Jon Powell

Sustainable Practices for Landfill Design and Operation

The management of municipal solid waste (MSW) in many countries throughout the world has changed significantly over the past 50 years, with a shift from uncontrolled dumping or burning to complex systems that integrate multiple processes to recover materials or energy and provide containment to reduce environmental impacts. A discussion of past landfilling practices and the evolution to modern landfilling is provided. Opportunities for designing and operating landfills in a more sustainable manner are discussed.

Case study of landfill leachate recirculation using small-diameter vertical wells

A case study of landfill liquids addition using small diameter (5 cm) vertical wells is reported. More than 25,000 m(3) of leachate was added via 134 vertical wells installed 3 m, 12 m, and 18 m deep over five years in a landfill in Florida, US. Liquids addition performance (flow rate per unit screen length per unit liquid head) ranged from 5.6×10(-8) to 3.6×10(-6) m(3) s(-1) per m screen length per m liquid head. The estimated radial hydraulic conductivity ranged from 3.5×10(-6) to 4.2×10(-4) m s(-1). The extent of lateral moisture movement ranged from 8 to 10 m based on the responses of moisture sensors installed around vertical well clusters, and surface seeps were found to limit the achievable liquids addition rates, despite the use of concrete collars under a pressurized liquids addition scenario. The average moisture content before (51 samples) and after (272 samples) the recirculation experiments were 23% (wet weight basis) and 45% (wet weight basis), respectively, and biochemical methane potential measurements of excavated waste indicated significant (p<0.025) decomposition.

Modeling of H2S migration through landfill cover materials

The emission of H2S from landfills in the United States is an emergent problem because measured concentrations within the waste mass and in ambient air have been observed at potentially unsafe levels for on-site workers and at levels that can cause a nuisance and potentially deleterious health impacts to surrounding communities. Though recent research has provided data on H2S concentrations that may be observed at landfills, facility operators and landfill engineers have limited predictive tools to anticipate and plan for potentially harmful H2S emissions. A one-dimensional gas migration model was developed to assist engineers and practitioners better evaluate and predict potential emission levels of H2S based on four factors: concentration of H2S below the landfill surface (C0), advection velocity (v), H2S effective diffusion coefficient (D), and H2S adsorption coefficient of landfill cover soil (μ). Model simulations indicated that H2S migration into the atmosphere can be mitigated by reducing H2S diffusion and advection or using alternative cover soils with a high H2S adsorption coefficient. Laboratory column experiments were conducted to investigate the effects of the four parameters on H2S migration in cover soils and to calculate the adsorption coefficient of different cover materials. The model was validated by comparing results with laboratory column experiments. Based on the results, the laboratory column provides an effective way to estimate the H2S adsorption coefficient, which can then be incorporated into the developed model to predict the depth of cover soil required to reduce emitted H2S concentrations below a desired level.

Evaluation of air sparging and vadose zone aeration for remediation of iron and manganese-impacted groundwater at a closed municipal landfill.

High concentrations of iron (Fe(II)) and manganese (Mn(II)) reductively dissolved from soil minerals have been detected in groundwater monitoring wells near many municipal solid waste landfills. Air sparging and vadose zone aeration (VZA) were evaluated as remedial approaches at a closed, unlined municipal solid waste landfill in Florida, USA. The goal of aeration was to oxidize Fe and Mn to their respective immobile forms. VZA and shallow air sparging using a partially submerged well screen were employed with limited success (Phase 1); decreases in dissolved iron were observed in three of nine monitoring wells during shallow air sparging and in two of 17 wells at VZA locations. During Phase 2, where deeper air sparging was employed, dissolved iron levels decreased in a significantly greater number of monitoring wells surrounding injection points, however no radial pattern was observed. Additionally, in wells affected positively by air sparging (mean total iron (FeTOT) <4.2mg/L, after commencement of air sparging), rising manganese concentrations were observed, indicating that the redox potential of the groundwater moved from an iron-reducing to a manganese-reducing environment. The mean FeTOT concentration observed in affected monitoring wells throughout the study was 1.40 mg/L compared to a background of 15.38 mg/L, while the mean Mn concentration was 0.60 mg/L compared to a background level of 0.27 mg/L. Reference wells located beyond the influence of air sparging areas showed little variation in FeTOT and Mn, indicating the observed effects were the result of air injection activities at study locations and not a natural phenomenon. Air sparging was found effective in intercepting plumes of dissolved Fe surrounding municipal landfills, but the effect on dissolved Mn was contrary to the desired outcome of decreased Mn groundwater concentrations.

Seepage Control Strategies at Bioreactor Landfills

AbstractThe occurrence of leachate seepage at side slopes of municipal solid waste landfills represents a major design and operational concern at bioreactor landfills where leachate is recirculated into the waste mass to enhance degradation of organic materials. Full-scale bioreactor landfills typically add liquids to the waste under pressure to optimize moisture distribution. When liquids are added at a high pressure or at a flow rate higher than the absorption capacity of the waste mass, there is a possibility of seeps. Two general approaches to controlling landfill leachate seepage are described: a less aggressive strategy where liquid volumes are limited to avoid seeps and a more aggressive strategy where seeps are more likely to occur but with design and operation considerations in place to mitigate seepage. Liquids addition into waste using buried horizontal trenches was modeled to determine moisture distribution under a variety of conditions most likely to lead to leachate seepage at bioreactor lan...

Calcium carbonate-based permeable reactive barriers for iron and manganese groundwater remediation at landfills

High concentrations of iron (Fe(II)) and manganese (Mn(II)) reductively dissolved from soil minerals have been detected in groundwater monitoring wells near many municipal solid waste landfills. Two in situ permeable reactive barriers (PRBs), comprised of limestone and crushed concrete, were installed downgradient of a closed, unlined landfill in Florida, USA, to remediate groundwater containing high concentrations of these metals. Influent groundwater to the PRBs contained mean Fe and Mn concentrations of approximately 30mg/L and 1.62mg/L, respectively. PRBs were constructed in the shallow aquifer (maximum depth 4.6m below land surface) and groundwater was sampled from a network of nearby monitoring wells to evaluate barrier performance in removing these metals. PRBs significantly (p<0.05) removed dissolved Fe and Mn from influent groundwater; Fe was removed from influent water at average rates of 91% and 95% (by mass) for the limestone and crushed concrete PRBs, respectively, during the first year of the study. The performance of the PRBs declined after 3years of operation, with Fe removal efficiency decreasing to 64% and 61% for limestone and concrete PRBs, respectively. A comparison of water quality in shallow and deep monitoring wells showed a more dramatic performance reduction in the deeper section of the concrete PRB, which was attributed to an influx of sediment into the barrier and settling of particulates from the upper portions of the PRBs. Although removal of Fe and Mn from redox impacts was achieved with the PRBs, the short time frame of effectiveness relative to the duration of a full-scale remediation effort may limit the applicability of these systems at some landfills because of the construction costs required.

Waste Informatics: Establishing Characteristics of Contemporary U.S. Landfill Quantities and Practices

Waste generation is expected to increase in most countries for many decades with landfill disposal still the dominant solid waste management method1-3. Yet, operational characteristics of landfills are often poorly understood with comparative statistics substantially lacking. Here, we call for a more formal waste informatics to organize and standardize waste management knowledge at multiple spatial scales through analysis of recently reported data from 1232 U.S. landfills and other high resolution data sets. We create the first known estimate of available U.S. municipal waste stocks (8.5 billion tonnes) and go on to resolve these stocks at the county level, reflecting prospective urban mining opportunities. Our analysis of disposal rates and landfill capacities reveals that more than half of U.S. states have more than 25 years of life remaining. We also estimate the gross energy potential of landfill gas in the U.S. (338 billion MJ/yr) by examining 922 operational methane collection systems and demonstrate that the greatest energy recovery opportunities lie at landfills with existing collection systems and energy conversion infrastructure. Finally, we found that the number of landfills reaching the federally defined 30-year postclosure care period will more than triple in the coming two decades, with 264 sites expected by the year 2044, highlighting the need to develop and standardize metrics carefully to define and standardize when it is appropriate to end or scale back long-term landfill monitoring.

Does Disposing of Construction and Demolition Debris in Unlined Landfills Impact Groundwater Quality? Evidence from 91 Landfill Sites in Florida

More than 1,500 construction and demolition debris (CDD) landfills operate in the United States (U.S.), and U.S. federal regulations do not require containment features such as low-permeability liners and leachate collection systems for these facilities. Here we evaluate groundwater quality from samples collected in groundwater monitoring networks at 91 unlined, permitted CDD landfills in Florida, U.S. A total of 460,504 groundwater sample results were analyzed, with a median of 10 years of quarterly or semiannual monitoring data per site including more than 400 different chemical constituents. Downgradient concentrations of total dissolved solids, sulfate, chloride, iron, ammonia-nitrogen, and aluminum were greater than upgradient concentrations (p < 0.05). At downgradient wells where sulfate concentrations were greater than 150 mg/L (approximately 10% of the maximum dissolved sulfate concentration in water, which suggests the presence of leachate from the landfill), iron and arsenic were detected in 91% and 43% of samples, with median concentrations of 1,900 μg/L and 11 μg/L, respectively. These results show that although health-based standards can be exceeded at unlined CDD landfills, the magnitude of detected chemical concentrations is generally small and reflective of leached minerals from components (wood, concrete, and gypsum drywall) that comprise the bulk of discarded CDD by mass.

Landfill Air Addition

Although less well-developed compared to anaerobic sustainable landfilling technologies, the addition of air as an extensive or just a portion of sustainable landfilling operations provides a series of distinct potential benefits compared to anaerobic systems. The fundamental system configuration and design approaches for aerobic systems are provided, along with operation, monitoring, and control techniques. Given the unique nature and relatively limited experience with full-scale aerobic systems (compared to anaerobic), a special series of case studies from Asia, Europe, and North America are provided to provide examples of how aerobic technologies can be incorporated into sustainable landfilling operations.

Development and Application of a Framework to Examine the Occurrence of Hazardous Components in Discarded Construction and Demolition Debris: Case Study of Asbestos-Containing Material and Lead-Based Paint

AbstractRegulations that dictate the management of asbestos-containing materials (ACM) and lead-based paint (LBP) debris in the United States require these materials to be managed in a specific manner at the job site to reduce potentially hazardous exposure to site workers, and the disposal of the materials is regulated through notification and special handling requirements. However, management of ACM and LBP from residential projects are afforded some exemptions in U.S. regulations; thus, some quantity of these materials may be delivered to a disposal facility, thus representing a potential exposure concern for landfill workers because ACM and LBP cannot be detected through visual inspection. A novel characterization framework was developed to quantify the occurrence of ACM and LBP in discarded construction and demolition (C&D) debris. A total of 266 loads of debris and 307 samples of potential ACM were collected from 10 landfills in Georgia with a total of four detections of asbestos (frequency of 1.3%)...