Patricia Plaza-Bolaños

Polycyclic aromatic hydrocarbons in food and beverages. Analytical methods and trends

Polycyclic aromatic hydrocarbons (PAHs) are compounds widespread in the environment, many of them showing carcinogenic effects. These compounds can reach the food chain by different ways and, therefore, the analysis of PAHs in food is a matter of concern. This article reviews the extraction methodologies together with the separation and detection techniques which are currently applied in the determination of PAHs in food and beverages. Specific extraction conditions, performance characteristics, chromatographic and detection parameters are discussed. A review of the occurrence of these compounds in the matrixes under study is also provided.

Comprehensive qualitative and quantitative determination of pesticides and veterinary drugs in honey using liquid chromatography-Orbitrap high resolution mass spectrometry.

A database has been created for the simultaneous analysis of more than 350 pesticides and veterinary drugs (including antibiotics) using ultra-high performance liquid chromatography coupled to high resolution Orbitrap mass spectrometry (UHPLC-Orbitrap-MS). This is a comprehensive exact mass database built using the Exactive-Orbitrap analyzer. The developed database includes exact masses of the target ions and retention time data, and allows the automatic search of the included compounds. Generic chromatographic and MS conditions have been applied. The presented database is suitable for qualitative analysis, and it was also evaluated for quantitative purposes in routine analysis, after the optimization and validation of a generic extraction method in honey samples. Adequate recovery and precision values for most of the studied analytes were obtained and the limits of detection (LOD) ranged from 1 to 50 μg kg(-1). For pesticides, LODs were always lower than the MRLs established by European Union in honey, except for a few compounds. This method was applied to the analysis of 26 real honey samples and some pesticides (azoxystrobin, coumaphos, dimethoate and thiacloprid) were detected in 4 samples. Azoxystrobin and coumaphos were determined in two different samples (organic honey) at 1.5 μg kg(-1) and 5.1 μg kg(-1). Veterinary drugs were not detected in the analyzed samples.

Determination of pesticide transformation products: a review of extraction and detection methods.

Pesticides are widely applied and they can produce a variety of transformation products (TPs), through different pathways and mechanisms. Nowadays there is a growing interest related to the determination of pesticide TPs in several matrices (environmental, food and biological samples), due to these compounds can be more toxic and persistent than parent compounds, and some of them can be used as markers of exposure to different pesticides. Although solid-phase extraction (SPE) is mainly used for the extraction of TPs, alternative techniques such as solid-phase microextraction (SPME) and liquid-phase extraction (LPE) can be used. These TPs are mainly determined by liquid chromatography (LC) due to the recent developments in this technique, especially when it is coupled to mass spectrometry (MS) detectors, allowing the determination of known and/or unknown TPs. Furthermore, MS is a very valuable tool for the structural elucidation of unknown TPs. This review discusses all phases of analytical procedure, including sample treatment and analysis, indicating the main problems related to the extraction of TPs from several matrices due to their high polarity, as well as the different alternatives found for the simultaneous determination of parent compounds and TPs, using chromatographic techniques coupled to MS detection.

Application of a quick, easy, cheap, effective, rugged and safe-based method for the simultaneous extraction of chlorophenols, alkylphenols, nitrophenols and cresols in agricultural soils, analyzed by using gas chromatography-triple quadrupole-mass spectrometry/mass spectrometry.

Due to the different physico-chemical properties of phenols, the development of a methodology for the simultaneous extraction and determination of phenolic compounds belonging to several families, such as chlorophenols (CPs), alkylphenols (APs), nitrophenols (NTPs) and cresols is difficult. This study shows the development and validation of a method for the analysis of 13 phenolic compounds (including CPs, APs, NTPs and cresols) in agricultural soils. For this purpose, a quick, easy, cheap, effective, rugged and safe (QuEChERS)-based procedure was developed, validated and applied to the analysis of real samples. A derivatization step prior to the final determination by gas chromatography (GC) coupled to a triple quadrupole analyzer operating in tandem mass spectrometry (QqQ-MS/MS) was performed by using acetic acid anhydride (AAA) and pyridine (Py). The optimized procedure was validated, obtaining average extraction recoveries in the range 69-103% (10microgkg(-1)), 65-98% (50microgkg(-1)), 76-112% (100microgkg(-1)) and 76-112% (300microgkg(-1)), with precision values (expressed as relative standard deviation, RSD)< or =22% (except for 4-chlorophenol) involving intra-day and inter-day studies. Furthermore, 15 real soil samples were analyzed by the proposed method in order to assess its applicability. Some phenolic compounds (e.g. 2,4,6-trichlorophenol or 4-tert-octylphenol) were found in the samples at trace levels (<10microgkg(-1)).

Simultaneous analysis of chlorophenols, alkylphenols, nitrophenols and cresols in wastewater effluents, using solid phase extraction and further determination by gas chromatography-tandem mass spectrometry.

An analytical methodology has been developed for the simultaneous extraction of 13 phenolic compounds, including chlorophenols (CPs), nitrophenols (NTPs), cresols and alkylphenols (APs) in different types of wastewater (WW) effluents. A solid-phase extraction (SPE) method has been optimized prior to the determination by gas chromatography coupled to triple quadrupole tandem mass spectrometry (GC-QqQ-MS/MS). Due to the complexity of the matrix, a comparison study of matrix-matched-calibration (MMC) and standard addition calibration (SAC) was carried out for quantification purposes. The optimized procedure was validated using the SAC approach since it provided the most adequate quantification results (in terms of recovery and precision values). Recoveries were in the range 60-135% (0.5 μg L(-1)), 70-115% (1 μg L(-1)), and 78-120% (5 μg L(-1)), with precision values (expressed as relative standard deviation, RSD) ≤ 30% (except for 2-nitrophenol) involving intra-day and inter-day precision studies. Limits of detection (LODs) and quantification (LOQs) were also evaluated, and LOQs ranged from 0.03 μg L(-1) to 2.5 μg L(-1). The proposed method was applied to the analysis of 8 real WW effluent samples, finding some phenolic compounds (e.g. 2-chlorophenol, 2,4,6-trichlorophenol and 4-tert-octylphenol) at concentrations higher than the established LOQs.

Comprehensive analysis of polycyclic aromatic hydrocarbons in wastewater using stir bar sorptive extraction and gas chromatography coupled to tandem mass spectrometry

The objective of this study was the optimization and comparison of two extraction methods for the determination of polycyclic aromatic hydrocarbons (PAHs) in wastewater (WW). A distribution study of the target compounds between the aqueous phase and the suspended particulate matter (SPM) has been performed in order to establish whether the analysis of both phases is necessary. In this sense, the feasibility of stir bar sorptive extraction (SBSE) and solid-phase extraction (SPE) for the determination of 24 PAHs in WW samples has been evaluated. The results demonstrated the suitability of SBSE to perform a comprehensive analysis of liquid samples containing high amounts of SPM, such as in the determination of PAHs in WWs. A gas chromatography triple quadrupole mass spectrometry (GC-QqQ-MS/MS) method has been also optimized for the separation and detection of the target compounds, avoiding the co-elution of some groups of isomers, such as benzo[b], [j] and [k] fluoranthenes and indene[1,2,3-cd]pyrene/dibenz[a,h]anthracene. For that purpose, a specific capillary column developed for PAH determination was used. The SBSE procedure was validated and adequate parameters (such as recovery, linearity, precision, limits of detection and quantification) were obtained. Finally, the validated method was applied to the analysis of real samples collected from an experimental WW treatment plant, detecting some PAHs at concentrations in the range 0.007-0.022 μg L(-1).

Food contaminant analysis at high resolution mass spectrometry: Application for the determination of veterinary drugs in milk

Veterinary drugs (VDs) can remain in milk as a consequence of their use in livestock. In order to control the levels of VD residues in milk, screening methodologies can be applied for a rapid discrimination among negative and non-negative samples. In a second stage, non-negative samples are classified as negative or positive samples by using a confirmation method. Pre-target screening methods in low resolution MS (LRMS) are normally applied, but the number of analytes is limited, whereas the information obtained by full scan acquisition in high resolution mass spectrometry (HRMS) is improved. Here, three screening methods (running time<4 min) based on Orbitrap, quadrupole-time of flight (QqTOF) and triple quadrupole (QqQ) have been compared, using in all cases ultra-high performance liquid chromatography (UHPLC). For HRMS, the identification of the VDs was based on retention time (RT) and accurate mass measurements. Confirmation was based on the monitoring of fragments generated without precursor selection. The performance characteristics of the screening method provided reliable information regarding the presence or absence of the compounds below an established value, including uncertainty region and cut-off values. Better results in terms of cut-off values (≤ 5.0 μg kg(-1), except for spiramycin with a cut-off of 13.4 μg kg(-1) for milk samples and 43.1 μg kg(-1) for powdered milk based, emamectin with a cut-off of 42.2 μg kg(-1) for milk samples and doxycycline, with a cut-off value of 15.8 μg kg(-1) in powdered milk-based infant formulae) and uncertainty region were obtained using the Orbitrap-based screening method, which was submitted to further validation and used to analyze different real milk samples. The proposed method can be used in routine analysis, providing reliable results.

Comparison of tandem-in-space and tandem-in-time mass spectrometry in gas chromatography determination of pesticides: application to simple and complex food samples.

Gas chromatography coupled to tandem mass spectrometry (GC-MS/MS) is one of the most powerful techniques in pesticide residue analysis. MS/MS can be conceived in two ways: tandem in space (e.g. triple quadrupole, QqQ) or in time (e.g. ion trap, IT). QqQ and IT are commonly interfaced to GC; however, there has not been any direct comparison between them in pesticide residue analysis so far. In the present work, the performance of GC coupled to these two analyzers (GC-QqQ-MS/MS and GC-IT-MS/MS) was studied and compared for pesticide residue analysis as well as its application in food analysis. The large volume injection (LVI) technique together with programmed-temperature vaporization (PTV) was applied. For this purpose, 19 pesticides, including organochlorine and organophophorus pesticides and pyrethroids, were analyzed in both systems. Mass spectrometric data, performance characteristics (linearity, intra-day and inter-day precision) and the influence of the matrix nature on the analysis of low concentrations were compared. The target compounds were analyzed in solvent and in two representative food matrices such as cucumber (high water content) and egg (high fat content). MS data and intra-day precision were similar in QqQ and IT, whereas inter-day precision was significantly worse in QqQ. Linearity (expressed as determination coefficient, R(2)) in the range 10-150 microg L(-1) was adequate in both systems; however, better R(2) values were obtained with the QqQ analyzer in high and low concentration ranges (1-50 and 1-750 microg L(-1), respectively). The influence of the matrix nature on the analysis of low concentrations of each analyzer was also evaluated. The QqQ and IT performance was similar in cucumber and solvent. However, QqQ provided better sensitivity in egg working in selected reaction monitoring (SRM).

Analysis and study of the distribution of polar and non-polar pesticides in wastewater effluents from modern and conventional treatments.

The analysis of a wide range of pesticides in wastewaters (WWs) undergoing different treatments (both modern and conventional) has been studied. The need for optimizing specific extraction methods for each WW effluent based on their physico-chemical characteristics has been considered. A distribution study was performed to establish if the filtration step before extraction is a correct procedure since pesticides can be more prone to be in the aqueous or the solid phase, depending on their hydrophobicity. This evaluation demonstrated that pesticides are distributed between the aqueous phase and the suspended particulate matter (SPM; e.g. pyrethroids are only found in the SPM). The proposed methodologies involved the determination of 39 polar and 139 non-polar pesticides using solid-phase extraction (SPE) and pressurized-liquid extraction (PLE) for the extraction of the aqueous phase and the SPM, respectively. Ultra high pressure liquid chromatography and gas chromatography coupled to tandem mass spectrometry (UHPLC-MS/MS, GC-MS/MS) were used in the determination stage. WW samples from four different technologies were evaluated: membrane bioreactor, extended aeration, maturation pond and anaerobic pond. Validation data for the four effluents studied were generated, obtaining adequate precision values (estimated as % relative standard deviation, RSD) in almost all cases (<25%). The methods showed limits of detection at 0.01-0.20μgL(-1) and limits of quantification from 0.02 to 0.50μgL(-1). The proposed methods were applied to the analysis of real samples collected from an experimental WW treatment plant, detecting non-polar and polar pesticides at concentrations in the range 0.02-1.94μgL(-1) and 0.02-0.33μgL(-1), respectively.

Wide‐scope analysis of pesticide and veterinary drug residues in meat matrices by high resolution MS: detection and identification using Exactive‐Orbitrap

A multiresidue and multiclass method for the simultaneous determination of more than 350 compounds including pesticides, biopesticides and veterinary drugs in different meat matrices (beef, pork and chicken) by ultra-high performance liquid chromatography coupled to Orbitrap MS has been developed. In the present study, the determination of fragments was accomplished as an essential tool for a reliable identification of compounds using high resolution MS. To obtain these fragments, different strategies have been carried out in order to ensure an appropriate fragment assignment and identification. The analytical method is suitable for qualitative analysis, and it was also evaluated for quantitative analysis. Generic extraction conditions were optimized, obtaining adequate recovery and precision values for most of the studied analytes (>290). The limits of detection ranged from 2 to 16 µg kg(-1). Limits of quantification were 10 µg kg(-1) with the exception of few compounds with a higher value (50 or 100 µg kg(-1)). Limits of identification were also established, and they ranged from 2 to 150 µg kg(-1). This method was applied to the analysis of 18 meat samples and some veterinary drugs as enrofloxacin and sulfadiazine were detected and further identified/quantified (with triple quadrupole) in two different samples at 33 µg kg(-1) and trace levels, respectively. No pesticides were detected in the analyzed samples.