Seungwan Kim

Noninvasive in vitro measurement of pig-blood D-glucose by using a microwave cavity sensor

We have developed an electromagnetic microwave cavity sensor based on the resonant frequency shift for real time measurement of the glycemia in pig blood. We could determine the concentration of d-glucose in pig blood in the range of 150-550mg/dl at the resonance frequency near 4.75GHz with a bandwidth of 300MHz. The change in the d-glucose concentration in blood brings microwave reflection coefficient S(11) changes of about 6.26dB and resonance frequency shifts of about 11.25MHz due to the electromagnetic interaction between the cavity resonator and the blood filled plastic tube inserted into the cavity. This proposed system provides a unique approach for real time noninvasive and contactless glucose monitoring.

Real-Time Noninvasive Measurement of Glucose Concentration Using a Microwave Biosensor

We measured the glucose concentration by using the real-time electromagnetic interaction between probe-tip and glucose solution using a microwave biosensor. The microwave biosensor, consisting of a dielectric resonator coupled to the probe-tip, allows observation of the small variation of the glucose concentration changes in the ranges of 0–300 mg/ml by measuring the microwave reflection coefficient . We could observe the concentration of glucose with a detectable resolution up to 1 mg/ml at an operating frequency of about GHz. The change of the glucose concentration is directly related to the change of the reflection coefficient due to the electromagnetic interaction between the microwave resonator and the glucose solution. The operational principal is explained by the plane-wave solution model. The measured signal-to-noise ratio was about 37 dB, and the minimum detectible signal was about 0.003 dB/(mg/ml). A glucose biosensor using a microwave resonator with probe provides a unique approach for glucose real-time monitoring.

Direct imaging of photoconductivity of solar cells by using a near-field scanning microwave microprobe

A near-field scanning microwave microprobe (NSMM) technique has been used to investigate the photovoltaic effect in solar cells. As the photoconductivity of the n-type silicon layer in the solar cells was varied due to the incident light intensities and the wavelength, we could directly observe the photoconductivity changes inside the solar cells by measuring the change of reflection coefficient S11 of the NSMM at an operating frequency near 4.1 GHz. We also directly imaged the photoconductivity changes by NSMM. Photoconductivity in solar cells is determined from the visualized microwave reflection coefficient changes at the interfaces with high sensitivity.

Non-invasive in vitro sensing of d-glucose in pig blood

We have developed an electromagnetic resonant spiral sensor and have measured the glycemia in pig blood and the concentration of D-glucose in aqueous solution by using a real-time electromagnetic interaction phenomenon between the microwave sensor and the liquid. We could determine the concentration of glucose with a minimal resolution of 5 mg/dl in the 100-600 mg/dl concentration range at operating frequencies of about 7.65 GHz (for the glucose aqueous solution) and 7.77 GHz (for the pig blood sample). The change in the glucose concentration brings the changes of the microwave reflection coefficient due to the electromagnetic interaction between the resonator and the glucose solution. The in vitro results show the measured signal-to-noise ratio of about 34 dB, and the minimum detectible signal level of about 0.022 dB/(mg/dl). Our proposed system provides a unique approach for non-invasive and non-contact glucose monitoring, and it may serve as a bloodless glucometer.

Label-free DNA microarray bioassays using a near-field scanning microwavemicroscope

A near-field scanning microwave microscope (NSMM) is used to readout and visualize homemade 10-mer oligonucleotide microarrays and an Agilent 60-mer DNA microarray as a realistic test of NSMM applicability to multiplexed sequence analysis. Sensitive characterization of DNA coverage and high resolution mapping of DNA spots in the microarray were realized by measuring the change of microwave reflection coefficient (S₁₁) at about 4 GHz operating frequency. Hybridization between target (free) and capture (immobilized) sequences leads to changes in the microwave reflection coefficient, which were measured by the NSMM. These changes are caused by hybridization-induced modification of the dielectric permittivity profile of the DNA film. The dynamic range based on analysis of the 10-mer microarrays is over 3 orders of magnitude with the detection limit estimated below 0.01 strands/μm². The NSMM method should be readily capable of detecting target coverages down to 98% of probe coverage. We also directly image the patterned DNA microarray by NSMM with a 2 μm resolution. The complementary optical image of the DNA microarray visualized by using a relative fluorescent intensity metric agrees well with the NSMM results.

Investigation of photoconductivity of silicon solar cells by a near-field scanning microwave microscope.

The photovoltaic effect in silicon solar cells were investigated by using a near-field scanning microwave microscope (NSMM) technique by measuring the microwave reflection coefficient at an operating frequency near 4GHz. As the photoconductivity in the solar cells was varied due to the incident light intensities and the wavelength, we could observe the photoconductivity changes at heterojunction interfaces inside the solar cells by measuring the change of reflection coefficient S(11) of the NSMM. By measuring the change of reflection coefficient, we also directly imaged the photoconductivity changes at heterojunction interfaces inside the solar cells.

Visualization of magnetic domains by near-field scanning microwave microscope

A near-field scanning microwave microscope (NSMM) system was used for the investigation of magnetic properties of a hard disk (HD) under an external magnetic field. To demonstrate local microwave characterization of magnetic domains by NSMM, we scanned the HD surface by measuring the microwave reflection coefficient S(11) of the NSMM at an operating frequency near 4.4GHz. The NSMM offers a reliable means for quantitative measurement of magnetic domains with high spatial resolution and sensitivity.

Design and Fabrication of a Compact 3-Dimensional Stacked Type Dielectric Ceramic Waveguide Bandpass Filter

A compact 3-D stacked type waveguide structure is proposed for supporting the modern communication systems in the L-band frequency (700-900 MHz). The proposed structure can achieve very small size in comparison with a standard metal cavity filter designed at 900 MHz center frequency with a 3% fractional bandwidth. The design for this filter was developed with the High Frequency Structural Simulator (HFSS) and a Direct coupled Waveguide Filter Design (DWFD) program based on the direct coupled filter of λ/2 line impedance prototypes. This waveguide filter was designed by 8 poles with bandwidth 27.8 MHz at the center frequency 881 MHz with a ceramic material (εr=35.4). The measured result was in good agreement with the simulated responses and confirmed the accuracy of the design method.

Layered-Type Dielectric Waveguide Filter Using Ceramic

Layered-type dielectric waveguide filters were designed. As the order of layers increased the fabrication process for dielectric waveguide filters which the resonator parts were connected by the lateral direction has many difficulties. The proposed structure in this report was designed based on the layered-type for the some parts of resonators. The size of layered-type dielectric waveguide filters installed on the PCB surface were reduced at 25% as compared with the usual waveguide filters by using a relative dielectric constant 22.

Design and Implementation of 3-Dimensional Laminated Dielectric Ceramic Filter in Waveguide Using a DWFD Program

The program for dielectric ceramic waveguide filter was developed based on the direct coupled filter of step impedance prototype. This developed program was called DWFD(Direct coupled Waveguide Filter Design). The filter was designed by 3-dimensional laminated type to reduce the size at the 1 GHz. S scattering matrix for this filter was calculated using the DWFD program. The width of inductive irises for laminated filter was computed by HFSS simulation tool. This waveguide filter was designed by 8 poles with bandwidth 25 MHz at the center frequency 881.5 MHz. By using a dielectric constant 35.4 and laminated type, the size of filter was reduced with width 50 mm and height 48 mm rapidly. We can see that the measured results agree well with the HFSS simulation result. Finally, this paper is shown that the design and implementation of waveguide filters can be presented by using DWFD program simply.