Gregory P. Schill

Heterogeneous Ice Nucleation on Simulated Secondary Organic Aerosol

In this study, we have explored the phase behavior and the ice nucleation properties of secondary organic aerosol made from aqueous processing (aqSOA). AqSOA was made from the dark reactions of methylglyoxal with methylamine in simulated evaporated cloud droplets. The resulting particles were probed from 215 to 250 K using Raman spectroscopy coupled to an environmental cell. We find these particles are in a semisolid or glassy state based upon their behavior when exposed to mechanical pressure as well as their flow behavior. Further, we find that these aqSOA particles are poor depositional ice nuclei, in contrast to previous studies on simple mixtures of glassy organics. Additionally, we have studied the effect of ammonium sulfate on the phase, morphology, and ice nucleation behavior of the aqSOA. We find that the plasticizing effect of ammonium sulfate lowers the viscosity of the aqSOA, allowing the ammonium sulfate to effloresce within the aqSOA matrix. Upon humidification, the aqSOA matrix liquefies before it can depositionally nucleate ice, and the effloresced ammonium sulfate can act as an immersion mode ice nucleus. This change in the mode of nucleation is accompanied by an increase in the overall ice nucleation efficiency of the aqSOA particles.

Chemical and Physical Transformations of Aluminosilicate Clay Minerals Due to Acid Treatment and Consequences for Heterogeneous Ice Nucleation

Mineral dust aerosol is one of the largest contributors to global ice nuclei, but physical and chemical processing of dust during atmospheric transport can alter its ice nucleation activity. In particular, several recent studies have noted that sulfuric and nitric acids inhibit heterogeneous ice nucleation in the regime below liquid water saturation in aluminosilicate clay minerals. We have exposed kaolinite, KGa-1b and KGa-2, and montmorillonite, STx-1b and SWy-2, to aqueous sulfuric and nitric acid to determine the physical and chemical changes that are responsible for the observed deactivation. To characterize the changes to the samples upon acid treatment, we use X-ray diffraction, transmission electron microscopy, and inductively coupled plasma-atomic emission spectroscopy. We find that the reaction of kaolinite and montmorillonite with aqueous sulfuric acid results in the formation of hydrated aluminum sulfate. In addition, sulfuric and nitric acids induce large structural changes in montmorillonite. We additionally report the supersaturation with respect to ice required for the onset of ice nucleation for these acid-treated species. On the basis of lattice spacing arguments, we explain how the chemical and physical changes observed upon acid treatment could lead to the observed reduction in ice nucleation activity.

Depositional ice nucleation on monocarboxylic acids: effect of the O:C ratio.

The heterogeneous ice nucleation efficiency of a series of thin C3-C6 monocarboxylic acid films between 180 and 200 K has been investigated using a Knudsen cell flow reactor. At each temperature, the critical ice saturation ratio for depositional nucleation as well as the effective contact angle was found to be strongly dependent on the chemical nature of the film. For the organic acids used in this study, increasing the O:C ratio lowered the supersaturation required for the onset of heterogeneous ice nucleation and decreased the effective angle of contact. This could be the result of an increase in surface hydrophilicity, which allows the film to better adsorb a metastable, icelike layer of water that serves as a template for the new phase of ice. These ice nucleation results are in excellent agreement with ice nucleation on laboratory generated α-pinene secondary organic aerosol as well as on predominantly organic particles collected in Mexico City.

Formation of semisolid, oligomerized aqueous SOA: lab simulations of cloud processing.

Glyoxal, methylglyoxal, glycolaldehyde, and hydroxyacetone form N-containing and oligomeric compounds during simulated cloud processing with small amines. Using a novel hygroscopicity tandem differential mobility analysis (HTDMA) system that allows varied humidification times, the hygroscopic growth (HG) of each of the resulting products of simulated cloud processing was measured. Continuous water uptake (gradual deliquescence) was observed beginning at ∼ 40% RH for all aldehyde-methylamine products. Particles containing ionic reaction products of either glyoxal or glycine were most hygroscopic, with HG between 1.16 and 1.20 at 80% RH. Longer humidification times (up to 20 min) produced an increase in growth factors for glyoxal-methylamine (19% by vol) and methylglyoxal-methylamine (8% by vol) aerosol, indicating that unusually long equilibration times can be required for HTDMA measurements of such particles. Glyoxal- and methylglyoxal-methylamine aerosol particles shattered in Raman microscopy impact-flow experiments, revealing that the particles were semisolid. Similar experiments on glycolaldehyde- and hydroxyacetone-methylamine aerosol found that the aerosol particles were liquid when dried for <1 h, but semisolid when dried for 20 h under ambient conditions. The RH required for flow (liquification) during humidification experiments followed the order methylglyoxal > glyoxal > glycolaldehyde = hydroxyacetone, likely caused by the speed of oligomer formation in each system.

Optical growth of highly viscous organic/sulfate particles

Light extinction by atmospheric particles is strongly dependent on their chemical composition and water content. Since light extinction directly impacts climate, optical measurements of atmospherically relevant aerosols at varying relative humidities (RH) are needed. Recent studies have highlighted the possibility that some atmospheric aerosols are glassy under ambient conditions. Here, the particle optical growth factor, fRHext, was measured for liquid and glassy particles using cavity ring-down aerosol extinction spectroscopy. The particles were composed of ammonium sulfate (AS), 1,2,6-hexanetriol, sucrose, raffinose, and mixed particles containing AS and either sucrose or raffinose. Both sucrose and raffinose can be glassy at room temperature. For the pure organics, the highly viscous sucrose and raffinose particles have similar optical growth curves to the liquid 1,2,6 hexanetriol particles. However, for particles composed of sucrose or raffinose mixed with AS, optical growth depends on the AS weight-percent, which in turn controls the phase state of the AS and ultimately the water uptake.

Impact of organic coating on optical growth of ammonium sulfate particles.

Light extinction by particles in Earths atmosphere is strongly dependent on particle size, chemical composition, hygroscopic growth properties, and particle mixing state. Here, the influence of an organic coating on particle optical growth was studied. The particle optical growth factor, fRHext, was measured using cavity ring-down aerosol extinction spectroscopy at 532 nm. The particles were composed of ammonium sulfate (AS), 1,2,6-hexanetriol, and mixed particles containing a wet or dry ammonium sulfate core and a 1,2,6-hexanetriol coating. Dry, coated particles were generated by atomization followed by drying. Wet, coated particles were formed via liquid-liquid phase separation (LLPS). LLPS was achieved by deliquescing and then drying the particles to a relative humidity (RH) between the phase separation RH and the efflorescence RH. For the LLPS particles, the fRHext at each RH was between the fRHext of ammonium sulfate and that of 1,2,6-hexanetriol. In contrast, for the mixed dry, coated particles, the fRHext was the same as 1,2,6-hexanetriol particles. At room temperature, the water uptake properties of AS coated with 1,2,6-hexanetriol are largely dictated by the phase of the AS. Thus, the total water uptake depends on the RH history of the particle and the resulting phase of AS.

Deposition and immersion mode nucleation of ice by three distinct samples of volcanic ash

The depositional and immersion mode ice nucleation efficiency of volcanic ash has been explored using a Raman microscope coupled to an environmental cell. Three separate ash samples from geographically distinct regions were specifically chosen to contain varying amounts of metal oxides and crystalline material, which could be integral factors in determining the inherent ice nucleation ability of each ash sample. Preliminary studies indicate that the samples have similar ice nucleating ability in the deposition mode. Ongoing studies are probing immersion freezing. In both cases, a range of ice active surface densities will be calculated, as well as an analysis of the effect of ash composition on ice nucleation ability.