deprotected in situ and gradually nucleate the crystalline framework. We demonstrate the utility of this approach by crystallizing a woven covalent organic framework (COF-112), in which covalent organic threads are interlaced to form a three-dimensional woven framework. The homogeneous imine COF synthesis also enabled the control of nucleation and crystal growth leading to uniform nanocrystals, through microwave-assisted reactions, and facile preparation of oriented thin films.

Single-crystal x-ray diffraction structures of covalent organic frameworks

Covalent organic frameworks writ large Covalent organic framework (COF) materials have been difficult to characterize structurally and to exploit because they tend to form powders or amorphous materials. Ma et al. studied a variety of three-dimensional COFs based on imine linkages (see the Perspective by Navarro). They found that the addition of aniline inhibited nucleation and allowed the growth of crystals large enough for single-crystal x-ray diffraction studies. Evans et al. describe a two-step process in which nanoscale seeds of boronate ester–linked two-dimensional COFs can be grown into micrometer-scale single crystals by using a solvent that suppresses the nucleation of additional nanoparticles. Transient absorption spectroscopy revealed superior charge transport in these crystallites compared with that observed in conventional powders. Science, this issue p. 48, p. 52; see also p. 35 The addition of aniline enables the growth of single crystals of imine-based covalent organic framework materials. The crystallization problem is an outstanding challenge in the chemistry of porous covalent organic frameworks (COFs). Their structural characterization has been limited to modeling and solutions based on powder x-ray or electron diffraction data. Single crystals of COFs amenable to x-ray diffraction characterization have not been reported. Here, we developed a general procedure to grow large single crystals of three-dimensional imine-based COFs (COF-300, hydrated form of COF-300, COF-303, LZU-79, and LZU-111). The high quality of the crystals allowed collection of single-crystal x-ray diffraction data of up to 0.83-angstrom resolution, leading to unambiguous solution and precise anisotropic refinement. Characteristics such as degree of interpenetration, arrangement of water guests, the reversed imine connectivity, linker disorder, and uncommon topology were deciphered with atomic precision—aspects impossible to determine without single crystals.

Practical water production from desert air

Next-generation MOF device and material for water production from desert air. Energy-efficient production of water from desert air has not been developed. A proof-of-concept device for harvesting water at low relative humidity was reported; however, it used external cooling and was not desert-tested. We report a laboratory-to-desert experiment where a prototype using up to 1.2 kg of metal-organic framework (MOF)–801 was tested in the laboratory and later in the desert of Arizona, USA. It produced 100 g of water per kilogram of MOF-801 per day-and-night cycle, using only natural cooling and ambient sunlight as a source of energy. We also report an aluminum-based MOF-303, which delivers more than twice the amount of water. The desert experiment uncovered key parameters pertaining to the energy, material, and air requirements for efficient production of water from desert air, even at a subzero dew point.

Deconvoluting the Role of Charge in a Supramolecular Catalyst

We have demonstrated that the microenvironment of a highly anionic supramolecular catalyst can mimic the active sites of enzymes and impart rate accelerations of a million-fold or more. However, these microenvironments can be challenging to study, especially in the context of understanding which specific features of the catalyst are responsible for its high performance. We report here the development of an experimental mechanistic probe consisting of two isostructural catalysts. When examined in parallel transformations, the behavior of these catalysts provides insight relevant to the importance of anionic host charge on reactivity. These two catalysts exhibit similar host-substrate interactions, but feature a significant difference in overall anionic charge (12- and 8-). Within these systems, we compare the effect of constrictive binding in a net neutral aza-Cope rearrangement. We then demonstrate how the magnitude of anionic host charge has an exceptional influence on the reaction rates for a Nazarov cyclization, evidenced by an impressive 680-fold change in reaction rate as a consequence of a 33% reduction in catalyst charge.

Response to Comment on “Water harvesting from air with metal-organic frameworks powered by natural sunlight”

In their comment, Bui et al. argue that the approach we described in our report is vastly inferior in efficiency to alternative off-the-shelf technologies. Their conclusion is invalid, as they compare efficiencies in completely different operating conditions. Here, using heat transfer and thermodynamics principles, we show how Bui et al.’s conclusions about the efficiencies of off-the-shelf technologies are fundamentally flawed and inaccurate for the operating conditions described in our study.