Jun-Pil Jee

Enhanced oral bioavailability of dexibuprofen by a novel solid self-emulsifying drug delivery system (SEDDS).

The main objective of this study was to prepare a solid form of lipid-based self-emulsifying drug delivery system (SEDDS) by spray drying liquid SEDDS with an inert solid carrier Aerosil 200 to improve the oral bioavailability of poorly water-soluble drug dexibuprofen. The liquid SEDDS was a system that consisted of dexibuprofen, Labrasol, Capryol 90 and Labrafil M 1944 CS. The particle size analysis revealed no difference in the z-average particle diameter of the reconstituted emulsion between liquid and solid SEDDS. The solid SEDDS was characterized by SEM, DSC and XRD studies. In vivo results of solid SEDDS and dexibuprofen powder in rats at the dose of 10mg/kg showed that the initial plasma concentrations of drug in solid SEDDS were significantly higher than those of dexibuprofen powder (P<0.05). The solid SEDDS gave significantly higher AUC and Cmax than did dexibuprofen powder (P<0.05). In particular, the AUC of solid SEDDS was about twofold higher than that of dexibuprofen powder. Our results suggested that this solid SEDDS could be used as an effective oral solid dosage form to improve the bioavailability of poorly water-soluble drug dexibuprofen.

Enhanced oral bioavailability of Coenzyme Q10 by self-emulsifying drug delivery systems.

To enhance the solubility and bioavailability of poorly water-soluble Coenzyme Q(10) (CoQ(10)), self-emulsifying drug delivery system (SEDDS) composed of oil, surfactant and cosurfactant for oral administration of CoQ(10) was formulated. The solubility of CoQ(10) was determined in various oils and surfactants. The formulations were prepared using two oils (Labrafil M 1944 and Labrafil M 2125), surfactant (Labrasol) and cosurfactant (Lauroglycol FCC and Capryol 90). In all the formulations, the level of CoQ(10) was fixed at 6% (w/v) of the vehicle. These formulations were characterized by solubility of the drug in the vehicle, particle size of the dispersed emulsion, zeta potential and drug release profile. Ternary phase diagrams were used to evaluate the emulsification domain. The self-emulsification time following introduction into an aqueous medium under gentle agitation was evaluated. The optimized SEDDS formulation consist of 65% (v/v) Labrasol, 25% (v/v) Labrafil M 1944 CS and 10% (v/v) Capryol 90 of each excipient showed minimum mean droplet size (about 240 nm) and optimal drug release profile in water. The pharmacokinetic study in rats for the optimized formulation was performed and compared to powder formulation. SEDDS have significantly increased the C(max) and area under the curve (AUC) of CoQ(10) compared to powder (P<0.05). Thus, this self-micro emulsifying drug delivery system should be an effective oral dosage form for improving oral bioavailability of lipophilic drug, CoQ(10).

Development of chitosan-based ondansetron buccal delivery system for the treatment of emesis

Background: For the buccal drug delivery, chitosan (CS) can be used to improve drug absorption and reduce application frequency and drug amount. The aim of this study is to develop and evaluate mucoadhesive ondansetron buccal films for the treatment of emesis using CS as a mucoadhesive polymer. Methods: The film prepared by solvent casting method was comprised of ondansetron (approximately 65 μg)-loaded mucoadhesive gels containing 1, 2 or 3% CS and impermeable backing layer. Rheological property of the gels, physiochemical properties of the films (weight, thickness, drug content, swelling ratio, adhesion time and mucoadhesive force) and in vitro ondansetron release profile from the films were determined to evaluate the formulation. The films containing 3% CS (diameter: 0.5 cm; thickness: 170 μm) was selected as the novel formulation, and were used for the in vivo study. Comparative pharmacokinetic studies of ondansetron with this film and oral solution were performed at the same dose in hamsters. Results: The mean values of Tmax and Cmax of the film and oral solution were similar. However, the half-life, mean residence time and AUC0–24 h of the film were about 1.7, 1.4 and 2.0-fold higher than those of the oral solution, respectively. The film showed enhanced bioavailability and prolonged efficacy compared to the oral solution. Conclusions: The mucoadhesive ondansetron buccal film may be a potential alternative to the marketed oral formulation, parenterals and solid suppositories with better patient compliance and higher bioavailability for the treatment of emesis.

Cefdinir Solid Dispersion Composed of Hydrophilic Polymers with Enhanced Solubility, Dissolution, and Bioavailability in Rats

The aim of this work was to develop cefdinir solid dispersions (CSDs) prepared using hydrophilic polymers with enhanced dissolution/solubility and in vivo oral bioavailability. CSDs were prepared with hydrophilic polymers such as hydroxypropyl-methylcellulose (HPMC; CSD1), carboxymethylcellulose-Na (CMC-Na; CSD2), polyvinyl pyrrolidone K30 (PVP K30; CSD3) at the weight ratio of 1:1 (drug:polymer) using a spray-drying method. The prepared CSDs were characterized by aqueous solubility, differential scanning calorimetry (DSC), powder X-ray diffraction (p-XRD), scanning electron microscopy (SEM), aqueous viscosity, and dissolution test in various media. The oral bioavailability of CSDs was also evaluated in rats and compared with cefdinir powder suspension. The cefdinir in CSDs was amorphous form, as confirmed in the DSC and p-XRD measurements. The developed CSDs commonly resulted in about 9.0-fold higher solubility of cefdinir and a significantly improved dissolution profile in water and at pH 1.2, compared with cefdinir crystalline powder. Importantly, the in vivo oral absorption (represented as AUCinf) was markedly increased by 4.30-, 6.77- and 3.01-fold for CSD1, CSD2, and CSD3, respectively, compared with cefdinir suspension in rats. The CSD2 prepared with CMC-Na would provide a promising vehicle to enhance dissolution and bioavailability of cefdinir in vivo.

Simplified analysis of lipoprotein lipase activity: Evaluation of lipasemic activity of low molecular weight heparin in rats

A simple procedure for measuring lipoprotein lipase activity was developed by using newly formulated substrate with turbidimetry method. The activity of lipoprotein lipase was expressed as Yvalue (%) that was calculated by measuring UV absorbance (600 nm) at two time points (30 sec and 15 min). Lipid emulsions as the substrate and other factors affecting the lipolytic activity of lipase were studied. The optimal conditions for an in vitro experiment were found to be with LIPOMCT® as lipid substrate at 37°C in tris-HCl buffer (pH 7.4) in the presence of BSA. To evaluate an in vivo applicability, low molecular weight heparin (LMWH)-containing drug, Sulodexide ®, was administered to the rats. The serum from LMWH-administered rats was incubated in an optimized analytical condition without BSA. As expected, increasing the amount of LMWH administered led to higher lipase activity. The newly developed method was successfully applied to an in vivo model suggesting the potential to be applicable for the pharmacodynamic studies of commercially available products of LPL analogues in human subjects, and for the diagnosis of acute pancreatitis in the clinical laboratory.

Development and Evaluation of a Reconstitutable Dry Suspension to Improve the Dissolution and Oral Absorption of Poorly Water-Soluble Celecoxib

This study aims at developing and evaluating reconstitutable dry suspension (RDS) improved for dissolution rate, oral absorption, and convenience of use of poorly water-soluble celecoxib (CXB). Micro-sized CXB particle was used to manufacture nanosuspension by using bead milling and then RDS was made by spray-drying the nanosuspension with effective resuspension agent, dextrin. The redispersibility, morphology, particle size, crystallinity, stability, dissolution, and pharmacokinetic profile of the RDS were evaluated. RDS was effectively reconstituted into nanoparticles in 775.8 ± 11.6 nm. It was confirmed that CXB particles are reduced into needle-shape ones in size after the bead-milling process, and the description of CXB was the same in the reconstituted suspension. Through the CXB crystallinity study using differential scanning calorimetry (DSC) and XRD analysis, it was identified that CXB has the CXB active pharmaceutical ingredient (API)’s original crystallinity after the bead milling and spray-drying process. In vitro dissolution of RDS was higher than that of CXB powder (93% versus 28% dissolution at 30 min). Furthermore, RDS formulation resulted in 5.7 and 6.3-fold higher area under the curve (AUC∞) and peak concentration (Cmax) of CXB compared to after oral administration of CXB powder in rats. Collectively, our results suggest that the RDS may be a potential oral dosage formulation for CXB to improve its bioavailability and patient compliance.

Isolation and identification of steroidogenic peptides from calf spleen

Since women with climacteric syndrome have significantly lower serum levels of estradiol and other related hormones, hormone replacement therapies (HRT) such as estrogen are needed to lessen symptoms. However, HRT can often cause severe adverse effects that include many cancers and stroke. Therefore, new and novel approaches to relieve climacteric syndrome still need to be developed. The aim of this study was to identify biologically active peptides from calf spleen that are responsible for stimulating biosynthesis of steroid hormone and to explore the potential of isolated peptides as therapeutic agents for menopausal syndrome. The reverse phase HPLC system was used to isolate active compounds from calf spleen extract, a cell culture system was used to screen the activity of stimulating hormone secretion, and Matrix-Assisted Laser Desorption/Ionization (MALDI) mass spectrometry was used for molecular weight determination. In the present study, two calf steroidogenic peptides, CSP-1 (MW; 4.655 kDa) and CSP-2 (MW; 8.331 kDa), were isolated and identified from calf spleen and may be putative climacteric syndrome therapeutic agents.

Reverse-phase liquid chromatography with electrospray ionization/mass spectrometry for the quantification of pseudoephedrine in human plasma and application to a bioequivalence study

A sensitive and selective reverse-phase liquid chromatography electrospray ionization mass spectrometry (LC-ESI-MS) method was developed and validated to quantify pseudoephedrine (CAS 90-82-4) in human plasma. Phenacetin was used as the internal standard (I.S.). Sample preparation was performed with a deproteinization step using acetonitrile. Pseudoephedrine and I.S. were successfully separated using gradient elution with 0.5% trifluoroacetic acid (TFA) in water and 0.5% TFA in methanol at a flow-rate of 0.2 mL/min. Detection was performed on a single quadrupole mass spectrometer by a selected ion monitoring (SIM) mode via electrospray ionization (ESI) source. The ESI source was set at positive ionization mode. The ion signals of m/z 166.3 and 180.2 were measured for the protonated molecular ions of pseudoephedrine and I.S., respectively. The lower limit of quantification (LLOQ) of pseudoephedrine in human plasma was 10 ng/mL and good linearity was observed in the range of concentrations 10-500 ng/mL (R2 = 1). The intra-day accuracy of the drug containing plasma samples was more than 97.60% with a precision of 3.99-11.82%. The inter-day accuracy was 99.36% or more, with a precision of 7.65-18.42%. By using this analytical method, the bioequivalence study of the pseudoephedrine preparation was performed and evaluated by statistical analysis of the log transformed mean ratios of pharmacokinetic parameters. All the results fulfilled the standard criteria of bioequivalence, being within the 80-125% range which is required by the Korea FDA, US FDA, and EMEA to conclude bioequivalence. Consequently, the developed reverse-phase LC-ESI-MS method was successfully applied to bioequivalence studies of pseudoephedrine in healthy male volunteers.