Ricardo Gariba Silva

Adhesion of Epiphany and AH Plus Sealers to Human Root Dentin Treated with Different Solutions

This study evaluated comparatively the adhesion of Epiphany and AH Plus endodontic sealers to human root dentin treated with 1% NaOCl and 1% NaOCl+17% EDTA, using the push-out test. Sixty root cylinders obtained from maxillary canines had the canals prepared and were randomly assigned to 3 groups (n=20), according to root dentin treatment: GI - distilled water (control), GII - 1% NaOCl and GIII - 1% NaOCl+17% EDTA. Each group was divided into 2 subgroups (n=10) filled with either Epiphany or AH Plus. Bond strength push-out test data (kN) were obtained and analyzed statistically by ANOVA and Tukeys post-hoc test. There was statistically significant difference between sealers (AH Plus: 0.78 +/- 0.13; Epiphany: 0.61 +/- 0.19; p<0.01) and among root dentin treatments (distilled water: 0.58 +/- 0.19; 1% NaOCl: 0.71 +/- 0.12; 1% NaOCl+17% EDTA: 0.80 +/- 0.17; p<0.05). In conclusion, AH Plus sealer presented greater adhesion to dentin than Epiphany, regardless of the treatment of root canal walls.

Effect of Chelating Solutions on the Microhardness of Root Canal Lumen Dentin

INTRODUCTION The greatest reduction in microhardness of the most superficial layer of dentin of the root canal lumen is desired. The use of chelating agents during biomechanical preparation of root canals removes smear layer, increasing the access of the irrigant into the dentin tubules to allow adequate disinfection, and also reduces dentin microhardness, facilitating the action of endodontic instruments. This study evaluated the effect of different chelating solutions on the microhardness of the most superficial dentin layer from the root canal lumen. METHODS Thirty-five recently extracted single-rooted maxillary central incisors were instrumented, and the roots were longitudinally sectioned in a mesiodistal direction to expose the entire canal extension. The specimens were distributed in seven groups according to the final irrigation: 15% EDTA, 10% citric acid, 5% malic acid, 5% acetic acid, apple vinegar, 10% sodium citrate, and control (no irrigation). A standardized volume of 50 μL of each chelating solution was used for 5 minutes. Dentin microhardness was measured with a Knoop indenter under a 10-g load and a 15-second dwell time. Data were analyzed statistically by one-way analysis of variance and Tukey-Kramer multiple-comparison test at 5% significance level. RESULTS EDTA and citric acid had the greatest overall effect, causing a sharp decrease in dentin microhardness without a significant difference (p > .05) from each other. However, both chelators differed significantly from the other solutions (p < .001). Sodium citrate and deionized water were similar to each other (p > .05) and did not affect dentin microhardness. Apple vinegar, acetic acid, and malic acid were similar to each other (p > .05) and presented intermediate results. CONCLUSION Except for sodium citrate, all tested chelating solutions reduced microhardness of the most superficial root canal dentin layer. EDTA and citric acid were the most efficient.

Atomic Absorption Spectrometry and Scanning Electron Microscopy Evaluation of Concentration of Calcium Ions and Smear Layer Removal With Root Canal Chelators

AIM The aim of this study was to evaluate the concentration of calcium ions and smear layer removal by using root canal chelators according to flame atomic absorption spectrophotometry and scanning electron microscopy. Forty-two human maxillary central incisors were irrigated with 15% ethylenediaminetetraacetic acid (EDTA), 10% citric acid, 10% sodium citrate, apple vinegar, 5% acetic acid, 5% malic acid, and sodium hypochlorite. The concentration of calcium ions was measured by using flame atomic absorption spectrometry, and smear layer removal was determined by scanning electron microscopy. Mean +/- standard deviation, one-way analysis of variance, Tukey-Kramer, Kruskal-Wallis, Dunn, and kappa tests were used for statistical analysis. The use of 15% EDTA resulted in the greatest concentration of calcium ions followed by 10% citric acid; 15% EDTA and 10% citric acid were the most efficient solutions for removal of smear layer.

Canal transportation and centring ability of RaCe rotary instruments

AIM Evaluate, through computerized tomography, canal transportation and centring ability of RaCe rotary instruments after preparation of mesiobuccal root canals in maxillary molar teeth. METHODOLOGY Twenty-seven teeth were submitted to three cone beam tomographic analyses, one preoperatively, and two after preparation with file size 35, .02 taper and size 50, .02 taper. Canal transportation and centring ability were measured with reference to the distance between the noninstrumented portion of the root canals and the mesial and distal periphery of the root, compared with images obtained after the preparation with size 35 and 50 instruments. RESULTS Canal transportation after preparation with the size 35 file was 0.030 +/- 0.253 mm and after the size 50 file was 0.057 +/- 0.317 mm. The centring ratio values after preparation with the size 35 file was 0.42 +/- 0.32 and after the size 50 file was 0.54 +/- 0.29, with no significant statistical difference between the groups. CONCLUSIONS RaCe instruments allowed the preparation of curved root canals with preparation diameters larger than those normally used with minimal canal transportation and adequate centring ability.

Adhesion of Endodontic Sealers to Human Root Dentine Submitted to Different Surface Treatments

OBJECTIVE To evaluate the adhesion of the endodontic sealers Epiphany, Apexit Plus, and AH Plus to root canal dentin submitted to different surface treatments, by using the push-out test. METHODS One hundred twenty-eight root cylinders obtained from maxillary canines were embedded in acrylic resin, had the canals prepared, and were randomly assigned to four groups (n = 32), according to root dentin treatment: (I) distilled water (control), (II) 17% EDTAC, (III) 1% NaOCl and (IV) Er:YAG laser with 16-Hz, 400-mJ input (240-mJ output) and 0.32-J/cm(2) energy density. Each group was divided into four subgroups (n = 8) filled with Epiphany (either dispensed from the automix syringe supplied by the manufacturer or prepared by hand mixing), Apexit Plus, or AH Plus. Data (MPa) were analyzed by ANOVA and Tukeys test. RESULTS A statistically significant difference (p < 0.01) was found among the root-canal sealers, except for the Epiphany subgroups, which had statistically similar results to each other (p > 0.01): AH Plus (4.77 +/- 0.85), Epiphany/hand mixed (3.06 +/- 1.34), Epiphany/automix syringe (2.68 +/- 1.35), and Apexit Plus (1.22 +/- 0.33). A significant difference (p < 0.01) was found among the dentin surface treatments. The highest adhesion values were obtained with AH Plus when root dentin was treated with Er:YAG laser and 17% EDTAC. Epiphany sealer presented the lowest adhesion values to root dentin treated with 17% EDTAC. CONCLUSIONS The resin-based sealers had different adhesive behaviors, depending on the treatment of root canal walls. The mode of preparation of Epiphany (automix syringe or hand mixing) did not influence sealer adhesion to root dentin.

Coronal resistance to fracture of endodontically treated teeth submitted to light-activated bleaching

OBJECTIVES The aim of this study was to assess the fracture resistance of endodontically treated teeth submitted to bleaching with 38% hydrogen peroxide activated by light-emitting diode (LED)-laser system. METHODS Fifty maxillary incisors were endodontically treated, received a zinc phosphate barrier and were embedded in acrylic resin until cemento-enamel junction. The specimens were distributed into five groups (n=10) according to the number of bleaching sessions: GI, no treatment (control); GII, one session; GIII, two sessions; GIV, three sessions and GV, four sessions. The whitening gel was applied to the buccal surface of the tooth and inside the pulp chamber for three times in each session, followed by LED-laser activation. Specimens were submitted to the fracture resistance test (kN) and data were submitted to the Tukey-Kramer multiple comparisons test. RESULTS No significant difference (p>0.05) was found between GI (0.71+/-0.30) and GII (0.65+/-0.13), which presented the highest strength values to fracture. Groups III (0.35+/-0.17), IV (0.23+/-0.13) and V (0.38+/-0.15) showed lower resistance to fracture (p<0.01) when compared to GI and GII. CONCLUSIONS The fracture resistance of endodontically treated teeth decreased after two sessions of bleaching with 38% hydrogen peroxide activated by LED-laser system.

Ex vivo analysis of the debris remaining in flattened root canals of vital and nonvital teeth after biomechanical preparation with Ni-Ti rotary instruments

The purpose of this study was to assess the presence of apical debris remaining in the apical third of flattened root canals of vital and nonvital teeth after biomechanical preparation with Ni-Ti rotary instruments. Fresh-extracted human mandibular incisors were used in this study. The teeth had clinical indication for extraction and were submitted to cold pulp vitality testing and radiographic examination. Eighteen teeth were selected and randomly assigned to two groups (n=9), according to the clinical diagnosis, i.e., pulp vitality or pulp necrosis. The canals were instrumented with the ProTaper NiTi rotary system in the following sequence: S1--up to the middle third; SX--at the cervical third; S2--up to the apical third; and S1, F1, F2, F3--at the working length. The canals were irrigated with 1% sodium hypochlorite, dried and were submitted to the histological processing. Sections from the apical third were analyzed by an optical microscope (X40) that was coupled to a computer where the images were captured and analyzed using specific softwares. A grid was placed over these images to assess the total canal area and the areas with debris. Mann-Whitney U-test showed no statistically significant difference (p>0.05) between the teeth with pulp vitality (6.49 +/- 3.39) and those with pulp necrosis (5.95 +/- 2.22). It may be concluded that the clinical condition of pulp tissue did not interfere with the amount of debris remaining in the apical third of flattened root canals prepared with Ni-Ti rotary instruments.

Analysis of the interface and bond strength of resin-based endodontic cements to root dentin

This study evaluated by scanning electron microscopy the interface between root dentin and resin cements, with or without additional application of a dual‐cured one‐step self‐etching dentin adhesive. In addition, the push‐out bond strength of these materials to dentin was evaluated. Root canals of 50 maxillary human canines were subjected to biomechanical preparation and randomly assigned into five groups (n = 10) according to the obturation employed: I. AH Plus/gutta‐percha; II. Endo‐REZ/gutta‐percha; III. Epiphany SE/Resilon; IV. Endo‐REZ/gutta‐percha + adhesive; and V. Epiphany SE/Resilon + adhesive. After obturation, two cross sections of 1.0 mm of each third of the root were obtained and analyzed by SEM and push‐out. Data were analyzed by Kruskal–Wallis, Two‐way ANOVA and Tukeys HSD tests (α = 5%). Significant differences occurred between scores for gap parameters and tags; greater tag formation resulted for Epiphany SE (P < 0.05). There were also significant differences between groups for the bond strength. AH Plus (1.24 ± 0.70) showed higher values (P < 0.05) compared to groups II (0,17 ± 0.19), III (0.10 ± 0.06), IV (0.09 ± 0.08), and V (0.06 ± 0.03), which were statistically similar (P > 0.05). There was no significant difference between the root thirds (P > 0.05). It was concluded that the use of a self‐etching adhesive system did not improve the adhesion of resin‐based sealers to dentin and that AH Plus showed better bond strength when compared to other cements. Microsc. Res. Tech., 2012.

Fracture resistance of teeth subjected to internal bleaching and restored with different procedures

This study evaluated the fracture resistance of teeth submitted to internal bleaching and restored with different procedures. Forty maxillary incisors were endodontically treated and assigned to 4 groups (n=10): G1- restored with composite resin (CR), G2- bleached with hydrogen peroxide (HP) and restored with CR, G3- restored with CR and fiberglass posts (CR + posts) and G4- bleached and restored with CR + posts. HP was applied in the buccal surface and pulp chamber 3 times at each one of 2 sessions with an interval of 7 days between them. Additional 10 sound incisors were subjected to fracture strength test (gold standard). The fracture strength (kN) was determined in an Instron machine. Data were analyzed by ANOVA and Tukey-Kramer test (α=0.05). The untreated teeth (gold standard) showed the highest (p.

Ex-vivo evaluation of the intrapulpal temperature variation and fracture strength in teeth subjected to different external bleaching protocols

This study evaluated the influence of bleaching protocols on intrapulpal temperature and fracture strength of the bleached teeth. Ninety maxillary incisors were assigned to 9 groups (n=10): G1: 35% carbamide peroxide (35% CP), G2: 38% hydrogen peroxide (38% HP), G3: halogen light, G4: LED-laser, G5: 35% CP + halogen light, G6: 38% HP + halogen light, G7: 35% CP + LED-laser, G8: 38% HP + LED-laser, and G9: no treatment (control). Pulp space was widened, a thermocouple was introduced through the apex up to the pulp chamber and the temperature was recorded (°C). The fracture strength (kN) was determined using an Instron machine. Data were analyzed by ANOVA and Tukeys test (p<0.05). The halogen light alone (1.10 ± 0.24) (G3) and associated with 38% HP (1.15 ± 0.30) (G6) produced the highest temperature increase, statistically different (p<0.05) from the other groups. G1 (0.15 ± 0.06) and G6 (0.19 ± 0.07) produced the lowest values, statistically different (p<0.05) from G5 (0.65 ± 0.49). The bleaching protocols increased the temperature, but no increment exceeded the critical value of 5.6°C. Neither 35% CP nor 38% HP or the light sources alone altered the fracture strength of the teeth.