Koji Kawabata

Heterogeneous structure and in vitro degradation behavior of wet-chemically derived nanocrystalline silicon-containing hydroxyapatite particles.

Nanocrystalline hydroxyapatite (HAp) and silicon-containing hydroxyapatite (SiHAp) particles were synthesized by a wet-chemical procedure and their heterogeneous structures involving a disordered phase were analyzed in detail by X-ray diffractometry (XRD), transmission electron microscopy (TEM), Fourier transform infrared (FTIR) spectroscopy and solid-state magic-angle spinning (MAS) nuclear magnetic resonance (NMR) spectroscopy. The effects of heterogeneous structure on in vitro biodegradability and the biologically active Ca(II)- and Si(IV)-releasing property of SiHAp particles were discussed. The (29)Si NMR analysis revealed that the Si(IV) was incorporated in the HAp lattice in the form of Q(0)(SiO(4)(4-)orHSiO(4)(3-)) species, accompanied by the formation of condensed silicate units outside the HAp lattice structure, where the fraction and amount of Q(0) species in the HAp lattice depends on the Si content. The (31)P and (1)H NMR results agreed well with the XRD, TEM and FTIR results. NMR quantitative analysis results were explained by using a core-shell model assuming a simplified hexagonal shape of HAp covered with a disordered layer, where Si(IV) in Q(0) was incorporated in the HAp lattice and a disordered phase consisted of hydrated calcium phosphates involving polymeric silicate species and carbonate anions. With the increase in the Si content in the HAp lattice, the in vitro degradation rate of the SiHAps increased, while their crystallite size stayed nearly unchanged. The biologically active Ca(II)- and Si(IV)-releasing ability of the SiHAps was remarkably enhanced at the initial stage of reactions by an increase in the amount of Si(IV) incorporated in the HAp lattice but also by an increase of the amount of polymeric silicate species incorporated in the disordered phase.

Properties and catalytic activity of NOx reduction of alumina-titania catalysts prepared by sol-gel method

The alumina-titania catalysts were prepared from various alumina and titania sources by sol-gel method, which were metal alkoxide and metal alkoxide modified with organic groups. Specific surface area, pore size distribution, solid acidity and catalytic activity of NO reduction for the alumina-titania catalysts depended on the alumina and titania sources. The alumina-titania catalyst prepared from metal alkoxide for alumina source and metal alkoxide modified with organic groups for titania source exhibited higher activity of NO reduction than the other alumina-titania catalysts. Catalytic activity of NO reduction for the alumina-titania catalysts depended on specific surface area and solid acidity. It was suggested that solid acidity of the alumina-titania catalysts depended on the coordination structure of Al atoms and the homogeneity of alumina and titania components.

Preparation of ZrO2-Al2O3 powder by thermal decomposition of gels produced from an aluminium chelate compound and zirconium butoxide

Organic precursors containing Al and Zr atoms were synthesized from an aluminium chelate compound and zirconium n-butoxide. A ZrO2-Al2O3 composite powder was prepared by the thermal decomposition of these precursors. An amorphous phase exists to higher temperatures for this ZrO2-Al2O3 powder than for a comparable powder prepared from aluminium sec-butoxide and zirconium n-butoxide. In addition the tetragonal ZrO2 phase was stabler in this ZrO2-Al2O3 powder than in a comparison powder. The ZrO2 grains were 50–500 nm in diameter and were homogeneously dispersed in the Al2O3 matrix after heating at 1400 °C.