Leslie John Ray Foster

Sutureless nerve repair with laser-activated chitosan adhesive : a pilot in vivo study

OBJECTIVE The anastomosis of peripheral nerves is a demanding procedure that has potential complications due to foreign body reactions elicited by sutures. In this study, the sutureless in vivo anastomosis of rat tibial nerves was successfully performed, using for the first time a chitosan-based laser-activated adhesive. The nerve thermal damage caused by the laser irradiation was quantitatively assessed. MATERIALS AND METHODS A novel adhesive composed of chitosan, indocyanine green, acetic acid, and water, was fabricated in thin sheets. Its adhesive strength was tested in vitro by bonding strips (surface area approximately 20 mm2, thickness approximately 20 microm) onto rat sciatic nerves and sheep intestine by laser activation with low fluence ( approximately 50 J/cm2), using a fiber-coupled diode laser (n = 13). The tensile strength of the adhesive/tissue bonds was measured after tissue repair. The chitosan adhesive was then used to perform sutureless anastomosis of tibial nerves in vivo (n = 6). Adhesive strips were also bonded in vivo onto intact rat sciatic nerves (n = 6) in order to quantitatively assess, by counting myelinated axons, the thermal damage induced by the laser. RESULTS The adhesive bonded well to tissue with a tensile strength of 12.5 +/- 2.6 KPa (mean +/- SD; n = 13). The in vivo anastomosed nerves were in continuity 3 d after surgery. Axon counting showed the number and morphology of myelinated axons were normal proximally ( approximately 96%) compared with intact nerves (100%). Axon demyelination was observed at the operation site ( approximately 49%) and distally ( approximately 27%), and was attributed to laser-induced thermal damage. CONCLUSIONS Nerve anastomosis, performed by the laser-adhesive procedure, was successful 3 d postoperatively. Proximal myelinated axons were not significantly damaged by the low laser fluence.

Chitosan as a Biomaterial: Influence of Degree of Deacetylation on Its Physiochemical, Material and Biological Properties

Chitosan is a biomaterial with a range of current and potential biomedical applications. Manipulation of chitosan degree of deacetylation (DDA) to achieve specific properties appears feasible, but studies investigating its influence on properties are often contradictory. With a view to the potential of chitosan in the regeneration of nerve tissue, the influence of DDA on the growth and health of olfactory ensheathing cells (OECs) was investigated. There was a linear increase in OEC proliferation as the DDA increased from 72 to 85%. This correlated with linear increases in average surface roughness (0.62 to 0.78 μm) and crystallinity (4.3 to 10.1%) of the chitosan films. Mitochondrial activity and membrane integrity of OECs was significantly different for OECs cultivated on chitosan with DDAs below 75%, while those on films with DDAs up to 85% were similar to cells in asynchronous growth. Apoptotic indices and cell cycle analysis also suggested that chitosan films with DDAs below 75% were cytocompatible but induced cellular stress, while OECs grown on films fabricated from chitosan with DDAs above 75% showed no significant differences compared to those in asynchronous growth. Tensile strength and elongation to break varied with DDA from 32.3 to 45.3 MPa and 3.6 to 7.1% respectively. DDA had no significant influence on abiotic and biotic degradation profiles of the chitosan films which showed approximately 8 and 20% weight loss respectively. Finally, perceived patterns in property changes are subject to change based on potential variations in DDA analysis. NMR examination of the chitosan samples here revealed significant differences depending upon which peaks were selected for integration; 6 to 13% in DDA values within individual samples. Furthermore, differences between DDA values determined here and those reported by the commercial suppliers were significant and this may also be a source of concern when selecting commercial chitosans for biomaterial research.

Towards Scarless Wound Healing: A Comparison of Protein Expression between Human, Adult and Foetal Fibroblasts

Proteins from human adult and foetal fibroblast cell lines were compared, focusing on those involved in wound healing. Proteins were separated through two-dimensional gel electrophoresis (2DE). Differences in protein spot intensity between the lineages were quantified through 3D gel scanning densitometry. Selected protein spots were excised, subjected to tryptic digests, prior to separation using HPLC with a linear ion trap mass spectrometer, and identified. Protein maps representing the proteomes from adult and foetal fibroblasts showed similar distributions but revealed differences in expression levels. Heat shock cognate 71 kDA protein, Tubulin alpha-1A chain, actin cytoplasmic-1, and neuron cytoplasmic protein were all expressed in significantly higher concentrations by foetal fibroblasts, nearly double those observed for their adult counterparts. Fructose bisphosphate aldolase A, Cofilin-1, Peroxiredoxin-1, Lactotransferrin Galectin-1, Profilin-1, and Calreticulin were expressed at comparatively higher concentrations by the adult fibroblasts. Significant differences in the expression levels of some proteins in human adult and foetal fibroblasts correlated with known differences in wound healing behaviour. This data may assist in the development of technologies to promote scarless wound healing and better functional tissue repair and regeneration.

A tuneable switch for controlling environmental degradation of bioplastics: addition of isothiazolinone to polyhydroxyalkanoates

Controlling the environmental degradation of polyhydroxybutyrate (PHB) and polyhydroxyvalerate (P(HB-co-HV)) bioplastics would expand the range of their potential applications. Combining PHB and P(HB-co-HV) films with the anti-fouling agent 4,5-dichloro-2-n-octyl-4-isothiazolin-3-one (DCOI, <10% w/w) restricted microbial colonisation in soil, but did not significantly affect melting temperature or the tensile strength of films. DCOI films showed reduced biofouling and postponed the onset of weight loss by up to 100 days, a 10-fold increase compared to unmodified films where the microbial coverage was significant. In addition, the rate of PHA-DCOI weight loss, post-onset, reduced by about 150%; in contrast a recorded weight loss of only 0.05% per day for P(HB-co-HV) with a 10% DCOI loading was observed. This is in stark contrast to the unmodified PHB film, where a recorded weight loss of only 0.75% per day was made. The ‘switch’ that initiates film weight loss, and its subsequent reduced rate, depended on the DCOI loading to control biofouling. The control of biofouling and environmental degradation for these DCOI modified bioplastics increases their potential use in biodegradable applications.

Chitosan adhesive for laser tissue repair

Background. Laser tissue repair usually relies on haemoderivate solders, based on serum albumin. These solders have intrinsic limitations that impair their widespread use, such as limited repair strength, high solubility, brittleness and viral transmission. Furthermore, the solder activation temperature (65-70 °C) can induce significant damage to tissue. In this study, a new laser-activated biomaterial for tissue repair was developed and tested in vitro and in vivo to overcome some of the shortcomings of traditional solders. Materials and Methods. Flexible and insoluble strips of chitosan adhesive (surface area ~34 mm2, thickness ~20 μm) were developed and bonded on sheep intestine with a laser fluence and irradiance of 52 ± 2 J/cm2 and ~15 W/cm2 respectively. The temperature between tissue and adhesive was measured using small thermocouples. The strength of repaired tissue was tested by a calibrated tensiometer. The adhesive was also bonded in vivo to the sciatic nerve of rats to assess the thermal damage induced by the laser (fluence = 65 ± 11 J/cm2, irradiance = 15 W/cm2) four days post-operatively. Results. Chitosan adhesives successfully repaired intestine tissue, achieving a repair strength of 0.50 ± 0.15 N (shear stress = 14.7 ± 4.7 KPa, n=30) at a temperature of 60-65 °C. The laser caused demyelination of axons at the operated site; nevertheless, the myelinated axons retained their normal morphology proximally and distally.

Polyhydroxyalkanoates as packaging materials: current applications and future prospects

Packaging serves a number of essential functions and conventional thermoplastics derived from fossil fuels are dominant in the packaging industry. However, there are serious issues with their environmental persistence and the leaching of their various additives. In contrast, the use of natural, biodegradable bioplastics supports sustainable development. The family of polyhydroxyalkanoates (PHAs) offers versatility in the properties required for plastic packaging. While their biodegradation ensures the continued development of PHAs for sustainable packaging, researchers are also using this property for the controlled release of agricultural agents such as herbicides and pesticides. Similarly, the biocompatibility and FDA approval have supported the investigation of PHAs in the packaging and delivery of pharmaceutical agents and cells for medical applications. Thus, PHAs have been used to produce value-added packaging with properties beyond current plastics while promoting an environmentally friendly alternative for a sustainable future. This chapter summarises the requirements for sustainable packaging and how the properties of PHAs support their continued development in their environmentally-friendly medical packaging applications.

SurgiLux: A Novel Thin Film, Laser-Activated Bioadhesive for Corneal Repair

Laser activated SurgiLux® technology was examined to determine its suitability as an ocular wound sealant. SurgiLux showed suitable strength and flexibility as well as moisture content for applications in the eye. In comparison to conventional microsuturing complemented with fibrin sealant, application of the SurgiLux technology was up to 5 times faster and the strength of the repaired wounds up to 7 times greater, with a 6 mm incision withstanding 235 mm Hg pressure compared to 120 mm Hg for sutures with fibrin.