Romain Bosc

The growing evidence for the use of platelet-rich plasma on diabetic chronic wounds: A review and a proposal for a new standard care.

Nonhealing chronic wounds and exposed tendons, bones and joints are very challenging to cure specially for diabetic patients. Plastic surgeons have a new weapon to enhance wound healing with the use of autologous growth factors. Recently, the process of fabrication of platelet‐rich plasma (PRP) has been simplified. The goal of this literature review is to summarize the evidenced‐based body of knowledge regarding the treatment of diabetic chronic wounds by PRP. A PubMed and Cochrane search (1978–2015) was performed and all studies assessing the clinical effect of PRP on the healing of diabetic chronic wounds were included. The screening retrieved 7,555 articles and 12 studies were included. On six randomized studies included, five found significant benefits for the use of PRP on diabetic chronic foot ulcers and the sixth randomized study did not publish a statistical analysis but found favorable outcomes. The two other controlled studies included found significant benefits regarding the healing rate and the four uncontrolled studies included showed high rates of healing with the adjunction of PRP. Regarding the method of use, PRP was applied on the wound as a gel twice a week (41.7% of studies) or once a week (33.3% of studies). In conclusion, 87.5% of controlled studies found a significant benefit for the adjunction of PRP to treat chronic diabetic wounds. As PRP may be beneficial, we suggest using PRP on diabetic ulcers which remain unhealed after standard treatment.

Management of Chest Wall Reconstruction After Resection for Cancer: A Retrospective Study of 22 Consecutive Patients

Aim:In this study, we report our experience on immediate reconstruction after resection of primary or metastatic chest wall tumors, to restore protective function and elasticity of chest or sternum. Methods:Between 2005 and 2009, 22 patients underwent reconstruction using a free or pedicled flap combined, or not, to alloplastic materials (Goretex®) in order to cover full-thickness defects of the chest wall after cancer surgery. Reconstruction was immediate in all cases. Results:Mean follow-up was 27 months. Of these, 18 patients were alive at the end of the study (81.5%). Eighteen patients had malignant tumors (82%); within these patients, 12 were alive without recurrence at the end of the study (67%). The average size of the chest wall defect was 255 cm2. Goretex® Mesh was used in 8 patients. All patients benefited from reconstruction with a flap: pedicled or free latissimus dorsi flap (n = 15), pedicled great omentum (n=3), deep inferior epigastric perforator free flap (n = 3), and parascapular pedicled flap (n=1). Conclusion:In this series, we were able to achieve long-term palliation and even cure in some patients by resecting full-thickness chest wall in local primary or recurrence of breast cancer without increasing morbidity. The same process was used successfully in association with adjuvant treatment in other tumors like skin sarcoma. We have followed a surgical algorithm according to the tumor localization and etiology.

Indocyanine green applications in plastic surgery: A review of the literature

INTRODUCTION Use of indocyanine green (ICG) near-infrared fluorescence as a dye to assess tissue vascularization is now well standardized. The aim of this literature review was to review and resume the most recent recommendations for ICG use in its plastic surgery applications. METHODS A systematic literature review was performed using Medline, EMBASE, and PubMed databases to obtain the latest recommendations for ICG in plastic surgery. Inclusion criteria were all articles written in English language that evaluated pre-, intra-, or postoperative ICG applications in surgical procedures usually performed by plastic surgeons. Case reports, reviews, meta-analyses, and experimental studies on animals or cadavers were excluded after title and abstract screening. RESULTS Of the 1389 article titles retrieved, 41 full-text articles met the inclusion criteria. ICG applications in plastic surgery were ICG lymphangiography used in sentinel lymph node mapping for breast cancer and melanoma and in microsurgery for the staging and treatment of secondary chronic lymphedema. The latest updates of ICG angiography in assessing free flaps, pedicled flaps, or large skin paddles were also retrieved. CONCLUSIONS Large prospective studies suggest that ICG lymphography could be used as a single tracer to reliably perform sentinel lymph node biopsy. In the case of cutaneous melanoma, ICG lymphography increases node detection sensitivity and accuracy in conjunction with lymphoscintigraphy. In chronic lymphedema, it is useful for pre- and postoperative staging and intraoperative anatomical location of lymphatic pathways when lymphovenous bypass is indicated. ICG angiography is used intraoperatively to assess free flap anastomosis and design skin paddles and postoperatively to monitor buried flaps. In pedicled perforator flaps or for large skin paddles, intraoperative ICG angiography is strongly correlated with postoperative outcomes. LEVEL OF EVIDENCE 3.

Finite element simulation of ultrasonic wave propagation in a dental implant for biomechanical stability assessment

Dental implant stability, which is an important parameter for the surgical outcome, can now be assessed using quantitative ultrasound. However, the acoustical propagation in dental implants remains poorly understood. The objective of this numerical study was to understand the propagation phenomena of ultrasonic waves in cylindrically shaped prototype dental implants and to investigate the sensitivity of the ultrasonic response to the surrounding bone quantity and quality. The 10-MHz ultrasonic response of the implant was calculated using an axisymetric 3D finite element model, which was validated by comparison with results obtained experimentally and using a 2D finite difference numerical model. The results show that the implant ultrasonic response changes significantly when a liquid layer is located at the implant interface compared to the case of an interface fully bounded with bone tissue. A dedicated model based on experimental measurements was developed in order to account for the evolution of the bone biomechanical properties at the implant interface. The effect of a gradient of material properties on the implant ultrasonic response is determined. Based on the reproducibility of the measurement, the results indicate that the device should be sensitive to the effects of a healing duration of less than one week. In all cases, the amplitude of the implant response is shown to decrease when the dental implant primary and secondary stability increase, which is consistent with the experimental results. This study paves the way for the development of a quantitative ultrasound method to evaluate dental implant stability.

Restoration of the donor after face graft procurement for allotransplantation: report on the technique and outcomes of seven cases.

Background: After organ retrieval, restoration of the donor is a legal and ethical necessity; this is particularly true in facial transplantation. However, very few data are available regarding this procedure. Methods: This article reviews the seven facial masks produced during seven consecutive face transplants carried out at Henri Mondor Hospital in Paris, France. The time of production, morphologic outcome, and donor family feedback were recorded. Technical tips and pitfalls are also discussed. Results: Recording an impression of the donors face with alginate required less than 25 minutes and, in all cases, the production of a resin mask was completed before the surgical harvesting was finished. Although all morphologic results were satisfactory or very satisfactory, the best outcomes were achieved using a total face mask, avoiding color discrepancies. Family feedback was positive, and none of the funeral ceremonies was disturbed by the procedure. Conclusions: The production of a full-face resin mask is a reliable and reproducible technique. This procedure restores donor integrity and gives a very satisfactory morphologic and aesthetic outcome. CLINICAL QUESTION/LEVEL OF EVIDENCE: Therapeutic, IV.

Ex vivo estimation of cementless acetabular cup stability using an impact hammer.

Obtaining primary stability of acetabular cup (AC) implants is one of the main objectives of press-fit procedures used for cementless hip arthroplasty. The aim of this study is to investigate whether the AC implant primary stability can be evaluated using the signals obtained with an impact hammer. A hammer equipped with a force sensor was used to impact the AC implant in 20 bovine bone samples. For each sample, different stability conditions were obtained by changing the cavity diameter. For each configuration, the inserted AC implant was impacted four times with a maximum force comprised between 2500 and 4500 N. An indicator I was determined based on the partial impulse estimation and the pull-out force was measured. The implant stability and the value of the indicator I reached a maximum value for an interference fit equal to 1 mm for 18 out of 20 samples. When pooling all samples and all configurations, the implant stability and I were significantly correlated (R(2) = 0.83). The AC implant primary stability can be assessed through the analysis of the impact force signals obtained using an impact hammer. Based on these ex vivo results, a medical device could be developed to provide a decision support system to the orthopedic surgeons.

Should we use platelet‐rich plasma as an adjunct therapy to treat “acute wounds,” “burns,” and “laser therapies”: A review and a proposal of a quality criteria checklist for further studies

Platelet‐rich plasma seems to help wound healing. The goal of this review is to determine if the adjunction of platelet‐rich plasma enhances the clinical outcome of acute wounds, burns, and laser therapies. A PubMed and Cochrane library search was performed by two reviewers with the senior author as a consultant. Medical Subject Headings search terms used were the following: [“Platelet‐rich plasma” OR “Platelet gel” OR “Platelet growth factor”] AND [“Acute wound” OR “Wound” OR “Burn” OR “Laser”]. We included controlled studies assessing the clinical outcome of acute wounds, burns, and laser therapies treated by platelet‐rich plasma. Nine randomized controlled studies, six prospective controlled studies, and two retrospective controlled studies were included. Regarding acute wounds, three randomized controlled trials found a statistical benefit regarding either the healing time, the return back to work time, the quality of life, or the pain and three prospective controlled studies found a statistical difference regarding the velocity of healing. Platelet‐rich plasma decreased the intensity or duration of erythema after laser therapy in four randomized studies. Regarding the long‐term outcome of laser therapies, two studies found a statistical benefit and two others did not. Platelet‐rich plasma accelerates acute wound healing and decreases erythema after laser therapies. Its use on burns has not been enough studied.

Monitoring the press-fit insertion of an acetabular cup by impact measurements: Influence of bone abrasion

Press-fit procedures used for the insertion of cementless hip prostheses aim at obtaining optimal implant primary stability. We have previously used the measurement of impact duration to follow the insertion of the acetabular cup implant within bone tissue. The aim of this study was to investigate the variation of the value of the impact momentum due to successive insertions of the acetabular cup into bone tissue. The results obtained with impact momentum and contact duration measurements were compared. A total of 10 bovine bone samples were subjected to three successive procedures consisting of 10 reproducible impacts (3.5 kg falling 40 mm). Each procedure aimed at inserting the acetabular cup implant into the same bone cavity. The time variation of force during each impact was recorded by a force sensor, allowing the measurement of the impact duration (I1) and momentum (I2). The value of I2 increased as a function of the impact number and reached a constant value after N2 = 5.07 ± 1.31 impacts. Moreover, statistical analyses show that N2 decreased significantly as a function of the number of experiments, which may be due to abrasion phenomena at the bone–implant interface. Abrasion phenomena led to a faster insertion of the acetabular cup when the implant had been previously inserted into the same bone cavity. An empirical analytical model considering a flat punch configuration to model the bone–implant contact conditions was used to understand the trend of the variation of I2 during the insertion of the acetabular cup. The measurement of the force during impacts is useful to assess the bone–implant interface properties, but needs to be validated in the clinic to be useful for orthopaedic surgeons intra-operatively.

The use of lipofilling to treat congenital hypoplastic breast anomalies: preliminary experiences.

BackgroundTreatment options for congenital hypoplastic breast anomalies are often open, including radial scoring, parenchymal flaps, and insertion of expanders and implants. Drawbacks of open techniques involve scarring, the use of drains, and inpatient stays. The use of lipofilling to treat breast deformities is increasing, as more research is completed in this area. Patients and MethodsWe report a retrospective study of 10 patients below the age of 20 following autologous fat transfer between January 1, 2003 and January 1, 2004. (2 Poland syndrome, 3 bilateral tuberous breast, and 5 unilateral micromastia). Age, cup size, the number of sessions, time interval between each session, volumes injected, and complications were recorded. Postoperative mammography, ultrasonography, and MRI were assessed by a specialized radiologist. Patients answered a questionnaire 1 year after the procedure. ResultsMean follow-up was 68 months (60–77 months) and mean age was 17.5 years (15–20 years). Mean number of fat injection sessions was 2 (1–4) and mean volume injected 285 mL per breast (200–500 mL). The time interval between each session was 5 months (3–6 months). Cup size remained unchanged after at least 5 years of follow-up. One case underwent a contralateral breast reduction. The cosmetic results considered satisfactory in almost all the patients after 1 year of follow-up. None of our patients complained of scars or defects at the donor site. All breasts imaging were normal except 1 patient with oil cysts. ConclusionOur preliminary results using lipofilling to treat young patients with breast hypoplasia with lipofilling are very encouraging. The authors believe it is an alternative of choice for the correction of the young woman’s breast deformities if the avoidance of scarring is preferred.

Assessing the Acetabular Cup Implant Primary Stability by Impact Analyses: A Cadaveric Study.

Background The primary stability of the acetabular cup (AC) implant is an important determinant for the long term success of cementless hip surgery. However, it remains difficult to assess the AC implant stability due to the complex nature of the bone-implant interface. A compromise should be found when inserting the AC implant in order to obtain a sufficient implant stability without risking bone fracture. The aim of this study is to evaluate the potential of impact signals analyses to assess the primary stability of AC implants inserted in cadaveric specimens. Methods AC implants with various sizes were inserted in 12 cadaveric hips following the same protocol as the one employed in the clinic, leading to 86 different configurations. A hammer instrumented with a piezoelectric force sensor was then used to measure the variation of the force as a function of time produced during the impact between the hammer and the ancillary. Then, an indicator I was determined for each impact based on the impact momentum. For each configuration, twelve impacts were realized with the hammer, the value of the maximum amplitude being comprised between 2500 and 4500 N, which allows to determine an averaged value IM of the indicator for each configuration. The pull-out force F was measured using a tangential pull-out biomechanical test. Results A significant correlation (R2 = 0.69) was found between IM and F when pooling all data, which indicates that information related to the AC implant biomechanical stability can be retrieved from the analysis of impact signals obtained in cadavers. Conclusion These results open new paths in the development of a medical device that could be used in the future in the operative room to help orthopedic surgeons adapt the surgical protocol in a patient specific manner.