Laurent C.-Labonnote

Aerosol Remote Sensing over Clouds Using A-Train Observations

Abstract The detection of aerosol above clouds is critical for the estimate of both the aerosol and cloud radiative impacts. In this study, the authors present a new method to retrieve the aerosol properties over clouds that uses the multiangle polarization measurements of the Polarization and Directionality of Earth Reflectances (POLDER)–Polarization and Anisotropy of Reflectances for Atmospheric Sciences Coupled with Observations from a Lidar (PARASOL) instrument. The method is illustrated and applied to a case study exploiting the coincident observations from other passive and active sensors of the NASA A-Train satellite constellation. The case study is relative to an elevated biomass burning aerosol layer that originates from southern Africa and is then transported over low-level clouds extending over the Atlantic Ocean. It is shown that the comparison between the cloud-top heights retrieved with the different passive techniques developed for the A-Train sensors can be used to detect the presence of a...

Polarized light scattering by inhomogeneous hexagonal monocrystals: Validation with ADEOS‐POLDER measurements

Various in situ measurements of the light-scattering diagram in ice clouds were performed with a new nephelometer during several airborne campaigns. These measurements were favorably compared with a theoretical scattering model called Inhomogeneous Hexagonal Monocrystal (IHM) model. This model consists in computing the scattering of light by an ensemble of randomly oriented hexagonal ice crystals containing spherical impurities of soot and air bubbles. It is achieved by using a combination of ray tracing, Mie theory, and Monte Carlo techniques and enables to retrieve the six independent elements of the scattering matrix. This good agreement between nephelometer measurements and IHM model provides an opportunity to use this model in order to analyze ADEOS-POLDER total and polarized reflectance measurements over ice clouds. POLDER uses an original concept to observe ice cloud properties, enabling to measure reflectances and polarized reflectances, for a given scene, under several (up to 14) viewing directions. A first analysis of ice cloud spherical albedoes over the terrestrial globe for November 10, 1996, and April 23, 1997, shows a rather good agreement between measurements and modeling. Moreover, polarized reflectances are also calculated and show a satisfactory agreement with measurements.

Modeling of light scattering in cirrus clouds with inhomogeneous hexagonal monocrystals. Comparison with in-situ and ADEOS-POLDER measurements

An Inhhomogeneous Hexagonal Monocrystal (IHM) model is used to simulate light scattering by randomly oriented hexagonal ice crystals containing air bubbles. This model based on a combination of ray-tracing, Mie theory and Monte-Carlo techniques, allows to retrieve the scattering phase function. In-situ measurements of the light scattering diagram in natural cirrus clouds with an airborne nephelometer have been performed. The results given by the IHM model have been favorably adjusted with these measurements. This agreement provides an opportunity to use this model in order to analyze ADEOS-POLDER reflectance measurements over cirrus clouds. POLDER uses an original concept to measure, for a given scene, total and polarized reflectances under several viewing directions. A first analysis of cirrus cloud spherical albedoes for the 10th November 1996 shows a rather good agreement between measurements and calculations.

Sensitivity of retrieved POLDER directional cloud optical thickness to various ice particle models

The ”directional” values of cloud optical thickness (or cloud spherical albedo) retrieved from ADEOS-POLDER data constitute a strong constraint on the microphysical model used in the retrieval algorithm. In this paper, we focus on ice clouds. We quantify the departure of the directional values of spherical albedo from their averaged value. By so doing, we can assess the suitability of different ice particle scattering models (i.e., spheres, fractal polycrystal, inhomogeneous hexagonal monocrystal, or a synthesized phase function). The liquid water droplet and the ice fractal polycrystal models appear to be inappropriate since they induce a notable dependence of the ice cloud spherical albedo on scattering angle. On the contrary, much better agreement is achieved by using a synthesized phase function or an inhomegeneous hexagonal monocrystal model. Using these models, the retrieved ice cloud optical thickness is then found to be 40% smaller than using the droplet model.

Comparison of PARASOL Observations with Polarized Reflectances Simulated Using Different Ice Habit Mixtures

AbstractInsufficient knowledge of the habit distribution and the degree of surface roughness of ice crystals within ice clouds is a source of uncertainty in the forward light scattering and radiative transfer simulations of ice clouds used in downstream applications. The Moderate Resolution Imaging Spectroradiometer (MODIS) collection-5 ice microphysical model presumes a mixture of various ice crystal shapes with smooth facets, except for the compact aggregate of columns for which a severely rough condition is assumed. When compared with Polarization and Anisotropy of Reflectances for Atmospheric Sciences coupled with Observations from a Lidar (PARASOL) polarized reflection data, simulations of polarized reflectance using smooth particles show a poor fit to the measurements, whereas very rough-faceted particles provide an improved fit to the polarized reflectance. In this study a new microphysical model based on a mixture of nine different ice crystal habits with severely roughened facets is developed. Si...

Frequency and causes of failed MODIS cloud property retrievals for liquid phase clouds over global oceans

Abstract Moderate Resolution Imaging Spectroradiometer (MODIS) retrieves cloud droplet effective radius (r e) and optical thickness (τ) by projecting observed cloud reflectances onto a precomputed look‐up table (LUT). When observations fall outside of the LUT, the retrieval is considered “failed” because no combination of τ and r e within the LUT can explain the observed cloud reflectances. In this study, the frequency and potential causes of failed MODIS retrievals for marine liquid phase (MLP) clouds are analyzed based on 1 year of Aqua MODIS Collection 6 products and collocated CALIOP and CloudSat observations. The retrieval based on the 0.86 µm and 2.1 µm MODIS channel combination has an overall failure rate of about 16% (10% for the 0.86 µm and 3.7 µm combination). The failure rates are lower over stratocumulus regimes and higher over the broken trade wind cumulus regimes. The leading type of failure is the “r e too large” failure accounting for 60%–85% of all failed retrievals. The rest is mostly due to the “r e too small” or τ retrieval failures. Enhanced retrieval failure rates are found when MLP cloud pixels are partially cloudy or have high subpixel inhomogeneity, are located at special Sun‐satellite viewing geometries such as sunglint, large viewing or solar zenith angles, or cloudbow and glory angles, or are subject to cloud masking, cloud overlapping, and/or cloud phase retrieval issues. The majority (more than 84%) of failed retrievals along the CALIPSO track can be attributed to at least one or more of these potential reasons. The collocated CloudSat radar reflectivity observations reveal that the remaining failed retrievals are often precipitating. It remains an open question whether the extremely large r e values observed in these clouds are the consequence of true cloud microphysics or still due to artifacts not included in this study.

Modeling total and polarized reflectances of ice clouds: evaluation by means of POLDER and ATSR-2 measurements

Four ice-crystal models are tested by use of ice-cloud reflectances derived from Along Track Scanning Radiometer-2 (ATSR-2) and Polarization and Directionality of Earths Reflectances (POLDER) radiance measurements. The analysis is based on dual-view ATSR-2 total reflectances of tropical cirrus and POLDER global-scale total and polarized reflectances of ice clouds at as many as 14 viewing directions. Adequate simulations of ATSR-2 total reflectances at 0.865 microm are obtained with model clouds consisting of moderately distorted imperfect hexagonal monocrystals (IMPs). The optically thickest clouds (tau > approximately 16) in the selected case tend to be better simulated by use of pure hexagonal monocrystals (PHMs). POLDER total reflectances at 0.670 microm are best simulated with columnar or platelike IMPs or columnar inhomogeneous hexagonal monocrystals (IHMs). Less-favorable simulations are obtained for platelike IHMs and polycrystals (POLYs). Inadequate simulations of POLDER total and polarized reflectances are obtained for model clouds consisting of PHMs. Better simulations of the POLDER polarized reflectances at 0.865 microm are obtained with IMPs, IHMs, or POLYs, although POLYs produce polarized reflectances that are systematically lower than most of the measurements. The best simulations of the polarized reflectance for the ice-crystal models assumed in this study are obtained for model clouds consisting of columnar IMPs or IHMs.

Review of capabilities of multi-angle and polarization cloud measurements from POLDER

Abstract Polarization and directionality of the Earth’s reflectances (POLDER) is a multispectral imaging radiometer–polarimeter with a wide field-of-view, a moderate spatial resolution, and a multi-angle viewing capability. It functioned nominally aboard ADEOS1 from November 1996 to June 1997. When the satellite passes over a target, POLDER allows to observe it under up to 14 different viewing directions and in several narrow spectral bands of the visible and near-infrared spectrum (443–910 nm). This new type of multi-angle instruments offers new opportunity for deriving cloud parameters at global scale. The aim of this short overview paper is to point out the main contributions of such an instrument for cloud study through its original instrumental capabilities (multidirectionality, multipolarization, and multispectrality). This is mainly illustrated by using ADEOS 1-POLDER derived cloud parameters which are operationally processed by CNES and are available since the beginning of 1999.

IPRT polarized radiative transfer model intercomparison project – Phase A

Abstract The polarization state of electromagnetic radiation scattered by atmospheric particles such as aerosols, cloud droplets, or ice crystals contains much more information about the optical and microphysical properties than the total intensity alone. For this reason an increasing number of polarimetric observations are performed from space, from the ground and from aircraft. Polarized radiative transfer models are required to interpret and analyse these measurements and to develop retrieval algorithms exploiting polarimetric observations. In the last years a large number of new codes have been developed, mostly for specific applications. Benchmark results are available for specific cases, but not for more sophisticated scenarios including polarized surface reflection and multi-layer atmospheres. The International Polarized Radiative Transfer (IPRT) working group of the International Radiation Commission (IRC) has initiated a model intercomparison project in order to fill this gap. This paper presents the results of the first phase A of the IPRT project which includes ten test cases, from simple setups with only one layer and Rayleigh scattering to rather sophisticated setups with a cloud embedded in a standard atmosphere above an ocean surface. All scenarios in the first phase A of the intercomparison project are for a one-dimensional plane–parallel model geometry. The commonly established benchmark results are available at the IPRT website ( http://www.meteo.physik.uni-muenchen.de/iprt ).

In Situ Observation of Cirrus Scattering Phase Functions with 22° and 46° Halos: Cloud Field Study on 19 February 1998

Abstract Observations of halos and related phenomena due to ice crystals are commonly reported from ground observations and presented in the literature. Nevertheless, ice crystal characteristics have only been poorly documented from in situ measurements performed in halo-producing cirrus with simultaneous observations of optical phenomena. Using the Polar Nephelometer, a new instrument for in situ measuring of the scattering phase function of cloud droplets and ice particles, 22° and 46° halo features have been evidenced during a cirrus uncinus cloud case study between −30°C and −38°C. Simultaneous microphysical measurements were made with a 2D-C probe manufactured by Particle Measuring Systems Inc. (PMS). The results show that ice crystal properties derived from 2D-C measurements do not present substantial differences when comparing cirrus cloud samples with and without halos. Consequently, the cloud scattering properties appear to be dominated by small ice particles (smaller than about 100 μm), which ar...