J.C.G. Esteves da Silva

Thiolated DAB dendrimers and CdSe quantum dots nanocomposites for Cd(II) or Pb(II) sensing

Four different generation of thiol-DAB dendrimers were synthesized, S-DAB-G(x) (x=1, 2, 3 and 5), and coupled with CdSe quantum dots, to obtain fluorescent nanocomposites as metal ions sensing. Cd(II) and Pb(II) showed the higher enhancement and quenching effects respectively towards the fluorescence of S-DAB-G(5)-CdSe nanocomposite. The fluorescence enhancement provoked by Cd(II) can be linearized using a Henderson-Hasselbalch type equation and the quenching provoked by Pb(II) can be linearized by a Stern-Volmer equation. The sensor responds to Cd(II) ion in the 0.05-0.7μM concentration range and to Pb(II) ion in the 0.01-0.15mM concentration range with a LOD of 0.06mM. The sensor has selectivity limitations but its dendrimer configuration has analytical advantages.

Fluorescent sensor for Cr(VI) based in functionalized silicon quantum dots with dendrimers

Highly luminescent nanoparticles based in Silicon quantum dots, coated by hydroxyl PAMAM dendrimer (PAMAM-OH) of 5th generation, were obtained by one step process by hydrothermal treatment of 3-Aminopropyl)triethoxysilane (APTES) in aqueous solution. Previous to the optimization of the synthesis procedure, different dendritic molecules of 5th generation were tested to obtain the most intense fluorescence signal. The influence of different parameters such ratio APTES/PAMAM-OH, pH and ionic strength on the fluorescence intensity was studied. The fluorescence spectra showed maximum excitation and emission wavelengths at 370 and 446 nm, respectively. The obtained silicon nanoparticles (SiQDs@PAMAM-OH) were characterized by TEM, DLS and XPS, and were found to detect selectively Cr(VI) in aqueous solutions at 2.7 μM level of detection, sensitivity of 0.2 μM with a RSD of 0.16% (n=10). To study the feasibility of the proposed system for Cr(VI) detection, it was tested in real electrochemical solution bath and a tanning effluent obtained from electrochemical industry and with two certified waters, demonstrating promising outcomes as nano-sensor.

Microwave-assisted synthesis of carbon dots and its potential as analysis of four heterocyclic aromatic amines

Fluorescent water soluble carbon nanoparticles, in short carbon dots (CDs), was synthesized from lactose by microwave assisted hydrochloric acid method. Characterized by TEM and DLS to obtain the morphology shape (average 10nm in size), with a higher negative surface charge supported by the composition was obtained by XPS spectroscopy. The maximum of the emission was centered at 450 nm with a lifetime of 2.1 ns. Without further functionalization of the CDs a nanosensor was obtained that responded exponentially to HAAs in the 0.35-0.45 mg L(-1) concentration range by fluorescence static quenching, demonstrated by the lifetime analysis of the CDs in presence of HAAs. Some amino compounds were selected as model for interferences to evaluate the selectivity of this method, showing a notorious added value, with recoveries around 98%. The accuracy of the method was in terms of RSD about 2.5%. The results suggest their promising applications in chemical sensing.

Luminescence-Based Optical Fiber Chemical Sensors

Abstract A scheme for the simultaneous determination of temperature and analyte concentration for application in luminescence-based chemical sensors is proposed. This scheme is applied to an optical oxygen sensor, which is based on the quenching of the fluorescence of a ruthenium complex. Temperature measurement is performed using the excitation radiation and an absorption long-pass filter. Preliminary results are presented that show the viability of an oxygen measurement that is independent of temperature and optical power level. The possibility of self-referenced temperature measurements with semiconductor nanoparticles is also investigated. In order to optimize the sensor design, several different optical fiber probe geometries for oxygen sensing are tested and compared, including different methods of coupling radiation into the optical fiber system. Polyvinyl alcohol (PVA) and polyacrylamide membranes are tested as supports for sensor immobilization in fiber-optical pH sensing devices in aqueous solution. Some results are presented that show the feasibility of using fiber-optical pH indicators for remote monitoring.

Fluorescent chemosensor for pyridine based on N-doped carbon dots

Fluorescent carbon dots (CDs) and its nitrogen doped (N-CDs) nanoparticles have been synthesized from lactose as precursor using a bottom-up hydrothermal methodology. The synthesized nanoparticles have been characterized by elemental analysis, FTIR, Raman, TEM, DLS, XPS, and steady-state and life-time fluorescence. The synthesized carbon nanoparticles, CDs and N-CDs, have a size at about 7.7±2.4 and 50±15nm, respectively, and quantum yields of 8% (CDs) and 11% (N-CDs). These techniques demonstrated the effectiveness of the synthesis procedure and the functionalization of the CDs surface with amine and amide groups in the presence of NH3 in aqueous media. The effect of excitation wavelength and pH on the luminescent properties was studied. Under the optimal conditions, the nitrogen doped nanoparticles can be used as pyridine sensor in aqueous media because they show an enhancement of its fluorescence with a good linear relationship. The analytical method is simple, reproducible and very sensitive for pyridine determination.

Thiolated DAB dendrimer/ZnSe nanoparticles for C-reactive protein recognition in human serum

A nanocomposite obtained by a thiol DAB-dendrimer (generation 5), coated with fluorescent ZnSe quantum dots, was successfully synthesized for the selective recognition of C-reactive protein. The procedure presented was carried out by a novel, cheap and non-toxic bottom up synthesis. The nanocomposite showed an excitation at 180 nm, with two emission bands at 411 and 465 nm, with a full-width at half-maximum of 336 nm. The Stokes shift was influenced by the presence of coating molecules and the intensity was dependent on pH due to the presence of a charge transfer process. The transmission electron microscopy images demonstrated that the spherical nanoparticles obtained displayed a regular shape of 30 nm size. The fluorescence intensity was markedly quenched by the presence of C-reactive protein, with a dynamic Stern-Volmer constant of 0.036 M(-1). The quenching profile shows that about 51% of the ZnSe QDs are located in the external layer of the thiol dendrimer accessible to the quencher. The precision of the method obtained as relative standard deviation was 3.76% (4 mg L(-1), n=3). This water soluble fluorescent nanocomposite showed a set of favorable properties to be used as a sensor for the C-reactive protein in serum samples, at concentrations of risk levels.

CdSe and ZnSe quantum dots capped with PEA for screening C-reactive protein in human serum

A fluorescence chemical sensor for C-reactive protein (CRP) was developed based on the selective interaction with CdSe and ZnSe quantum dots (QDs) coated with O-phosphorylethanolamine (PEA). Synthesis procedure and analytical parameters such as pH and ionic strength were studied. The decrease in the fluorescence emission intensity was explained due to the specific interaction of the QDs-PEA with CRP, and a correlation was observed between the quenching of the fluorescence and the concentration of CRP. The accuracy of the proposed method was 0.37% as RSD. The proposed method was applied to screen serum samples, and showed to be sensible at the C-reactive protein concentrations of risks levels.

Hybrid porous phosphate heterostructures as adsorbents of Hg(II) and Ni(II) from industrial sewage.

Porous phosphate heterostructures (PPH), functionalized with different ratios of aminopropyl and mercaptopropyl groups, labelled as N(x=5,25,50)-PPH and S(x=5,25,50)-PPH, respectively, were tested as adsorbents for Ni(II) and Hg(II) found in industrial sewage from electroplating processes and button battery recycling. X-ray diffraction was used to study the structures. The specific surface area of the pristine material (PPH) was 620 m(2)g(-1), whereas the specific surface areas of the modified mercaptopropyl (S(5)-PPH) and aminopropyl (N(5)-PPH) were 472 and 223 m(2)g(-1), respectively. The adsorption data were fitted to a Langmuir isotherm model. The S(5)-PPH material was saturated by 120 mmol Hg(II) per 100g of material, whereas for Ni(II) adsorption, N(25)-PPH material displayed the highest adsorption with a saturation value of 43.5 mmol per 100g. These results suggest that functionalized PPH materials may be promising toxic metal scavengers and that they may provide an alternative environmental technology.

Component analysis of fluorescence spectra of thiol DAB dendrimer/ZnSe-PEA nanoparticles

The fluorescence spectroscopy technique is an accurate method and has great utility in the interpretation of complex systems based on several emission bands. An interpretation of the system requires determination of the number, positions and intensities of the spectral components. In this work, the emission spectra of the synthesized ZnSe complex coated with O-phosphorylethanolamine (ZnSe-PEA), both with and without thiol DAB dendrimer generation 5 (S-DAB G5), were analyzed using a combination of asymmetric (log-normal) and symmetric (Gaussian) models. The method applied for the deconvolution of fluorescence spectra has proven to be very sensitive for observing the stability of the ZnSe-PEA complex after binding with S-DAB. The ZnSe-PEA emission spectrum contains two components. The positions of the emission maxima of these two components are not significantly affected by the presence of S-DAB G5 in the complex, which revealed the presence of a stable complex at a pH of 7. By applying the spectral deconvolution method, strong evidence was obtained that suggested that the ZnSe-PEA complex is stable after complexation with S-DAB G5.

Characterization of cellulose membranes modified with luminescent silicon quantum dots nanoparticles.

A highly hydrophilic planar membrane fabricated with regenerated cellulose (RC-4 membrane), a biocompatible polymer, was modified by inclusion of water-soluble silicon quantum dot nanoparticles (SiQDs). Both bare SiQDs and SiQDs coated with a PAMAM-OH dendrimer were employed in order to obtain luminescent and thermally stable membrane systems (RC-4/SiQDs and RC-4/SiQDs-PAMAM-OH membranes). Original and SiQDs-modified membranes were characterized by fluorescence spectroscopy (steady and confocal), derivative thermogravimetric analysis and impedance spectroscopy measurements. According to these results, both SiQDs-regenerated cellulose composite membranes present luminescent character as well as higher thermal resistance and conductivity than the original sample, although the dendrimer coverage of the SiQDs might partially shield such effects. Moreover, the permanence of SiQDs nanoparticles in the structure of the cellulosic support in aqueous environments and their effect on diffusive transport were determined by water uptake as well as by membrane potential measurements at different concentrations of a model electrolyte (KCl). These results demonstrate the possible use of these stable nano-engineered membranes, which are based on SiQDs nanoparticles, in electrochemical devices under flow conditions.