S. S. Kushvaha

Highly c-axis oriented growth of GaN film on sapphire (0001) by laser molecular beam epitaxy using HVPE grown GaN bulk target

Growth temperature dependant surface morphology and crystalline properties of the epitaxial GaN layers grown on pre-nitridated sapphire (0001) substrates by laser molecular beam epitaxy (LMBE) were investigated in the range of 500–750 °C. The grown GaN films were characterized using high resolution x-ray diffraction, atomic force microscopy (AFM), micro-Raman spectroscopy, and secondary ion mass spectroscopy (SIMS). The x-ray rocking curve full width at a half maximum (FWHM) value for (0002) reflection dramatically decreased from 1582 arc sec to 153 arc sec when the growth temperature was increased from 500 °C to 600 °C and the value further decreased with increase of growth temperature up to 720 °C. A highly c-axis oriented GaN epitaxial film was obtained at 720 °C with a (0002) plane rocking curve FWHM value as low as 102 arc sec. From AFM studies, it is observed that the GaN grain size also increased with increasing growth temperature and flat, large lateral grains of size 200-300 nm was obtained for t...

Structural, optical and electronic properties of homoepitaxial GaN nanowalls grown on GaN template by laser molecular beam epitaxy

We have grown homoepitaxial GaN nanowall networks on GaN template using an ultra-high vacuum laser assisted molecular beam epitaxy system by ablating solid GaN target under a constant r.f. nitrogen plasma ambient. The effect of laser repetition rate in the range of 10 to 30 Hz on the structural properties of the GaN nanostructures has been studied using high resolution X-ray diffraction, field emission scanning electron microscopy and Raman spectroscopy. The variation of the laser repetition rate affected the tip width and pore size of the nanowall networks. The z-profile Raman spectroscopy measurements revealed the GaN nanowall network retained the same strain present in the GaN template. The optical properties of these GaN nanowall networks have been studied using photoluminescence and ultrafast spectroscopy and an enhancement of optical band gap has been observed for the nanowalls having a tip width of 10–15 nm due to the quantum carrier confinement effect at the wall edges. The electronic structure of the GaN nanowall networks has been studied using X-ray photoemission spectroscopy and it has been compared to the GaN template. The calculated Ga/N ratio is largest (∼2) for the GaN nanowall network grown at 30 Hz. Surface band bending decreases for the nanowall network with the lowest tip width. The homoepitaxial growth of porous GaN nanowall networks holds promise for the design of nitride based sensor devices.

Influence of laser repetition rate on the structural and optical properties of GaN layers grown on sapphire (0001) by laser molecular beam epitaxy

High-quality GaN layers were grown on sapphire (0001) substrates using laser molecular beam epitaxy (LMBE) by laser ablating a solid GaN target at different laser repetition rates (10–40 Hz) under a constant supply of r.f. nitrogen plasma. The effect of laser repetition rate on the structural and optical properties of GaN layers was systematically studied using high-resolution X-ray diffraction (HRXRD), field emission scanning electron microscopy, atomic force microscopy, Raman spectroscopy and photoluminescence (PL) spectroscopy. High-resolution X-ray rocking curve measurements revealed highly c-axis oriented GaN layers on sapphire grown at 30 Hz with a calculated screw dislocation density of ~1.42 × 107 cm−2, whereas the GaN layers grown at 10 or 40 Hz consisted the screw dislocation density in the range of 108–109 cm−2. Surface morphological analysis revealed a change in grain size as well as surface roughness as a function of laser repetition rate and is explained on the basis of growth kinetics. Vibrational Raman spectroscopy revealed that the GaN layer grown at 10 Hz shows an in-plane compressive stress of ~1 GPa, while the film grown at 30 Hz exhibits a minimum stress of ~0.3 GPa. The PL measurements show a highly luminescent band-to-band emission of GaN at 3.44 eV for the 10 Hz grown highly strained GaN layer and at 3.41 eV for the less strained film grown at 30 Hz along with a broad defect band emission centered around 2.28 eV. It is found that the GaN layers grown at 30 Hz have excellent structural and optical properties. We expect that the less strained thin and highly oriented GaN film grown by LMBE can further be utilized for developing prodigious low-temperature-grown nitride-based multilayer structures and devices.

Light assisted irreversible resistive switching in ultra thin hafnium oxide

An ultra thin film (∼5 nm) high-k Hafnium oxide dielectric, grown on a doped p-Si(100) substrate by the atomic layer deposition technique has been investigated for resistive and capacitive switching with and without illumination of light. As grown samples illustrate small non-switching leakage current under high applied electric fields and probe frequencies and trap charge assisted counter-clockwise capacitance–voltage behavior. A unique resistance switching was observed under illumination of 15–60 mW light. In the first cycle, the light assisted switching provide a 104 : 1 resistance ratio, which diminishes in the next cycle onward, which may be due to irreversible charge injection in the oxide layers. The band offset and band match-up energy diagram for the charge carriers responsible for resistive switching and charge trapping near the interface have been demonstrated under the application of a bias electric field and light.

Photoconductivity and photo-detection response of multiferroic bismuth iron oxide

We report visible light detection with in-plane BiFeO3 (BFO) thin films grown on pre-patterned inter-digital electrodes. In-plane configured BFO film displayed photocurrents with a 40:1 photo-to-dark-current ratio and improved photo-sensing ability for >15 000 s (4 h) under small bias voltage (42 V). Nearly, sixty percent of the photo-induced charge carriers decay in 1.0 s and follow a double-exponential decay model. At 373 K, the effect of light does not significantly increase the dark current, probably due to reduced mobility. Sub-bandgap weak monochromatic light (1 mw/cm2) shows one fold increase in photo-charge carriers.

Effect of growth temperature on defects in epitaxial GaN film grown by plasma assisted molecular beam epitaxy

We report the effect of growth temperature on defect states of GaN epitaxial layers grown on 3.5 μm thick GaN epi-layer on sapphire (0001) substrates using plasma assisted molecular beam epitaxy. The GaN samples grown at three different substrate temperatures at 730, 740 and 750 °C were characterized using atomic force microscopy and photoluminescence spectroscopy. The atomic force microscopy images of these samples show the presence of small surface and large hexagonal pits on the GaN film surfaces. The surface defect density of high temperature grown sample is smaller (4.0 × 108 cm−2 at 750 °C) than that of the low temperature grown sample (1.1 × 109 cm−2 at 730 °C). A correlation between growth temperature and concentration of deep centre defect states from photoluminescence spectra is also presented. The GaN film grown at 750 °C exhibits the lowest defect concentration which confirms that the growth temperature strongly influences the surface morphology and affects the optical properties of the GaN ep...

Facile Synthesis of Semiconducting Ultrathin Layer of Molybdenum Disulfide

In this paper, we have reported a simple and efficient method for the synthesis of uniform, highly conducting single or few layer molybdenum disulfide (MoS2) on large scale. Scanning Electron Microscopy (SEM) and High Resolution Transmission Electron Microscopy (HRTEM) have been used for the confirmation of mono or few layered nature of the as-synthesized MoS2 sheets. X-ray Photoelectron Spectroscopy (XPS), X-Ray Diffraction (XRD) and Raman Spectroscopy have also been used to study the elemental, phase, and molecular composition of the sample. Optical properties of as-synthesized sample have been probed by measuring absorption and photoluminescence spectra which also compliment the formation of mono and few layers MoS2 Current-voltage (I-V ) characteristics of as-synthesized sample in the pellet form reveal that MoS2 sheets have an ohmic character and found to be highly conducting. Besides characterizing the as-synthesized sample, we have also proposed the mechanism and factors which play a decisive role in formation of high quality MoS2 sheets.

Growth and characterizations of various GaN nanostructures on C-plane sapphire using laser MBE

We have grown various GaN nanostructures such as three-dimensional islands, nanowalls and nanocolumns on c-plane sapphire substrates using laser assisted molecular beam epitaxy (LMBE) system. The shape of the GaN nanostructures was controlled by using different nucleation surfaces such as bare and nitridated sapphire with GaN or AlN buffer layers. The structural and surface morphological properties of grown GaN nanostructures were characterized by ex-situ high resolution x-ray diffraction, Raman spectroscopy and field emission scanning electron microscopy. The symmetric x-ray rocking curve along GaN (0002) plane shows that the GaN grown on pre-nitridated sapphire with GaN or AlN buffer layer possesses good crystalline quality compared to sapphire without nitridation. The Raman spectroscopy measurements revealed the wurtzite phase for all the GaN nanostructures grown on c-sapphire.

Low temperature laser molecular beam epitaxy and characterization of AlGaN epitaxial layers

We have grown AlGaN (0001) epitaxial layers on sapphire (0001) by using laser molecular beam epitaxy (LMBE) technique. The growth was carried out using laser ablation of AlxGa1-x liquid metal alloy under r.f. nitrogen plasma ambient. Before epilayer growth, the sapphire nitradation was performed at 700 °C using r.f nitrogen plasma followed by AlGaN layer growth. The in-situ reflection high energy electron diffraction (RHEED) was employed to monitor the substrate nitridation and AlGaN epitaxial growth. High resolution x-ray diffraction showed wurtzite hexagonal growth of AlGaN layer along c-axis. An absorption bandgap of 3.97 eV is obtained for the grown AlGaN layer indicating an Al composition of more than 20 %. Using ellipsometry, a refractive index (n) value of about 2.19 is obtained in the visible region.

Low Temperature Growth of GaN Epitaxial Layer on Sapphire (0001) Substrate by Laser Molecular Beam Epitaxy Technique

GaN epitaxial layers have been grown on sapphire (0001) substrate by laser molecular beam epitaxy. The Ga and N fluxes have been optimized for a good quality, smooth surface GaN layer growth by suitably adjusting the laser power and frequency. It is found that the moderate laser energy with high frequency up to 45 Hz yields more uniform Ga flux for the growth. Similar to conventional MBE, the N-rich growth condition produced rough surface GaN layers while flat surface GaN was obtained under slightly Ga-rich condition. The effect of growth temperature in the range 300–750 °C on the structural properties of the grown GaN layers has been studied. The (0002) plane x-ray rocking curve full width at half maximum (FWHM) of GaN epilayers has been found to decrease dramatically with increasing growth temperature. A narrow x-ray rocking curve value of about 245 arcsec has been achieved for GaN (0002) plane reflection for the epilayers grown in the range of 500–600 °C, which is about 150 °C lower than the conventional MBE growth.