Haiyu Fang

Synthesis and Thermoelectric Properties of Compositional-Modulated Lead Telluride–Bismuth Telluride Nanowire Heterostructures

We demonstrate the rational solution-phase synthesis of compositional modulated telluride nanowire heterostructures containing lead telluride (PbTe) and bismuth telluride (Bi2Te3). By tuning the ratio between PbTe and Bi2Te3 through adjusting the amount of critical reactants and precursors during the synthesis, the influence of composition on the thermoelectric properties of the nanowire heterostructures has been investigated in hot pressed nanocomposite pellets. Measurements of the thermoelectric properties show strongly reduced thermal conductivity that leads to an enhanced thermoelectric figure of merit (ZT) of 1.2 at 620 K.

The effects of the size and the doping concentration on the power factor of n-type lead telluride nanocrystals for thermoelectric energy conversion.

For the first time, we demonstrate a successful synthesis of colloidal n-type lead telluride nanocrystals doped with iodine. By tuning the reaction time and iodine concentration in the precursor solution, nanocrystals with different sizes and doping concentrations are synthesized. The Seebeck coefficient and electrical conductivity of the nanocrystals are measured on nanocrystal thin films fabricated by dip-coating glass substrates in the nanocrystals solution. Investigations on the influence of size and doping concentration on the electrical properties have been performed. The results show that the size of the nanocrystals significantly influences the electrical conductivity but not the Seebeck coefficient of nanocrystal films, while higher doping concentration leads to lower Seebeck coefficient but higher electrical conductivity in the nanocrystal films. Proof-of-concept thin-film thermoelectric modules are also fabricated using both p-type and n-type PbTe nanocrystals for the conversion of thermal energy into electrical energy.

Structure and Thermoelectric Properties of Spark Plasma Sintered Ultrathin PbTe Nanowires

Solution-synthesized thermoelectric nanostructured materials have the potential to have lower cost and higher performance than materials synthesized by solid-state methods. Herein we present the synthesis of ultrathin PbTe nanowires, which are compressed by spark plasma sintering at various temperatures in the range of 405-500 °C. The resulting discs possess grains with sizes of 5-30 μm as well as grains with sizes on the order of the original 12 nm diameter PbTe nanowires. This micro- and nanostructure leads to a significantly reduced thermal conductivity compared to bulk PbTe. Careful electron transport analysis shows suppressed electrical conductivity due to increased short-range and ionized defect scatterings, while the Seebeck coefficient remains comparable to the bulk value. The PbTe nanowire samples are found unintentionally p-type doped to hole concentrations of 2.16-2.59 × 10(18) cm(-3). The maximum figure of merit achieved in the unintentionally doped spark plasma sintered PbTe nanowires is 0.33 at 350 K, which is among the highest reported for unintentionally doped PbTe at low temperatures.

Impact of Surface-Bound Small Molecules on the Thermoelectric Property of Self-Assembled Ag2Te Nanocrystal Thin Films

Small molecules with functional groups can show different electron affinity and binding behavior on nanocrystal surface, which in principle could be used to alternate the electrical transport in self-assembled nanocrystal thin films. These small molecules can also serve for scattering the phonons to reduce the thermal conductivity. Here, we present our research on the thermoelectric characteristic of self-assembled silver telluride (Ag2Te) nanocrystal thin films that are fabricated by a layer-by-layer (LBL) dip-coating process. We perform investigations on the electrical conductivity and Seebeck coefficient on the Ag2Te nanocrystal thin films containing hydrazine, 1,2-ethanedithiol, and ethylenediamine between 300 and 400 K. We also use photothermal (PT) technique to obtain the thermal conductivity of the films at room temperature and estimate the thermoelectric figure of merit (ZT). The experimental results suggest that the surface-bound small molecules could serve as a beneficial component to build nanocrystal-based thermoelectric devices operating at low temperature.

Thermoelectric properties of solution-synthesized n-type Bi2Te3 nanocomposites modulated by Se: An experimental and theoretical study

We report the investigation of the thermoelectric properties of large-scale solution-synthesized Bi2Te3 nanocomposites prepared from nanowires hotpressed into bulk pellets. A third element, Se, is introduced to tune the carrier concentration of the nanocomposites. Due to the Se doping, the thermoelectric figure of merit (ZT) of the nanocomposites is significantly enhanced due to the increased power factor and reduced thermal conductivity. We also find that thermal transport in our hot-pressed pellets is anisotropic, which results in different thermal conductivities along the in-plane and cross-plane directions. Theoretical calculations for both electronic and thermal transport are carried out to establish fundamental understanding of the material system and provide directions for further ZT optimization with adjustments to carrier concentration and mobility.

Measurement of Thermal Conductivity of PbTe Nanocrystal Coated Glass Fibers by the 3ω Method

Fiber-based thermoelectric materials can conform to curved surfaces to form energy harvesting devices for waste heat recovery. Here we investigate the thermal conductivity in the axial direction of glass fibers coated with lead telluride (PbTe) nanocrystals using the self-heated 3ω method particularly at low frequency. While prior 3ω measurements on wire-like structures have only been demonstrated for high thermal conductivity materials, the present work demonstrates the suitability of the 3ω method for PbTe nanocrystal coated glass fibers where the low thermal conductivity and high aspect ratio result in a significant thermal radiation effect. We simulate the experiment using a finite-difference method that corrects the thermal radiation effect and extract the thermal conductivity of glass fibers coated by PbTe nanocrystals. The simulation method for radiation correction is shown to be generally much more accurate than analytical methods. We explore the effect of nanocrystal volume fraction on thermal conductivity and obtain results in the range of 0.50-0.93 W/mK near room temperature.

Thermoelectric Properties of Solution Synthesized Nanostructured Materials

Thermoelectric nanocomposites made by solution synthesis and compression of nanostructured chalcogenides could potentially be low-cost, scalable alternatives to traditional solid-state synthesized materials. We review the progress in this field by comparing the power factor and/or the thermoelectric figure of merit, ZT, of four classes of materials: (Bi,Sb)2(Te,Se)3, PbTe, ternary and quaternary copper chalcogenides, and silver chalcogenides. We also discuss the thermal conductivity reduction associated with multiphased nanocomposites. The ZT of the best solution synthesized materials are, in several cases, shown to be equal to or greater than the corresponding bulk materials despite the generally reduced mobility associated with solution synthesized nanocomposites. For the solution synthesized materials with the highest performance, the synthesis and processing conditions are summarized to provide guidance for future work.