Marika Hogland

Field-portable X-ray fluorescence spectrometry as rapid measurement tool for landfill mining operations: comparison of field data vs. laboratory analysis

Landfill mining applied in reclamation at the territories of old dump sites and landfills is a known approach tended to global economic and environmental benefits as recovery of metals and energy is an important challenge. The aim of this study was to analyse the concentration of several metallic elements (Ca, Cu, Cr, Fe, K, Mn, Pb, Zn) in the fine fraction of waste derived in the landfill and to compare the results of measurements obtained by field-portable equipment with the data gained by advanced analytical tools. Atomic absorption spectrometry (AAS) and inductively coupled plasma mass spectrometry (ICP-MS) were used for the quantitative detection of metallic elements at the laboratory; whereas field-portable X-ray fluorescence spectrometry (FPXRF) was applied for rapid sample characterisation in the field (on-site). Wet digestion of samples (fine fraction of waste at landfill) was done prior analytical procedures at the laboratory conditions, but FPXRF analysis was performed using raw solid samples of waste fine fraction derived in the Kudjape Landfill in Estonia. Although the use of AAS and ICP-MS for the measurements of metals achieves more precise results, it was concluded that precision and accuracy of the measurements obtained by FPXRF is acceptable for fast approximate evaluation of quantities of metallic elements in fine fraction samples excavated from the waste at landfills. Precision and accuracy of the results provided by express method is acceptable for quick analysis or screening of the concentration of major and trace metallic elements in field projects; however, data correction can be applied by calculating moisture and organic matter content dependent on sample matrix as well as special attention must be paid on sample selection and homogenisation and number of analysed samples.

Paradigms on landfill mining: From dump site scavenging to ecosystem services revitalization

Abstract For the next century to come, one of the biggest challenges is to provide the mankind with relevant and sufficient resources. Recovery of secondary resources plays a significant role. Industrial processes developed to regain minerals for commodity production in a circular economy become ever more important in the European Union and worldwide. Landfill mining (LFM) constitutes an important technological toolset of processes that regain resources and redistribute them with an accompanying reduction of hazardous influence of environmental contamination and other threats for human health hidden in former dump sites and landfills. This review paper is devoted to LFM problems, historical development and driving paradigms of LFM from ‘classical hunting for valuables’ to ‘perspective in ecosystem revitalization’. The main goal is to provide a description of historical experience and link it to more advanced concept of a circular economy. The challenge is to adapt the existing knowledge to make decisions in accordance with both, economic feasibility and ecosystems revitalization aspects.

Characterisation of excavated fine fraction and waste composition from a Swedish landfill

The present research studies the characterisation and the physico-chemical properties of an excavated fine fraction (<10 mm) from a Swedish landfill, the Högbytorp. The results showed that the fine fraction represents 38% by mass of the total excavated wastes and it contains mainly soil-type materials and minerals. Higher concentrations of zinc, copper, barium and chromium were found with concentrations higher than the Swedish Environmental Protection Agency (EPA) for contaminated soil. The found moisture and organic contents of the fine fraction were 23.5% and 16.6%, respectively. The analysed calorific value (1.7 MJ kg−1), the potential of CH4 (4.74 m3 t−1 dry matter) and Total Organic Carbon (TOC) (5.6%) were low and offer low potential of energy. Sieving the fine fraction further showed that 80% was smaller than 2 mm. The fine represents a major fraction at any landfill (40%–70%), therefore, characterising the properties of this fraction is essential to find the potential of reusing/recycling or safely redisposing.

Formation and properties of sediments in constructed wetlands for treatment of domestic wastewater

Sediments formation and biogeochemical properties were studied in an experimental constructed wetland site in Ukraine (“Bioplato”) for treatment of domestic effluents. The wetland, with a capacity of 50 m3 d− 1 of wastewater, consists of vertical and horizontal filtrations units with fine gravel, middle and coarse sand, a subsurface flow unit with natural wetland soil applied, and a septic tank and sludge-drying field. Macrophytes, reed (Phragmites australis), cattail (Typha latifolia) and a number of sedge species (Carex spp.) were planted in the area and dominate the average cover of 85–90%. Treatment efficiency for BOD5 and suspended solids was 93–96%, for COD – 82%, for nutrients – 27–50%, and for pathogenic microorganisms 99.3–99.6%. Sludge was sampled at each unit followed by standard laboratory analyses of its main characteristics: total organic carbon (TOC), total nutrients (N, P), contents of trace elements, abundance of pathogenic microorganisms, and general toxicity. Results confirmed that the top layer of sludge from each unit of wetland could be used as a source of fertilizers for grain and leguminous crops.

Hunting for valuables from landfills and assessing their market opportunities : A case study with Kudjape landfill in Estonia

Landfill mining is an alternative technology that merges the ideas of material recycling and sustainable waste management. This paper reports a case study to estimate the value of landfilled materials and their respective market opportunities, based on a full-scale landfill mining project in Estonia. During the project, a dump site (Kudjape, Estonia) was excavated with the main objectives of extracting soil-like final cover material with the function of methane degradation. In total, about 57,777 m3 of waste was processed, particularly the uppermost 10-year layer of waste. Manual sorting was performed in four test pits to determine the detailed composition of wastes. 11,610 kg of waste was screened on site, resulting in fine (<40 mm) and coarse (>40 mm) fractions with the share of 54% and 46%, respectively. Some portion of the fine fraction was sieved further to obtain a very fine grained fraction of <10 mm and analyzed for its potential for metals recovery. The average chemical composition of the <10 mm soil-like fraction suggests that it offers opportunities for metal (Cr, Cu, Ni, Pb, and Zn) extraction and recovery. The findings from this study highlight the importance of implementing best available site-specific technologies for on-site separation up to 10 mm grain size, and the importance of developing and implementing innovative extraction methods for materials recovery from soil-like fractions.

Fractionation of Pb and Cu in the fine fraction (<10 mm) of waste excavated from a municipal landfill

The fractionation of metals in the fine fraction (<10 mm) of excavated waste from an Estonian landfill was carried out to evaluate the metal (Pb and Cu) contents and their potential towards not only mobility but also possibilities of recovery/extraction. The fractionation followed the BCR (Community Bureau of Reference) sequential extraction, and the exchangeable (F1), reducible (F2), oxidizable (F3) and residual fractions were determined. The results showed that Pb was highly associated with the reducible (F2) and oxidizable (F3) fractions, suggesting the potential mobility of this metal mainly when in contact with oxygen, despite the low association with the exchangeable fraction (F1). Cu has also shown the potential for mobility when in contact with oxygen, since high associations with the oxidizable fraction (F3) were observed. On the other hand, the mobility of metals in excavated waste can be seen as beneficial considering the circular economy and recovery of such valuables back into the economy. To conclude, not only the total concentration of metals but also a better understanding of fractionation and in which form metals are bound is very important to bring information on how to manage the fine fraction from excavated waste both in terms of environmental impacts and also recovery of such valuables in the economy.