Jr-Tai Chen

Dispersive Effects in Microwave AlGaN/AlN/GaN HEMTs With Carbon-Doped Buffer

Aluminium gallium nitride (AlGaN)/GaN high-electron mobility transistor performance is to a large extent affected by the buffer design, which, in this paper, is varied using different levels of carbon incorporation. Three epitaxial structures have been fabricated: 1) two with uniform carbon doping profile but different carbon concentration and 2) one with a stepped doping profile. The epitaxial structures have been grown on 4H-SiC using hot-wall metal-organic chemical vapor deposition with residual carbon doping. The leakage currents in OFF-state at 10 V drain voltage were in the same order of magnitude (10-4 A/mm) for the high-doped and stepped-doped buffer. The high-doped material had a current collapse (CC) of 78.8% compared with 16.1% for the stepped-doped material under dynamic I-V conditions. The low-doped material had low CC (5.2%) but poor buffer isolation. Trap characterization revealed that the high-doped material had two trap levels at 0.15 and 0.59 eV, and the low-doped material had one trap level at 0.59 eV.

Room-Temperature mobility above 2200 cm2/V.s of two-dimensional electron gas in a sharp-interface AlGaN/GaN heterostructure

A high mobility of 2250 cm2/V·s of a two-dimensional electron gas (2DEG) in a metalorganic chemical vapor deposition-grown AlGaN/GaN heterostructure was demonstrated. The mobility enhancement was a ...

Metalorganic chemical vapor deposition growth of high-mobility AlGaN/AlN/GaN heterostructures on GaN templates and native GaN substrates

Severe surface decomposition of semi-insulating (SI) GaN templates occurred in high-temperature H2 atmosphere prior to epitaxial growth in a metalorganic chemical vapor deposition system. A two-step heating process with a surface stabilization technique was developed to preserve the GaN template surface. Utilizing the optimized heating process, a high two-dimensional electron gas mobility ∼2000 cm2/V·s was obtained in a thin AlGaN/AlN/GaN heterostructure with an only 100-nm-thick GaN spacer layer homoepitaxially grown on the GaN template. This technique was also demonstrated viable for native GaN substrates to stabilize the surface facilitating two-dimensional growth of GaN layers. Very high residual silicon and oxygen concentrations were found up to ∼1 × 1020 cm−3 at the interface between the GaN epilayer and the native GaN substrate. Capacitance-voltage measurements confirmed that the residual carbon doping controlled by growth conditions of the GaN epilayer can be used to successfully compensate the do...

A GaN–SiC hybrid material for high-frequency and power electronics

We demonstrate that 3.5% in-plane lattice mismatch between GaN (0001) epitaxial layers and SiC (0001) substrates can be accommodated without triggering extended defects over large areas using a grain-boundary-free AlN nucleation layer (NL). Defect formation in the initial epitaxial growth phase is thus significantly alleviated, confirmed by various characterization techniques. As a result, a high-quality 0.2-μm thin GaN layer can be grown on the AlN NL and directly serve as a channel layer in power devices, like high electron mobility transistors (HEMTs). The channel electrons exhibit a state-of-the-art mobility of >2000 cm2/V-s, in the AlGaN/GaN heterostructures without a conventional thick C- or Fe-doped buffer layer. The highly scaled transistor processed on the heterostructure with a nearly perfect GaN–SiC interface shows excellent DC and microwave performances. A peak RF power density of 5.8 W/mm was obtained at VDSQ = 40 V and a fundamental frequency of 30 GHz. Moreover, an unpassivated 0.2-μm GaN/AlN/SiC stack shows lateral and vertical breakdowns at 1.5 kV. Perfecting the GaN–SiC interface enables a GaN–SiC hybrid material that combines the high-electron-velocity thin GaN with the high-breakdown bulk SiC, which promises further advances in a wide spectrum of high-frequency and power electronics.We demonstrate that 3.5% in-plane lattice mismatch between GaN (0001) epitaxial layers and SiC (0001) substrates can be accommodated without triggering extended defects over large areas using a grain-boundary-free AlN nucleation layer (NL). Defect formation in the initial epitaxial growth phase is thus significantly alleviated, confirmed by various characterization techniques. As a result, a high-quality 0.2-μm thin GaN layer can be grown on the AlN NL and directly serve as a channel layer in power devices, like high electron mobility transistors (HEMTs). The channel electrons exhibit a state-of-the-art mobility of >2000 cm2/V-s, in the AlGaN/GaN heterostructures without a conventional thick C- or Fe-doped buffer layer. The highly scaled transistor processed on the heterostructure with a nearly perfect GaN–SiC interface shows excellent DC and microwave performances. A peak RF power density of 5.8 W/mm was obtained at VDSQ = 40 V and a fundamental frequency of 30 GHz. Moreover, an unpassivated 0.2-μm GaN/A...