Jeremy E. Melanson

Switchable hydrophilicity solvents for lipid extraction from microalgae for biofuel production

A switchable hydrophilicity solvent (SHS) was studied for its effectiveness at extracting lipids from freeze-dried samples of Botryococcus braunii microalgae. The SHS N,N-dimethylcyclohexylamine extracted up to 22 wt.% crude lipid relative to the freeze-dried cell weight. The solvent was removed from the extract with water saturated with carbon dioxide at atmospheric pressure and recovered from the water upon de-carbonation of the mixture. Liquid chromatography-mass spectrometry (LC-MS) showed that the extracted lipids contained high concentrations of long chain tri-, di- and mono-acylglycerols, no phospholipids, and only 4-8% of residual solvent. Unlike extractions with conventional organic solvents, this new method requires neither distillation nor the use of volatile, flammable or chlorinated organic solvents.

Triacylglycerol profiling of microalgae strains for biofuel feedstock by liquid chromatography-high-resolution mass spectrometry.

AbstractBiofuels from photosynthetic microalgae are quickly gaining interest as a viable carbon-neutral energy source. Typically, characterization of algal feedstock involves breaking down triacylglycerols (TAG) and other intact lipids, followed by derivatization of the fatty acids to fatty acid methyl esters prior to analysis by gas chromatography (GC). However, knowledge of the intact lipid profile could offer significant advantages for discovery stage biofuel research such as the selection of an algal strain or the optimization of growth and extraction conditions. Herein, lipid extracts from microalgae were directly analyzed by ultra-high pressure liquid chromatography–mass spectrometry (UHPLC-MS) using a benchtop Orbitrap mass spectrometer. Phospholipids, glycolipids, and TAGs were analyzed in the same chromatographic run, using a combination of accurate mass and diagnostic fragment ions for identification. Using this approach, greater than 100 unique TAGs were identified over the six algal strains studied and TAG profiles were obtained to assess their potential for biofuel applications. Under the growth conditions employed, Botryococcus braunii and Scenedesmus obliquus yielded the most comprehensive TAG profile with a high abundance of TAGs containing oleic acid. FigureOptical microscope image of Botryococcus braunii and high resolution mass spectrum of triacylglycerol 28:2/18:1/18:1 (inset)

Suitability of Soxhlet Extraction to Quantify Microalgal Fatty Acids as Determined by Comparison with In Situ Transesterification

To assess Soxhlet extraction as a method for quantifying fatty acids (FA) of microalgae, crude lipid, FA content from Soxhlet extracts and FA content from in situ transesterification (ISTE) were compared. In most cases, gravimetric lipid content was considerably greater (up to sevenfold) than the FA content of the crude lipid extract. FA content from Soxhlet lipid extraction and ISTE were similar in 12/18 samples, whereas in 6/18 samples, total FA content from Soxhlet extraction was less than the ISTE procedure. Re-extraction of residual biomass from Soxhlet extraction with ISTE liberated a quantity of FA equivalent to this discrepancy. Employing acid hydrolysis before Soxhlet extraction yielded FA content roughly equivalent to ISTE, indicating that acidic conditions of ISTE are responsible for this observed greater recovery of FA. While crude lipid derived from Soxhlet extraction was not a useful proxy for FA content for the species tested, it is effective in most strains at extracting total saponifiable lipid. Lipid class analysis showed the source of FA was primarily polar lipids in most samples (12/18 lipid extracts contained <5% TAG), even in cases where total FA content was high (>15%). This investigation confirms the usefulness of ISTE, reveals limitations of gravimetric methods for projecting biodiesel potential of microalgae, and reinforces the need for intelligent screening using both FA and lipid class analysis.

Profiling phlorotannins in brown macroalgae by liquid chromatography-high resolution mass spectrometry.

INTRODUCTION Phlorotannins, phenolic compounds produced exclusively by Phaeophyceae (brown algae), have recently been associated with a wide variety of beneficial bioactivities. Several studies have measured the total phenolic content in extracts from various species, but little characterisation of individual phlorotannin components has been demonstrated. OBJECTIVE The purpose of this study was to develop a liquid chromatography-mass spectrometry (LC-MS) based method for rapid profiling of phlorotannins in brown algae. METHODOLOGY Phlorotannin-enriched extracts from five phaeophyceaen species were analysed by ultrahigh-pressure liquid chromatography (UHPLC) operating in hydrophilic interaction liquid chromatography (HILIC) mode combined with high resolution mass spectrometry (HRMS). The method was optimised using an extract of Fucus vesiculosus; separation was achieved in less than 15 min. The basic mobile phase enhanced negative-ion electrospray ionisation (ESI), and generated multiply charged ions that allowed detection of high molecular weight phlorotannins. RESULTS The phlorotannin profiles of Pelvetia canaliculata, Fucus spiralis, F. vesiculosus, Ascophyllum nodosum and Saccharina longicruris differed significantly. Fucus vesiculosus yielded a high abundance of low molecular weight (< 1200 Da) phlorotannins, while P. canaliculata exhibited a more evenly distributed profile, with moderate degrees of polymerisation ranging from 3 to 49. HRMS enabled the identification of phlorotannins with masses up to 6000 Da using a combination of accurate mass and ¹³C isotopic patterns. CONCLUSION The UHPLC-HRMS method described was successful in rapidly profiling phlorotannins in brown seaweeds based on their degree of polymerisation. HILIC was demonstrated to be an effective separation mode, particularly for low molecular weight phlorotannins.

Strategic identification of in vitro metabolites of 13‐desmethyl spirolide C using liquid chromatography/high‐resolution mass spectrometry

A strategy to identify metabolites of a marine biotoxin, 13-desmethyl spirolide C, has been developed using liquid chromatography coupled to high-resolution mass spectrometry (LC/HRMS). Metabolites were generated in vitro through incubation with human liver microsomes. A list of metabolites was established by selecting precursor ions of a common fragment ion characteristic of the spirolide toxin which was known to contain a cyclic imine ring. Accurate mass measurements were subsequently used to confirm the molecular formula of each biotransformation product. Using this approach, a total of nine phase I metabolites was successfully identified with deviations of mass accuracy less than 2 ppm. The biotransformations observed included hydroxylation, dihydroxylation, oxidation of a quaternary methyl group to hydroxymethyl or carboxylic acid groups, dehydrogenation and hydroxylation, as well as demethylation and dihydroxylation reactions. In a second step, tandem mass spectrometry (MS/MS) was performed to elucidate structures of the metabolites. Using the unique fragment ions in the spectra, the structures of the three major metabolites, 13,19-didesmethyl-19-carboxy spirolide C, 13,19-didesmethyl-19-hydroxymethyl spirolide C and 13-desmethyl-17-hydroxy spirolide C, were assigned. Levels of 13-desmethyl spirolide C and its metabolites were monitored at selected time points over a 32-h incubation period with human liver microsomes. It was determined that 13,19-didesmethyl-19-carboxy spirolide C became the predominant metabolite after 2 h of incubation. The stability plot of 13-desmethyl spirolide C showed first-order kinetics for its metabolism and the intrinsic clearance was calculated to be 41 μL/min/mg, suggesting first-pass metabolism may contribute to limiting oral toxicity of 13-desmethyl spirolide C.

Studying the Chemistry of Cationized Triacylglycerols Using Electrospray Ionization Mass Spectrometry and Density Functional Theory Computations

AbstractAnalysis of triacylglycerols (TAGs), found as complex mixtures in living organisms, is typically accomplished using liquid chromatography, often coupled to mass spectrometry. TAGs, weak bases not protonated using electrospray ionization, are usually ionized by adduct formation with a cation, including those present in the solvent (e.g., Na+). There are relatively few reports on the binding of TAGs with cations or on the mechanisms by which cationized TAGs fragment. This work examines binding efficiencies, determined by mass spectrometry and computations, for the complexation of TAGs to a range of cations (Na+, Li+, K+, Ag+, NH4+). While most cations bind to oxygen, Ag+ binding to unsaturation in the acid side chains is significant. The importance of dimer formation, [2TAG + M]+ was demonstrated using several different types of mass spectrometers. From breakdown curves, it became apparent that two or three acid side chains must be attached to glycerol for strong cationization. Possible mechanisms for fragmentation of lithiated TAGs were modeled by computations on tripropionylglycerol. Viable pathways were found for losses of neutral acids and lithium salts of acids from different positions on the glycerol moiety. Novel lactone structures were proposed for the loss of a neutral acid from one position of the glycerol moiety. These were studied further using triple-stage mass spectrometry (MS3). These lactones can account for all the major product ions in the MS3 spectra in both this work and the literature, which should allow for new insights into the challenging analytical methods needed for naturally occurring TAGs. Figureᅟ

Hydroxylation of Longiborneol by a Clm2-Encoded CYP450 Monooxygenase to Produce Culmorin in Fusarium graminearum.

A second structural gene required for culmorin biosynthesis in the plant pathogen Fusarium graminearum is described. Clm2 encodes a regio- and stereoselective cytochrome P450 monooxygenase for C-11 of longiborneol (1). Clm2 gene disruptants were grown in liquid culture and assessed for culmorin production via HPLC-evaporative light scattering detection. The analysis indicated a complete loss of culmorin (2) from the liquid culture of the ΔClm2 mutants. Culmorin production resumed in a ΔClm2 complementation experiment. A detailed analysis of the secondary metabolites extracted from the large-scale liquid culture of disruptant ΔClm2D20 revealed five new natural products: 3-hydroxylongiborneol (3), 5-hydroxylongiborneol (4), 12-hydroxylongiborneol (5), 15-hydroxylongiborneol (6), and 11-epi-acetylculmorin (7). The structures of the new compounds were elucidated by a combination of HRMS, 1D and 2D NMR, and X-ray crystallography.

Sulfated diesters of okadaic acid and DTX-1: Self-protective precursors of diarrhetic shellfish poisoning (DSP) toxins

Many toxic secondary metabolites used for defense are also toxic to the producing organism. One important way to circumvent toxicity is to store the toxin as an inactive precursor. Several sulfated diesters of the diarrhetic shellfish poisoning (DSP) toxin okadaic acid have been reported from cultures of various dinoflagellate species belonging to the genus Prorocentrum. It has been proposed that these sulfated diesters are a means of toxin storage within the dinoflagellate cell, and that a putative enzyme mediated two-step hydrolysis of sulfated diesters such as DTX-4 and DTX-5 initially leads to the formation of diol esters and ultimately to the release of free okadaic acid. However, only one diol ester and no sulfated diesters of DTX-1, a closely related DSP toxin, have been isolated leading some to speculate that this toxin is not stored as a sulfated diester and is processed by some other means. DSP components in organic extracts of two large scale Prorocentrum lima laboratory cultures have been investigated. In addition to the usual suite of okadaic acid esters, as well as the free acids okadaic acid and DTX-1, a group of corresponding diol- and sulfated diesters of both okadaic acid and DTX-1 have now been isolated and structurally characterized, confirming that both okadaic acid and DTX-1 are initially formed in the dinoflagellate cell as the non-toxic sulfated diesters.

Development of Certified Reference Materials for Diarrhetic Shellfish Poisoning Toxins, Part 1: Calibration Solutions.

Okadaic acid (OA) and its analogs dinophysistoxins-1 (DTX1) and -2 (DTX2) are lipophilic polyethers produced by marine dinoflagellates. These toxins accumulate in shellfish and cause diarrhetic shellfish poisoning (DSP) in humans. Regulatory testing of shellfish is essential to safeguard public health and for international trade. Certified reference materials (CRMs) play a key role in analytical monitoring programs. This paper presents an overview of the interdisciplinary work that went into the planning, production, and certification of calibration-solution CRMs for OA, DTX1, and DTX2. OA and DTX1 were isolated from large-scale algal cultures and DTX2 from naturally contaminated mussels. Toxins were isolated by a combination of extraction and chromatographic steps with processes adapted to suit the source and concentration of each toxin. New 19-epi-DSP toxin analogs were identified as minor impurities. Once OA, DTX1, and DTX2 were established to be of suitable purity, solutions were prepared and dispensed into flame-sealed glass ampoules. Certification measurements were carried out using quantitative NMR spectroscopy and LC-tandem MS. Traceability of measurements was established through certified external standards of established purity. Uncertainties were assigned following standards and guidelines from the International Organization for Standardization, with components from the measurement, stability, and homogeneity studies being propagated into final combined uncertainties.

Characterization of Phlorotannins from Brown Algae by LC-HRMS

Phlorotannins are a class of polyphenols found in brown seaweeds that have significant potential for use as therapeutics, owing to their wide range of bioactivities. Molecular characterization of phlorotannin-enriched extracts is challenging due to the extreme sample complexity and the wide range of molecular weights observed. Herein, we describe a method for characterizing phlorotannins employing ultrahigh-pressure liquid chromatography (UHPLC) operating in hydrophilic interaction liquid chromatography (HILIC) mode combined with high-resolution mass spectrometry (HRMS).