Network


Latest external collaboration on country level. Dive into details by clicking on the dots.

Hotspot


Dive into the research topics where Han Vervaeren is active.

Publication


Featured researches published by Han Vervaeren.


Biotechnology Advances | 2012

Flue gas compounds and microalgae: (bio-)chemical interactions leading to biotechnological opportunities

Sofie Van Den Hende; Han Vervaeren; Nico Boon

Flue gases are a resource yet to be fully utilised in microalgal biotechnology, not only to moderate the anthropogenic effects on our climate, but also to steer microalgal resource management towards innovative applications of microalgal biomass compounds. These gases, both untreated and treated into current discharge standards, contain CO2, N2, H2O, O2, NOx, SOx, CxHy, CO, particulate matter, halogen acids and heavy metals. To better steer and engineer flue gas-fed microalgal cultures, all these compounds need to be considered. Therefore, here, we review (i) the chemical composition and treatment technologies of flue gas, (ii) the uptake pathways and removal of the different compounds in microalgae reactors, and (iii) the tolerance and effects on microalgae of all flue gas compounds. By emphasising the interactions between microalgae and flue gas compounds, we envisage new pathways for microalgal biomass valorisation such as enzyme production for environmental technology, novel biogas production and biosequestration of minerals. Furthermore, we highlight fundamental and applied research niches that merit further investigation.


Bioresource Technology | 2014

Up-scaling aquaculture wastewater treatment by microalgal bacterial flocs: From lab reactors to an outdoor raceway pond

Sofie Van Den Hende; Veerle Beelen; Gaelle Bore; Nico Boon; Han Vervaeren

Sequencing batch reactors with microalgal bacterial flocs (MaB-floc SBRs) are a novel approach for photosynthetic aerated wastewater treatment based on bioflocculation. To assess their technical potential for aquaculture wastewater treatment in Northwest Europe, MaB-floc SBRs were up-scaled from indoor photobioreactors of 4 L over 40 and 400 L to a 12 m(3) outdoor raceway pond. Scale-up decreased the nutrient removal efficiencies with a factor 1-3 and the volumetric biomass productivities with a factor 10-13. Effluents met current discharge norms, except for nitrite and nitrate. Flue gas sparging was needed to decrease the effluent pH. Outdoor MaB-flocs showed enhanced settling properties and an increased ash and chlorophyll a content. Bioflocculation enabled successful harvesting by gravity settling and dewatering by filtering at 150-250 μm. Optimisation of nitrogen removal and biomass valorisation are future challenges towards industrial implementation of MaB-floc SBRs for aquaculture wastewater treatment.


Biotechnology and Bioengineering | 2011

Microalgal bacterial floc properties are improved by a balanced inorganic/organic carbon ratio.

Sofie Van Den Hende; Han Vervaeren; Hans Saveyn; Guy Maes; Nico Boon

Microalgal bacterial floc (MaB‐floc) reactors have been suggested as a more sustainable secondary wastewater treatment. We investigated whether MaB‐flocs could be used as tertiary treatment. Tertiary influent has a high inorganic/organic carbon ratio, depending on the efficiency of the secondary treatment. In this study, the effect of this inorganic/organic carbon ratio on the MaB‐flocs performance was determined, using three sequencing batch photobioreactors. The MaB‐flocs were fed with synthetic wastewater containing 84, 42, and 0 mg L−1 C‐KHCO3 supplemented with 0, 42, 84 mg L−1 C‐sucrose, respectively, representing inorganic versus organic carbon. Bicarbonate significantly decreased the autotrophic index of the MaB‐flocs and resulted in poorly settling flocs. Moreover, sole bicarbonate addition led to a high pH of 9.5 and significant lower nitrogen removal efficiencies. Sucrose without bicarbonate resulted in good settling MaB‐flocs, high nitrogen removal efficiencies and neutral pH levels. Despite the lower chlorophyll a content of the biomass and the lower in situ oxygen concentration, 92–96% of the soluble COD‐sucrose was removed. This study shows that the inorganic/organic carbon ratio of the wastewater is of major importance and that organic carbon is requisite to guarantee a good performance of the MaB‐flocs for wastewater treatment. Biotechnol. Bioeng. 2011; 108:549–558.


Bioresource Technology | 2014

Treatment of industrial wastewaters by microalgal bacterial flocs in sequencing batch reactors.

Sofie Van Den Hende; Erwan Carré; Elodie Cocaud; Veerle Beelen; Nico Boon; Han Vervaeren

Microalgal bacterial flocs in sequencing batch reactors (MaB-floc SBRs) represent a novel approach to wastewater treatment. In this approach, mechanical aeration is replaced by photosynthetic aeration and MaB-floc settling separates the treated wastewater from the produced biomass. However, its technical potential for industrial wastewaters needs to be shown. Therefore, wastewaters of aquaculture, manure treatment, food-processing and chemical industry were treated in MaB-floc SBRs. This treatment resulted in significantly different nutrient removal rates and effluent qualities among wastewaters. A high MaB-floc production was obtained for all wastewaters, ranging from 0.14 to 0.26g total suspended solids Lreactor(-1)day(-1). A major advantage of MaB-flocs is the harvesting via a filter press with a large pore size of 200μm, resulting in MaB-floc recoveries of 79-99% and cakes containing 12-21% dry matter. These results may contribute to evolving MaB-floc SBRs as a valuable remediation strategy, especially for aquaculture and food-processing wastewaters.


Bioresource Technology | 2014

Impact of enzymatic pretreatment on corn stover degradation and biogas production

Michel Schroyen; Han Vervaeren; Stijn Van Hulle; Katleen Raes

Corn stover is an agricultural residue consisting of lignocellulose, cellulose and hemicellulose polymers, sheeted in a lignin barrier. Corn stover can be used as feedstock for biogas production. Previous studies have shown biological pretreatment of lignocellulose materials can increase digestibility of the substrate improving hydrolysis, the rate-limiting step in biogas production. The impact of pretreating with different enzymes (laccase, manganese peroxidase and versatile peroxidase) and different incubation times, (0, 6 and 24 h) was studied. The effect on the matrix and biomethane production was determined. Pretreatments did not yield high concentrations of phenolic compounds, inhibitors of biogas production. The laccase enzyme showed an increase in biomethane production of 25% after 24 h of incubation. Pretreatment with peroxidase enzymes increased biomethane production with 17% after 6 h of incubation. As such it can be concluded that by introducing the different enzymes at different stages during pretreatment an increased biomethane production can be obtained.


Bioresource Technology | 2014

Effect of liquid hot water pre-treatment on sugarcane press mud methane yield.

Lisbet Mailin López González; Ileana Pereda Reyes; Jo Dewulf; Jörn Budde; Monika Heiermann; Han Vervaeren

Sugarcane press mud was pretreated by liquid hot water (LHW) at different temperatures (140-210 °C) and pre-treatment times (5-20 min) in order to assess the effects on the chemical oxygen demand (COD) solubilisation, inhibitors formation and methane yield. The experimental results showed that a high degree of biomass solubilisation was possible using LHW. Higher methane yields were obtained at lower severities (log(Ro) = 2.17-2.77) with (i) mild temperatures (140-150 °C) and long contact times (12.5 min, 20 min) or (ii) mild temperatures (175 °C) with short contact time (2 min). The highest increase in methane yield (up to 63%) compared to the untreated press mud was found at 150 °C for 20 min. At temperatures of 200 °C and 210 °C, low methane efficiency was attributed to the possible formation of refractory compounds through the Maillard reaction.


Bioresource Technology | 2015

Effect of enzymatic pretreatment of various lignocellulosic substrates on production of phenolic compounds and biomethane potential.

Michel Schroyen; Han Vervaeren; Hanne Vandepitte; Stijn Van Hulle; Katleen Raes

Pretreatment of lignocellulosic biomass is necessary to enhance the hydrolysis, which is the rate-limiting step in biogas production. Laccase and versatile peroxidase are enzymes known to degrade lignin. Therefore, the impact of enzymatic pretreatment was studied on a variety of biomass. A significant higher release in total phenolic compounds (TPC) was observed, never reaching the inhibiting values for anaerobic digestion. The initial concentration of TPC was higher in the substrates containing more lignin, miscanthus and willow. The anaerobic digestion of these two substrates resulted in a significant lower biomethane production (68.8-141.7 Nl/kg VS). Other substrates, corn stover, flax, wheat straw and hemp reached higher biomethane potential values (BMP), between 241 and 288 Nl/kg VS. Ensilaged maize reached 449 Nl/kg VS, due to the ensilation process, which can be seen as a biological and acid pretreatment. A significant relation (R(2) = 0.89) was found between lignin content and BMP.


Bioresource Technology | 2013

Thermo-chemical pre-treatment to solubilize and improve anaerobic biodegradability of press mud

Lisbet Mailin López González; Han Vervaeren; Ileana Pereda Reyes; Ann Dumoulin; Osvaldo Romero Romero; Jo Dewulf

Different pre-treatment severities by thermo-alkaline conditions (100°C, Ca(OH)2) on press mud were evaluated for different pre-treatment time and lime loading. COD solubilization and the methane yield enhancement were assessed. The biochemical methane potential was determined in batch assays under mesophilic conditions (37±1°C). The best pre-treatment resulted in a surplus of 72% of methane yield, adding 10g Ca(OH)2 100g(-1)TS(-1) for 1h. Pre-treatment also increased the COD solubilization, but the optimal severity for COD solubilization as determined by response surface methodology did not ensure the highest methane production. Inhibitory effects on anaerobic digestion were noticed when the severity was increased. These results demonstrate the relevance of thermo-alkaline pre-treatment severity in terms of both lime loading and pre-treatment time to obtain optimal anaerobic biodegradability of lignocellulosic biomass from press mud.


Bioresource Technology | 2015

Low temperature calcium hydroxide treatment enhances anaerobic methane production from (extruded) biomass

Way Cern Khor; Korneel Rabaey; Han Vervaeren

Ca(OH)2 treatment was applied to enhance methane yield. Different alkali concentration, incubation temperature and duration were evaluated for their effect on methane production and COD conversion efficiency from (non-)extruded biomass during mesophilic anaerobic digestion at lab-scale. An optimum Ca(OH)2 pretreatment for grass is found at 7.5% lime loading at 10°C for 20h (37.3% surplus), while mild (50°C) and high temperatures perform sub-optimal. Ca(OH)2 post-treatment after fast extrusion gives an additional surplus compared to extruded material of 15.2% (grass), 11.2% (maize straw) and 8.2% (sprout stem) regarding methane production. COD conversion improves accordingly, with additional improvements of 10.3% (grass), 9.0% (maize straw) and 6.8% (sprout stem) by Ca(OH)2 post-treatment. Therefore, Ca(OH)2 pretreatment and post-treatment at low temperature generate an additional effect regarding methane production and COD conversion efficiency. Fast extrusion gives a higher energy efficiency ratio compared to slow extrusion.


Bioresource Technology | 2016

Technical potential of microalgal bacterial floc raceway ponds treating food-industry effluents while producing microalgal bacterial biomass : an outdoor pilot-scale study

Sofie Van Den Hende; Veerle Beelen; Lucie Julien; Alexandra Lefoulon; Thomas Vanhoucke; Carlos Coolsaet; Stanislaus Sonnenholzner; Han Vervaeren; Diederik Rousseau

To replace costly mechanical aeration by photosynthetical aeration, upflow anaerobic sludge blanket (UASB) effluent of food-industry was treated in an outdoor MaB-floc raceway pond. Photosynthetic aeration was sufficient for nitrification, but the raceway effluent quality was below current discharge limits, despite the high hydraulic retention time (HRT) of 35days. Hereafter, conventional activated sludge (CAS) effluent of food-industry was treated in this pond to recover phosphorus. The two-day HRT results in a more realistic pond area, but the phosphorus removal efficiency was low (20%). High biomass productivities were obtained, i.e. 31.3 and 24.9ton total suspended solids hapond(-1)year(-1) for UASB and CAS effluent, respectively. Bioflocculation enabled successful harvesting of CAS effluent-fed MaB-flocs by settling and filtering at 150-250μm to 22.7% total solids. To conclude, MaB-floc raceway ponds cannot be recommended as the sole treatment for these food-industry effluents, but huge potential lies in added-value biomass production.

Collaboration


Dive into the Han Vervaeren's collaboration.

Top Co-Authors

Avatar

Nico Boon

Janssen Pharmaceutica

View shared research outputs
Top Co-Authors

Avatar
Top Co-Authors

Avatar
Top Co-Authors

Avatar
Top Co-Authors

Avatar
Top Co-Authors

Avatar
Top Co-Authors

Avatar
Top Co-Authors

Avatar
Top Co-Authors

Avatar
Top Co-Authors

Avatar
Researchain Logo
Decentralizing Knowledge