Ramon Villarino

ANALYSIS OF VITAL SIGNS MONITORING USING AN IR-UWB RADAR

Ultra-wide Band (UWB) technology is a new, useful and safe technology in the fleld of wireless body networks. This paper focuses on the feasibility of estimating vital signs | speciflcally breathing rate and heartbeat frequency | from the spectrum of recorded waveforms, using an impulse-radio (IR) UWB radar. To this end, an analytical model is developed to perform and interpret the spectral analysis. Both the harmonics and the intermodulation between respiration and heart signals are addressed. Simulations have been performed to demonstrate how they afiect the detection of vital signs and also to analyze the in∞uence of the pulse waveform. A fllter to cancel out breathing harmonics is also proposed to improve heart rate detection. The results of the experiments are presented under difierent scenarios which demonstrate the accuracy of the proposed technique for determining respiration and heartbeat rates. It has been shown that an IR-UWB radar can meet the requirements of typical biomedical applications such as non-invasive heart and respiration rate monitoring.

The WISE 2000 and 2001 field experiments in support of the SMOS mission: sea surface L-band brightness temperature observations and their application to sea surface salinity retrieval

Soil Moisture and Ocean Salinity (SMOS) is an Earth Explorer Opportunity Mission from the European Space Agency with a launch date in 2007. Its goal is to produce global maps of soil moisture and ocean salinity variables for climatic studies using a new dual-polarization L-band (1400-1427 MHz) radiometer Microwave Imaging Radiometer by Aperture Synthesis (MIRAS). SMOS will have multiangular observation capability and can be optionally operated in full-polarimetric mode. At this frequency the sensitivity of the brightness temperature (T/sub B/) to the sea surface salinity (SSS) is low: 0.5 K/psu for a sea surface temperature (SST) of 20/spl deg/C, decreasing to 0.25 K/psu for a SST of 0/spl deg/C. Since other variables than SSS influence the T/sub B/ signal (sea surface temperature, surface roughness and foam), the accuracy of the SSS measurement will degrade unless these effects are properly accounted for. The main objective of the ESA-sponsored Wind and Salinity Experiment (WISE) field experiments has been the improvement of our understanding of the sea state effects on T/sub B/ at different incidence angles and polarizations. This understanding will help to develop and improve sea surface emissivity models to be used in the SMOS SSS retrieval algorithms. This paper summarizes the main results of the WISE field experiments on sea surface emissivity at L-band and its application to a performance study of multiangular sea surface salinity retrieval algorithms. The processing of the data reveals a sensitivity of T/sub B/ to wind speed extrapolated at nadir of /spl sim/0.23-0.25 K/(m/s), increasing at horizontal (H) polarization up to /spl sim/0.5 K/(m/s), and decreasing at vertical (V) polarization down to /spl sim/-0.2 K/(m/s) at 65/spl deg/ incidence angle. The sensitivity of T/sub B/ to significant wave height extrapolated to nadir is /spl sim/1 K/m, increasing at H-polarization up to /spl sim/1.5 K/m, and decreasing at V-polarization down to -0.5 K/m at 65/spl deg/. A modulation of the instantaneous brightness temperature T/sub B/(t) is found to be correlated with the measured sea surface slope spectra. Peaks in T/sub B/(t) are due to foam, which has allowed estimates of the foam brightness temperature and, taking into account the fractional foam coverage, the foam impact on the sea surface brightness temperature. It is suspected that a small azimuthal modulation /spl sim/0.2-0.3 K exists for low to moderate wind speeds. However, much larger values (4-5 K peak-to-peak) were registered during a strong storm, which could be due to increased foam. These sensitivities are satisfactorily compared to numerical models, and multiangular T/sub B/ data have been successfully used to retrieve sea surface salinity.

Passive Wireless Temperature Sensor Based on Time-Coded UWB Chipless RFID Tags

In this paper, an RF identification sensor system is developed. It comprises passive sensors and an ultra-wideband (UWB) reader. The sensors are based on time-coded chipless tags. They consist of an UWB antenna connected to a delay line that is, in turn, loaded with a resistive temperature sensor. This sensor modulates the amplitude of the backscattered signals as a function of the temperature. The sensor tags are identified by changing the length of the delay line. In this paper, the operation principle and design of time-coded tags is presented and the integration of sensors in these tags is addressed. In addition, two measurement techniques are compared to implement the UWB reader. The first one is based on frequency sweeping and uses a vector network analyzer. The second one is based on a low-cost UWB radar. A full characterization of the sensor system is provided.

The emissivity of foam-covered water surface at L-band: theoretical modeling and experimental results from the FROG 2003 field experiment

Sea surface salinity can be measured by microwave radiometry at L-band (1400-1427 MHz). This frequency is a compromise between sensitivity to the salinity, small atmospheric perturbation, and reasonable pixel resolution. The description of the ocean emission depends on two main factors: (1) the sea water permittivity, which is a function of salinity, temperature, and frequency, and (2) the sea surface state, which depends on the wind-induced wave spectrum, swell, and rain-induced roughness spectrum, and by the foam coverage and its emissivity. This study presents a simplified two-layer emission model for foam-covered water and the results of a controlled experiment to measure the foam emissivity as a function of salinity, foam thickness, incidence angle, and polarization. Experimental results are presented, and then compared to the two-layer foam emission model with the measured foam parameters used as input model parameters. At 37 psu salt water the foam-induced emissivity increase is /spl sim/0.007 per millimeter of foam thickness (extrapolated to nadir), increasing with increasing incidence angles at vertical polarization, and decreasing with increasing incidence angles at horizontal polarization.

Wavelet-Based Breast Tumor Localization Technique Using a UWB Radar

This paper deals with the potential of ultra-wideband (UWB) microwave imaging for the detection and localization of breast cancer in its early stages. A method is proposed for locating tumors which is based on the signal time-of-∞ight backscattered by the tumor. Time-of-∞ight is detected using a wavelet transform algorithm. The feasibility of the method has been investigated by means of simulated results using Finite-Difierence Time-Domain (FDTD) and experimental results with a UWB radar and a phantom.

Sea surface emissivity observations at L-band: first results of the Wind and Salinity Experiment WISE 2000

Sea surface salinity can be measured by passive microwave remote sensing at L-band. In May 1999, the European Space Agency (ESA) selected the Soil Moisture and Ocean Salinity (SMOS) Earth Explorer Opportunity Mission to provide global coverage of soil moisture and ocean salinity. To determine the effect of wind on the sea surface emissivity, ESA sponsored the Wind and Salinity Experiment (WISE 2000). This paper describes the field campaign, the measurements acquired with emphasis in the radiometric measurements at L-band, their comparison with numerical models, and the implications for the remote sensing of sea salinity.

Frequency-Coded Chipless RFID Tag Based on Dual-Band Resonators

The integration of dual-band resonators in frequency-coded chipless RFID tags is proposed in this letter. It is demonstrated that 3N words can be coded in a tag when using N stub-loaded dual-band resonators. It is also shown that an operation bandwidth improvement is achieved in comparison to the use of conventional half-wavelength resonators. A theoretical analysis of the resonator is provided, and a four-resonator tag is designed, manufactured, and measured as a proof of concept. Two processing techniques are used to improve detection and increase the read range: calibration and time gating.

Techniques for Clutter Suppression in the Presence of Body Movements during the Detection of Respiratory Activity through UWB Radars

This paper focuses on the feasibility of tracking the chest wall movement of a human subject during respiration from the waveforms recorded using an impulse-radio (IR) ultra-wideband radar. The paper describes the signal processing to estimate sleep apnea detection and breathing rate. Some techniques to solve several problems in these types of measurements, such as the clutter suppression, body movement and body orientation detection are described. Clutter suppression is achieved using a moving averaging filter to dynamically estimate it. The artifacts caused by body movements are removed using a threshold method before analyzing the breathing signal. The motion is detected using the time delay that maximizes the received signal after a clutter removing algorithm is applied. The periods in which the standard deviations of the time delay exceed a threshold are considered macro-movements and they are neglected. The sleep apnea intervals are detected when the breathing signal is below a threshold. The breathing rate is determined from the robust spectrum estimation based on Lomb periodogram algorithm. On the other hand the breathing signal amplitude depends on the body orientation respect to the antennas, and this could be a problem. In this case, in order to maximize the signal-to-noise ratio, multiple sensors are proposed to ensure that the backscattered signal can be detected by at least one sensor, regardless of the direction the human subject is facing. The feasibility of the system is compared with signals recorded by a microphone.

SIMULATED AND EXPERIMENTAL INVESTIGATION OF MICROWAVE IMAGING USING UWB

Microwave breast tumour detection is a non-invasive technique that uses non ionizing radiation. Microwave imaging has the potential to achieve early detection of breast cancer due to the high speciflcity and the large difierence in electrical properties of the malignant tissue when compared to normal breast tissue. This paper studies the feasibility of using UWB signals for breast imaging. Simulated results using Finite-Difierence Time-Domain (FDTD) Method will be presented. A sensibility study of the variations in the breast relative dielectric permittivity and of the variations of the skin-surface contour is also provided. A working prototype for microwave imaging is developed using a conventional Vector Network Analyzer (VNA) with the time processing capability.

Effects of Interferences in UHF RFID Systems

The Radio Frequency Identiflcation (RFID) applications are growing rapidly, especially in the UHF frequency band that is being used in inventory management. Passive UHF tags are preferred for these applications. In this paper, RFID reader-to-reader interference is analyzed. A model to estimate the minimum distance between readers to achieve a desired probability of detection in real multipath environments is derived and compared to the ideal case (AWGN channel). Diversity techniques to combat multipath and interference efiects are proposed and studied.