Siddharth Alur

Raman analysis of longitudinal optical phonon-plasmon coupled modes of aligned ZnO nanorods

The electronic properties of vertically aligned ZnO nanorods have been investigated using micro-Raman spectroscopy. The concentration and mobility of the charge carriers were determined via Raman line shape analysis using longitudinal-optical-phonon-plasmon coupled mode. The local laser heating and the stress effects have been considered when analyzing the Raman spectra. The mobility and carrier concentration of the aligned ZnO nanorods are 84.8cm2∕Vs and 3.8×1017cm−3, respectively. As a comparison, the mobility and carrier concentration of the undoped bulk ZnO were also obtained from the Raman line shape analysis. The mobility of the aligned ZnO nanorods is about 20% lower than that of the undoped bulk ZnO, which can be attributed to enhanced surface scattering due to the reduction in dimension.

Ultra-low leakage and high breakdown Schottky diodes fabricated on free-standing GaN substrate

Vertical Schottky diodes were fabricated on the bulk GaN substrate with decreasing impurity concentration from N-face to Ga-face. An array of circular Pt Schottky contacts and a full backside Ti/Al/Ni/Au ohmic contact were prepared on the Ga-face and the N-face of the n-GaN substrate, respectively. The Schottky diode exhibits a minimum specific on-state

Biofunctionalized AlGaN/GaN high electron mobility transistor for DNA hybridization detection

Label-free electrical detection of deoxyribonucleic acid (DNA) hybridization was demonstrated using an AlGaN/GaN high electron mobility transistor (HEMT) based transducer with a biofunctionalized gate. The HEMT DNA sensor employed the immobilization of amine-modified single strand DNA on the self-assembled monolayers of 11-mercaptoundecanoic acid. The sensor exhibited a substantial current drop upon introduction of complimentary DNA to the gate well, which is a clear indication of the hybridization. The application of 3 base-pair mismatched target DNA showed little change in output current characteristics of the transistor. Therefore, it can be concluded that our DNA sensor is highly specific to DNA sequences.