Shenghuang Lin

Broadband photodetectors based on graphene-Bi2Te3 heterostructure.

Recently, research on graphene based photodetectors has drawn substantial attention due to ultrafast and broadband photoresponse of graphene. However, they usually have low responsivity and low photoconductive gain induced by the gapless nature of graphene, which greatly limit their applications. The synergetic integration of graphene with other two-dimensional (2D) materials to form van der Waals heterostructure is a very promising approach to overcome these shortcomings. Here we report the growth of graphene-Bi2Te3 heterostructure where Bi2Te3 is a small bandgap material from topological insulator family with a similar hexagonal symmetry to graphene. Because of the effective photocarrier generation and transfer at the interface between graphene and Bi2Te3, the device photocurrent can be effectively enhanced without sacrificing the detecting spectral width. Our results show that the graphene-Bi2Te3 photodetector has much higher photoresponsivity (35 AW(-1) at a wavelength of 532 nm) and higher sensitivity (photoconductive gain up to 83), as compared to the pure monolayer graphene-based devices. More interestingly, the detection wavelength range of our device is further expanded to near-infrared (980 nm) and telecommunication band (1550 nm), which is not observed on the devices based on heterostructures of graphene and transition metal dichalcogenides.

Field‐Effect Transistors Based on Amorphous Black Phosphorus Ultrathin Films by Pulsed Laser Deposition

Amorphous black phosphorus (a-BP) ultrathin films are deposited by pulsed laser deposition. a-BP field-effect trans-istors, exhibiting high carrier mobility and moderate on/off current ratio, are demonstrated. Thickness dependence of the bandgap, mobility, and on/off ratio are observed. These results offer not only a new nanoscale member in the BP family, but also a new opportunity to develop nano-electronic devices.

Synthesis and Transfer of Large-Area Monolayer WS2 Crystals: Moving Toward the Recyclable Use of Sapphire Substrates

Two-dimensional layered transition metal dichalcogenides (TMDs) show intriguing potential for optoelectronic devices due to their exotic electronic and optical properties. Only a few efforts have been dedicated to large-area growth of TMDs. Practical applications will require improving the efficiency and reducing the cost of production, through (1) new growth methods to produce large size TMD monolayer with less-stringent conditions, and (2) nondestructive transfer techniques that enable multiple reuse of growth substrate. In this work, we report to employ atmospheric pressure chemical vapor deposition (APCVD) for the synthesis of large size (>100 μm) single crystals of atomically thin tungsten disulfide (WS2), a member of TMD family, on sapphire substrate. More importantly, we demonstrate a polystyrene (PS) mediated delamination process via capillary force in water which reduces the etching time in base solution and imposes only minor damage to the sapphire substrate. The transferred WS2 flakes are of excellent continuity and exhibit comparable electron mobility after several growth cycles on the reused sapphire substrate. Interestingly, the photoluminescence emission from WS2 grown on the recycled sapphire is much higher than that on fresh sapphire, possibly due to p-type doping of monolayer WS2 flakes by a thin layer of water intercalated at the atomic steps of the recycled sapphire substrate. The growth and transfer techniques described here are expected to be applicable to other atomically thin TMD materials.

Ultrafast recovery time and broadband saturable absorption properties of black phosphorus suspension

As a new type of two-dimensional crystal material, black phosphorus (BP) exhibits excellent electronics and optical performance. Herein, we focus on carrier relaxation dynamics and nonlinear optical properties of BP suspension. Atomic force microscopy, transmission electron microscopy, and optical transmission spectrum are employed to characterize the structure and linear optical properties of the BP. Additionally, pump-probe experiments at wavelength of 1550 nm were carried out to study the carrier dynamics in BP suspension, and ultrafast recovery time was observed (τs = 24 ± 2 fs). Furthermore, we demonstrate the saturable absorption signals by open aperture Z-scan experiments at wavelengths of 1550 nm, 532 nm, and 680 nm. The results indicate that BP has broadband saturable absorption properties and the nonlinear absorption coefficients were determined to be β2 = −0.20 ± 0.08 × 10−3 cm/GW (532 nm), β2 = −0.12 ± 0.05 × 10−3 cm/GW (680 nm), and β2 = −0.15 ± 0.09 × 10−3 cm/GW (1550 nm).

Highly responsive MoS2 photodetectors enhanced by graphene quantum dots

Molybdenum disulphide (MoS2), which is a typical semiconductor from the family of layered transition metal dichalcogenides (TMDs), is an attractive material for optoelectronic and photodetection applications because of its tunable bandgap and high quantum luminescence efficiency. Although a high photoresponsivity of 880–2000 AW−1 and photogain up to 5000 have been demonstrated in MoS2-based photodetectors, the light absorption and gain mechanisms are two fundamental issues preventing these materials from further improvement. In addition, it is still debated whether monolayer or multilayer MoS2 could deliver better performance. Here, we demonstrate a photoresponsivity of approximately 104 AW−1 and a photogain of approximately 107 electrons per photon in an n-n heterostructure photodetector that consists of a multilayer MoS2 thin film covered with a thin layer of graphene quantum dots (GQDs). The enhanced light-matter interaction results from effective charge transfer and the re-absorption of photons, leading to enhanced light absorption and the creation of electron-hole pairs. It is feasible to scale up the device and obtain a fast response, thus making it one step closer to practical applications.

Wafer-Scale Synthesis of High-Quality Semiconducting Two-Dimensional Layered InSe with Broadband Photoresponse

Large-scale synthesis of two-dimensional (2D) materials is one of the significant issues for fabricating layered materials into practical devices. As one of the typical III-VI semiconductors, InSe has attracted much attention due to its outstanding electrical transport property, attractive quantum physics characteristics, and dramatic photoresponse when it is reduced to atomic scale. However, scalable synthesis of single phase 2D InSe has not yet been achieved so far, greatly hindering further fundamental studies and device applications. Here, we demonstrate the direct growth of wafer-scale layered InSe nanosheets by pulsed laser deposition (PLD). The obtained InSe layers exhibit good uniformity, high crystallinity with macro texture feature, and stoichiometric growth by in situ precise control. The characterization of optical properties indicates that PLD grown InSe nanosheets have a wide range tunable band gap (1.26-2.20 eV) among the large-scale 2D crystals. The device demonstration of field-effect transistor shows the n-type channel feature with high mobility of 10 cm2 V-1 s-1. Upon illumination, InSe-based phototransistors show a broad photoresponse to the wavelengths from ultraviolet to near-infrared. The maximum photoresponsivity attains 27 A/W, plus a response time of 0.5 s for the rise and 1.7 s for the decay, demonstrating the strong and fast photodetection ability. Our findings suggest that the PLD grown InSe would be a promising choice for future device applications in the 2D limit.

A highly efficient thermo-optic microring modulator assisted by graphene

Graphenes remarkable electrical and optical properties afford great potential for constructing various optoelectronic devices, including modulators, photodetectors and pulse lasers. In particular, graphene-based optical modulators were demonstrated to be featured with a broadband response, small footprint, ultrafast speed and CMOS-compatibility, which may provide an alternative architecture for light-modulation in integrated photonic circuits. While on-chip graphene modulators have been studied in various structures, most of them are based on a capacitance-like configuration subjected to complicated fabrication processes and providing a low yield of working devices. Here, we experimentally demonstrate a new type of graphene modulator by employing graphenes electrical and thermal properties, which can be achieved with a simple fabrication flow. On a graphene-coated microring resonator with a small active area of 10 μm(2), we have obtained an effective optical modulation via thermal energy electrically generated in a graphene layer. The resonant wavelength of the ring resonator shifts by 2.9 nm under an electrical power of 28 mW, which enables a large modulation depth of 7 dB and a broad operating wavelength range of 6.2 nm with 3 dB modulation. Due to the extremely high electrical and thermal conductivity in graphene, the graphene thermo-optical modulator operates at a very fast switching rate compared with the conventional silicon thermo-optic modulator, i.e. 10%-90% rise (90%-10% fall) time of 750 ns (800 ns). The results promise a novel architecture for massive on-chip modulation of optical interconnects compatible with CMOS technology.

Effect of impurities on the Raman scattering of 6H-SiC crystals

Raman spectroscopy was applied to different-impurities-doped 6H-SiC crystals. It had been found that the first-order Raman spectra of N-, Al- and B-doped 6H-SiC were shifted to higher frequency when comparing with undoped samples. However, the first-order Raman spectra of V-doped sample was shifted to lower frequency, revealing that there existed low free carrier concentration, which might be induced by the deep energy level effect of V impurity. Meanwhile, the second-order Raman spectra are independent of polytype and impurity type.

Black Phosphorus Quantum Dots Used for Boosting Light Harvesting in Organic Photovoltaics

Although organic photovoltaic devices (OPVs) have been investigated for more than two decades, the power conversion efficiencies of OPVs are much lower than those of inorganic or perovskite solar cells. One effective approach to improve the efficiency of OPVs is to introduce additives to enhance light harvesting as well as charge transportation in the devices. Here, black phosphorus quantum dots (BPQDs) are introduced in OPVs as an additive. By adding 0.055 wt % BPQDs relative to the polymer donors in the OPVs, the device efficiencies can be dramatically improved for more than 10 %. The weight percentage is much lower than that of any other additive used in OPVs before, which is mainly due to the two-dimentional structure as well as the strong broadband light absorption and scattering of the BPQDs. This work paves a way for using two-dimentional quantum dots in OPVs as a cost-effective approach to enhance device efficiencies.

Distinctive in-Plane Cleavage Behaviors of Two-Dimensional Layered Materials

Mechanical exfoliation from bulk layered crystal is widely used for preparing two-dimensional (2D) layered materials, which involves not only out-of-plane interlayer cleavage but also in-plane fracture. Through a statistical analysis on the exfoliated 2D flakes, we reveal the in-plane cleavage behaviors of six representative layered materials, including graphene, h-BN, 2H phase MoS2, 1T phase PtS2, FePS3, and black phosphorus. In addition to the well-known interlayer cleavage, these 2D layered materials show a distinctive tendency to fracture along certain in-plane crystallography orientations. With theoretical modeling and analysis, these distinct in-plane cleavage behaviors can be understood as a result of the competition between the release of the elastic energy and the increase of the surface energy during the fracture process. More importantly, these in-plane cleavage behaviors provide a fast and noninvasive method using optical microscopy to identify the lattice direction of mechanical exfoliated 2D layered materials.