M.A. Alonso-Lomillo

CYP450 2B4 covalently attached to carbon and gold screen printed electrodes by diazonium salt and thiols monolayers.

An easy covalent immobilization method used to develop enzyme biosensors based on carbon and gold screen printed electrodes (SPCEs and gold SPEs) is described. The linkage of biomolecules through 4-nitrobenzenediazonium tetrafluoroborate, mercaptopropionic acid and thioctic acid monolayers has been attempted using bare SPCEs and gold SPEs, as well as gold nanoparticles (AuNPs) modified SPCEs and gold SPEs. Direct covalent attachment of Cytochrome P450 2B4 (CYP450 2B4) to the transducer has been carried out by carbodiimide and hydroxysuccinimide. Experimental variables in the immobilization process and in the chronoamperometric determination of Phenobarbital (PB) have been optimized by the experimental design methodology. Reproducibility of the different biosensors has been checked under the optimum conditions, yielding values lower than 6%. Their performances have been shown by the determination of PB in pharmaceutical drugs.

Development of urease based amperometric biosensors for the inhibitive determination of Hg (II).

Enzymatic amperometric procedures for measurement of Hg (II), based on the inhibitive action of this metal on urease enzyme activity, were developed. Screen-printed carbon electrodes (SPCEs) and gold nanoparticles modified screen-printed carbon electrodes (AuNPs/SPCEs) were used as supports for the cross-linking inmobilization of the enzyme urease. The amperometric response of urea was affected by the presence of Hg (II) ions which caused a decreasing in the current intensity. The optimum working conditions were found using experimental design methodology. Under these conditions, repeatability and reproducibility for both types of biosensors were determined, reaching values below 6% in terms of residual standard deviation. The detection limit obtained for Hg (II) was 4.2x10(-6)M for urease/SPCE biosensor and 5.6x10(-8)M for urease/AuNPs/SPCE biosensor. Analysis of the possible effect of the presence of foreign ions in the solution was performed. The method was applied to determine levels of Hg (II) in spiked human plasma samples.

CYP450 biosensors based on gold chips for antiepileptic drugs determination

Three-electrode configuration chips containing a Pt, Au and a screen-printed Ag/AgCl as counter, working and reference electrode, respectively, have been developed. Selective determination of Phenobarbital (PB) has been carried out by Cytochrome P450 2B4 (CYP450) immobilization into a polypyrrole matrix onto the gold working electrode. Chronoamperometric experiments show a PB diffusion coefficient of 2.42x10(-6)cm(2)s(-1), a reproducibility and repeatability in terms of residual standard deviation (RSD) of 13% and 5.51%, respectively, and a limit of detection (LOD) of 0.289 micromol dm(-3) (alpha=beta=0.05) for the developed CYP450-biosensor chip. Its performance has been showed by the determination of PB in pharmaceutical drugs. HPLC has been used as reference technique.

Acetylcholinesterase Inhibition-Based Biosensor for Aluminum(III) Chronoamperometric Determination in Aqueous Media

A novel amperometric biosensor for the determination of Al(III) based on the inhibition of the enzyme acetylcholinesterase has been developed. The immobilization of the enzyme was performed on screen-printed carbon electrodes modified with gold nanoparticles. The oxidation signal of acetylthiocholine iodide enzyme substrate was affected by the presence of Al(III) ions leading to a decrease in the amperometric current. The developed system has a detection limit of 2.1 ± 0.1 μM for Al(III). The reproducibility of the method is 8.1% (n = 4). Main interferences include Mo(VI), W(VI) and Hg(II) ions. The developed method was successfully applied to the determination of Al(III) in spiked tap water. The analysis of a certified standard reference material was also carried out. Both results agree with the certified values considering the respective associated uncertainties.

Resolution of quaternary mixtures of cadaverine, histamine, putrescine and tyramine by the square wave voltammetry and partial least squares method.

This work presents the simultaneous determination of cadaverine, histamine, putrescine and tyramine by square wave voltammetry using a boron-doped diamond electrode. A multivariate calibration method based on partial least square regressions has allowed the resolution of the very high overlapped voltammetric signals obtained for the analyzed biogenic amines. Prediction errors lower than 9% have been obtained when concentration of quaternary mixtures were calculated. The developed procedure has been applied in the analysis of ham samples, which results are in good agreement with those obtained using the standard HPLC method.

Thick-film voltammetric pH-sensors with internal indicator and reference species.

The following paper describes the development of a screen-printed voltammetric pH-sensor based on graphite electrodes incorporating both internal indicator (i.e., phenanthraquinone) and reference species (i.e., dimethylferrocene). The key advantages of this type of system stem from its simplicity, low cost and ease of fabrication. More importantly, as opposed to conventional voltammetric systems where the height of the voltammetric peaks is taken into account to quantify the amount of a species of interest, here, the difference between the peak potential of the indicator species and the peak potential of the reference species is used. Thus, this measurement principle makes the electrochemical system presented here less dependent on the potential of the reference electrode (RE), as is often the case in other electrochemical systems. The developed system displays very promising performances, with a reproducible Super Nernstian response to pH changes and a lifetime of at least nine days.

A Chronoamperometric Screen Printed Carbon Biosensor Based on Alkaline Phosphatase Inhibition for W(VI) Determination in Water, Using 2-Phospho-L-Ascorbic Acid Trisodium Salt as a Substrate

This paper presents a chronoamperometric method to determine tungsten in water using screen-printed carbon electrodes modified with gold nanoparticles and cross linked alkaline phosphatase immobilized in the working electrode. Enzymatic activity over 2-phospho-l-ascorbic acid trisodium salt, used as substrate, was affected by tungsten ions, which resulted in a decrease of chronoamperometric current, when a potential of 200 mV was applied on 10 mM of substrate in a Tris HCl buffer pH 8.00 and 0.36 M of KCl. Calibration curves for the electrochemical method validation, give a reproducibility of 5.2% (n = 3), a repeatability of 9.4% (n = 3) and a detection limit of 0.29 ± 0.01 μM. Enriched tap water, purified laboratory water and bottled drinking water, with a certified tungsten reference solution traceable to NIST, gave a recovery of 97.1%, 99.1% and 99.1% respectively (n = 4 in each case) and a dynamic range from 0.6 to 30 μM. This study was performed by means of a Lineweaver–Burk plot, showing a mixed kinetic inhibition.

A Disposable Alkaline Phosphatase-Based Biosensor for Vanadium Chronoamperometric Determination

A chronoamperometric method for vanadium ion determination, based on the inhibition of the enzyme alkaline phosphatase, is reported. Screen-printed carbon electrodes modified with gold nanoparticles were used as transducers for the immobilization of the enzyme. The enzymatic activity over 4-nitrophenyl phosphate sodium salt is affected by vanadium ions, which results in a decrease in the chronoamperometric current registered. The developed method has a detection limit of 0.39 ± 0.06 μM, a repeatability of 7.7% (n = 4) and a reproducibility of 8% (n = 3). A study of the possible interferences shows that the presence of Mo(VI), Cr(III), Ca(II) and W(VI), may affect vanadium determination at concentration higher than 1.0 mM. The method was successfully applied to the determination of vanadium in spiked tap water.

Disposable immunosensor for human cytomegalovirus glycoprotein B detection

Combining the advantages of the biosensor field with the problem of detecting Human Cytomegalovirus (HCMV) in human samples, an inexpensive, simple and disposable electrochemical immunosensor for glycoprotein B detection in urine is proposed. Glycoprotein B has been chosen once is the dominant antigen of HCMV. The approach is based on a sandwich-type immunoassay, with the HCMV glycoprotein B sandwiched between the Anti-HCMV antibody adsorbed onto the working electrode, and the Anti-HCMV labeled with gold nanoparticles. Glycoprotein B detection was carried out through electrochemical stripping analysis of silver nanoparticles quantitatively deposited on the immunosensor through catalysis by the nanogold labels. The influence of different steps in the immunosensor construction, namely the silver deposition time, silver enhancer concentration, antibody concentration, BSA concentration and glycoprotein B incubation time, were examined and optimized. The method showed a linear dependence between glycoprotein B concentration and the corresponding anodic stripping peak current, resulting in detection limits of 3.3±1.7ng/mL for samples prepared in buffer and 3.2±0.2ng/mL for urine samples, suggesting that the biological matrix does not interfere with the immunosensor detection capability. Given its mode of preparation, by physical adsorption of the capture antibody in the working electrode, the immunosensor also exhibited an acceptable reproducibility, with a residual standard deviation of 13.5% for samples prepared in buffer and 11.2% for urine samples, thereby presenting a promising development potential for clinical applications.