Sercan Pravadali-Cekic

Ferric reducing antioxidant potential (FRAP) of antioxidants using reaction flow chromatography

High performance liquid chromatography coupled with post column derivatisation (HPLC-PCD) may be used to profile the antioxidant content of a sample. There are, however, drawbacks in the use of HPLC-PCD setups; namely the high volume reaction coils that are typically used lowering the observed separation efficiency. Reaction flow chromatography has the ability to overcome these inefficiencies by using a more efficient mixing technique inside the outlet fitting itself, post column reaction loops can be removed with resulting improvement in signal to noise response, plus the separation efficiency is maintained. We assessed two methods of HPLC-PCD antioxidant analysis based on the ferric reducing antioxidant power (FRAP) assay in both conventional and reaction flow HPLC-PCD modes. It was found that the reaction flow technique demonstrated significant advantages over the conventional technique in terms of signal to noise, linear range, precision and observed separation efficiency.

Post column derivatisation analyses review. Is post-column derivatisation incompatible with modern HPLC columns?

Post Column derivatisation (PCD) coupled with high performance liquid chromatography or ultra-high performance liquid chromatography is a powerful tool in the modern analytical laboratory, or at least it should be. One drawback with PCD techniques is the extra post-column dead volume due to reaction coils used to enable adequate reaction time and the mixing of reagents which causes peak broadening, hence a loss of separation power. This loss of efficiency is counter-productive to modern HPLC technologies, -such as UHPLC. We reviewed 87 PCD methods published from 2009 to 2014. We restricted our review to methods published between 2009 and 2014, because we were interested in the uptake of PCD methods in UHPLC environments. Our review focused on a range of system parameters including: column dimensions, stationary phase and particle size, as well as the geometry of the reaction loop. The most commonly used column in the methods investigated was not in fact a modern UHPLC version with sub-2-micron, (or even sub-3-micron) particles, but rather, work-house columns, such as, 250 × 4.6 mm i.d. columns packed with 5 μm C18 particles. Reaction loops were varied, even within the same type of analysis, but the majority of methods employed loop systems with volumes greater than 500 μL. A second part of this review illustrated briefly the effect of dead volume on column performance. The experiment evaluated the change in resolution and separation efficiency of some weak to moderately retained solutes on a 250 × 4.6 mm i.d. column packed with 5 μm particles. The data showed that reaction loops beyond 100 μL resulted in a very serious loss of performance. Our study concluded that practitioners of PCD methods largely avoid the use of UHPLC-type column formats, so yes, very much, PCD is incompatible with the modern HPLC column.

Outlining a Multidimensional Approach for the Analysis of Coffee using HPLC

This study investigated approaches for the profiling of coffee using two multidimensional approaches: (1) a multi-detection process and (2) a multi-separation process employing HPLC. The first approach compared multidetection techniques of conventional High Performance Liquid Chromatography (HPLC) hyphenated with a detector (DPPH•, UV-Vis and MS), and multiplexed mode via HPLC with an Active Flow Technology (AFT) column in Parallel Segmented Flow (PSF) format with DPPH• detection, UV-Vis and MS running simultaneously. Multiplexed HPLCPSF enabled the determination of key chemical entities by reducing the data complexity of the sample whilst obtaining a greater degree of molecule-specific information within a fraction of the time it takes using conventional multi-detection processes. DPPH•, UV-Vis and MS (TIC) were multiplexed for the analysis of espresso coffee and decaffeinated espresso coffee. Up to 20 DPPH• peaks were detected for each sample, and with direct retention time peak matching, 70% of DPPH• peaks gave a UV-Vis response for the espresso coffee and 95% for the decaffeinated espresso coffee. The second approach involved the use of a two-dimensional (2D) HPLC system to expand the separation space and separation power for the analysis of coffee, focusing on the resolution and detection of coeluting and overlapping peaks, which was beyond the limits of conventional HPLC in resolving complex samples. The 2DHPLC analysis resulted with the detection of 176 peaks and a closer observation showed the presence of an additional 17 peaks in a cut section where in 1D mode only one peak was observed.

Post Column Derivatization Using Reaction Flow High Performance Liquid Chromatography Columns

A protocol for the use of reaction flow high performance liquid chromatography columns for methods employing post column derivatization (PCD) is presented. A major difficulty in adapting PCD to modern HPLC systems and columns is the need for large volume reaction coils that enable reagent mixing and then the derivatization reaction to take place. This large post column dead volume leads to band broadening, which results in a loss of observed separation efficiency and indeed detection in sensitivity. In reaction flow post column derivatization (RF-PCD) the derivatization reagent(s) are pumped against the flow of mobile phase into either one or two of the outer ports of the reaction flow column where it is mixed with column effluent inside a frit housed within the column end fitting. This technique allows for more efficient mixing of the column effluent and derivatization reagent(s) meaning that the volume of the reaction loops can be minimized or even eliminated altogether. It has been found that RF-PCD methods perform better than conventional PCD methods in terms of observed separation efficiency and signal to noise ratio. A further advantage of RF-PCD techniques is the ability to monitor effluent coming from the central port in its underivatized state. RF-PCD has currently been trialed on a relatively small range of post column reactions, however, there is currently no reason to suggest that RF-PCD could not be adapted to any existing one or two component (as long as both reagents are added at the same time) post column derivatization reaction.

Multiplexed Detection: Fast Comprehensive Sample Analysis of Tobacco Leaf Extracts Using HPLC with AFT Columns

Detector-based comprehensive screening analysis of complex samples of natural origin using High Performance Liquid Chromatography (HPLC) can be a complicated and time-consuming task. There are a number of ways multidetection characterization can be achieved; however, there are limitations associated with each technique. Active Flow Technology (AFT) in Parallel Segmented Flow (PSF) mode allows for multiplexed detection HPLC analysis within a single injection, whereas maintaining chromatographic performance and allowing the use of multiple destructive detectors to achieve a comprehensive yet efficient screening of a complex sample. In this study, a comprehensive characterization analysis of tobacco leaf extract was carried out through multiplexed detection using a PSF column for the detection of biomolecules by UV-Vis detection, DPPH• for reactive-oxygen species (ROS) detection, and mass spectrometry, the latter two detection methods being sample destructive.

Tuning a Parallel Segmented Flow Column and Enabling Multiplexed Detection

Active flow technology (AFT) is new form of column technology that was designed to overcome flow heterogeneity to increase separation performance in terms of efficiency and sensitivity and to enable multiplexed detection. This form of AFT uses a parallel segmented flow (PSF) column. A PSF column outlet end-fitting consists of 2 or 4 ports, which can be multiplexed to connect up to 4 detectors. The PSF column not only allows a platform for multiplexed detection but also the combination of both destructive and non-destructive detectors, without additional dead volume tubing, simultaneously. The amount of flow through each port can also be adjusted through pressure management to suit the requirements of a specific detector(s). To achieve multiplexed detection using a PSF column there are a number of parameters which can be controlled to ensure optimal separation performance and quality of results; that is tube dimensions for each port, choice of port for each type of detector and flow adjustment. This protocol is intended to show how to use and tune a PSF column functioning in a multiplexed mode of detection.