Olivier Balmes

Modeling proton binding at the goethite (α-FeOOH)–water interface

The basic charging behaviours of goethite particles with different surfaces area (23, 37 and 85 m2 g-1) in 0.003-2.0 M NaNO3 were interpreted using surface complexation theory with the basic Stern ...

Novel, Spongelike Ruthenium Particles of Controllable Size Stabilized Only by Organic Solvents

Soluble ruthenium nanoparticles of uniform size (see picture) with a porous spongelike structure were obtained by the reaction of [Ru(C(8)H(10))(C(8)H(12))] with H(2) in methanol or THF/methanol. The particle size can be controlled in the range 15-100 nm by varying the MeOH/THF ratio. The particles catalyze benzene hydrogenation without modification of their size or structure. Their formation is proposed to occur in the droplets of a nanosized emulsion, which act as nanoreactors.

Tracking the shape-dependent sintering of platinum-rhodium model catalysts under operando conditions.

Nanoparticle sintering during catalytic reactions is a major cause for catalyst deactivation. Understanding its atomic-scale processes and finding strategies to reduce it is of paramount scientific and economic interest. Here, we report on the composition-dependent three-dimensional restructuring of epitaxial platinum–rhodium alloy nanoparticles on alumina during carbon monoxide oxidation at 550u2009K and near-atmospheric pressures employing in situ high-energy grazing incidence x-ray diffraction, online mass spectrometry and a combinatorial sample design. For platinum-rich particles our results disclose a dramatic reaction-induced height increase, accompanied by a corresponding reduction of the total particle surface coverage. We find this restructuring to be progressively reduced for particles with increasing rhodium composition. We explain our observations by a carbon monoxide oxidation promoted non-classical Ostwald ripening process during which smaller particles are destabilized by the heat of reaction. Its driving force lies in the initial particle shape which features for platinum-rich particles a kinetically stabilized, low aspect ratio.

Imaging Atomic Structure in Metal Nanoparticles Using High-Resolution Cryo-TEM

It has been shown, by imaging gold (200) planes, that it is possible to achieve better than 0.20-nm structural resolution in cryo-transmission electron microscopy (cryo-TEM). This has been done using commercially available cryo equipment and using a 300-kV field emission gun (FEG) TEM. The images of 15-nm gold particles embedded in amorphous frozen water clearly show the (111) planes (separated by 0.235 nm) in gold. Fourier transform demonstrates the presence of (200) planes in the image, proving a resolution of better than 0.20 nm. The experimental results are supported by image simulations using the multislice method. These simulations suggest that it should be possible to achieve the same resolution even in smaller particles and particles of lighter elements. The crucial experimental problem to overcome is keeping the thickness of the amorphous film low and to work at low electron dose conditions.

Self-healing and self-organized gold nanoparticle films at a water/organic solvent interface.

A self-assembled biomolecule was used to create a highly sensitive sensor surface for detecting toxic chemical species (polychlorinated biphenyls, PCBs). We fabricated the nanostructured sensor surface via the self-assembly of cytochrome c on a Au thin film. Surface plasmon resonance (SPR), an evanescent wave technique possessing maximum sensitivity on the surface and characterized by an exponential decay of sensitivity with distance from the surface, was utilized as the principle for signal transduction. When this sensor surface was used for the detection of PCB, even trace amounts of PCB (from 0.1 ppb to 8.0 ppb) in an aqueous solution were readily detectable.

A New View on Chemistry of Solids in Solution‐Cryo Energy‐Filtered Transmission Electron Microscopy (Cryo‐EFTEM) Imaging of Aggregating Palladium Colloids in Vitreous Ice

It is shown that by using cryo-transmission electron microscopy (cryo-TEM) it is possible to image the aggregation behaviour of nanoparticles while they are still in solution. This technique has allowed the study of the arrangement of colloidal palladium particles in solution by preparing the specimen by the plunge-freezing technique. This method of rapidly cooling the specimen avoids rearrangement of the particles during specimen preparation. The palladium particles were identified by energy-filtered cryo-TEM. The aggregation of particles in solution was studied as a function of pH and ionic strength. The results can be used as recommendations for colloidal solutions intended for deposition of single particles.

A new potassium-based intermediate and its role in the desorption properties of the K–Mg–N–H system

New insights into the reaction pathways of different potassium/magnesium amide-hydride based systems are discussed. In situ SR-PXD experiments were for the first time performed in order to reveal the evolution of the phases connected with the hydrogen releasing processes. Evidence of a new K-N-H intermediate is shown and discussed with particular focus on structural modification. Based on these results, a new reaction mechanism of amide-hydride anionic exchange is proposed.

In-situ Synchrotron X-ray Diffraction Analysis of the Setting Process of Brushite Cement: Reaction and Crystal Growth

Brushite cements are fast self-setting materials that can be used as bone substitute materials. Although tracing their fast setting process is a challenge, it is important for the understanding of the same, which in turn is important for the materials further development and use in the clinics. In this study, the setting rate, phase formation, and crystal growth of brushite cements were quantitatively studied by in situ synchrotron powder X-ray diffraction (SXRD) on a time scale of seconds. The influence of reactant ratios and a retardant (citric acid) on the setting reaction were analyzed. To complement the in situ investigations, scanning electron microscopy was carried out for ex situ morphological evolution of crystals. The initial reaction followed a four-step process, including a fast nucleation induction period, nucleation, crystal growth, and completion of the setting. The brushite crystal size grew up to the micro scale within 1 min, and the brushite content increased linearly after the nucleation until all monocalcium phosphate monohydrate (MCPM; Ca(H2PO4)2·H2O) had dissolved within minutes, followed by a slow increase until the end of the monitoring. By adjusting the MCPM to the β-tricalcium phosphate (β-TCP, β-Ca3(PO4)2) ratio in the starting powders, the brushite/monetite ratio in the cements could be modified. In the presence of citric acid, the formation of brushite nuclei was not significantly retarded, whereas the increase in brushite content and the growth of crystal size were effectively hindered. The amount of monetite also increased by adding citric acid. This is the first time that the brushite setting process has been characterized in the first seconds and minutes of the reaction by SXRD.

In situ observation of synthesized nanoparticles in ultra-dilute aerosols via X-ray scattering

In-air epitaxy of nanostructures (Aerotaxy) has recently emerged as a viable route for fast, large-scale production. In this study, we use small-angle X-ray scattering to perform direct in-flight characterizations of the first step of this process, i.e., the engineered formation of Au and Pt aerosol nanoparticles by spark generation in a flow of N2 gas. This represents a particular challenge for characterization because the particle density can be extremely low in controlled production. The particles produced are examined during production at operational pressures close to atmospheric conditions and exhibit a lognormal size distribution ranging from 5–100 nm. The Au and Pt particle production and detection are compared. We observe and characterize the nanoparticles at different stages of synthesis and extract the corresponding dominant physical properties, including the average particle diameter and sphericity, as influenced by particle sintering and the presence of aggregates. We observe highly sorted and sintered spherical Au nanoparticles at ultra-dilute concentrations (< 5 × 105 particles/cm3) corresponding to a volume fraction below 3 × 10–10, which is orders of magnitude below that of previously measured aerosols. We independently confirm an average particle radius of 25 nm via Guinier and Kratky plot analysis. Our study indicates that with high-intensity synchrotron beams and careful consideration of background removal, size and shape information can be obtained for extremely low particle concentrations with industrially relevant narrow size distributions.