Guosheng Xu

Study on H-mode access at low density with lower hybrid current drive and lithium-wall coatings on the EAST superconducting tokamak

The first high-confinement mode (H-mode) with type-III edge localized modes at an H factor of HIPB98(y,2) ∼ 1 has been obtained with about 1 MW lower hybrid wave power on the EAST superconducting tokamak. The first H-mode plasma appeared after wall conditioning by lithium (Li) evaporation before plasma breakdown and the real-time injection of fine Li powder into the plasma edge. The threshold power for H-mode access follows the international tokamak scaling even in the low density range and a threshold in density has been identified. With increasing accumulation of deposited Li the H-mode duration was gradually extended up to 3.6 s corresponding to ∼30 confinement times, limited only by currently attainable durations of the plasma current flat top. Finally, it was observed that neutral density near the lower X-point was progressively reduced by a factor of 4 with increasing Li accumulation, which is considered the main mechanism for the H-mode power threshold reduction by the Li wall coatings. (Some figures in this article are in colour only in the electronic version)

Progress of long pulse and H-mode experiments in EAST

Significant progress, on both the technological and physical fronts, towards high-performance, long-pulse plasma discharges has been made in EAST (the experimental advanced superconducting tokamak) since the last IAEA FEC. With enhanced operational capabilities, the following key results have been achieved with lithium wall conditioning: fully steady-state long-pulse diverted plasmas entirely driven by the lower hybrid current drive (LHCD) over 400 s and stationary H-mode discharges over 30 s with LHCD and ion cyclotron resonant heating (ICRF). H-modes with various types of edge localized modes (ELMs) have been achieved with HIPB98(y,2) ranging from 0.7 to over unity, providing great opportunities for the study of H-mode physics. New and exciting physics with dominant radio-frequency heating has emerged, including new findings of LHCD-induced 3D edge magnetic topology and its effect on ELM dynamics and particle and heat deposition; the role of zonal flows during the L–H transition and I-phase; and a new turbulence-flow cycle state at the H-mode pedestal. Various means for mitigating ELMs have also been demonstrated to facilitate long-pulse operation, including supersonic molecular beam injection, as well as innovative solid Li granule injection. A brief overview of these recent advances is presented.

Physics Design of CFETR: Determination of the Device Engineering Parameters

Chinese Fusion Engineering Test Reactor (CFETR) based on the tokamak approach with superconducting magnet technology is envisioned to provide 200-MW fusion power and operate with a goal of an annual duty factor of 0.3-0.5. This report based on a zero-dimensional system study using extrapolations of current physics by considering engineering constraints, is focused on qualitative determination of the engineering parameters of the device. Conservative assumptions of plasma performance based on present day existing experiments were made to assure achievable goals, since CFETR could be a near-term project to bridge the gaps between ITER and DEMO. The baseline of 200-MW fusion power in standard H-mode for a duration longer than 1000 s and in a modest improved H-mode (or hybrid mode) with H98 ≤ 1.3 for steady-state operation derive a device of R=5.7 m, a=1.6 m in size with Bt=5 T, and total heating and current drive source power of 80 MW. More ambitious operating modes with higher fusion power reaching the alpha-particle dominated self-heating regime for burning plasma study is possible with the same device hardware, if the more advanced physics is incorporated. Since large vacuum chamber design, possible upgrades both on physics and technologies enable operation of the device with larger plasma configuration and provide potentials to demonstrate key physics issues relevant to DEMO.

Advances in H-mode physics for long-pulse operation on EAST

Since the 2012 International Atomic Energy Agency Fusion Energy Conference (IAEA-FEC), significant advances in both physics and technology has been made on the Experimental Advanced Superconducting Tomakak (EAST) toward a long-pulse stable high-confinement (H-mode) plasma regime. The experimental capabilities of EAST have been technically upgraded with the power enhancement (source power up to 26 MW) of the continuous-wave heating and current drive system, replacement of the upper graphite divertor with an ITER-like W monoblock divertor, and installation of a new internal cryopump in the upper divertor and a set of 16 in-vessel resonant magnetic perturbation (RMP) coils. This new upgrade enables EAST to be a unique operating device capable of investigating ITER-relevant long-pulse high-performance operations with dominant electron heating and low torque input within the next 5 years. Remarkable physics progress in controlling transient and steady-state divertor heat fluxes has been achieved on EAST, e.g. (i) edge-localized mode (ELM) mitigation/suppression with a number of attractive methods including lower hybrid wave (LHW), supersonic molecular beam injection (SMBI), RMPs, and real-time Li aerosol injection; and (ii) active control of steady-state power distribution by the synergy of LHW and SMBI. In the 2014 experimental campaign, a long-pulse high-performance H-mode plasma with H98 ~ 1.2 has been obtained with a duration over 28 s (~200 times the energy confinement time). In addition, several new experimental advances have been achieved in the last EAST campaign, including: (i) high-performance H-mode with βN ~ 2 and stored plasma energy ~220 kJ; (ii) H-mode plasma sustained by neutral beam injection (NBI) alone or modulated NBI with lower hybrid current drive (LHCD), for the first time in EAST; (iii) high current drive efficiency and nearly full noninductive plasmas maintained by the new 4.6 GHz LHCD system; (iv) demonstration of a quasi-snowflake divertor configuration; and (v) observation of a new edge-coherent mode and its effects on edge transport in H-mode plasmas.

Approaches towards long-pulse divertor operations on EAST by active control of plasma–wall interactions

The Experimental Advanced Superconducting Tokamak (EAST) has demonstrated, for the first time, long-pulse divertor plasmas over 400 s, entirely driven by lower hybrid current drive (LHCD), and further extended high-confinement plasmas, i.e. H-modes, over 30 s with predominantly LHCD and advanced lithium wall conditioning. Many new and exciting physics results have been obtained in the quest for long-pulse operations. The key findings are as follows: (1) access to H-modes in EAST favours the divertor configuration with the ion ∇B drift directed away from the dominant X-point; (2) divertor asymmetry during edge-localized modes (ELMs) also appears to be dependent on the toroidal field direction, with preferential particle flow opposite to the ion ∇B drift; (3) LHCD induces a striated heat flux (SHF), enhancing heat deposition away from the strike point, and the degree of SHF can be modified by supersonic molecule beam injection; (4) the long-pulse H-modes in EAST exhibit a confinement quality between type-I and type-III ELMy H-modes, with H98(y,2) ~ 0.9, similar to type-II ELMy H-modes.

Characterizations of power loads on divertor targets for type-I, compound and small ELMs in the EAST superconducting tokamak

The Experimental Advanced Superconducting Tokamak (EAST) has recently achieved a variety of H-mode regimes with different edge-localized mode (ELM) dynamics, including type-I ELMs, compound ELMs, which are manifested by the onset of a large spike followed by a sequence of small spikes on Dα emissions, usual type-III ELMs, and very small ELMs. This newly observed very small ELMy H-mode appears to be similar to the type-II ELMy H-mode, with higher repetition frequency (~1 kHz) and lower amplitude than the type-III ELMy H-mode, exhibiting an intermediate confinement level between type-I and type-III ELMy H-modes. The energy loss and divertor power load are systematically characterized for these different ELMy H-modes to provide a physics basis for the next-step high-power long-pulse operations in EAST. Both type-I and compound ELMs exhibit good confinement (H98(y,2) ~ 1). A significant loss of the plasma stored energy occurs at the onset of type-I ELMs (~8%) and compound ELMs (~5%), while no noticeable change in the plasma stored energy is observed for the small ELMs, including both type-III ELMs and very small ELMs. The peak heat flux on divertor targets for type-I ELMs currently achieved in EAST is about 10 MW m−2, as determined from the divertor-embedded triple Langmuir probe system with high time resolution. As expected, type-III ELMs lead to much smaller divertor power loads with a peak heat flux of about 2 MW m−2. Peak power loads for compound ELMs are between those for type-I and type-III ELMs. It is remarkable that the new very small ELMy H-modes exhibit even lower target power deposition than type-III ELMs, with the peak heat flux generally below 1 MW m−2. These very small ELMs are usually accompanied by broadband fluctuations with frequencies ranging from 20 to 50 kHz, which may promote particle and power exhaust throughout the very small ELMy H-mode regime.

Fast reciprocating probe system on the EAST superconducting tokamak.

A new fast reciprocating probe system (FRPS) has been built and installed on the outer midplane of the EAST tokamak to investigate the profiles of the boundary plasma parameters such as electron density and temperature. The system consists of a two-stage motion drive mechanism: slow motion and fast motion. The fast motion is powered by a servo motor, which drives the probe horizontally up to 50 cm to scan the edge region of the EAST tokamak. The maximum velocity achieved is 2 m/s. High velocity and flexible control of the fast motion are the remarkable features of this FRPS. A specially designed connector installed at the front end of the probe shaft makes it easy to install or replace the probe head on FRPS. During the latest experimental campaign in the spring of 2010, a probe head with seven tips, including two tips for a Mach probe, has been used. An example is given for simultaneous profile measurements of the plasma temperature, plasma density, and the plasma flow velocity.

Particle and power deposition on divertor targets in EAST H-mode plasmas

The effects of edge-localized modes (ELMs) on divertor particle and heat fluxes were investigated for the first time in the Experimental Advanced Superconducting Tokamak (EAST). The experiments were carried out with both double null and lower single null divertor configurations, and comparisons were made between the H-mode plasmas with lower hybrid current drive (LHCD) and those with combined ion cyclotron resonance heating (ICRH). The particle and heat flux profiles between and during ELMs were obtained from Langmuir triple-probe arrays embedded in the divertor target plates. And isolated ELMs were chosen for analysis in order to reduce the uncertainty resulting from the influence of fast electrons on Langmuir triple-probe evaluation during ELMs. The power deposition obtained from Langmuir triple probes was consistent with that from the divertor infra-red camera during an ELM-free period. It was demonstrated that ELM-induced radial transport predominantly originated from the low-field side region, in good agreement with the ballooning-like transport model and experimental results of other tokamaks. ELMs significantly enhanced the divertor particle and heat fluxes, without significantly broadening the SOL width and plasma-wetted area on the divertor target in both LHCD and LHCD + ICRH H-modes, thus posing a great challenge for the next-step high-power, long-pulse operation in EAST. Increasing the divertor-wetted area was also observed to reduce the peak heat flux and particle recycling at the divertor target, hence facilitating long-pulse H-mode operation. The particle and heat flux profiles during ELMs appeared to exhibit multiple peak structures, and were analysed in terms of the behaviour of ELM filaments and the flux tubes induced by modified magnetic topology during ELMs.

Study of the L–I–H transition with a new dual gas puff imaging system in the EAST superconducting tokamak

The intermediate oscillatory phase during the L–H transition, termed the I-phase, is studied in the EAST superconducting tokamak using a newly developed dual gas puff imaging (GPI) system near the L–H transition power threshold. The experimental observations suggest that the oscillatory behaviour appearing at the L–H transition could be induced by the synergistic effect of the two components of the sheared m, n = 0 E × B flow, i.e. the turbulence-driven zonal flow (ZF) and the equilibrium flow. The latter arises from the equilibrium, and is, to leading order, balanced by the ion diamagnetic term in the radial force balance equation. A slow increase in the poloidal flow and its shear at the plasma edge are observed tens of milliseconds prior to the I-phase. During the I-phase, the turbulence recovery appears to originate from the vicinity of the separatrix with clear wave fronts propagating both outwards into the far scrape-off layer (SOL) and inwards into the core plasma. The turbulence Reynolds stress is directly measured using the GPI system during the I-phase, providing direct evidence of kinetic energy transfer from turbulence to ZFs at the plasma edge. The GPI observations strongly suggest that the SOL transport physics and the evolution of pressure gradient near the separatrix play an important role in the L–I–H transition dynamics. To highlight these new physics, the previous predator–prey model is extended to include a new equation for the SOL physics. The model successfully reproduces the L–I–H transition process with several features comparing favourably with GPI observations.

Scaling of divertor power footprint width in RF-heated type-III ELMy H-mode on the EAST superconducting tokamak

Dedicated experiments for the scaling of divertor power footprint width have been performed in the ITER-relevant radiofrequency (RF)-heated H-mode scheme under the lower single null, double null and upper single null divertor configurations in the Experimental Advanced Superconducting Tokamak (EAST) under lithium wall coating conditioning. A strong inverse scaling of the edge localized mode (ELM)-averaged power fall-off width with the plasma current (equivalently the poloidal field) has been demonstrated for the attached type-III ELMy H-mode as λq ∝ I −1.05 p by various heat flux diagnostics including the divertor Langmuir probes (LPs), infra-red (IR) thermograph and reciprocating LPs on the low-field side. The IR camera and divertor LP measurements show that λq,IR ≈ λq,div-LPs/1.3 = 1.15B −1.25 p,omp , in good agreement with the multi-machine scaling trend during the inter-ELM phase between type-I ELMs or ELM-free enhanced Dα (EDA). H-mode. However, the magnitude is nearly doubled, which may be attributed to the different operation scenarios or heating schemes in EAST, i.e., dominated by electron heating. It is also shown that the type-III ELMs only broaden the power fall-off width slightly, and the ELM-averaged width is representative for the inter-ELM period. Furthermore, the inverse Ip (Bp) scaling appears to be independent of the divertor configurations in EAST. The divertor power footprint integral width, fall-off width and dissipation width derived from EAST IR camera measurements follow the relation, λint ∼ λq +1.64S, yielding λ EAST = (1.39±0.03)λ EAST +(0.97±0.35) mm. Detailed analysis of these three characteristic widths was carried out to shed more light on their extrapolation to ITER.