Jiangting Wang

Numerical Investigation of Influence of the Martensite Volume Fraction on DP Steels Fracture Behavior on the Basis of Digital Material Representation Model

Development of the methodology for creating reliable digital material representation (DMR) models of dual-phase steels and investigation of influence of the martensite volume fraction on fracture behavior under tensile load are the main goals of the paper. First, an approach based on image processing algorithms for creating a DMR is described. Then, obtained digital microstructures are used as input for the numerical model of deformation, which takes into account mechanisms of ductile fracture. Ferrite and martensite material model parameters are evaluated on the basis of micropillar compression tests. Finally, the model is used to investigate the impact of the martensite volume fraction on the DP steel behavior under plastic deformation. Results of calculations are presented and discussed in the paper.

Complex precipitation phenomena in strip cast steels with high sulfur and copper contents

A series of three steel alloys with increasing Cu and S concentrations has been prepared by simulated direct strip casting. It was found that the rapid solidification that occurs during direct strip casting results in the formation of a high number density of fine MnS precipitates, while Cu was retained in solid solution above equilibrium concentration. Upon ageing the MnS particles were found to coarsen and increase in volume fraction, indicating that some S was retained in solid solution in the as-cast condition. Ageing also resulted in the precipitation of Cu-rich precipitates. A new method to determine precipitate composition from small-angle neutron scattering is presented. This methodology, in conjunction with atom-probe tomography, has been used to show that the composition of the Cu-rich precipitates depends on the alloys bulk Cu content.

Mechanical Behavior of Nano-crystalline Metallic Thin Films and Multilayers Under Microcompression

Microcompression tests were performed to determine the mechanical behavior of nano-crystalline Cu/Fe and Fe/Cu multilayers, as well as monolithic Cu and Fe thin films. The results show that the micropillars of pure Cu thin film bulge out under large compressive strains without failure, while those of pure Fe thin film crack near the top at low compressive strains followed by shear failure. For Cu/Fe and Fe/Cu multilayers, the Cu layers accommodate the majority of plastic deformation, and the geometry constraints imposed by Fe layers exaggerates the bulging in the Cu layers. However, the existence of ductile Cu layers does not improve the overall ductility of Cu/Fe and Fe/Cu multilayers. Cracking in the Fe layers directly lead to the failure of the multilayer micropillars, although the Cu layers have very good ductility. The results imply that suppressing the cracking of brittle layers is more important than simply adding ductile layers for improving the overall ductility of metallic multilayers.

Residual Thermal Stresses in a Fe3Al/Al2O3 Gradient Coating System

To combine the merits of both metals and ceramics into one material, many researchers have been studying the deposition of alumina coating using plasma spray on metal substrates. However, as the coatings are deposited at a high temperature, residual thermal stresses develop due to the mismatch of thermal expansion coefficients of the coating and substrate and these are responsible for the initiation and expansion of cracks, which induce the possible failure of the entire material. In this paper, the residual thermal-structural analysis of a Fe3Al/Al2O3 gradient coating on carbon steel substrate is performed using finite element modelling to simulate the plasma spray. The residual thermal stress fields are obtained and analyzed on the basis of temperature fields in gradient coatings during fabrication. The distribution of residual thermal stresses including radial, axial and shear stresses shows stress concentration at the interface between the coatings and substrate. The mismatch between steel substrate and composite coating is still the dominant factor for the residual stresses.