Lucia Sanchez-Prado

Microwave-assisted extraction: Application to the determination of emerging pollutants in solid samples

Flame retardants, surfactants, pharmaceutical and personal care products, among other compounds, have been the object of numerous environmental studies. In this chapter, the application of microwave-assisted extraction (MAE) in the development of analytical methods for several groups of organic compounds with growing concern as emerging pollutants has been considered. Compared to other extraction techniques, optimization of MAE experimental conditions is rather easy owing to the low number of influential parameters (i.e. matrix moisture, nature of the solvent, time, power, and temperature in closed vessels). The great reduction in the extraction time and solvent consumption, as well as the possibility of performing multiple extractions, increasing the sample throughput, can also be highlighted among MAE advantages. In summary, the study of several applications of MAE to environmental problems demonstrates that this technique constitutes a good alternative for the determination of organic compounds in environmental samples. It can be used as a rapid screening tool, and also to obtain detailed information on the sources, behaviour and fate of emerging pollutants in environmental matrices.

Sonochemical degradation of triclosan in water and wastewater

The sonochemical degradation of 5 microg l(-1) triclosan, a priority micro-pollutant, in various environmental samples (seawater, urban runoff and influent domestic wastewater) as well as in model solutions (pure and saline water) was investigated. Experiments were conducted with a horn-type sonicator operating at 80 kHz frequency and a nominal applied power of 135 W, while solid-phase microextraction coupled with gas chromatography-electron capture detector (SPME/GC-ECD) was employed to monitor triclosan degradation. The latter followed pseudo-first order kinetics with the rate constant being (min(-1)): 0.2284 for seawater>0.1051 for 3.5% NaCl in deionised water>0.0597 for centrifuged urban runoff approximately 0.0523 for untreated urban runoff >0.0272 for deionised water >0.0063 for wastewater influent. SPME/GC-ECD and SPME coupled with gas chromatography-mass spectrometry (SPME/GC-MS) were also used to check for the formation of chlorinated and other toxic by-products; at the conditions in question, the presence of such compounds was not confirmed.

Analysis of plasticizers and synthetic musks in cosmetic and personal care products by matrix solid-phase dispersion gas chromatography–mass spectrometry

Matrix solid-phase dispersion (MSPD) and gas chromatography-mass spectrometry were used for the rapid determination of 18 plasticizers (phthalates and adipates), 7 polycyclic musks and 5 nitromusks, which makes a total of 30 targets, in both rinse-off and leave-on cosmetic formulations. The MSPD method was miniaturized and customized to avoid or minimize risks of phthalate contamination and to reduce residues and costs. The amount of sample and extraction solvent employed were 0.1g and 1mL, respectively. The procedure was optimized by means of an experimental design and under the optima conditions it showed satisfactory linearity, repeatability and intermediate precision. LOQs were, in general, in the low ngg(-1), and recoveries were quantitative for all the 18 plasticizers and the 12 fragrances. Twenty-six cosmetic products such as creams, emulsions, lotions, gels for the skin, bath and shower preparations, deodorants, hair-setting, hair-cleansing and hair-conditioning products, shaving products, and sunbathing products, were analyzed. Twenty-five out of thirty targets were detected in the samples. The most frequently found compounds were galaxolide and tonalide reaching concentrations above 0.1% (1000μgg(-1)), and diethyl phthalate (between 0.7 and 357μgg(-1)). The presence of banned substances (Regulation (EC) No. 1223/2009) such as dibutyl phthalate, diisobutyl phthalate, dimethoxyethyl phthalate, benzylbutyl phthalate, diethylhexyl phthalate, diisopentyl phthalate and dipentyl phthalate, musk ambrette and musk tibetene was confirmed in sixteen of the twenty-six personal care products (62%).

Multicomponent analytical methodology to control phthalates, synthetic musks, fragrance allergens and preservatives in perfumes.

A simple, fast, robust and reliable multicomponent analytical method applicable in control laboratories with a high throughput level has been developed to analyze commercial brands of perfumes. Contents of 52 cosmetic ingredients belonging to different chemical families can be determined in a single run. Instrumental linearity, precision of the method and recovery studies in real samples showed excellent results, so that quantification by external calibration can be effectively applied. Relevant limits of detection and quantification were obtained for all the targets considered, far below the legal requirements and amply adequate for its accurate analytical control. A survey of 70 commercial perfumes and colognes has been performed, in order to verify whether these products complied with the recent changes in European legislation: regarding the maxima allowed concentrations of the ingredients and/or ingredient labelling. All samples contained some of the target ingredients. Several samples do not comply with the regulations concerning the presence of phthalates. Musks data confirmed the trend about the replacement of nitromusks by polycyclic musks; as well as the noticeable introduction of macrocyclic musks in the perfumes composition. The prohibited musk moskene has been detected in one sample in an appreciable concentration. The average number of fragrance allergens is twelve per sample; their presence must be indicated in the list of ingredients when its concentration exceeds the 0.001%, but values higher than 1% have been found in some samples. Preservatives data show that parabens, although ubiquitous in other cosmetic products, are not widely used in perfumery. In contrast, the presence of BHT is indeed widespread. The degree of compliance with the European Regulation on the labelling has been evaluated in a subset of samples, and only about the 38% of the perfumes were properly labelled for the allergens tested.

Determination of isothiazolinone preservatives in cosmetics and household products by matrix solid-phase dispersion followed by high-performance liquid chromatography-tandem mass spectrometry.

In this work, the development of a new efficient methodology applying, for the first time, matrix solid phase dispersion (MSPD) for the determination of sensitizer isothiazolinone biocides in cosmetics and household products - 2-methyl-3-isothiazolinone (MI), 5-chloro-2-methyl-3-isothiazolinone (CMI), 1,2-benzisothiazolinone (BzI) and 2-octyl-3-isothiazolinone (OI) - is described. The main factors affecting the MSPD extraction procedure, the dispersive phase and the elution solvent, are assessed and optimized through a multicategorical experimental design, using a real cosmetic sample. The most suitable extraction conditions comprise the use of 2g of florisil as dispersive phase and 5 mL of methanol as elution solvent. Subsequently, the extract is readily analyzed by HPLC-MS/MS without any further clean-up or concentration steps. Method performance was evaluated demonstrating to have a broad linear range (R(2)>0.9980) and limits of detection (LOD) and quantification (LOQ) at the low nanogram per gram level, which are well below the required limits for UE regulation compliance. Satisfactory recoveries above 80%, except for MI (mean values close to 60%), were obtained. In all cases, the method precision (% RSD) was lower than 7%, making this low cost extraction method reliable for routine control. The validated methodology was finally applied to the analysis of a wide variety of cosmetics and household products. Most of the real samples analyzed have been shown to comply with the current European Cosmetic Regulation, although the results obtained for some rinse-off cosmetics (e.g. baby care products) revealed high isothiazolinone content.

Determination of suspected fragrance allergens in cosmetics by matrix solid-phase dispersion gas chromatography-mass spectrometry analysis

An effective low cost sample preparation methodology for the determination of regulated fragrance allergens in leave-on and rinse-off cosmetics has been developed applying, for the first time, matrix solid-phase dispersion (MSPD) to this kind of analytes and samples. The selection of the most suitable extraction conditions was made using statistical tools such as ANOVA, as well as a factorial multifactor experimental design. These studies were carried out using real cosmetic samples. In the final conditions, 0.5 of sample, previously mixed with 1g of anhydrous Na(2)SO(4), were blended with 2g of dispersive sorbent (Florisil), and the MSPD column was eluted with 5 mL of hexane/acetone (1:1). The extract was then analyzed by GC-MS without any further clean-up or concentration step. Accuracy, precision, linearity and detection limits (LODs) were evaluated to assess the performance of the proposed method. Quantitative recoveries (>75%) were obtained and RSD values were lower than 10% in all cases. The quantification limits were well below those set by the international cosmetic regulations, making this multi-component analytical method suitable for routine control. In addition, the MSPD method can be implemented in any laboratory at low cost since it does not require special equipment. Finally, a wide variety of cosmetic products were analyzed. All the samples contained several of the target cosmetic ingredients, with and average number of seven. The total fragrance allergen content was in general quite high, even in baby care products, with values close to or up to 1%, for several samples, although the actual European Cosmetic Regulation was fulfilled.

Hazardous organic chemicals in rubber recycled tire playgrounds and pavers

In this study, the presence of hazardous organic chemicals in surfaces containing recycled rubber tires is investigated. Direct material analyses using solvent extraction, as well as SPME analysis of the vapour phase above the sample, were carried out. Twenty-one rubber mulch samples were collected from nine different playgrounds. In addition, seven commercial samples of recycled rubber pavers were acquired in a local store of a multinational company. All samples were extracted by ultrasound energy, followed by analysis of the extract by GC-MS. The analysis confirmed the presence of a large number of hazardous substances including PAHs, phthalates, antioxidants (e.g. BHT, phenols), benzothiazole and derivatives, among other chemicals. The study evidences the high content of toxic chemicals in these recycled materials. The concentration of PAHs in the commercial pavers was extremely high, reaching values up to 1%. In addition, SPME studies of the vapour phase above the samples confirm the volatilisation of many of those organic compounds. Uses of recycled rubber tires, especially those targeting play areas and other facilities for children, should be a matter of regulatory concern.

Ultrasound-assisted emulsification–microextraction of fragrance allergens in water

A method based on ultrasound-assisted emulsification-microextraction (USAEME) and gas chromatography-mass spectrometry (GC-MS) has been developed for the analysis of regulated fragrance allergens in water. Extraction conditions such as the type of solvent, extraction temperature, irradiation time, and salting-out effect were optimized using a multivariate approach. Compounds were extracted during 2 min in an acoustically emulsified media formed by 100 μL chloroform and 10 mL sample. The USAEME process provided an efficient and exhaustive extraction (enrichment factor ∼100) and, after centrifugation, the extract was ready for GC analysis. Validation was performed using spiked ultrapure water as well as other most complex matrices such as sewage water. Recoveries between 75% and 110% were generally obtained, and precision was characterized by RSD values <10% in most cases. The limits of detection (LODs) were at the sub-nanogram per millilitre level. The proposed procedure was applied to the determination of allergens in several real samples including tap water, baby bathwater, recreational place water, public washing place water, and sewage water. The presence of some of the target compounds was confirmed in all the samples excluding tap water, demonstrating the ubiquity of this group of cosmetic and personal care products ingredients.

Determination of fragrance allergens in indoor air by active sampling followed by ultrasound-assisted solvent extraction and gas chromatography–mass spectrometry

Fragrances are ubiquitous pollutants in the environment, present in the most of household products, air fresheners, insecticides and cosmetics. Commercial perfumes may contain hundreds of individual fragrance chemicals. In addition to the widespread use and exposure to fragranced products, many of the raw fragrance materials have limited available health and safety data. Because of their nature as artificial fragrances, inhalation should be considered as an important exposure pathway, especially in indoor environments. In this work, a very simple, fast, and sensitive methodology for the analysis of 24 fragrance allergens in indoor air is presented. Considered compounds include those regulated by the EU Directive, excluding limonene; methyl eugenol was also included due to its toxicity. The proposed methodology is based on the use of a very low amount of adsorbent to retain the target compounds, and the rapid ultrasound-assisted solvent extraction (UAE) using a very low volume of solvent which avoids further extract concentration. Quantification was performed by gas chromatography coupled to mass spectrometry (GC-MS). The influence of main factors involved in the UAE step (type of adsorbent and solvent, solvent volume and extraction time) was studied using an experimental design approach to account for possible factor interactions. Using the optimized procedure, 0.2 m(-3) air are sampled, analytes are retained on 25 mg Florisil, from which they are extracted by UAE (5 min) with 2 mL ethyl acetate. Linearity was demonstrated in a wide concentration range. Efficiency of the total sampling-extraction process was studied at several concentration levels (1, 5 and 125 microg m(-3)), obtaining quantitative recoveries, and good precision (RSD<10%). Method detection limits were < or =0.6 microg m(-3). Finally, the proposed method was applied to real samples collected in indoor environments in which several of the target compounds were determined.

Development of a solid phase dispersion-pressurized liquid extraction method for the analysis of suspected fragrance allergens in leave-on cosmetics

A new method based on solid phase dispersion-pressurized liquid extraction (PLE) followed by gas chromatography-mass spectrometry (GC-MS) has been developed for the determination of 26 suspected fragrance allergens (all the regulated in the EU Cosmetics Directive amenable by GC, as well as pinene and methyleugenol) in cosmetic samples. The effects of the temperature, extraction time and solvent, and dispersing sorbent, affecting the whole proposed procedure, have been evaluated using a multifactor strategy. The optima conditions after the analysis of main and second order effects entailed the extraction at 120°C for 15 min, using hexane/acetone as solvent, and florisil as dispersing sorbent. The method performance has been studied, showing good linearity (R≥0.996) as well as good precision (RSD≤10%). Detection limits (S/N=3) ranged from 0.000001 to 0.0002% (w/w), values far below the established restrictions as regard labelling in the European Cosmetics Regulation. Reliability was demonstrated through the quantitative recoveries of all the studied compounds. The absence of matrix effects allowed quantification of the compounds by calibration with standard solutions. The analysis of 10 samples (several moisturizing and anti-wrinkle creams and lotions, hand creams, and sunscreen and after-sun creams), covering very different matrices, showed the presence of suspected allergens in all the analyzed samples; in fact, half of the samples contained an elevated number of them. Although the ubiquity of these compounds was demonstrated, labelling was in all cases in consonance with the European Cosmetics Regulation.