Hemma Mistry

Particle Size Effects in the Catalytic Electroreduction of CO2 on Cu Nanoparticles

A study of particle size effects during the catalytic CO2 electroreduction on size-controlled Cu nanoparticles (NPs) is presented. Cu NP catalysts in the 2-15 nm mean size range were prepared, and their catalytic activity and selectivity during CO2 electroreduction were analyzed and compared to a bulk Cu electrode. A dramatic increase in the catalytic activity and selectivity for H2 and CO was observed with decreasing Cu particle size, in particular, for NPs below 5 nm. Hydrocarbon (methane and ethylene) selectivity was increasingly suppressed for nanoscale Cu surfaces. The size dependence of the surface atomic coordination of model spherical Cu particles was used to rationalize the experimental results. Changes in the population of low-coordinated surface sites and their stronger chemisorption were linked to surging H2 and CO selectivities, higher catalytic activity, and smaller hydrocarbon selectivity. The presented activity-selectivity-size relations provide novel insights in the CO2 electroreduction reaction on nanoscale surfaces. Our smallest nanoparticles (~2 nm) enter the ab initio computationally accessible size regime, and therefore, the results obtained lend themselves well to density functional theory (DFT) evaluation and reaction mechanism verification.

Exceptional size-dependent activity enhancement in the electroreduction of CO2 over Au nanoparticles.

The electrocatalytic reduction of CO2 to industrial chemicals and fuels is a promising pathway to sustainable electrical energy storage and to an artificial carbon cycle, but it is currently hindered by the low energy efficiency and low activity displayed by traditional electrode materials. We report here the size-dependent catalytic activity of micelle-synthesized Au nanoparticles (NPs) in the size range of ∼1-8 nm for the electroreduction of CO2 to CO in 0.1 M KHCO3. A drastic increase in current density was observed with decreasing NP size, along with a decrease in Faradaic selectivity toward CO. Density functional theory calculations showed that these trends are related to the increase in the number of low-coordinated sites on small NPs, which favor the evolution of H2 over CO2 reduction to CO. We show here that the H2/CO product ratio can be specifically tailored for different industrial processes by tuning the size of the catalyst particles.

Highly selective plasma-activated copper catalysts for carbon dioxide reduction to ethylene

There is an urgent need to develop technologies that use renewable energy to convert waste products such as carbon dioxide into hydrocarbon fuels. Carbon dioxide can be electrochemically reduced to hydrocarbons over copper catalysts, although higher efficiency is required. We have developed oxidized copper catalysts displaying lower overpotentials for carbon dioxide electroreduction and record selectivity towards ethylene (60%) through facile and tunable plasma treatments. Herein we provide insight into the improved performance of these catalysts by combining electrochemical measurements with microscopic and spectroscopic characterization techniques. Operando X-ray absorption spectroscopy and cross-sectional scanning transmission electron microscopy show that copper oxides are surprisingly resistant to reduction and copper+ species remain on the surface during the reaction. Our results demonstrate that the roughness of oxide-derived copper catalysts plays only a partial role in determining the catalytic performance, while the presence of copper+ is key for lowering the onset potential and enhancing ethylene selectivity.

Tailoring the Catalytic Properties of Metal Nanoparticles via Support Interactions

The development of new catalysts for energy technology and environmental remediation requires a thorough knowledge of how the physical and chemical properties of a catalyst affect its reactivity. For supported metal nanoparticles (NPs), such properties can include the particle size, shape, composition, and chemical state, but a critical parameter which must not be overlooked is the role of the NP support. Here, we highlight the key mechanisms behind support-induced enhancement in the catalytic properties of metal NPs. These include support-induced changes in the NP morphology, stability, electronic structure, and chemical state, as well as changes in the support due to the NPs. Utilizing the support-dependent phenomena described in this Perspective may allow significant breakthroughs in the design and tailoring of the catalytic activity and selectivity of metal nanoparticles.

Pressure‐Dependent Effect of Hydrogen Adsorption on Structural and Electronic Properties of Pt/γ‐Al2O3 Nanoparticles

Understanding the interaction of hydrogen with subnanometer platinum nanoparticles (NPs) under industrially relevant conditions is of great importance to heterogeneous catalysis. In this work, we investigate the pressure‐dependent changes in hydrogen coverage on size‐ and shape‐selected Pt/γ‐Al2O3 NPs by in situ X‐ray absorption near‐edge structure (XANES) analysis. Difference XANES calculations revealed an increase in the H/Pt ratio from 1.9 to 2.5 upon increasing the hydrogen pressure from 1 to 21 bar at room temperature (1 bar=100 kPa). In addition, extended X‐ray absorption fine structure measurements of the local geometrical structure showed changes in PtPt bond length and coordination number, revealing a morphological transformation in the NPs from a 2 D to a 3 D shape under increasing H2 pressure at room temperature. Such shape evolution leads to a decrease in the NP–support contact area and is thus expected to affect the NP stability against coarsening.

Carbon Monoxide-Induced Stability and Atomic Segregation Phenomena in Shape-Selected Octahedral PtNi Nanoparticles

The chemical and morphological stability of size- and shape-selected octahedral PtNi nanoparticles (NP) were investigated after different annealing treatments up to a maximum temperature of 700 °C in a vacuum and under 1 bar of CO. Atomic force microscopy was used to examine the mobility of the NPs and their stability against coarsening, and X-ray photoelectron spectroscopy to study the surface composition, chemical state of Pt and Ni in the NPs, and thermally and CO-induced atomic segregation trends. Exposing the samples to 1 bar of CO at room temperature before annealing in a vacuum was found to be effective at enhancing the stability of the NPs against coarsening. In contrast, significant coarsening was observed when the sample was annealed in 1 bar of CO, most likely as a result of Ni(CO)4 formation and their enhanced mobility on the support surface. Sample exposure to CO at room temperature prior to annealing led to the segregation of Pt to the NP surface. Nevertheless, oxidic PtOx and NiOx species still remained at the NP surface, and, irrespective of the initial sample pretreatment, Ni surface segregation was observed upon annealing in a vacuum at moderate temperature (T < 300 °C). Interestingly, a distinct atomic segregation trend was detected between 300 and 500 °C for the sample pre-exposed to CO; namely, Ni surface segregation was partially hindered. This might be attributed to the higher bonding energy of CO to Pt as compared to Ni. Annealing in the presence of 1 bar CO also resulted in the initial surface segregation of Ni (T < 400 °C) as long as PtOx and NiOx species were available on the surface as a result of the higher affinity of Ni for oxygen. Above 500 °C, and regardless of the sample pretreatment, the diffusion of Pt atoms to the NP surface and the formation of a Ni-Pt alloy are observed.

Enhanced carbon dioxide electroreduction to carbon monoxide over defect rich plasma-activated silver catalysts

Efficient, stable catalysts with high selectivity for a single product are essential if electroreduction of CO2 is to become a viable route to the synthesis of industrial feedstocks and fuels. A plasma oxidation pre-treatment of silver foil enhances the number of low-coordinated catalytically active sites, which dramatically lowers the overpotential and increases the activity of CO2 electroreduction to CO. At -0.6 V versus RHE more than 90 % Faradaic efficiency towards CO was achieved on a pre-oxidized silver foil. While transmission electron microscopy (TEM) and operando X-ray absorption spectroscopy showed that oxygen species can survive in the bulk of the catalyst during the reaction, quasi in situ X-ray photoelectron spectroscopy showed that the surface is metallic under reaction conditions. DFT calculations reveal that the defect-rich surface of the plasma-oxidized silver foils in the presence of local electric fields drastically decrease the overpotential of CO2 electroreduction.

Operando Phonon Studies of the Protonation Mechanism in Highly Active Hydrogen Evolution Reaction Pentlandite Catalysts

Synthetic pentlandite (Fe4.5Ni4.5S8) is a promising electrocatalyst for hydrogen evolution, demonstrating high current densities, low overpotential, and remarkable stability in bulk form. The depletion of sulfur from the surface of this catalyst during the electrochemical reaction has been proposed to be beneficial for its catalytic performance, but the role of sulfur vacancies and the mechanism determining the reaction kinetics are still unknown. We have performed electrochemical operando studies of the vibrational dynamics of pentlandite under hydrogen evolution reaction conditions using 57Fe nuclear resonant inelastic X-ray scattering. Comparing the measured Fe partial vibrational density of states with density functional theory calculations, we have demonstrated that hydrogen atoms preferentially occupy substitutional positions replacing pre-existing sulfur vacancies. Once all vacancies are filled, the protonation proceeds interstitially, which slows down the reaction. Our results highlight the beneficial role of sulfur vacancies in the electrocatalytic performance of pentlandite and give insights into the hydrogen adsorption mechanism during the reaction.

Dynamic Changes in the Structure, Chemical State and Catalytic Selectivity of Cu Nanocubes during CO2 Electroreduction: Size and Support Effects

In situ and operando spectroscopic and microscopic methods were used to gain insight into the correlation between the structure, chemical state, and reactivity of size- and shape-controlled ligand-free Cu nanocubes during CO2 electroreduction (CO2 RR). Dynamic changes in the morphology and composition of Cu cubes supported on carbon were monitored under potential control through electrochemical atomic force microscopy, X-ray absorption fine-structure spectroscopy and X-ray photoelectron spectroscopy. Under reaction conditions, the roughening of the nanocube surface, disappearance of the (100) facets, formation of pores, loss of Cu and reduction of CuOx species observed were found to lead to a suppression of the selectivity for multi-carbon products (i.e. C2 H4 and ethanol) versus CH4 . A comparison with Cu cubes supported on Cu foils revealed an enhanced morphological stability and persistence of CuI species under CO2 RR in the former samples. Both factors are held responsible for the higher C2 /C1 product ratio observed for the Cu cubes/Cu as compared to Cu cubes/C. Our findings highlight the importance of the structure of the active nanocatalyst but also its interaction with the underlying substrate in CO2 RR selectivity.

Corrigendum: Highly selective plasma-activated copper catalysts for carbon dioxide reduction to ethylene.

Nature Communications 7 Article number: 12123 (2016); Published 30 June 2016; Updated 12 September 2016 An incorrect version of the Supplementary Information was inadvertently published with this Article in which the image for Supplementary Fig. 7 was missing. The Article has now been updated to include the correct version of the Supplementary Information.