Mª Carmen Mejuto

Development of an ionic liquid based dispersive liquid–liquid microextraction method for the analysis of polycyclic aromatic hydrocarbons in water samples

A simple, rapid and efficient method, ionic liquid based dispersive liquid-liquid microextraction (IL-DLLME), has been developed for the first time for the determination of 18 polycyclic aromatic hydrocarbons (PAHs) in water samples. The chemical affinity between the ionic liquid (1-octyl-3-methylimidazolium hexafluorophosphate) and the analytes permits the extraction of the PAHs from the sample matrix also allowing their preconcentration. Thus, this technique combines extraction and concentration of the analytes into one step and avoids using toxic chlorinated solvents. The factors affecting the extraction efficiency, such as the type and volume of ionic liquid, type and volume of disperser solvent, extraction time, dispersion stage, centrifuging time and ionic strength, were optimised. Analysis of extracts was performed by high performance liquid chromatography (HPLC) coupled with fluorescence detection (Flu). The optimised method exhibited a good precision level with relative standard deviation values between 1.2% and 5.7%. Quantification limits obtained for all of these considered compounds (between 0.1 and 7 ng L(-1)) were well below the limits recommended in the EU. The extraction yields for the different compounds obtained by IL-DLLME, ranged from 90.3% to 103.8%. Furthermore, high enrichment factors (301-346) were also achieved. The extraction efficiency of the optimised method is compared with that achieved by liquid-liquid extraction. Finally, the proposed method was successfully applied to the analysis of PAHs in real water samples (tap, bottled, fountain, well, river, rainwater, treated and raw wastewater).

Determination of chlorophenols at the sub-ppb level in tap water using derivatization, solid-phase extraction and gas chromatography with plasma atomic emission detection

Abstract A method for the determination of eight chlorophenols in tap water is proposed, involving the direct acetylation of the chlorophenols in water samples with acetic anhydride in the presence of K2CO3, extraction of the acetylated derivatives by passage through a graphitized carbon cartridge, elution of the cartridge and measurement of the chlorophenol derivatives by means of a microwave-induced plasma atomic emission detector coupled to a gas chromatograph. The quantitativeness of the derivatization process and analyte losses through preconcentration and evaporation were investigated. The limits of quantification obtained permit the application of the proposed method to the analysis of natural and tap water samples.

Speciation of organomercurials in marine samples using capillary electrophoresis

A rapid method for speciation and determination of organomercury compounds in biological samples of marine origin using Capillary Electrophoresis (CE) is reported. Organomercurials were extracted from the samples by means of the classical Westöö procedure thus giving organomercury-cysteine complexes which can be separated from each other by means of CE resulting in effective speciation. Electrophoretic separation was achieved in an open silica capillary tube at 15-18 kV using a 100mM sodium borate buffer (pH 8.35). All mercury species were distinctively separated within 12 min. Results are presented for the analysis of real marine samples and reference materials, and compared with those obtained by the GC commonly accepted procedure.

Determination of chlorophenols in drinking water samples at the subnanogram per millilitre level by gas chromatography with atomic emission detection

The use of an atomic emission detector following a process of preconcentration of drinking water samples by a factor of 1500:1 allows the highly selective determination of chlorophenols present in samples below the maximum limit of 0.5 ng/ml set by international regulations. The preconcentration of the samples is carried out using 0.25-g commercial graphitized carbon cartridges without the need for sample derivatization prior to solid-phase extraction.

Evaluation of two solid-phase extraction procedures for the preconcentration of chlorophenols in drinking water

Two off-line concentration procedures for the determination of sixteen chlorophenols in drinking water were developed. One involves acetylation of the samples and their subsequent preconcentration over graphitized carbon black cartridges. In the other, chlorophenols are derivatized following preconcentration over cross-linked styrene-divinylbenzene. The two proposed procedures are compared in terms of chlorophenol recoveries, throughput and breakthrough volume of the cartridges. The acetylated derivatives of chlorophenols are determined highly selectively at the concentration levels established by international legislation using gas chromatography in combination with microwave induced plasma atomic emission spectroscopy.

Development of a matrix solid-phase dispersion method for the determination of polycyclic aromatic hydrocarbons in sewage sludge samples

A new, single-step extraction and purification method based on matrix solid-phase dispersion (MSPD) was developed to determine 17 polycyclic aromatic hydrocarbons (PAHs) in sewage sludge samples. The MSPD method consists of sample homogenisation, exhaustive extraction and clean-up by a single process. The different operational parameters of the method, such as the type of dispersant, type and amount of additives, clean-up co-sorbent and extractive solvent were evaluated. Reversed-phase (C18) and polymeric (Oasis HLB and Oasis MAX) materials, as well as normal phase sorbents (Florisil, silica, neutral alumina) and an inert support (sand) were tested to assess the sorbents effect on the yield and selectivity of the MSPD process. Analysis of extracts was performed by high performance liquid chromatography (HPLC) coupled with fluorescence detection. Quantification limits obtained for all of these considered compounds (between 0.0001 and 0.005mugg(-1) dry mass) were well below of the limits recommended in the EU. The extraction yields for the different compounds obtained by MSPD ranged from 76.3% to 103.6%. On the other hand, the extraction efficiency of the optimised method is compared with that achieved by microwave-assisted extraction and the method was applied to the analysis of real sewage sludge samples. A certified reference material (sewage sludge (BCR 088)) and a reference material (sewage sludge (RTC-CNS312-04)) were used to validate the proposed method.

Selective determination of COXIBs in environmental water samples by mixed-mode solid phase extraction and liquid chromatography quadrupole time-of-flight mass spectrometry

The development and performance evaluation of a method for the simultaneous determination of six pharmaceuticals belonging to the class of non-steroidal anti-inflammatory drugs (NSAIDs) which present high selectivity for the cyclooxygenase (COX)-2 isoform of COX (COXIBs) in environmental waters are presented. The method involves an off-line mixed mode (reversed-phase and strong anionic exchange) solid phase extraction (SPE) for the selective concentration of COXIBs in combination with liquid chromatography (LC) quadrupole time-of-flight (QTOF) mass spectrometry (MS). The use of a strong anionic exchange sorbent (Oasis MAX) led to a significant reduction of matrix effects, during electrospray ionization (ESI), in comparison with results obtained for mixed mode weak anionic exchange sorbent (Oasis Wax) and polymeric reversed phase sorbents (Oasis HLB and Strata X). The developed method attained limits of quantification (LOQs) between 0.01 and 0.20 ng L(-1) for river water and effluent wastewater and, for influent wastewater this limits were ranged between 0.03 and 0.45 ng L(-1). Among the pharmaceuticals investigated, two of them (celecoxib and etoricoxib) were detected at low levels (ppt) in real samples of treated and raw wastewaters, and two metabolites were also found; the carboxylated celecoxib and the hydroxylated etoricoxib.

Optimization of a dispersive liquid–liquid microextraction method for the analysis of benzotriazoles and benzothiazoles in water samples

A simple and rapid dispersive liquid–liquid microextraction method has been developed for the determination of 11 benzotriazoles and benzothiazoles in water samples. Tri-n-butylphosphate (TBP) was used as extractant, thus avoiding the use of toxic water-immiscible chlorinated solvents. The influence of several variables (e.g., type and volume of dispersant and extraction solvents, sample pH, ionic strength, etc.) on the performance of the sample preparation step was systematically evaluated. Analytical determinations were carried out by high-performance liquid chromatography with fluorescence and UV detection and liquid chromatography–electrospray ionization-tandem mass spectrometry. The optimized method exhibited a good precision level with relative standard deviation values between 3.7% and 8.4%. Extraction yields ranging from 67% to 97% were obtained for all of these considered compounds. Finally, the proposed method was successfully applied to the analysis of benzotriazoles and benzothiazoles in real water samples (tap, river, industrial waters, and treated and raw wastewaters).

Speciation of organotin compounds in marine biomaterials after basic leaching in a non-focused microwave extractor equipped with pressurized vessels

A rapid method for the speciation of butyl- and triphenyltin compounds in marine biotissues is described. A non-focused microwave extractor, operating at a power of 950 W and equipped with 12 pressurized vessels, was used to achieve fast sample leaching with tetramethylammonium hydroxide. The pH of the liquid extract was adjusted to 5. Organotins were ethylated with sodium tetraethylborate, extracted in isooctane and determined by means of a microwave-induced plasma atomic emission detector coupled to a gas chromatograph. The stability of butyl and phenyl compounds, exposed to the microwave energy, was studied as a function of the vessel temperature. The possibility of simultaneous carried-out extractions and the use of microwave to perform the ethylation and extraction of organotin compounds was also studied. The full procedure was validated with certified material NIES-11 and with real samples, by comparison with a classic leaching method using tetramethylammonium hydroxide without microwave.

Development of a sample preparation procedure of sewage sludge samples for the determination of polycyclic aromatic hydrocarbons based on selective pressurized liquid extraction.

An automated, simple and sensitive method based on selective pressurized liquid extraction (SPLE) was developed for the analysis of polycyclic aromatic hydrocarbons in sewage sludge samples. The new sample preparation procedure consists of on-line clean-up by inclusion of sorbents in the extraction cell, and combines elevated temperatures and pressures with liquid solvents to achieve fast and efficient removal of target analytes from complex sewage sludge matrices. The effects of various operational parameters (e.g. sample pretreatment, extraction solvent, temperature, pressure, static time, etc.) on the performance of SPLE procedure were carefully investigated, obtaining the best results when SPLE conditions were fixed at 140 degrees C, 1500 psi, static time of 5 min and n-hexane as extraction solvent. A new programmed temperature vaporization-gas chromatography-tandem mass spectrometry method based on large volume injection (PTV-LVI-GC-MS/MS) was also developed and analytical determinations were performed by high performance liquid chromatography coupled with fluorescence detection and GC-MS/MS. The extraction yields for the different compounds obtained by SPLE ranged from 84.8% to 106.6%. Quantification limits obtained for all of these studied compounds (between 0.0001 and 0.005 microg g(-1), dry mass) were well below the regulatory limits for all compounds considered. To test the accuracy of the SPLE technique, the optimized methodology was applied to the analysis of a certified reference material (sewage sludge (BCR088)) and a reference material (sewage sludge (RTC-CNS312-04)), with excellent results.