Robert Maher

Digital Coherent Receivers for Long-Reach Optical Access Networks

The relative merits of coherent-enabled optical access network architectures are explored, with a focus on achievable capacity, reach and split ratio. We review the progress in implementing the particular case of the ultra dense wavelength division multiplexed (UDWDM) passive optical network (PON), and discuss some challenges and solutions encountered. The applicability of digital signal processing (DSP) to coherent receivers in PONs is shown through the design and implementation of parallelized, low-complexity application-specific digital filters. In this work, we focus on mitigating the impact of local oscillator laser (LO) relative intensity noise (RIN) on receiver sensitivity, and propose an algorithm which compensates for this impairment. This phenomenon is investigated theoretically and then experimentally by evaluating the sensitivity of a coherent receiver incorporating different tunable light sources; a low-RIN external cavity laser (ECL) and a monolithically integrated digital supermode distributed Bragg reflector (DS-DBR) laser. It is shown that the RIN of the signal laser does not significantly contribute to the degradation of the receiver sensitivity. Finally, a 10 Gbit/s coherent PON is demonstrated using a DS-DBR laser as the LO laser. It is found that a receiver sensitivity of -38.8 dBm is achievable assuming the use of hard-decision forward error correction.

Generation of Coherent Multicarrier Signals by Gain Switching of Discrete Mode Lasers

The authors demonstrate the generation of a highly coherent multicarrier signal that consists of eight clearly resolved 10.7-GHz coherent sidebands generated within 3 dB of the spectral envelope peak and with an extinction ratio in excess of 45 dB by gain switching a discrete mode (DM) laser. The generated spectral comb displays a corresponding picosecond pulse train at a repetition rate of 10.7 GHz with a pulse duration of 24 ps and a temporal jitter of ~450 fs. The optical spectra and associated pulses of the gain-switched DM laser are subsequently compared with a gain-switched distributed feedback (DFB) laser that generates a spectrum with no discernible sidebands and corresponding pulses with ~3 ps of temporal jitter. By means of external injection, the temporal jitter of the gain-switched DFB laser is then reduced to <; 1 ps, resulting in visible tones on the output spectrum. Finally, a nonlinear scheme is employed and initially tailored to compress the optical pulses, after which, the setup is slightly altered to expand the original frequency comb from the gain-switched DM laser.

Spectrally Shaped DP-16QAM Super-Channel Transmission with Multi-Channel Digital Back-Propagation

The achievable transmission capacity of conventional optical fibre communication systems is limited by nonlinear distortions due to the Kerr effect and the difficulty in modulating the optical field to effectively use the available fibre bandwidth. In order to achieve a high information spectral density (ISD), while simultaneously maintaining transmission reach, multi-channel fibre nonlinearity compensation and spectrally efficient data encoding must be utilised. In this work, we use a single coherent super-receiver to simultaneously receive a DP-16QAM super-channel, consisting of seven spectrally shaped 10GBd sub-carriers spaced at the Nyquist frequency. Effective nonlinearity mitigation is achieved using multi-channel digital back-propagation (MC-DBP) and this technique is combined with an optimised forward error correction implementation to demonstrate a record gain in transmission reach of 85%; increasing the maximum transmission distance from 3190 km to 5890 km, with an ISD of 6.60 b/s/Hz. In addition, this report outlines for the first time, the sensitivity of MC-DBP gain to linear transmission line impairments and defines a trade-off between performance and complexity.

Replacing the Soft-Decision FEC Limit Paradigm in the Design of Optical Communication Systems

The FEC limit paradigm is the prevalent practice for designing optical communication systems to attain a certain bit error rate (BER) without forward error correction (FEC). This practice assumes that there is an FEC code that will reduce the BER after decoding to the desired level. In this paper, we challenge this practice and show that the concept of a channel-independent FEC limit is invalid for soft-decision bit-wise decoding. It is shown that for low code rates and high-order modulation formats, the use of the soft-decision FEC limit paradigm can underestimate the spectral efficiencies by up to 20%. A better predictor for the BER after decoding is the generalized mutual information, which is shown to give consistent post-FEC BER predictions across different channel conditions and modulation formats. Extensive optical full-field simulations and experiments are carried out in both the linear and nonlinear transmission regimes to confirm the theoretical analysis.

Widely Tunable Burst Mode Digital Coherent Receiver With Fast Reconfiguration Time for 112 Gb/s DP-QPSK WDM Networks

A widely tunable burst mode digital coherent receiver is implemented in a 112 Gb/s DP-QPSK WDM system. The receiver performance is validated in a 24-channel WDM test-bed using a commercially available DS-DBR laser as the local oscillator. It is demonstrated that the wavelength tunable laser can switch to any one of the 24-channels in less than 130 ns, thus enabling the dynamic reception of 5 μ s optical bursts. The performance of the DS-DBR local oscillator laser is commensurate with burst mode coherent reception when differential decoding is employed and the parallel DSP implementation does not impair the polarization and frequency tracking performance of a digital coherent receiver under burst mode operation. The worst case reconfiguration time of the burst mode receiver, which is a combination of the laser switching time and the CMA convergence time, is less than 410 ns when switching from a single channel to any other channel in the WDM grid. It is shown that the variation in reconfiguration time is dependent on the convergence time of the CMA equalizer, which is adversely affected by certain input states of polarization.

Maximizing the optical network capacity

Most of the digital data transmitted are carried by optical fibres, forming the great part of the national and international communication infrastructure. The information-carrying capacity of these networks has increased vastly over the past decades through the introduction of wavelength division multiplexing, advanced modulation formats, digital signal processing and improved optical fibre and amplifier technology. These developments sparked the communication revolution and the growth of the Internet, and have created an illusion of infinite capacity being available. But as the volume of data continues to increase, is there a limit to the capacity of an optical fibre communication channel? The optical fibre channel is nonlinear, and the intensity-dependent Kerr nonlinearity limit has been suggested as a fundamental limit to optical fibre capacity. Current research is focused on whether this is the case, and on linear and nonlinear techniques, both optical and electronic, to understand, unlock and maximize the capacity of optical communications in the nonlinear regime. This paper describes some of them and discusses future prospects for success in the quest for capacity.

4 Tb/s Transmission Reach Enhancement Using 10 × 400 Gb/s Super-Channels and Polarization Insensitive Dual Band Optical Phase Conjugation

In this paper, we experimentally demonstrate the benefit of polarization insensitive dual-band optical phase conjugation for up to ten 400 Gb/s optical super-channels using a Raman amplified transmission link with a realistic span length of 75 km. We demonstrate that the resultant increase in transmission distance may be predicted analytically if the detrimental impacts of power asymmetry and polarization mode dispersion are taken into account.

Burst Mode Receiver for 112 Gb/s DP-QPSK with parallel DSP.

We demonstrate a burst mode 112Gb/s DP-QPSK digital coherent optical receiver with parallel DSP suitable for implementation in a CMOS ASIC (437.5MHz clock speed). A convergence time of less than 200ns is reported.

Dynamic linewidth measurement technique using digital intradyne coherent receivers

The linewidth settling time of a fast switching tuneable laser is investigated using a dynamic coherent receiver and we show that a minimum linewidth can be realised within 70ns of a wavelength switching event.

Increasing the information rates of optical communications via coded modulation: a study of transceiver performance

Optical fibre underpins the global communications infrastructure and has experienced an astonishing evolution over the past four decades, with current commercial systems transmitting data rates in excess of 10 Tb/s over a single fibre core. The continuation of this dramatic growth in throughput has become constrained due to a power dependent nonlinear distortion arising from a phenomenon known as the Kerr effect. The mitigation of fibre nonlinearities is an area of intense research. However, even in the absence of nonlinear distortion, the practical limit on the transmission throughput of a single fibre core is dominated by the finite signal-to-noise ratio (SNR) afforded by current state-of-the-art coherent optical transceivers. Therefore, the key to maximising the number of information bits that can be reliably transmitted over a fibre channel hinges on the simultaneous optimisation of the modulation format and code rate, based on the SNR achieved at the receiver. In this work, we use an information theoretic approach based on the mutual information and the generalised mutual information to characterise a state-of-the-art dual polarisation m-ary quadrature amplitude modulation transceiver and subsequently apply this methodology to a 15-carrier super-channel to achieve the highest throughput (1.125 Tb/s) ever recorded using a single coherent receiver.