Morton A. Barlaz

Present and Long-Term Composition of MSW Landfill Leachate: A Review

The major potential environmental impacts related to landfill leachate are pollution of groundwater and surface waters. Landfill leachate contains pollutants that can be categorized into four groups (dissolved organic matter, inorganic macrocomponents, heavy metals, and xenobiotic organic compounds). Existing data show high leachate concentrations of all components in the early acid phase due to strong decomposition and leaching. In the long methanogenic phase a more stable leachate, with lower concentrations and a low BOD/COD-ratio, is observed. Generally, very low concentrations of heavy metals are observed. In contrast, the concentration of ammonia does not decrease, and often constitutes a major long-term pollutant in leachate. A broad range of xenobiotic organic compounds is observed in landfill leachate. The long-term behavior of landfills with respect to changes in oxidation-reduction status is discussed based on theory and model simulations. It seems that the somewhere postulated enhanced release of accumulated heavy metals would not take place within the time frames of thousands of years. This is supported by a few laboratory investigations. The existing data and model evaluations indicate that the xenobiotic organic compounds in most cases do not constitute a major long-term problem. This may suggest that ammonia will be of most concern in the long run.

Accumulation and fragmentation of plastic debris in global environments

One of the most ubiquitous and long-lasting recent changes to the surface of our planet is the accumulation and fragmentation of plastics. Within just a few decades since mass production of plastic products commenced in the 1950s, plastic debris has accumulated in terrestrial environments, in the open ocean, on shorelines of even the most remote islands and in the deep sea. Annual clean-up operations, costing millions of pounds sterling, are now organized in many countries and on every continent. Here we document global plastics production and the accumulation of plastic waste. While plastics typically constitute approximately 10 per cent of discarded waste, they represent a much greater proportion of the debris accumulating on shorelines. Mega- and macro-plastics have accumulated in the highest densities in the Northern Hemisphere, adjacent to urban centres, in enclosed seas and at water convergences (fronts). We report lower densities on remote island shores, on the continental shelf seabed and the lowest densities (but still a documented presence) in the deep sea and Southern Ocean. The longevity of plastic is estimated to be hundreds to thousands of years, but is likely to be far longer in deep sea and non-surface polar environments. Plastic debris poses considerable threat by choking and starving wildlife, distributing non-native and potentially harmful organisms, absorbing toxic chemicals and degrading to micro-plastics that may subsequently be ingested. Well-established annual surveys on coasts and at sea have shown that trends in mega- and macro-plastic accumulation rates are no longer uniformly increasing: rather stable, increasing and decreasing trends have all been reported. The average size of plastic particles in the environment seems to be decreasing, and the abundance and global distribution of micro-plastic fragments have increased over the last few decades. However, the environmental consequences of such microscopic debris are still poorly understood.

Transport and release of chemicals from plastics to the environment and to wildlife.

Plastics debris in the marine environment, including resin pellets, fragments and microscopic plastic fragments, contain organic contaminants, including polychlorinated biphenyls (PCBs), polycyclic aromatic hydrocarbons, petroleum hydrocarbons, organochlorine pesticides (2,2′-bis(p-chlorophenyl)-1,1,1-trichloroethane, hexachlorinated hexanes), polybrominated diphenylethers, alkylphenols and bisphenol A, at concentrations from sub ng g–1 to µg g–1. Some of these compounds are added during plastics manufacture, while others adsorb from the surrounding seawater. Concentrations of hydrophobic contaminants adsorbed on plastics showed distinct spatial variations reflecting global pollution patterns. Model calculations and experimental observations consistently show that polyethylene accumulates more organic contaminants than other plastics such as polypropylene and polyvinyl chloride. Both a mathematical model using equilibrium partitioning and experimental data have demonstrated the transfer of contaminants from plastic to organisms. A feeding experiment indicated that PCBs could transfer from contaminated plastics to streaked shearwater chicks. Plasticizers, other plastics additives and constitutional monomers also present potential threats in terrestrial environments because they can leach from waste disposal sites into groundwater and/or surface waters. Leaching and degradation of plasticizers and polymers are complex phenomena dependent on environmental conditions in the landfill and the chemical properties of each additive. Bisphenol A concentrations in leachates from municipal waste disposal sites in tropical Asia ranged from sub µg l–1 to mg l–1 and were correlated with the level of economic development.

Methane production from municipal refuse: A review of enhancement techniques and microbial dynamics

Methane is recovered from about 100 municipal solid waste landfills in the U.S. in saleable volumes, although yields are 1 to 50% of the methane potential of refuse based on biodegradability data. Studies on the microbiology of refuse decomposition and efforts to enhance refuse methanogenesis are reviewed here. Results of studies on the effects of leachate recycle and neutralization, a reduction in refuse particle size, the addition of anaerobic sewage sludge or old refuse as a seed, nutrient addition, calcium carbonate addition, and moisture on methane production are examined in consideration of new findings on landfill microbiology. A four‐phase description of refuse decomposition with leachate recycle, including an aerobic phase, an anaerobic acid phase, an accelerated methane production phase, and a decelerated methane production phase, is proposed. Mass balances and pumping tests may be used to estimate the methane potential of a sanitary landfill. The use of empirical, zero, and first‐order models t...

Occurrence and Treatment of 1,4-Dioxane in Aqueous Environments

1,4-Dioxane is classified as a probable human carcinogen. It is used as a stabilizer for chlorinated solvents, particularly, 1,1,1-trichloroethane (TCA), and it is formed as a by-product during the manufacture of polyester and various polyethoxylated compounds. Improper disposal of industrial waste and accidental solvent spills have resulted in the contamination of groundwater with 1,4-dioxane. Volatilization and sorption are not significant attenuation mechanisms due to 1,4-dioxanes complete miscibility with water. At present, advanced oxidation processes (AOPs) are the only proven technology for 1,4-dioxane treatment. 1,4-Dioxane was believed to be very resistant to both abiotic and biologically mediated degradation due to its heterocyclic structure with two ether linkages. However, recent studies have shown that 1,4-dioxane can be biodegraded as a sole carbon and energy source, and that cost-effective biological treatment processes can be developed. Future work should be oriented towards the developme...

Models for waste life cycle assessment : Review of technical assumptions

A number of waste life cycle assessment (LCA) models have been gradually developed since the early 1990 s, in a number of countries, usually independently from each other. Large discrepancies in results have been observed among different waste LCA models, although it has also been shown that results from different LCA studies can be consistent. This paper is an attempt to identify, review and analyse methodologies and technical assumptions used in various parts of selected waste LCA models. Several criteria were identified, which could have significant impacts on the results, such as the functional unit, system boundaries, waste composition and energy modelling. The modelling assumptions of waste management processes, ranging from collection, transportation, intermediate facilities, recycling, thermal treatment, biological treatment, and landfilling, are obviously critical when comparing waste LCA models. This review infers that some of the differences in waste LCA models are inherent to the time they were developed. It is expected that models developed later, benefit from past modelling assumptions and knowledge and issues. Models developed in different countries furthermore rely on geographic specificities that have an impact on the results of waste LCA models. The review concludes that more effort should be employed to harmonise and validate non-geographic assumptions to strengthen waste LCA modelling.

Nitrogen management in bioreactor landfills

One scenario for long-term nitrogen management in landfills is ex situ nitrification followed by denitrification in the landfill. The objective of this research was to measure the denitrification potential of actively decomposing and well decomposed refuse. A series of 10-l reactors that were actively producing methane were fed 400 mg NO3-N /l every 48 h for periods of 19-59 days. Up to 29 nitrate additions were either completely or largely depleted within 48 h of addition and the denitrification reactions did not adversely affect the leachate pH. Nitrate did inhibit methane production, but the reactors recovered their methane-producing activity with the termination of nitrate addition. In well decomposed refuse, the nitrate consumption rate was reduced but was easily stimulated by the addition of either acetate or an overlayer of fresh refuse. Addition of acetate at five times the amount required to reduce nitrate did not lead to the production of NH4+ by dissimilatory nitrate reduction. The most probable number of denitrifying bacteria decreased by about five orders of magnitude during refuse decomposition in a reactor that did not receive nitrate. However, rapid denitrification commenced immediately with nitrate addition. This study shows that the use of a landfill as a bioreactor for the conversion of nitrate to a harmless byproduct, nitrogen gas, is technically viable.

A review of approaches for the long-term management of municipal solid waste landfills

After closure, municipal solid waste (MSW) landfills must be managed and controlled to avoid adverse effects on human health and the environment (HHE). Aftercare (or post-closure care) can be brought to an end when the authorities consider the landfill to no longer pose a threat to HHE. Different approaches have been suggested for long-term landfill management and evaluation of aftercare completion. In this paper, research on aftercare and its completion is analyzed and regulatory approaches for the completion of landfill aftercare are reviewed. Approaches to aftercare could be categorized as (i) target values, (ii) impact/risk assessment, and (iii) performance based. Comparison of these approaches illustrates that each has limitations and strengths. While target values are typically used as screening indicators to be complemented with site-specific assessments, impact/risk assessment approaches address the core issue about aftercare completion, but face large uncertainties and require a high level of expertise. A performance-based approach allows for the combination of target values and impact/risk assessments in a consistent evaluation framework with the aim of sequentially reducing aftercare intensity and, ultimately, leading to the completion of aftercare. At a regulatory level, simple qualitative criteria are typically used as the primary basis for defining completion of aftercare, most likely due to the complexity of developing rigorous evaluation methodologies. This paper argues that development of transparent and consistent regulatory procedures represents the basis for defining the desired state of a landfill at the end of aftercare and for reducing uncertainty about the intensity and duration of aftercare. In this context, recently presented technical guidelines and the ongoing debate with respect to their regulatory acceptance are a valuable step towards developing strategies for the cost-effective protection of HHE at closed MSW landfills. To assess the practicality of evaluation methodologies for aftercare, well-documented case studies including regulatory review and acceptance are needed.

A Review of Chemical Warfare Agent Simulants for the Study of Environmental Behavior

There is renewed interest in the environmental fate of chemical warfare agents attributable to the intensified threat of chemical weapons use in a terrorist attack. Knowledge of processes that influence the fate of agents such as distilled mustard, lewisite, tabun, sarin, soman, and VX in the environment is important for development of disposal strategies and for risk and exposure assessments. However, it is often necessary to conduct studies examining chemical agent behavior using simulants due to the toxicity of the agents and usage restrictions. The objective of this study was to review the physical–chemical properties and mammalian toxicity of compounds that can be used to simulate chemical agents and to identify the most appropriate compounds to simulate specific environmental fate processes, including hydrolysis, sorption, bioavailability, and volatilization.

Composition of Municipal Solid Waste in the United States and Implications for Carbon Sequestration and Methane Yield

Eleven statewide waste characterization studies were compared to assess variation in the quantity and composition of waste after separation of recyclable and compostable materials, i.e., discarded waste. These data were also used to assess the impact of varying composition on sequestered carbon and methane yield. Inconsistencies in the designation of waste component categories and definitions were the primary differences between study methodologies; however, sampling methodologies were consistent with recommended protocols. The average municipal solid waste (MSW) discard rate based on the statewide studies was 1.90 kg MSW  person−1 day−1 , which was within the range of two national estimates: 2.35 and 1.46 kg MSW  person−1 day−1 . Dominant components in MSW discards were similar between studies. Organics (food waste, yard trimmings), paper, and plastic components averaged 23.6±4.9% , 28.5±6.5% , and 10.6±3.0% of discarded MSW, respectively. Construction and demolition (C&D) waste was 20.2±9.7% of tota...