Michele L. de Souza

Probing Dynamic Generation of Hot-Spots in Self-Assembled Chains of Gold Nanorods by Surface-Enhanced Raman Scattering

Further progress in the applications of self-assembled nanostructures critically depends on developing a fundamental understanding of the relation between the properties of nanoparticle ensembles and their time-dependent structural characteristics. Following dynamic generation of hot-spots in the self-assembled chains of gold nanorods, we established a direct correlation between ensemble-averaged surface-enhanced Raman scattering and extinction properties of the chains. Experimental results were supported with comprehensive finite-difference time-domain simulations. The established relationship between the structure of nanorod ensembles and their optical properties provides the basis for creating dynamic, solution-based, plasmonic platforms that can be utilized in applications ranging from sensing to nanoelectronics.

Rapid Synthesis of Hollow Ag–Au Nanodendrites in 15 Seconds by Combining Galvanic Replacement and Precursor Reduction Reactions

Metallic nanomaterials displaying hollow interiors as well as sharp tips/branches at their surface (such as hollow nanodendrites) are attractive, because these features enable higher surface-to-volume ratios than their solid and/or rounded counterparts. This paper describes a simple strategy for the synthesis of Ag-Au nanodendrites in 15 s using Ag nanospheres prepared in a previous synthetic step as seeds. Our approach was based on the utilization of Ag nanospheres as seeds for Au deposition by a combination of galvanic replacement reaction between Ag and AuCl4(-)(aq) and AuCl4(-)(aq) reduction using hydroquinone in the presence of polyvinylpyrrolidone (PVP) as a stabilizer and water as the solvent. The produced Ag-Au nanodendrites presented monodisperse sizes, and their surface morphologies could be tuned as a function of growth time. Owing to their hollow interiors and sharp tips, the Ag-Au nanodendrites performed as effective substrates for surface-enhanced Raman scattering (SERS) detection of 4-MPy (4-mercaptopyridine) and R6G (rhodamine 6G) as probe molecules. We believe that the approach described herein can serve as a protocol for the fast and one-step synthesis of Ag-Au hollow nanondendrites with a wide range of sizes, compositions, and surface morphologies for applications in SERS and catalysis.

Aplicação de espectroscopias raman e infravermelho na identificação e quantificação de plastificantes em filmes comerciais de PVC esticável

This paper reports the use of Raman and infrared techniques for the qualitative and quantitative analysis of plasticizers in polyvinylchloride (PVC) commercial films. FT-Raman marker bands were indentified for di-2-ethyl-hexyl adipate (DEHA) and di-2-ethyl-hexyl phthalate (DEHP), allowing for the rapid identification of these species in the commercial film. Quantitative analysis by FT-IR resulted in plasticizers concentrations ranging from 11 to 27% (w/w). Considering the little sample preparation and the low cost of the techniques, FT-IR and FT-Raman are viable techniques for a first assessment of plasticizers in commercial samples.

Cu nanoparticles enable plasmonic-improved silicon photovoltaic devices

This work examines the effect of copper nanoparticles (Cu NPs) on the photocurrent efficiency of silicon photovoltaic (Si PV) devices. An optimized synthesis of stable Cu NPs is reported together with a procedure for their immobilization on the Si PV surface. A comprehensive analysis of the photocurrent and power dependence of the Cu NPs surface coverage and size is presented. A decrease in photoconversion was observed for wavelengths shorter than ~500 nm, due to the Cu interband absorption. In the low surface coverage limit, where the level of aggregation was found to be low, the surface plasmon resonance absorption dominates leading to a modest effect on the photocurrent response. As the number of aggregates increased with the surface coverage, the photocurrent efficiency also increased, and a maximum enhancement power conversion of 16% was found for a 54 ± 6 NPs per μm(2) PV cell. This enhancement was attributed to SPR light scattering and trapping into the Si PV device. Higher surface coverage yielded numerous aggregates which acted as a bulk coating and caused a decrease in both photocurrent and power measurements.

Localized surface plasmon resonance enhanced photocatalysis: an experimental and theoretical mechanistic investigation

Titanium dioxide (TiO2) is an advantageous material in catalytic photodegradation due to its low cost, high stability, and considerably higher efficiency when compared to other semiconductors. However, the need for artificial radiation sources in the UV range is a limitation to its use in wastewater remediation. In this context, Localized Surface Plasmon Resonance (LSPR) has been shown to enhance the photoexcitation of charge carriers in the semiconductor. In the present work, the investigation of catalytic photodegradation of phenol solution under distinct excitation by UV-visible or just visible radiation, employing three TiO2 based plasmonic catalysts, was conducted. Spherical silver nanoparticles which present LSPR along the TiO2 bandgap energy and electrically insulated silver nanoparticles were employed. Gold nanoparticles, which present low energy LSPR, were also employed in order to compare the excitation efficiency. Discrete dipole approximation simulations were carried out in order to verify the electric field enhancement and penetration at the semiconductor surface of each plasmonic catalyst. The results presented here may help to shed some light with respect to the contribution of plasmonic photocatalysts and the charge transfer mechanism in catalysts containing plasmonic structures.