S R Furtado

The Schenberg spherical gravitational wave detector: the first commissioning runs

Here we present a status report of the first spherical antenna project equipped with a set of parametric transducers for gravitational detection. The Mario Schenberg, as it is called, started its commissioning phase at the Physics Institute of the University of Sao Paulo, in September 2006, under the full support of FAPESP. We have been testing the three preliminary parametric transducer systems in order to prepare the detector for the next cryogenic run, when it will be calibrated. We are also developing sapphire oscillators that will replace the current ones thereby providing better performance. We also plan to install eight transducers in the near future, six of which are of the two-mode type and arranged according to the truncated icosahedron configuration. The other two, which will be placed close to the sphere equator, will be mechanically non-resonant. In doing so, we want to verify that if the Schenberg antenna can become a wideband gravitational wave detector through the use of an ultra-high sensitivity non-resonant transducer constructed using the recent achievements of nanotechnology.

Status Report of the Schenberg Gravitational Wave Antenna

Here we present a status report of the Schenberg antenna. In the past three years it has gone to a radical upgrading operation, in which we have been installing a 1K pot dilution refrigerator, cabling and amplifiers for nine transducer circuits, designing a new suspension and vibration isolation system for the microstrip antennas, and developing a full set of new transducers, microstrip antennas, and oscillators. We are also studying an innovative approach, which could transform Schenberg into a broadband gravitational wave detector.

The Brazilian spherical detector: progress and plans

We are building the Schenberg gravitational wave detector at the Physics Institute of the University of Sao Paulo as programmed by the Brazilian Graviton Project. The antenna and its vibration isolation system are already built, and we have made a first cryogenic run for an overall test, in which we measured the antenna mechanical Q (figure of merit). We also have built a 10.21 GHz oscillator with phase noise performance better than -120 dBc at 3.2 kHz to pump an initial CuA16% two-mode transducer. We plan to prepare this spherical antenna for a first operational run at 4.2 K with a single transducer and an initial target sensitivity of h ∼ 2 x 10 -21 Hz -1/2 in a 50 Hz bandwidth around 3.2 kHz soon. Here we present details of this plan and some recent results of the development of this project.

The Brazilian gravitational wave detector Mario Schenberg : status report

The Mario Schenberg gravitational wave detector has been constructed at its site in the Physics Institute of the University of Sao Paulo as programmed by the Brazilian Graviton Project, under the full support of FAPESP (the Sao Paulo State Foundation for Research Support). We are preparing it for a first commissioning run of the spherical antenna at 4.2 K with three parametric transducers and an initial target sensitivity of h ~ 2 × 10−21 Hz−1/2 in a 60 Hz bandwidth around 3.2 kHz. Here we present the status of this project.

The Brazilian gravitational wave detector Mario Schenberg: progress and plans

The Schenberg gravitational wave detector is almost completed for operation at its site in the Physics Institute of the University of Sao Paulo, under the full support of FAPESP (the Sao Paulo State Foundation for Research Support). We have been working on the development of a transducer system, which will be installed after the arrival of all the microwave components and the completion of the transducer mechanical parts. The initial plan is to operate a CuAl6% two-mode parametric transducer in a first operational run at 4.2 K with nine transducers and an initial target sensitivity of h ~ 2 × 10−21 Hz−1/2 in a 50 Hz bandwidth around 3.2 kHz. Here we present details of this plan and some recent results of the development of this project.

The status of the Brazilian spherical detector

The first phase of the Brazilian Graviton Project is the construction and operation of the gravitational wave detector Mario Schenberg at the Physics Institute of the University of S?o Paulo. This gravitational wave spherical antenna is planned to feature a sensitivity better than h = 10?21 Hz?1/2 at the 3.0?3.4 kHz bandwidth, and to work not only as a detector, but also as a testbed for the development of new technologies. Here we present the status of this detector.

The Schenberg data acquisition and analysis: results from its first commissioning run

The Mario Schenberg gravitational wave detector has started its commissioning phase at the Physics Institute of the University of Sao Paulo. We have collected almost 200 h of data from the instrument in order to check out its behavior and performance. We have also been developing a data acquisition system for it under a VXI System. Such a system is composed of an analog-to-digital converter and a GPS receiver for time synchronization. We have been building the software that controls and sets up the data acquisition. Here we present an overview of the Mario Schenberg detector and its data acquisition system, some results from the first commissioning run and solutions for some problems we have identified.

The gravitational wave detector "Mario Schenberg": status of the project

The first phase of the Brazilian Graviton Project is the construction and operation of the gravitational wave detector Mario Schenberg at the Physics Institute of the University of Sao Paulo. This gravitational wave spherical antenna is planned to feature a sensitivity better than h = 10-21 Hz-1/2 at the 3.0-3.4 kHz bandwidth, and to work not only as a detector, but also as a testbed for the development of new technologies. Here we present the status of this detector.

Progress report on the development of a very high sensitivity parametric transducer for the Mario Schenberg Gravitational wave detector

We have constructed the Mario Schenberg gravitational wave detector at the Physics Institute of the University of Sao Paulo as programmed by the Brazilian Graviton Project, under the full support of FAPESP (the Sao Paulo State Foundation for Research Support). We are ready to do a first test run of the spherical antenna at 4.2K with three parametric transducers and an initial target sensitivity of h~10−21Hz−½ in a 60Hz bandwidth around 3.2kHz. The parametric transducers to be used on the Mario Schenberg detector consist of reentrant klystron copper-aluminum cavities covered with a thin layer of niobium on the walls and on the oscillating membrane. The gap between the central conical post and the membrane is about 40µm. Here we present a progress report on this transducer development related with niobium layer deposition in the transducer cavities and on the design of silicon membranes for the last transducer mechanical mode.

Tests with superconducting re-entrant cavities for transducer applications in gravitational wave detectors

We studied the niobium re-entrant cavity utilized by the Australian group in the Niobe gravitational wave detector. Instead of using their non-contact re-entrant cavity, we plan to change it to a closed one to be used in the parametric transducers of the Brazilian Mario Schenberg detector. The performance of the transducer depends on some cavity parameters such as the electrical Q and the electrical coupling. We measured the resonant frequency and the loaded electrical Q as a function of the probe position in a closed niobium ~15 GHz cavity operating at 4.2 K.