Johan Knutsson

Direct Imaging of Atomic Scale Structure and Electronic Properties of GaAs Wurtzite and Zinc Blende Nanowire Surfaces.

Using scanning tunneling microscopy and spectroscopy we study the atomic scale geometry and electronic structure of GaAs nanowires exhibiting controlled axial stacking of wurtzite (Wz) and zinc blende (Zb) crystal segments. We find that the nonpolar low-index surfaces {110}, {101[overline]0}, and {112[overline]0} are unreconstructed, unpinned, and without states in the band gap region. Direct comparison between Wz and Zb GaAs reveal a type-II band alignment and a Wz GaAs band gap of 1.52 eV.

Electronic and Structural Differences between Wurtzite and Zinc Blende InAs Nanowire Surfaces: Experiment and Theory

We determine the detailed differences in geometry and band structure between wurtzite (Wz) and zinc blende (Zb) InAs nanowire (NW) surfaces using scanning tunneling microscopy/spectroscopy and photoemission electron microscopy. By establishing unreconstructed and defect-free surface facets for both Wz and Zb, we can reliably measure differences between valence and conduction band edges, the local vacuum levels, and geometric relaxations to the few-millielectronvolt and few-picometer levels, respectively. Surface and bulk density functional theory calculations agree well with the experimental findings and are used to interpret the results, allowing us to obtain information on both surface and bulk electronic structure. We can thus exclude several previously proposed explanations for the observed differences in conductivity of Wz-Zb NW devices. Instead, fundamental structural differences at the atomic scale and nanoscale that we observed between NW surface facets can explain the device behavior.

Electrical and Surface Properties of InAs/InSb Nanowires Cleaned by Atomic Hydrogen

We present a study of InAs/InSb heterostructured nanowires by X-ray photoemission spectroscopy (XPS), scanning tunneling microscopy (STM), and in-vacuum electrical measurements. Starting with pristine nanowires covered only by the native oxide formed through exposure to ambient air, we investigate the effect of atomic hydrogen cleaning on the surface chemistry and electrical performance. We find that clean and unreconstructed nanowire surfaces can be obtained simultaneously for both InSb and InAs by heating to 380 ± 20 °C under an H2 pressure 2 × 10(-6) mbar. Through electrical measurement of individual nanowires, we observe an increase in conductivity of 2 orders of magnitude by atomic hydrogen cleaning, which we relate through theoretical simulation to the contact-nanowire junction and nanowire surface Fermi level pinning. Our study demonstrates the significant potential of atomic hydrogen cleaning regarding device fabrication when high quality contacts or complete control of the surface structure is required. As hydrogen cleaning has recently been shown to work for many different types of III-V nanowires, our findings should be applicable far beyond the present materials system.

Atomic Scale Surface Structure and Morphology of InAs Nanowire Crystal Superlattices: The Effect of Epitaxial Overgrowth

While shell growth engineering to the atomic scale is important for tailoring semiconductor nanowires with superior properties, a precise knowledge of the surface structure and morphology at different stages of this type of overgrowth has been lacking. We present a systematic scanning tunneling microscopy (STM) study of homoepitaxial shell growth of twinned superlattices in zinc blende InAs nanowires that transforms {111}A/B-type facets to the nonpolar {110}-type. STM imaging along the nanowires provides information on different stages of the shell growth revealing distinct differences in growth dynamics of the crystal facets and surface structures not found in the bulk. While growth of a new surface layer is initiated simultaneously (at the twin plane interface) on the {111}A and {111}B nanofacets, the step flow growth proceeds much faster on {111}A compared to {111}B leading to significant differences in roughness. Further, we observe that the atomic scale structures on the {111}B facet is different from its bulk counterpart and that shell growth on this facet occurs via steps perpendicular to the ⟨112⟩B-type directions.

Self-cleaning and surface chemical reactions during hafnium dioxide atomic layer deposition on indium arsenide

Atomic layer deposition (ALD) enables the ultrathin high-quality oxide layers that are central to all modern metal-oxide-semiconductor circuits. Crucial to achieving superior device performance are the chemical reactions during the first deposition cycle, which could ultimately result in atomic-scale perfection of the semiconductor–oxide interface. Here, we directly observe the chemical reactions at the surface during the first cycle of hafnium dioxide deposition on indium arsenide under realistic synthesis conditions using photoelectron spectroscopy. We find that the widely used ligand exchange model of the ALD process for the removal of native oxide on the semiconductor and the simultaneous formation of the first hafnium dioxide layer must be significantly revised. Our study provides substantial evidence that the efficiency of the self-cleaning process and the quality of the resulting semiconductor–oxide interface can be controlled by the molecular adsorption process of the ALD precursors, rather than the subsequent oxide formation.Atomic layer deposition of high-quality thin oxide layers is crucial for many modern semiconductor electronic devices. Here, the authors explore the surface chemistry during the initial deposition and observe a previously unknown two-step process, with promise for an improved self-cleaning effect.

Imaging Atomic Scale Dynamics on III–V Nanowire Surfaces During Electrical Operation

As semiconductor electronics keep shrinking, functionality depends on individual atomic scale surface and interface features that may change as voltages are applied. In this work we demonstrate a novel device platform that allows scanning tunneling microscopy (STM) imaging with atomic scale resolution across a device simultaneously with full electrical operation. The platform presents a significant step forward as it allows STM to be performed everywhere on the device surface and high temperature processing in reactive gases of the complete device. We demonstrate the new method through proof of principle measurements on both InAs and GaAs nanowire devices with variable biases up to 4 V. On InAs nanowires we observe a surprising removal of atomic defects and smoothing of the surface morphology under applied bias, in contrast to the expected increase in defects and electromigration-related failure. As we use only standard fabrication and scanning instrumentation our concept is widely applicable and opens up the possibility of fundamental investigations of device surface reliability as well as new electronic functionality based on restructuring during operation.

Electronic Structure Changes due to Crystal Phase Switching at the Atomic Scale Limit

The perfect switching between crystal phases with different electronic structure in III-V nanowires allows for the design of superstructures with quantum wells only a single atomic layer wide. However, it has only been indirectly inferred how the electronic structure will vary down to the smallest possible crystal segments. We use low-temperature scanning tunneling microscopy and spectroscopy to directly probe the electronic structure of Zinc blende (Zb) segments in Wurtzite (Wz) InAs nanowires with atomic-scale precision. We find that the major features in the band structure change abruptly down to a single atomic layer level. Distinct Zb electronic structure signatures are observed on both the conduction and valence band sides for the smallest possible Zb segment: a single InAs bilayer. We find evidence of confined states in the region of both single and double bilayer Zb segments indicative of the formation of crystal segment quantum wells due to the smaller band gap of Zb as compared to Wz. In contrast to the internal electronic structure of the nanowire, surface states located in the band gap were found to be only weakly influenced by the presence of the smallest Zb segments. Our findings directly demonstrate the feasibility of crystal phase switching for the ultimate limit of atomistic band structure engineering of quantum confined structures. Further, it indicates that band gap values obtained for the bulk are reasonable to use even for the smallest crystal segments. However, we also find that the suppression of surface and interface states could be necessary in the use of this effect for engineering of future electronic devices.

Band bending at the heterointerface of GaAs/InAs core/shell nanowires monitored by synchrotron X-ray photoelectron spectroscopy

Unique electronic properties of semiconductor heterostructured nanowires make them useful for future nano-electronic devices. Here, we present a study of the band bending effect at the heterointerface of GaAs/InAs core/shell nanowires by means of synchrotron based X-ray photoelectron spectroscopy. Different Ga, In, and As core-levels of the nanowire constituents have been monitored prior to and after cleaning from native oxides. The cleaning process mainly affected the As-oxides and was accompanied by an energy shift of the core-level spectra towards lower binding energy, suggesting that the As-oxides turn the nanowire surfaces to n-type. After cleaning, both As and Ga core-levels revealed an energy shift of about −0.3 eV for core/shell compared to core reference nanowires. With respect to depth dependence and in agreement with calculated strain distribution and electron quantum confinement, the observed energy shift is interpreted by band bending of core-levels at the heterointerface between the GaAs nan...

Surface morphology of Au-free grown nanowires after native oxide removal

Using scanning tunneling microscopy, we evaluate the surface structure and morphology down to the atomic scale for micrometers along Au-free grown InAs nanowires (NWs) free from native oxide. We find that removal of the native oxide (which covers the NWs upon exposure to the ambient air) using atomic hydrogen does not alter the underlying step structure. Imaging with sub-nanometer resolution along the NWs, we find an extremely low tapering (diameter change along the NW) of 1.7 ± 0.5 Åμm(-1). A surface morphology with monolayer high islands, whose shape was influenced by stacking faults, was found to cover the NWs and was attributed to the decomposed native oxide. The appearance of point defects in the form of As-vacancies at the surface is analyzed and we set limits to the amount of carbon impurities in the NWs.