Ghulam Abbas Kandhro

Copper, Chromium, Manganese, Iron, Nickel, and Zinc Levels in Biological Samples of Diabetes Mellitus Patients

There is accumulating evidence that the metabolism of several trace elements is altered in diabetes mellitus and that these nutrients might have specific roles in the pathogenesis and progress of this disease. The aim of present study was to compare the level of essential trace elements, chromium (Cr), copper (Cu), iron (Fe), manganese (Mn), nickel (Ni), and zinc (Zn) in biological samples (whole blood, urine, and scalp hair) of patients who have diabetes mellitus type 2 (n = 257), with those of nondiabetic control subjects (n = 166), age ranged (45–75) of both genders. The element concentrations were measured by means of an atomic absorption spectrophotometer after microwave-induced acid digestion. The validity and accuracy was checked by conventional wet-acid-digestion method and using certified reference materials. The overall recoveries of all elements were found in the range of (97.60–99.49%) of certified values. The results of this study showed that the mean values of Zn, Mn, and Cr were significantly reduced in blood and scalp-hair samples of diabetic patients as compared to control subjects of both genders (p < 0.001). The urinary levels of these elements were found to be higher in the diabetic patients than in the age-matched healthy controls. In contrast, high mean values of Cu and Fe were detected in scalp hair and blood from patients versus the nondiabetic subjects, but the differences found in blood samples was not significant (p < 0.05). These results are consistent with those obtained in other studies, confirming that deficiency and efficiency of some essential trace metals may play a role in the development of diabetes mellitus.

Heavy metal accumulation in different varieties of wheat (Triticum aestivum L.) grown in soil amended with domestic sewage sludge

The concentrations of heavy metals (HMs) in plants served to indicate the metal contamination status of the site, and also revealed the abilities of various plant species to take up and accumulate them from the soil dressed with sewage sludge. A study to comprehend the mobility and transport of HMs from soil and soil amended with untreated sewage sludge to different newly breaded varieties of wheat (Anmol, TJ-83, Abadgar and Mehran-89) in Pakistan. A pot-culture experiment was conducted to study the transfer of HMs to wheat grains, grown in soil (control) and soil amended with sewage sludge (test samples). The total and ethylenediaminetetraaceticacid (EDTA)-extractable HMs in agricultural soil and soil amended with domestic sewage sludge (SDWS) and wheat grains were analysed by flame atomic absorption spectrometer/electrothermal atomic absorption spectrometer, prior to microwave-assisted wet acid digestion method. The edible part of wheat plants (grains) from test samples presented high concentration of all HMs understudy (mgkg(-1)). Significant correlations were found between metals in exchangeable fractions of soil and SDWS, with total metals in control and test samples of wheat grains. The bio-concentration factors of all HMs were high in grains of two wheat varieties, TJ-83 and Mehran-89, as compared to other varieties, Anmol and Abadgar grown in the same agricultural plots.

Evaluation of arsenic and other physico-chemical parameters of surface and ground water of Jamshoro, Pakistan

Arsenic contamination in water has caused severe health problems around the world. The purpose of this study was to evaluate the geological and anthropogenic aspects of As pollution in surface and groundwater resources of Jamshoro Sindh, Pakistan. Hydride generator atomic absorption spectrophotometry (HG-AAS) is employed for the determination of arsenic in water samples, with detection limit of 0.02 microg l(-1). Arsenic concentrations in surface and underground water range from 3.0 to 50.0, and 13 to 106 microg l(-1), respectively. In most of the water samples As levels exceeded the WHO provisional guideline values 10 microg l(-1). The high level of As in under study area may be due to widespread water logging from Indus river irrigation system which causes high saturation of salts in this semi-arid region and lead to enrichment of As in shallow groundwater. Among the physico-chemical parameters, electrical conductivity, Na(+), K(+), and SO(4)(2-) were found to be higher in surface and ground water, while elevated levels of Ca(2+) and Cl(-) were detected only in ground water than WHO permissible limit. The high level of iron was observed in ground water, which is a possible source of As enrichment in the study area. The multivariate technique (cluster analysis) was used for the elucidation of high, medium and low As contaminated areas. It may be concluded that As originate from coal combustion at brick factories and power generation plants, and it was mobilized promotionally by the alkaline nature of the understudy groundwater samples.

Biosorption studies on powder of stem of Acacia nilotica: Removal of arsenic from surface water

In present study a biomass derived from the stem of Acacia nilotica has been investigated to remove As ions from surface water samples of different origins (lake, canal and river). The effects of various parameters viz. pH, biosorbent dosage, contact time and temperature on the biosorption processes were systematically studied. Experimental data were modeled by Langmuir, Freundlich and Dubinin-Radushkevich (D-R) isotherms. It was observed that As biosorption best fitted to the Langmuir and Freundlich isotherms. The mean sorption energy (E) calculated from D-R model, indicated physico-chemical biosorption. Study of thermodynamic parameters revealed the endothermic, spontaneous and feasible nature of biosorption process. The pseudo-second-order rate equation described better the kinetics of As biosorption with good correlation coefficients than pseudo-first-order equation. The biomass of A. nilotica was found to be effective for the removal of As with 95% sorption efficiency at a concentration of <200 microg/L of As solution, and thus uptake capacity is 50.8 mg As/g of biomass. The A. nilotica biomass could be used as a low-cost biosorbent for As ion removal.

Optimization of cloud point extraction and solid phase extraction methods for speciation of arsenic in natural water using multivariate technique.

The simple and rapid pre-concentration techniques viz. cloud point extraction (CPE) and solid phase extraction (SPE) were applied for the determination of As(3+) and total inorganic arsenic (iAs) in surface and ground water samples. The As(3+) was formed complex with ammonium pyrrolidinedithiocarbamate (APDC) and extracted by surfactant-rich phases in the non-ionic surfactant Triton X-114, after centrifugation the surfactant-rich phase was diluted with 0.1 mol L(-1) HNO(3) in methanol. While total iAs in water samples was adsorbed on titanium dioxide (TiO(2)); after centrifugation, the solid phase was prepared to be slurry for determination. The extracted As species were determined by electrothermal atomic absorption spectrometry. The multivariate strategy was applied to estimate the optimum values of experimental factors for the recovery of As(3+) and total iAs by CPE and SPE. The standard addition method was used to validate the optimized methods. The obtained result showed sufficient recoveries for As(3+) and iAs (>98.0%). The concentration factor in both cases was found to be 40.

Arsenic fractionation in sediments of different origins using BCR sequential and single extraction methods.

The arsenic (As) contaminated sediment serves as a long-term source of arsenic because its mobility and transport in the environment are strongly influenced to associated solid phase. A single extraction method based on the reagents employed in the BCR three steps sequential extraction scheme (BCR-SES) for partitioning of arsenic (As) in sediment samples has been developed. The single-step extraction enabled a reduction of extraction times, yielding extractable contents in accordance with those obtained by application of the BCR-SES, which can be regarded as a standard method and validated by using certified reference material BCR 701. The extractable As content associated with different phases in sediment samples were analysed by electrothermal atomic absorption spectrophotometer. The extraction efficiency of As by single-step extraction was slightly higher than BCR-SES, ranged (100-104%), while difference was not significant at 95% confidence limit with <10% precision. The sediment samples from different origins varied in their physico-chemical properties and total As content. The relative mobility of As obtained from different origins was found in increasing order as: acid soluble fraction<oxidizable fraction<reducible fraction. The acid soluble fraction of As was higher in lake sediment samples as compared to those of canal and river sediments, indicating the contamination of lake ecosystem.

Evaluation of cadmium, lead, nickel and zinc status in biological samples of smokers and nonsmokers hypertensive patients

The objective of this study was to evaluate the association between trace and toxic elements zinc (Zn), cadmium (Cd), nickel (Ni) and lead (Pb) in biological samples (scalp hair, blood and urine) of smoker and nonsmoker hypertensive patients (n=457), residents of Hyderabad, Pakistan. For the purpose of comparison, the biological samples of age-matched healthy controls were selected as referents. The concentrations of trace and toxic elements were measured by atomic absorption spectrophotometer prior to microwave-assisted acid digestion. The validity and accuracy of the methodology were checked using certified reference materials and by the conventional wet acid digestion method on the same certified reference materials and real samples. The recovery of all the studied elements was found to be in the range of 97.8–99.3% in certified reference materials. The results of this study showed that the mean values of Cd, Ni and Pb were significantly higher in scalp hair, blood and urine samples of both smoker and nonsmoker patients than in referents (P<0.001), whereas the concentration of Zn was lower in the scalp hair and blood, but higher in the urine samples of hypertensive patients. The deficiency of Zn and the high exposure of toxic metals as a result of tobacco smoking may be synergistic with risk factors associated with hypertension.

Time saving modified BCR sequential extraction procedure for the fraction of Cd, Cr, Cu, Ni, Pb and Zn in sediment samples of polluted lake.

The mobility, availability and persistence of heavy metals (Cd, Cr, Cu, Ni, Pb and Zn) in contaminated lake sediment samples were evaluated by means of sequential extraction scheme, proposed by the Community Bureau of Reference protocol (BCR). The metal content in the extracts was measured by atomic absorption spectrometry. The precision and accuracy of the proposed procedure were evaluated by using a certified reference material BCR 701. The maximum recoveries for heavy metals (HMs) were observed for all three steps of BCR protocol at 32h total shaking period instead of previously reported 51h, with p>0.05. The lixiviation tests (DIN 38414-S4) were used to evaluate the leaching of HMs from sediment samples and it was observed that levels of water extractable HMs were low as compared to those values obtained by acid-soluble fraction of the BCR protocol.

Speciation and evaluation of Arsenic in surface water and groundwater samples: a multivariate case study.

The principal object of the current study was to estimate total arsenic and its inorganic speciation in different origins of surface water (n=480) and groundwater (n=240) of Sindh, Pakistan. This study provided a description based on the evaluation of physico-chemical parameters of collected water samples and possible distribution of As with respect to its speciation. The concentration of total inorganic As (iAs) and its species (As(3+) and As(5+)) for the surface and underground water was reported in terms of basic statistical parameters, principal component analysis, cluster analysis, metal-to-metal correlations and linear regression analyses. The chemical correlations were observed by PCA, which were used to classify the samples by CA, based on the PCA scores. Standard addition method confirmed the accuracy; the recoveries of As(3+) and iAs were found to be >98%. The concentration of As(5+) in the water samples was calculated by the difference of the total inorganic arsenic and As(3+). The results revealed that the groundwater of the understudied area was more contaminated as compared to the surface water samples. The mean concentration of As(3+) and As(5+) in the surface water and groundwater samples were in the range 3.0 to 18.3 and 8.74-352 microg/L, respectively.

Respiratory effects in people exposed to arsenic via the drinking water and tobacco smoking in southern part of Pakistan

In this study, a survey has been conducted during 2005-2007 on surface and groundwater arsenic (As) contamination and its impact on the health of local population, of villages located on the banks of Manchar lake, southern part of Sindh, Pakistan. We have also assessed the relationship between arsenic exposure through respiratory disorders in male subjects with drinking water and smoking cigarettes made from tobacco grown in agricultural land irrigated with As contaminated lake water. The biological samples (blood and scalp hair) were collected from As exposed subjects (100% smokers) and age matched healthy male subjects (40.2% smoker and 59.8% non smokers) belong to unexposed areas for comparison purposes. The As concentration in drinking water (surface and underground water), agricultural soil, cigarette tobacco and biological samples were determined by electrothermal atomic absorption spectrometry. The range of As concentrations in lake water was 35.2-158 microg/L (average 97.5 microg/L), which is 3-15 folds higher than permissible limit of World Health Organization (WHO, 2004). While the As level in local cigarette tobacco was found to be 3-6 folds higher than branded cigarettes (0.37-0.79 microg/g). Arsenic exposed subjects (with and without RD) had significantly elevated levels of As in their biological samples as compared to referent male subject of unexposed area. These respiratory effects were more pronounced in individuals who had also As induced skin lesions. The linear regressions showed good correlations between As concentrations in water versus hair and blood samples of exposed subjects with and without respiratory problems.