Jameel Ahmed Baig

Assessment of water quality of polluted lake using multivariate statistical techniques: A case study

Multivariate statistical techniques, cluster analysis (CA) and principal component analysis (PCA) were applied to the data on water quality of Manchar Lake (Pakistan), generated during 2005-06, with monitoring at five different sites for 36 parameters. This study evaluated and interpreted complex water quality data sets and apportioned of pollution sources to get better information about water quality and to design a monitoring network. The chemical correlations were observed by PCA, which were used to classify the samples by CA, based on the PCA scores. Three significant sampling locations--(sites 1 and 2), (site 4) and (sites 3 and 5)--were detected on the basis of similarity of their water quality. The results revealed that the major causes of water quality deterioration were related to inflow of effluent from industrial, domestic, agricultural and saline seeps into the lake at site 1 and also resulting from people living in boats and fishing at sites 2 and 3.

Heavy metal accumulation in different varieties of wheat (Triticum aestivum L.) grown in soil amended with domestic sewage sludge

The concentrations of heavy metals (HMs) in plants served to indicate the metal contamination status of the site, and also revealed the abilities of various plant species to take up and accumulate them from the soil dressed with sewage sludge. A study to comprehend the mobility and transport of HMs from soil and soil amended with untreated sewage sludge to different newly breaded varieties of wheat (Anmol, TJ-83, Abadgar and Mehran-89) in Pakistan. A pot-culture experiment was conducted to study the transfer of HMs to wheat grains, grown in soil (control) and soil amended with sewage sludge (test samples). The total and ethylenediaminetetraaceticacid (EDTA)-extractable HMs in agricultural soil and soil amended with domestic sewage sludge (SDWS) and wheat grains were analysed by flame atomic absorption spectrometer/electrothermal atomic absorption spectrometer, prior to microwave-assisted wet acid digestion method. The edible part of wheat plants (grains) from test samples presented high concentration of all HMs understudy (mgkg(-1)). Significant correlations were found between metals in exchangeable fractions of soil and SDWS, with total metals in control and test samples of wheat grains. The bio-concentration factors of all HMs were high in grains of two wheat varieties, TJ-83 and Mehran-89, as compared to other varieties, Anmol and Abadgar grown in the same agricultural plots.

Evaluation of status of toxic metals in biological samples of diabetes mellitus patients

There is accumulating evidence that the metabolism of several trace elements is altered in diabetes mellitus and that these nutrients might have specific roles in the pathogenesis and progress of this disease. The aim of present study was to compare the level of toxic elements, lead (Pb), cadmium (Cd), and arsenic (As) in biological samples (whole blood, urine, and scalp hair) of patients having diabetes mellitus type-2 age ranged (31-60) (n=238), with those of age matched non-diabetics (ND) as control subjects (n=196), of both genders. The concentrations of elements were measured by means of an atomic absorption spectrophotometer after microwave-assisted acid digestion. The validity and accuracy was checked by conventional wet acid digestion method and using certified reference materials. The overall recoveries of all elements were found in the range of 98.1-99.4% of certified values. The results of this study showed that the mean values of Pb, Cd and, As were significantly higher in scalp hair samples of smoker and non-smoker diabetic patients as compared to control subjects (p<0.001). The concentration of understudy toxic metals was also high in blood and urine samples of DM patient but difference was more significant in smoker DM patients. These results are consistent with those obtained in other studies, confirming that toxic metals may play a role in the development of diabetes mellitus.

Determination of arsenic levels in lake water, sediment, and foodstuff from selected area of Sindh, Pakistan: estimation of daily dietary intake.

The aim of present study was to develop a database of arsenic (As) in lake water, ground water, sediment, soil, vegetables, grain crops and fish to evaluate the potential human health risks posed by higher level of As, in south east part of Sindh, Pakistan during 2005-2007. The total concentration of As in various samples under study was determined by electrothermal atomic absorption spectrophotometry (ETAAS). The reliability and accuracy of technique was checked by different certified reference materials. The concentration of As in lake and ground water samples exceeded the WHO guideline values. The concentration of As in lake sediment and agricultural soil samples ranged between 11.3-55.8 and 8.7-46.2 mg/kg while acid soluble As (acetic acid 0.11 mol/L) was observed in the range of 1.48-3.54 and 0.34-3.78 mg/kg, respectively. It was observed that the leafy vegetables (spinach, coriander and peppermint) contain higher As levels (0.90-1.20 mg/kg) as compared to ground vegetables (0.048-0.25) and grain crops (0.248-0.367 mg/kg) on dried weight basis. The estimated daily intake of total As in the diet was 9.7-12.2 microg/kg body weight/day.

The correlation of arsenic levels in drinking water with the biological samples of skin disorders.

Arsenic (As) poisoning has become a worldwide public health concern. The skin is quite sensitive to As and skin lesions are the most common and earliest nonmalignant effects associated to chronic As exposure. In 2005-2007, a survey was carried out on surface and groundwater arsenic contamination and relationships between As exposure via the drinking water and related adverse health effects (melanosis and keratosis) on villagers resides on the banks of Manchar lake, southern part of Sindh, Pakistan. We screened the population from arsenic-affected villages, 61 to 73% population were identified patients suffering from chronic arsenic toxicity. The effects of As toxicity via drinking water were estimated by biological samples (scalp hair and blood) of adults (males and females), have or have not skin problem (n=187). The referent samples of both genders were also collected from the areas having low level of As (<10 microg/L) in drinking water (n=121). Arsenic concentration in drinking water and biological samples were analyzed using electrothermal atomic absorption spectrometry. The range of arsenic concentrations in lake surface water was 35.2-158 microg/L, which is 3-15 folds higher than World Health Organization [WHO, 2004. Guidelines for drinking-water quality third ed., WHO Geneva Switzerland.]. It was observed that As concentration in the scalp hair and blood samples were above the range of permissible values 0.034-0.319 microg As/g for hair and <0.5-4.2 microg/L for blood. The linear regressions showed good correlations between arsenic concentrations in water versus hair and blood samples of exposed skin diseased subjects (R2=0.852 and 0.718) as compared to non-diseased subjects (R2=0.573 and 0.351), respectively.

Evaluation of arsenic and other physico-chemical parameters of surface and ground water of Jamshoro, Pakistan

Arsenic contamination in water has caused severe health problems around the world. The purpose of this study was to evaluate the geological and anthropogenic aspects of As pollution in surface and groundwater resources of Jamshoro Sindh, Pakistan. Hydride generator atomic absorption spectrophotometry (HG-AAS) is employed for the determination of arsenic in water samples, with detection limit of 0.02 microg l(-1). Arsenic concentrations in surface and underground water range from 3.0 to 50.0, and 13 to 106 microg l(-1), respectively. In most of the water samples As levels exceeded the WHO provisional guideline values 10 microg l(-1). The high level of As in under study area may be due to widespread water logging from Indus river irrigation system which causes high saturation of salts in this semi-arid region and lead to enrichment of As in shallow groundwater. Among the physico-chemical parameters, electrical conductivity, Na(+), K(+), and SO(4)(2-) were found to be higher in surface and ground water, while elevated levels of Ca(2+) and Cl(-) were detected only in ground water than WHO permissible limit. The high level of iron was observed in ground water, which is a possible source of As enrichment in the study area. The multivariate technique (cluster analysis) was used for the elucidation of high, medium and low As contaminated areas. It may be concluded that As originate from coal combustion at brick factories and power generation plants, and it was mobilized promotionally by the alkaline nature of the understudy groundwater samples.

Biosorption studies on powder of stem of Acacia nilotica: Removal of arsenic from surface water

In present study a biomass derived from the stem of Acacia nilotica has been investigated to remove As ions from surface water samples of different origins (lake, canal and river). The effects of various parameters viz. pH, biosorbent dosage, contact time and temperature on the biosorption processes were systematically studied. Experimental data were modeled by Langmuir, Freundlich and Dubinin-Radushkevich (D-R) isotherms. It was observed that As biosorption best fitted to the Langmuir and Freundlich isotherms. The mean sorption energy (E) calculated from D-R model, indicated physico-chemical biosorption. Study of thermodynamic parameters revealed the endothermic, spontaneous and feasible nature of biosorption process. The pseudo-second-order rate equation described better the kinetics of As biosorption with good correlation coefficients than pseudo-first-order equation. The biomass of A. nilotica was found to be effective for the removal of As with 95% sorption efficiency at a concentration of <200 microg/L of As solution, and thus uptake capacity is 50.8 mg As/g of biomass. The A. nilotica biomass could be used as a low-cost biosorbent for As ion removal.

Optimization of cloud point extraction and solid phase extraction methods for speciation of arsenic in natural water using multivariate technique.

The simple and rapid pre-concentration techniques viz. cloud point extraction (CPE) and solid phase extraction (SPE) were applied for the determination of As(3+) and total inorganic arsenic (iAs) in surface and ground water samples. The As(3+) was formed complex with ammonium pyrrolidinedithiocarbamate (APDC) and extracted by surfactant-rich phases in the non-ionic surfactant Triton X-114, after centrifugation the surfactant-rich phase was diluted with 0.1 mol L(-1) HNO(3) in methanol. While total iAs in water samples was adsorbed on titanium dioxide (TiO(2)); after centrifugation, the solid phase was prepared to be slurry for determination. The extracted As species were determined by electrothermal atomic absorption spectrometry. The multivariate strategy was applied to estimate the optimum values of experimental factors for the recovery of As(3+) and total iAs by CPE and SPE. The standard addition method was used to validate the optimized methods. The obtained result showed sufficient recoveries for As(3+) and iAs (>98.0%). The concentration factor in both cases was found to be 40.

Arsenic fractionation in sediments of different origins using BCR sequential and single extraction methods.

The arsenic (As) contaminated sediment serves as a long-term source of arsenic because its mobility and transport in the environment are strongly influenced to associated solid phase. A single extraction method based on the reagents employed in the BCR three steps sequential extraction scheme (BCR-SES) for partitioning of arsenic (As) in sediment samples has been developed. The single-step extraction enabled a reduction of extraction times, yielding extractable contents in accordance with those obtained by application of the BCR-SES, which can be regarded as a standard method and validated by using certified reference material BCR 701. The extractable As content associated with different phases in sediment samples were analysed by electrothermal atomic absorption spectrophotometer. The extraction efficiency of As by single-step extraction was slightly higher than BCR-SES, ranged (100-104%), while difference was not significant at 95% confidence limit with <10% precision. The sediment samples from different origins varied in their physico-chemical properties and total As content. The relative mobility of As obtained from different origins was found in increasing order as: acid soluble fraction<oxidizable fraction<reducible fraction. The acid soluble fraction of As was higher in lake sediment samples as compared to those of canal and river sediments, indicating the contamination of lake ecosystem.

Evaluation of cadmium, lead, nickel and zinc status in biological samples of smokers and nonsmokers hypertensive patients

The objective of this study was to evaluate the association between trace and toxic elements zinc (Zn), cadmium (Cd), nickel (Ni) and lead (Pb) in biological samples (scalp hair, blood and urine) of smoker and nonsmoker hypertensive patients (n=457), residents of Hyderabad, Pakistan. For the purpose of comparison, the biological samples of age-matched healthy controls were selected as referents. The concentrations of trace and toxic elements were measured by atomic absorption spectrophotometer prior to microwave-assisted acid digestion. The validity and accuracy of the methodology were checked using certified reference materials and by the conventional wet acid digestion method on the same certified reference materials and real samples. The recovery of all the studied elements was found to be in the range of 97.8–99.3% in certified reference materials. The results of this study showed that the mean values of Cd, Ni and Pb were significantly higher in scalp hair, blood and urine samples of both smoker and nonsmoker patients than in referents (P<0.001), whereas the concentration of Zn was lower in the scalp hair and blood, but higher in the urine samples of hypertensive patients. The deficiency of Zn and the high exposure of toxic metals as a result of tobacco smoking may be synergistic with risk factors associated with hypertension.