Robert M. Heath

Nano-optical single-photon response mapping of waveguide integrated molybdenum silicide (MoSi) superconducting nanowires

We present low temperature nano-optical characterization of a silicon-on-insulator (SOI) waveguide integrated SNSPD. The SNSPD is fabricated from an amorphous Mo83Si17 thin film chosen to give excellent substrate conformity. At 350 mK, the SNSPD exhibits a uniform photoresponse under perpendicular illumination, corresponding to a maximum system detection efficiency of approximately 5% at 1550 nm wavelength. Under these conditions 10 Hz dark count rate and 51 ps full width at half maximum (FWHM) timing jitter is observed.

Nanoantenna Enhancement for Telecom-Wavelength Superconducting Single Photon Detectors

Superconducting nanowire single photon detectors are rapidly emerging as a key infrared photon-counting technology. Two front-side-coupled silver dipole nanoantennas, simulated to have resonances at 1480 and 1525 nm, were fabricated in a two-step process. An enhancement of 50 to 130% in the system detection efficiency was observed when illuminating the antennas. This offers a pathway to increasing absorption into superconducting nanowires, creating larger active areas, and achieving more efficient detection at longer wavelengths.

Current distribution in a parallel configuration superconducting strip-line detector

Superconducting detectors based on parallel microscopic strip-lines are promising candidates for single molecule detection in time-of-flight mass spectrometry. The device physics of this configuration is complex. In this letter, we employ nano-optical techniques to study the variation of current density, count rate, and pulse amplitude transversely across the parallel strip device. Using the phenomenological London theory, we are able to correlate our results to a non-uniform current distribution between the strips, governed by the London magnetic penetration depth. This fresh perspective convincingly explains anomalous behaviour in large area parallel superconducting strip-line detectors reported in previous studies.

Nano-optical observation of cascade switching in a parallel superconducting nanowire single photon detector

The device physics of parallel-wire superconducting nanowire single photon detectors is based on a cascade process. Using nano-optical techniques and a parallel wire device with spatially separate pixels, we explicitly demonstrate the single- and multi-photon triggering regimes. We develop a model for describing efficiency of a detector operating in the arm-trigger regime. We investigate the timing response of the detector when illuminating a single pixel and two pixels. We see a change in the active area of the detector between the two regimes and find the two-pixel trigger regime to have a faster timing response than the one-pixel regime.

A tunable fiber-coupled optical cavity for agile enhancement of detector absorption

Maximizing photon absorption into thin active structures can be the limiting factor for photodetector efficiency. In this work, a fiber-coupled tunable cavity is demonstrated, designed to achieve close to unity absorption of photons into a thin film superconducting nanowire single photon detector (SNSPD). A technique for defining a stable cavity between the end of a telecommunications optical fiber and a reflective substrate is described and realized. Cavity resonances are demonstrated both through the tuning of input wavelength and cavity length. The resulting optical cavity can tune the resonant absorption in situ over a wavelength range of 100 nm. This technique is used to maximize the single photon absorption into both a back-side-coupled Au mirror SNSPD and a front-side-coupled distributed Bragg reflector cavity SNSPD. The system detection efficiency (SDE) is limited by imperfections in the thin films, but in both cases we demonstrate an improvement of the SDE by 40% over bare fiber illumination.

Parallel superconducting strip-line detectors: reset behaviour in the single-strip switch regime

Superconducting strip-line detectors (SSLDs) are an important emerging technology for the detection of single molecules in time-of-flight mass spectrometry (TOF-MS). We present an experimental investigation of a SSLD laid out in a parallel configuration, designed to address selected single strip-lines operating in the single-strip switch regime. Fast laser pulses were tightly focused onto the device, allowing controllable nucleation of a resistive region at a specific location and study of the subsequent device response dynamics. We observed that in this regime, although the strip-line returns to the superconducting state after triggering, no effective recovery of the bias current occurs, in qualitative agreement with a phenomenological circuit simulation that we performed. Moreover, from theoretical considerations and by looking at the experimental pulse amplitude distribution histogram, we have the first confirmation of the fact that the phenomenological London model governs the current redistribution in these large area devices also after detection events.

Nano-optical measurements of novel superconducting single photon detector designs

Superconducting nanowire single photon detectors (SNSPDs) are a highly promising emerging photon counting technology, offering infrared sensitivity combined with low dark count rates and sub-100 ps timing jitter [1]. These devices are under consideration for a wide variety of photon counting applications, from quantum cryptography to remote sensing. Next generation device designs based on optical cavities, ultra narrow wires, parallel wire arrays and nano-antenna enhanced devices are being evaluated to meet the demands of advanced photon counting applications.