Ion Cinca

Mechanical and corrosion resistance of a new nanostructured Ti–Zr–Ta–Nb alloy

In this work, a multi-elementary Ti-10Zr-5Nb-5Ta alloy, with non-toxic alloying elements, was used to develop an accumulative roll bonding, ARB-type procedure in order to improve its structural and mechanical properties. The alloy was obtained by cold crucible semi-levitation melting technique and then was ARB deformed following a special route. After three ARB cycles, the total deformation degree per layer is about 86%; the calculated medium layer thickness is about 13 μm. The ARB processed alloy has a low Youngs modulus of 46 GPa, a value very close to the value of the natural cortical bone (about 20 GPa). Data concerning ultimate tensile strength obtained for ARB processed alloy is rather high, suitable to be used as a material for bone substitute. Hardness of the ARB processed alloy is higher than that of the as-cast alloy, ensuring a better behaviour as a implant material. The tensile curve for the as-cast alloy shows an elastoplastic behaviour with a quite linear elastic behaviour and the tensile curve for the ARB processed alloy is quite similar with a strain-hardening elastoplastic body. Corrosion behaviour of the studied alloy revealed the improvement of the main electrochemical parameters, as a result of the positive influence of ARB processing. Lower corrosion and ion release rates for the ARB processed alloy than for the as-cast alloy, due to the favourable effect of ARB thermo-mechanical processing were obtained.

X-ray Diffraction Study and Texture Evolution for a Ti-Nb-Ta Biomedical Alloy Processed by Accumulative Roll Bonding

AbstractA Ti-25Nb-25Ta β-type alloy was subjected to severe plastic deformation via accumulative roll bonding; the method was applied on two different precursor samples, in order to establish the influence of the precursor structural state on the final alloy properties processed by ARB.

Investigation of the Pore Morphology of the Hydroxyapatite-Based Bicomposites Processed by Two Step Sintering

\overline{Bo}

Recrystallization temperature influence upon texture evolution of a SPD processed Ti-Nb-Ta-Zr-O alloy

Bo¯ and

Evaluation of Developed Texture during Cold-Rolling Deformation of Ti-Nb-Ta-Zr Biocompatible Alloy

\overline{Md}

Structural Observation of Twinning Deformation Mechanism in a Ti-Ta-Nb Alloy

Md¯ electronic parameters have been calculated in order to establish, by plotting the alloy on