Ju-Heon Kim

The effect of Al on the hydrogen sorption mechanism of LiBH4

We demonstrate the synthesis of LiBH(4) from LiH and AlB(2) without the use of additional additives or catalysts at 450 degrees C under hydrogen pressure of 13 bar to the following equation: 2LiH + AlB(2) + 3H(2)<--> 2LiBH(4) + Al. By applying AlB(2) the kinetics of the formation of LiBH(4) is strongly enhanced compared to the formation from elemental boron. The formation of LiBH(4) during absorption requires the dissociation of AlB(2), i.e. a coupled reaction. The observed low absorption-pressure of 13 bar, measured during hydrogen cycling, is explained by a low stability of AlB(2), in good agreement with theoretical values. Thus starting from AlB(2) instead of B has a rather low impact on the thermodynamics, and the effect of AlB(2) on the formation of LiBH(4) is of kinetic nature facilitating the absorption by overcoming the chemical inertness of B. For desorption, the decomposition of LiBH(4) is not indispensably coupled to the immediate formation of AlB(2). LiBH(4) may decompose first into LiH and elemental B and during a slower second step AlB(2) is formed. In this case, no destabilization will be observed for desorption. However, due to similar stabilities of LiBH(4) and LiBH(4)/Al a definite answer on the desorption mechanism cannot be given and neither a coupled nor decoupled desorption can be excluded. At low hydrogen pressures the reaction of LiH and Al gives LiAl under release of hydrogen. The formation of LiAl increases the total hydrogen storage capacity, since it also contributes to the LiBH(4) formation in the absorption process.

Microstructure Evolution and Defect Formation in Cu Through-Silicon Vias (TSVs) During Thermal Annealing

The microstructural evolution of Cu through-silicon vias (TSVs) during thermal annealing was investigated by analyzing the Cu microstructure and the effects of twin boundaries and stress in the TSV. The Cu TSV had two regions with different grain sizes between the center and the edge with a random Cu texture before and after annealing. The grain size of large grains was almost unchanged after annealing, and the abrupt grain growth was restricted by the twin boundaries due to their structural stability. However, microvoids and cracks in the Cu TSV were observed after annealing. These defects were formed by the stress concentration among Cu grains. After defects were formed, the stress level of the TSV was decreased after annealing.

Systemic Immunity Requires SnRK2.8-Mediated Nuclear Import of NPR1 in Arabidopsis

Phosphorylation of NPR by the protein kinase SnRK2.8 allows nuclear import of NPR1, an essential step in systemic acquired resistance. In plants, necrotic lesions occur at the site of pathogen infection through the hypersensitive response, which is followed by induction of systemic acquired resistance (SAR) in distal tissues. Salicylic acid (SA) induces SAR by activating NONEXPRESSER OF PATHOGENESIS-RELATED GENES1 (NPR1) through an oligomer-to-monomer reaction. However, SA biosynthesis is elevated only slightly in distal tissues during SAR, implying that SA-mediated induction of SAR requires additional factors. Here, we demonstrated that SA-independent systemic signals induce a gene encoding SNF1-RELATED PROTEIN KINASE 2.8 (SnRK2.8), which phosphorylates NPR1 during SAR. The SnRK2.8-mediated phosphorylation of NPR1 is necessary for its nuclear import. Notably, although SnRK2.8 transcription and SnRK2.8 activation are independent of SA signaling, the SnRK2.8-mediated induction of SAR requires SA. Together with the SA-mediated monomerization of NPR1, these observations indicate that SA signals and SnRK2.8-mediated phosphorylation coordinately function to activate NPR1 via a dual-step process in developing systemic immunity in Arabidopsis thaliana.

Grain-Size Effects on the High-Temperature Oxidation of Modified 304 Austenitic Stainless Steel

The high-temperature oxidation behavior of modified 304 austenitic stainless steels in a water vapor atmosphere was investigated. Samples were prepared by various thermo mechanical treatments to result in different grain sizes in the range 8–30xa0μm. Similar Σ3 grain boundary fraction was achieved to eliminate any grain-boundary characteristics effect. Samples were oxidized in an air furnace at 700xa0°C with 20xa0% water vapor atmosphere. On the fine-grained sample, a uniform Cr2O3 layer was formed, which increased the overall oxidation resistance. Whereas on the coarse-grained sample, an additional Fe2O3 layer formed on the Cr-rich oxide layer, which resulted in a relatively high oxidation rate. In the fine-grained sample, grain boundaries act as rapid diffusion paths for Cr and provided enough Cr to form Cr2O3 oxide on the entire sample surface.

Core shell structure for solid gas synthesis of LiBD4

The formation of LiBD(4) by the reaction of LiD in a diborane/hydrogen atmosphere was analysed by in situ neutron diffraction and subsequent microstructural and chemical analysis of the final product. The neutron diffraction shows that nucleation of LiBD(4) already starts at temperatures of 100 degrees C, i.e. in its low temperature phase (orthorhombic structure). However, even at higher temperatures the reaction is incomplete. We observe a yield of approximately 50% at a temperature of 185 degrees C. A core shell structure of the grains, in which LiBD(4) forms a passivation layer on the surface of the LiD grains, was found in the subsequent microstructural (electron microscopy) and chemical (electron energy loss spectrometry) analysis.

Effect of Heat Treatment on the Thermoelectric Properties of Bismuth–Antimony–Telluride Prepared by Mechanical Deformation and Mechanical Alloying

In this work, p-type 20%Bi2Te3–80%Sb2Te3 bulk thermoelectric (TE) materials were prepared by mechanical deformation (MD) of pre-melted ingot and by mechanical alloying (MA) of elemental Bi, Sb, and Te granules followed by cold-pressing. The dependence on annealing time of changes of microstructure and TE properties of the prepared samples, including Seebeck coefficient, electrical resistivity, thermal conductivity, and figure-of-merit, was investigated. For both samples, saturation of the Seebeck coefficient and electrical resistivity were observed after annealing for 1xa0h at 380°C. It is suggested that energy stored in samples prepared by both MA and MD facilitated their recrystallization within short annealing times. The 20%Bi2Te3–80%Sb2Te3 sample prepared by MA followed by heat treatment had higher a Seebeck coefficient and electrical resistivity than specimens fabricated by MD. Maximum figures-of-merit of 3.00xa0×xa010−3/K and 2.85xa0×xa010−3/K were achieved for samples prepared by MA and MD, respectively.

HOS1 Facilitates the Phytochrome B-Mediated Inhibition of PIF4 Function during Hypocotyl Growth in Arabidopsis

Upon exposure to light, developing seedlings undergo photomorphogenesis, as illustrated by inhibition of hypocotyl elongation, cotyledon opening, and leaf greening. During hypocotyl photomorphogenesis, light signals are sensed by multiple photoreceptors, among which the red/far-red light-sensing phytochromes have been extensively studied. However, it is not fully understood how the phytochromes modulate hypocotyl growth. Here, we demonstrated that HIGH EXPRESSION OF OSMOTICALLY RESPONSIVE GENES 1xa0(HOS1), which is known to either act as E3 ubiquitin ligase or affect chromatin organization, inhibits the transcriptional activation activity of PHYTOCHROME INTERACTING FACTOR 4 (PIF4), a key transcription factor that promotes hypocotyl growth. Consistent with the negative regulatory role of HOS1 in hypocotyl growth, HOS1-defective mutants exhibited elongated hypocotyls in the light. Notably, phyB induces HOS1 activity in inhibiting PIF4 function. Taken together, these observations provide a molecular basis for the phyB-mediated suppression of hypocotyl growth in Arabidopsis.

Shoot phytochrome B modulates reactive oxygen species homeostasis in roots via abscisic acid signaling in Arabidopsis

Underground roots normally reside in darkness. However, they are often exposed to ambient light that penetrates through cracks in the soil layers which can occur due to wind, heavy rain or temperature extremes. In response to light exposure, roots produce reactive oxygen species (ROS) which promote root growth. It is known that ROS-induced growth promotion facilitates rapid escape of the roots from non-natural light. Meanwhile, long-term exposure of the roots to light elicits a ROS burst, which causes oxidative damage to cellular components, necessitating that cellular levels of ROS should be tightly regulated in the roots. Here we demonstrate that the red/far-red light photoreceptor phytochrome B (phyB) stimulates the biosynthesis of abscisic acid (ABA) in the shoots, and notably the shoot-derived ABA signals induce a peroxidase-mediated ROS detoxification reaction in the roots. Accordingly, while ROS accumulate in the roots of the phyb mutant that exhibits reduced primary root growth in the light, such an accumulation of ROS did not occur in the dark-grown phyb roots that exhibited normal growth. These observations indicate that mobile shoot-to-root ABA signaling links shoot phyB-mediated light perception with root ROS homeostasis to help roots adapt to unfavorable light exposure. We propose that ABA-mediated shoot-to-root phyB signaling contributes to the synchronization of shoot and root growth for optimal propagation and performance in plants.

Towards room temperature, direct, solvent free synthesis of tetraborohydrides

Due to their high hydrogen content, tetraborohydrides are discussed as potential synthetic energy carriers. On the example of lithium borohydride LiBH4, we discuss current approaches of direct, solvent free synthesis based on gas solid reactions of the elements or binary hydrides and/or borides with gaseous H2 or B2H6. The direct synthesis from the elements requires high temperature and high pressure (700?C, 150bar D2). Using LiB or AlB2 as boron source reduces the required temperature by more than 300 K. Reactive milling of LiD with B2H6 leads to the formation of LiBD4 already at room temperature. The reactive milling technique can also be applied to synthesize other borohydrides from their respective metal hydrides.

HOS1 acts as a key modulator of hypocotyl photomorphogenesis

ABSTRACT Plants recognize light as an environmental signal to determine the proper timing of growth and development. In Arabidopsis seedlings, hypocotyl growth is promoted in the dark but suppressed in the light. It is known that the red/far-red light-sensing receptor phytochrome B (phyB) suppresses the function of PHYTOCHROME INTERACTING FACTOR (PIF) transcription factors, which act as photomorphogenic repressors. However, molecular mechanisms underlying the phyB-mediated inhibition of PIF functioning remain unclear. We recently demonstrated that HIGH EXPRESSION OF OSMOTICALLY RESPONSIVE GENES 1 (HOS1) facilitates the phyB-mediated suppression of PIF4 during the light period to achieve hypocotyl photomorphogenesis. HOS1 inhibits the transcriptional activation activity of PIF4 by forming protein complexes. Notably, phyB-mediated light signals induce HOS1 activity, thus promoting hypocotyl photomorphogenesis. While HOS1 is known to act as an E3 ubiquitin ligase or a chromatin remodeling factor, our data illustrate a novel role of HOS1: it acts as a component of phyB-mediated light signaling in hypocotyl photomorphogenesis.