Mark A. Rould

Crystal Structures of Expressed Non-polymerizable Monomeric Actin in the ADP and ATP States

Actin filament growth and disassembly, as well as affinity for actin-binding proteins, is mediated by the nucleotide-bound state of the component actin monomers. The structural differences between ATP-actin and ADP-actin, however, remain controversial. We expressed a cytoplasmic actin in Sf9 cells, which was rendered non-polymerizable by virtue of two point mutations in subdomain 4 (A204E/P243K). This homogeneous monomer, called AP-actin, was crystallized in the absence of toxins, binding proteins, or chemical modification, with ATP or ADP at the active site. The two surface mutations do not perturb the structure. Significant differences between the two states are confined to the active site region and sensor loop. The active site cleft remains closed in both states. Minor structural shifts propagate from the active site toward subdomain 2, but dissipate before reaching the DNase binding loop (D-loop), which remains disordered in both the ADP and ATP states. This result contrasts with previous structures of actin made monomeric by modification with tetramethylrhodamine, which show formation of an α-helix at the distal end of the D-loop in the ADP-bound but not the ATP-bound form (Otterbein, L. R., Graceffa, P., and Dominguez, R. (2001) Science 293, 708-711). Our reanalysis of the TMR-modified actin structures suggests that the nucleotide-dependent formation of the D-loop helix may result from signal propagation through crystal packing interactions. Whereas the observed nucleotide-dependent changes in the structure present significantly different surfaces on the exterior of the actin monomer, current models of the actin filament lack any actin-actin interactions that involve the region of these key structural changes.

A structural rationale for stalling of a replicative DNA polymerase at the most common oxidative thymine lesion, thymine glycol

Thymine glycol (Tg) is a common product of oxidation and ionizing radiation, including that used for cancer treatment. Although Tg is a poor mutagenic lesion, it has been shown to present a strong block to both repair and replicative DNA polymerases. The 2.65-Å crystal structure of a binary complex of the replicative RB69 DNA polymerase with DNA shows that the templating Tg is intrahelical and forms a regular Watson–Crick base pair with the incorporated A. The C5 methyl group protrudes axially from the ring of the damaged pyrimidine and hinders stacking of the adjacent 5′ template guanine. The position of the displaced 5′ template guanine is such that the next incoming nucleotide cannot be incorporated into the growing primer strand, and it explains why primer extension past the lesion is prohibited even though DNA polymerases can readily incorporate an A across from the Tg lesion.

Crystal structures of monomeric actin bound to cytochalasin D.

The fungal toxin cytochalasin D (CD) interferes with the normal dynamics of the actin cytoskeleton by binding to the barbed end of actin filaments. Despite its widespread use as a tool for studying actin-mediated processes, the exact location and nature of its binding to actin have not been previously determined. Here we describe two crystal structures of an expressed monomeric actin in complex with CD: one obtained by soaking preformed actin crystals with CD, and the other obtained by cocrystallization. The binding site for CD, in the hydrophobic cleft between actin subdomains 1 and 3, is the same in the two structures. Polar and hydrophobic contacts play equally important roles in CD binding, and six hydrogen bonds stabilize the actin-CD complex. Many unrelated actin-binding proteins and marine toxins target this cleft and the hydrophobic pocket at the front end of the cleft (viewing actin with subdomain 2 in the upper right corner). CD differs in that it binds to the back half of the cleft. The ability of CD to induce actin dimer formation and actin-catalyzed ATP hydrolysis may be related to its unique binding site and the necessity to fit its bulky macrocycle into this cleft. Contacts with residues lining this cleft appear to be crucial to capping and/or severing. The cocrystallized actin-CD structure also revealed changes in actin conformation. An approximately 6 degrees rotation of the smaller actin domain (subdomains 1 and 2) with respect to the larger domain (subdomains 3 and 4) results in small changes in crystal packing that allow the D-loop to adopt an extended loop structure instead of being disordered, as it is in most crystal structures of actin. We speculate that these changes represent a potential conformation that the actin monomer can adopt on the pathway to polymerization or in the filament.

[26] Screening for heavy-atom derivatives and obtaining accurate isomorphous differences.

Publisher Summary This chapter discusses the screening of heavy-atom derivatives for obtaining accurate isomorphous differences. Rapid data collection on electronic area detectors, imaging plates, and charge-coupled device (CCD) detectors, coupled with synchrotron sources, the cryogenic immortalization of crystals, and the desktop supercomputer, have greatly accelerated the pace of de novo macromolecular structure determination. Multiple isomorphous replacement (MIR) remains the predominant method for the initial phasing of new structures and requires at least one and sometimes several heavy-atom derivatives. After crystallization, the search for these isomorphous derivatives often becomes the rate-limiting step of structure determination. In some cases, dozens of potential heavy-atom reagents must be tried before one is found that not only binds well but also does not damage the crystal or perturb its contents. The chapter discusses a general scheme for the rapid screening of these derivatives, along with suggestions for obtaining accurate isomorphous differences to be used to locate and refine heavy atoms.

Disruption of TgPHIL1 Alters Specific Parameters of Toxoplasma gondii Motility Measured in a Quantitative, Three-Dimensional Live Motility Assay

T. gondii uses substrate-dependent gliding motility to invade cells of its hosts, egress from these cells at the end of its lytic cycle and disseminate through the host organism during infection. The ability of the parasite to move is therefore critical for its virulence. T. gondii engages in three distinct types of gliding motility on coated two-dimensional surfaces: twirling, circular gliding and helical gliding. We show here that motility in a three-dimensional Matrigel-based environment is strikingly different, in that all parasites move in irregular corkscrew-like trajectories. Methods developed for quantitative analysis of motility parameters along the smoothed trajectories demonstrate a complex but periodic pattern of motility with mean and maximum velocities of 0.58±0.07 µm/s and 2.01±0.17 µm/s, respectively. To test how a change in the parasites crescent shape might affect trajectory parameters, we compared the motility of Δphil1 parasites, which are shorter and wider than wild type, to the corresponding parental and complemented lines. Although comparable percentages of parasites were moving for all three lines, the Δphil1 mutant exhibited significantly decreased trajectory lengths and mean and maximum velocities compared to the parental parasite line. These effects were either partially or fully restored upon complementation of the Δphil1 mutant. These results show that alterations in morphology may have a significant impact on T. gondii motility in an extracellular matrix-like environment, provide a possible explanation for the decreased fitness of Δphil1 parasites in vivo, and demonstrate the utility of the quantitative three-dimensional assay for studying parasite motility.

Insights into the mechanism of Rad51 recombinase from the structure and properties of a filament interface mutant

Rad51 protein promotes homologous recombination in eukaryotes. Recombination activities are activated by Rad51 filament assembly on ssDNA. Previous studies of yeast Rad51 showed that His352 occupies an important position at the filament interface, where it could relay signals between subunits and active sites. To investigate, we characterized yeast Rad51 H352A and H352Y mutants, and solved the structure of H352Y. H352A forms catalytically competent but salt-labile complexes on ssDNA. In contrast, H352Y forms salt-resistant complexes on ssDNA, but is defective in nucleotide exchange, RPA displacement and strand exchange with full-length DNA substrates. The 2.5 Å crystal structure of H352Y reveals a right-handed helical filament in a high-pitch (130 Å) conformation with P61 symmetry. The catalytic core and dimer interface regions of H352Y closely resemble those of DNA-bound Escherichia coli RecA protein. The H352Y mutation stabilizes Phe187 from the adjacent subunit in a position that interferes with the γ-phosphate-binding site of the Walker A motif/P-loop, potentially explaining the limited catalysis observed. Comparison of Rad51 H352Y, RecA–DNA and related structures reveals that the presence of bound DNA correlates with the isomerization of a conserved cis peptide near Walker B to the trans configuration, which appears to prime the catalytic glutamate residue for ATP hydrolysis.

Isomorphous difference methods

Publisher Summary This chapter describes isomorphous difference Fourier methods and explains the way these methods are carried out and when they are applicable or can be made applicable. By these simple methods, extremely small changes in otherwise identical structures can be seen. Over the decades, these powerful methods have been largely forgotten by mainstream crystallographers. These methods are certain to be more widely practiced as macromolecular crystallography evolves from being a form of atomic-level wildlife photography to a bona fide science in which specimens are modified and characterized to test structural or biochemical hypotheses. The sensitivity of isomorphous differences to subtle structural changes and their relative insensitivity to the phase set chosen for imaging make difference maps based on the method of choice for many of the structural studies carried out subsequent to initial structure determinations. One of the great strengths of isomorphous difference Fourier maps is their insensitivity to model bias.

The same, but different

Regional trucks have a lot in common with their over-the-road siblings, but theres room to optimize and specialize.

Crystallization and preliminary X-ray analysis of bacteriophage T4 UvsY recombination mediator protein.

Bacteriophage T4 UvsY protein is considered to be the prototype of recombination mediator proteins, a class of proteins which assist in the loading of recombinases onto DNA. Wild-type and Se-substituted UvsY protein have been expressed and purified and crystallized by hanging-drop vapor diffusion. The crystals diffract to 2.4 A using in-house facilities and to 2.2 A at NSLS, Brookhaven National Laboratory. The crystals belong to space group P422, P4(2)22, P42(1)2 or P4(2)2(1)2, the ambiguity arising from pseudo-centering, with unit-cell parameters a = b = 76.93, c = 269.8 A. Previous biophysical characterization of UvsY indicates that it exists primarily as a hexamer in solution. Along with the absence of a crystallographic threefold, this suggests that the asymmetric unit of these crystals is likely to contain either three monomers, giving a solvent content of 71%, or six monomers, giving a solvent content of 41%.