Rémy Bayard

Phase partition of organic pollutants between coal tar and water under variable experimental conditions.

On some abandoned manufactured-gas plant sites the presence of a particular non-aqueous phase liquid (NAPL), namely coal tar, represents a potential source of groundwater pollution. The aim of this study was to characterise the phase partition of aromatic pollutants between coal tar and water. Batch trials have been carried out in order to evaluate the state of phase partition equilibrium of pollutants between coal tar and water, under variable experimental conditions (temperature, pH, ionic strength, coal tar composition). The experimental results clearly show that coal tar cannot be considered as an ideal solution with regards to phase partition of pollutants with water. The main identified mechanisms of phase partition are the quasi instantaneous solubilization of pollutants near the coal tar/water interphase, and the diffusion of pollutants within the organic phase or at the interphase which controls the transfer kinetics of pollutants towards the aqueous phase. The dissolution kinetics experimentally observed were therefore correlated to a diffusional model of mass transfer. The formation of a film which increased resistance to mass transfer was also observed at the coal tar/water interphase. This ageing phenomenon of the coal tar/water interphase was found to be an important aspect which can have a significant influence on the long term fate of coal tar in soils or subsoils, as well as on soil remediation techniques.

Effect of leachate injection modes on municipal solid waste degradation in anaerobic bioreactor

Three pilots simulated landfill bioreactors were used to investigate the effect of leachate injection modes on anaerobic digestion and biogas production from municipal solid waste. The technical modes used to increase waste moisture consisted of an initial saturation of the waste by flushing with leachate followed by a quick drainage, or weekly leachate injections with two different rates. The results confirmed that increasing moisture content is a key parameter to boost the biological reactions. Weekly leachate injection with high flow rate led to better results than the initial saturation of the waste in terms of biogas production kinetics. Water percolation was found to be an important factor to accelerate the degradation of solid waste. However, a modelling of the collected data by Gompertz model clearly showed that the intrinsic biogas potential determined on the initial solid waste was not reached with any of the progressive leachate injection modes.

Effect of microbial activity on the mobility of chromium in soils.

The effect of microbial activity on the chemical state of chromium, in a contaminated soil located in the Rhĵne-Alpes region (France), has been investigated. This soil contained 4,700 mg kg(-1) Cr, with about 40% present in the soluble hexavalent form. Indigenous microbial activity was found to significantly reduce Cr(VI) to the less mobile form (III) when the soil was incubated at 30 degrees C in an aqueous medium containing glucose and nutrients. A Cr(VI)-reducing strain of Streptomyces thermocarboxydus was isolated from the contaminated soil. The strain was found to metabolize Cr(VI) in a similar manner as an exogenous inoculum of Pseudomonas fluorescens LB300, and to precipitate chromium as a Cr oxyhydroxide with a gammaCrOOH-like local structure. The Cr(VI)-reducing activity of S. thermocarboxydus was induced, or significantly accelerated, by the aggregation of bacterial cells or their adhesion to suspended solid particles, and was stimulated in pure culture by glycerol and chromate.

Influence of substrate concentration and moisture content on the specific methanogenic activity of dry mesophilic municipal solid waste digestate spiked with propionate

The objective of this study was to evaluate the influence of substrate concentration and moisture content on the specific methanogenic activity (SMA) of a fresh dry mesophilic digestate from a municipal solid waste digester plant. For this purpose, SMA tests were performed under mesophilic conditions into glass bottles of 500 mL volume used as batch reactors, during a period of 20-25 days. Propionate was used as substrate at concentrations ranging from 1 to 10 gCOD/kg. Four moisture contents were studied: 65%, 75%, 80% and 82%. Experimental results showed that propionate concentration and moisture content strongly influenced the SMA. The highest SMA was observed at a substrate concentration of 10 gCOD/kg (11.3 mgCOD gVS(-1) d(-1) for the second dose of propionate) and at a moisture content of 82% (7.8 mgCOD gVS(-1) d(-1) for the second dose of propionate, at a concentration of 5 gCOD/kg). SMA was found to decrease linearly when decreasing the moisture content.

The remediation of wastewater containing 4-chlorophenol using integrated photocatalytic and biological treatment.

In this work, the performance of integrated photocatalytic and biological treatment was studied for the degradation of 4-chlorophenol (MCP) present in wastewaters. Photocatalysis was used as a pre-treatment to biological degradation. Pollutant removal efficiency was quantified using MCP removal and total organic carbon (TOC) removal. Both photocatalytic as well as biological treatments were carried out in batch reactors, using TiO(2) as the photocatalyst. The inoculum for biological experiments was obtained from paper mill effluent treatment plant and was developed through a process of selection and acclimatization. Effect of TiO(2) concentration on the photocatalytic degradation of MCP was studied along with the effect of the duration of photochemical oxidation and glucose concentrations (0 g/L, 1 g/L and 2 g/L) on the biodegradation of MCP. Integrated biological and photochemical degradation was found to be more effective in treating MCP, especially at higher concentrations (400 mg/L). An initial MCP concentration of 400 mg/L required 96 h for complete mineralization when treated with the process combination, whereas the treatment went on up to 264 h when biodegradation alone was employed.

Assessment of the effectiveness of an industrial unit of mechanical–biological treatment of municipal solid waste

An assessment of the French municipal solid waste (MSW) mechanical-biological treatment (MBT) unit of Mende was performed in terms of mass reduction, biogas emissions reduction and biostability of the biologically treated waste. The MBT unit consists of mechanical sorting operations, an aerobic rotating bioreactor, forced-aeration process in open-air tunnels (stabilization), ripening platforms and a sanitary landfill site for waste disposal in separated cells. On the overall plant, results showed a dry matter reduction of 18.9% and an oxidative organic matter reduction of 39.0%. A 46.2% biogas production decrease could also be observed. Concerning the biotreatment steps, high reductions were observed: 88.1% decrease of biogas potential and 57.7% decrease of oxidative organic matter content. Nevertheless, the usually considered stabilization indices (biogas potential, respirometric index) remained higher than recommended by the German or Austrian regulation for landfilling. Mass balance performed on each step of the treatment line showed that several stages needed improvement (especially mechanical sorting operations) as several waste fractions containing potentially biodegradable matter were landfilled with very few or no biological treatment.

Study of the VOC emissions from a municipal solid waste storage pilot-scale cell: comparison with biogases from municipal waste landfill site.

The emission of volatile organic compounds (VOCs) from municipal solid waste stored in a pilot-scale cell containing 6.4 tonnes of waste (storage facility which is left open during the first period (40 days) and then closed with recirculation of leachates during a second period (100 days)) was followed by dynamic sampling on activated carbon and analysed by GC-MS after solvent extraction. This was done in order to know the VOC emissions before the installation of a methanogenesis process for the entire waste mass. The results, expressed in reference to toluene, were exploited during the whole study on all the analyzable VOCs: alcohols, ketones and esters, alkanes, benzenic and cyclic compounds, chlorinated compounds, terpene, and organic sulphides. The results of this study on the pilot-scale cell are then compared with those concerning three biogases from a municipal waste landfill: biogas (1) coming from waste cells being filled or recently closed, biogas (2) from all the waste storage cells on site, and biogas (3) which is a residual gas from old storage cells without aspiration of the gas. The analysis of the results obtained revealed: (i) a high emission of VOCs, principally alcohols, ketones and esters during the acidogenesis; (ii) a decrease in the alkane content and an increase in the terpene content were observed in the VOCs emitted during the production of methane; (iii) the production of heavier alkanes and an increase in the average number of carbon atoms per molecule of alkane with the progression of the stabilisation/maturation process were also observed. Previous studies have concentrated almost on the analysis of biogases from landfills. Our research aimed at gaining a more complete understanding of the decomposition/degradation of municipal solid waste by measuring the VOCs emitted from the very start of the landfill process i.e. during the acidogenesis and acetogenesis phases.

Long-term moisture measurements in large-scale bioreactor cells using TDR and neutron probes

This paper investigates the measurement of moisture content in municipal solid waste using two different indirect techniques: neutron scattering and time-domain reflectometry (TDR). Therefore, six laboratory-scale landfill bioreactors were instrumented with both neutron and TDR probes; in addition to that a gravimetric moisture balance was established for each cell. Different leachate recirculation modes were applied to perform different wetting conditions. In a first step, both probes were calibrated based on the water balance from three cells presenting homogeneous water distributions and sufficient temporal moisture variations. The calibration functions were then used for temporal and spatial moisture monitoring of all six cells. The results show that both methods are sensitive to moisture variations and provide interesting information on the complexity of vertical flows within the municipal solid waste. Nevertheless, it appears that neutron scattering offers better accuracy at the laboratory scale.

Liquid mixing and solid segregation in high-solid anaerobic digesters.

An experimental procedure (Residence Time Distribution technique) was used to characterize the macro-mixing of both liquid and solid phases of a laboratory-scale dry anaerobic digester using appropriate tracers. The effects of the waste origin and total solid content were studied. An increase in TS content from 22% to 30% TS (w/w) induced a macro-mixing mode closer to a theoretical Plug Flow Reactor. The segregation of particles having different densities was investigated regarding the RTD of the solid phase. Segregation of dense particles occurred at low TS content. By using different TS content and waste origins, it was also determined that the yield stress was a key parameter in the mechanism of segregation. At high yield stress, dense particles were more stable and thus less subjected to settling. As a consequence, operating at high TS content may permit to prevent the sedimentation of the denser particles.

Experimental and theoretical assessment of the multi-domain flow behaviour in a waste body during leachate infiltration

The optimisation of landfill operation is a key challenge for the upcoming years. A promising solution to improve municipal solid waste (MSW) management is the bioreactor technology. A meso-scale (around 1m(3)) experimental set-up was performed to study the effect of moisture control in low density conditions with different leachate injection operations and bioreactor monitoring including the use of a neutron probe. The moisture content distribution evolution demonstrates a multi-domain flow behaviour. A classic van Genuchten-Mualem description of the connected porosity proved insufficient to correctly describe the observed phenomena. A bimodal description of the connected porosity is proposed as solution and a connected/non-connected porosities numerical model was applied to the results. The model explains the experimental results reasonably well.