Harald Kübler

Coherent excitation of Rydberg atoms in micrometre-sized atomic vapour cells

The coherent control of mesoscopic ensembles of atoms and Rydberg atom blockade are the basis for proposed quantum devices such as integrable gates and single photon sources. So far, experimental progress has been limited to complex experimental setups that use ultracold atoms. Here, we show that coherence times of ∼ 100 ns are achievable with coherent Rydberg atom spectroscopy in μm sized thermal vapor cells. We investigated states with principle quantum numbers between 30 and 50. Our results demonstrate that microcells with a size on the order of the blockade radius, ∼ 2μm, at temperatures of 100 − 300 ◦C are robust, promising candidates to investigate low dimensional strongly interacting Rydberg gases, construct quantum gates and build single photon sources.

Atom Based Vector Microwave Electrometry Using Rubidium Rydberg Atoms in a Vapor Cell

It is clearly important to pursue atomic standards for quantities like electromagnetic fields, time, length, and gravity. We have recently shown using Rydberg states that Rb atoms in a vapor cell can serve as a practical, compact standard for microwave electric field strength. Here we demonstrate for the first time that Rb atoms excited in a vapor cell can also be used for vector microwave electrometry by using Rydberg-atom electromagnetically induced transparency. We describe the measurements necessary to obtain an arbitrary microwave electric field polarization at a resolution of 0.5°. We compare the experiments to theory and find them to be in excellent agreement.

Atom based RF electric field sensing

Atom-based measurements of length, time, gravity, inertial forces and electromagnetic fields are receiving increasing attention. Atoms possess properties that suggest clear advantages as self calibrating platforms for measurements of these quantities. In this review, we describe work on a new method for measuring radio frequency (RF) electric fields based on quantum interference using either Cs or Rb atoms contained in a dielectric vapor cell. Using a bright resonance prepared within an electromagnetically induced transparency window it is possible to achieve high sensitivities, <1 μV cm−1 Hz−1/2, and detect small RF electric fields μV cm−1 with a modest setup. Some of the limitations of the sensitivity are addressed in the review. The method can be used to image RF electric fields and can be adapted to measure the vector electric field amplitude. Extensions of Rydberg atom-based electrometry for frequencies up to the terahertz regime are described.

Atom-Based Sensing of Weak Radio Frequency Electric Fields Using Homodyne Readout

We utilize a homodyne detection technique to achieve a new sensitivity limit for atom-based, absolute radio-frequency electric field sensing of 5 μV cm−1 Hz−1/2. A Mach-Zehnder interferometer is used for the homodyne detection. With the increased sensitivity, we investigate the dominant dephasing mechanisms that affect the performance of the sensor. In particular, we present data on power broadening, collisional broadening and transit time broadening. Our results are compared to density matrix calculations. We show that photon shot noise in the signal readout is currently a limiting factor. We suggest that new approaches with superior readout with respect to photon shot noise are needed to increase the sensitivity further.

Atomic vapor spectroscopy in integrated photonic structures

We investigate an integrated optical chip immersed in atomic vapor providing several waveguide geometries for spectroscopy applications. The narrow-band transmission through a silicon nitride waveguide and interferometer is altered when the guided light is coupled to a vapor of rubidium atoms via the evanescent tail of the waveguide mode. We use grating couplers to couple between the waveguide mode and the radiating wave, which allow for addressing arbitrary coupling positions on the chip surface. The evanescent atom-light interaction can be numerically simulated and shows excellent agreement with our experimental data. This work demonstrates a next step towards miniaturization and integration of alkali atom spectroscopy and provides a platform for further fundamental studies of complex waveguide structures.

Electrical readout for coherent phenomena involving Rydberg atoms in thermal vapor cells.

We present a very sensitive and scalable method to measure the population of highly excited Rydberg states in a thermal vapor cell of rubidium atoms. We detect the Rydberg ionization current in a 5 mm electrically contacted cell. The measured current is found to be in qualitatively good agreement with a theory for the Rydberg population based on a master equation for the three-level problem, including an ionization channel and the full Doppler distributions at the corresponding temperatures. The signal-to-noise ratio of the current detection is substantially better than that of purely optical techniques.

Two-frequency acousto-optic modulator driver to improve the beam pointing stability during intensity ramps.

We report on a scheme to improve the pointing stability of the first order beam diffracted by an acousto-optic modulator (AOM). Due to thermal effects inside the crystal, the angular position of the beam can change by as much as 1 mrad when the radio-frequency power in the AOM is reduced to decrease the first order beam intensity. This is done, for example, to perform forced evaporative cooling in ultracold atom experiments using far-off-resonant optical traps. We solve this problem by driving the AOM with two radio frequencies f(1) and f(2). The power of f(2) is adjusted relative to the power of f(1) to keep the total power constant. Using this, the beam displacement is decreased by a factor of 20. The method is simple to implement in existing experimental setups, without any modification of the optics.

Charge-induced optical bistability in thermal Rydberg vapor

We investigate the phenomenon of optical bistability in a driven ensemble of Rydberg atoms. By performing two experiments with thermal vapors of rubidium and cesium, we are able to shed light onto the underlying interaction mechanisms causing such a non-linear behavior. Due to the different properties of these two atomic species, we conclude that the large polarizability of Rydberg states in combination with electric fields of spontaneously ionized Rydberg atoms is the relevant interaction mechanism. In the case of rubidium, we directly measure the electric field in a bistable situation via two-species spectroscopy. In cesium, we make use of the different sign of the polarizability for different l-states and the possibility of applying electric fields. Both these experiments allow us to rule out dipole-dipole interactions, and support our hypothesis of a charge-induced bistability.

Triple stack glass-to-glass anodic bonding for optogalvanic spectroscopy cells with electrical feedthroughs

We demonstrate the use of an anodic bonding technique for building a vacuum tight vapor cell for the use of Rydberg spectroscopy of alkali atoms with thin film electrodes on the inside of the cell. The cell is fabricated by simultaneous triple stack glass-to-glass anodic bonding at 300 °C. This glue-free, low temperature sealing technique provides the opportunity to include thin film electric feedthroughs. The pressure broadening is only limited by the vapor pressure of rubidium and the lifetime is at least four months with operating temperatures up to 230 °C.

Fabrication and characterization of an electrically contacted vapor cell

We demonstrate the use of electrically contacted vapor cells to switch the transmission of a probe laser. The excitation scheme makes use of electromagnetically induced transparency involving a Rydberg state. The cell fabrication technique involves thin-film-based electric feedthroughs, which are well suited for scaling this concept to many addressable pixels like in flat panel displays.