Richard A. Hargis

Sorbents for mercury removal from flue gas

A review of the various promoters and sorbents examined for the removal of mercury from flue gas is presented. Commercial sorbent processes are described along with the chemistry of the various sorbent-mercury interactions. Novel sorbents for removing mercury from flue gas are suggested. Since activated carbons are expensive, alternate sorbents and/or improved activated carbons are needed. Because of their lower cost, sorbent development work can focus on base metal oxides and halides. Additionally, the long-term sequestration of the mercury on the sorbent needs to be addressed. Contacting methods between the flue gas and the sorbent also merit investigation.

Modeling Sorbent Injection for Mercury Control in Baghouse Filters: I—Model Development and Sensitivity Analysis

Abstract A two-stage mathematical model for Hg removal using powdered activated carbon injection upstream of a bag-house filter was developed, with the first stage accounting for removal in the ductwork and the second stage accounting for additional removal caused by the retention of carbon particles on the filter. The model shows that removal in the ductwork is minimal, and the additional carbon detention time from the entrapment of the carbon particles in the fabric filter enhances the Hg removal from the gas phase. A sensitivity analysis on the model shows that Hg removal is dependent on the isotherm parameters, the carbon pore radius and tortuosity, the C/Hg ratio, and the carbon particle radius.

Modeling Sorbent Injection for Mercury Control in Baghouse Filters: II—Pilot-Scale Studies and Model Evaluation

Abstract Activated carbon injection for Hg control in a 500-lb/hr pilot-scale coal-fired furnace equipped with a fabric filter for particulate control was evaluated at different operating conditions. The pilot-scale tests showed that Hg removal was improved at lower temperatures and higher C/Hg ratios. The two-stage mathematical model developed to describe Hg removal using powdered activated carbon injection upstream of a baghouse filter was used to obtain Langmuir isotherm parameters as a function of temperature by fitting the model to a subset of experimental data. The predictive capability of the model was then tested by comparing model calculations with additional experimental data from this system obtained using different operating temperatures and sorbent to Hg ratios. Model predictions were in good agreement with experimentally measured Hg removal efficiency. Based on the model predictions, Hg removal in the duct appears to be limited and higher C/Hg ratio, lower operating temperature, and longer cleaning cycle of the baghouse filter should be utilized to achieve higher Hg removal in this system.

The role of pressure drop and flow redistribution on modeling mercury control using sorbent injection in baghouse filters.

Abstract A mathematical model based on simple cake filtration theory was coupled to a reviously developed two-stage mathematical model for mercury (Hg) removal using powdered activated carbon injection upstream of a bag-house filter. Values of the average permeability of the filter cake and the filter resistance extracted from the model were 4.4× 10−13 m2 and 2.5 ×10−4 m−1, respectively. The flow is redistributed during partial cleaning of the filter, with flows higher across the newly cleaned filter section. The calculated average Hg removal efficiency from the baghouse is lower because of the high mass flux of Hg exiting the filter in the newly cleaned section. The model shows that calculated average Hg removal is affected by permeability, filter resistance, fraction of the baghouse cleaned, and cleaning interval.