Srinivasan Shanmugam

Formulation and in vitro assessment of minoxidil niosomes for enhanced skin delivery

Niosomes have been reported as a possible approach to improve the low skin penetration and bioavailability characteristics shown by conventional topical vehicle for minoxidil. Niosomes formed from polyoxyethylene alkyl ethers (Brij) or sorbitan monoesters (Span) with cholesterol molar ratios of 0, 1 and 1.5 were prepared with varying drug amount 20-50mg using thin film-hydration method. The prepared systems were characterized for entrapment efficiency, particle size, zeta potential and stability. Skin permeation studies were performed using static vertical diffusion Franz cells and hairless mouse skin treated with either niosomes, control minoxidil solution (propylene glycol-water-ethanol at 20:30:50, v/v/v) or a leading topical minoxidil commercial formulation (Minoxyl). The results showed that the type of surfactant, cholesterol and incorporated amount of drug altered the entrapment efficiency of niosomes. Higher entrapment efficiency was obtained with the niosomes prepared from Span 60 and cholesterol at 1:1 molar ratio using 25mg drug. Niosomal formulations have shown a fairly high retention of minoxidil inside the vesicles (80%) at refrigerated temperature up to a period of 3 months. It was observed that both dialyzed and non-dialyzed niosomal formulations (1.03+/-0.18 to 19.41+/-4.04%) enhanced the percentage of dose accumulated in the skin compared to commercial and control formulations (0.11+/-0.03 to 0.48+/-0.17%) except dialyzed Span 60 niosomes. The greatest skin accumulation was always obtained with non-dialyzed vesicular formulations. Our results suggest that these niosomal formulations could constitute a promising approach for the topical delivery of minoxidil in hair loss treatment.

Solid self-nanoemulsifying drug delivery system (S-SNEDDS) containing phosphatidylcholine for enhanced bioavailability of highly lipophilic bioactive carotenoid lutein

The objectives of this study was to prepare solid self-nanoemulsifying drug delivery system (S-SNEDDS) containing phosphatidylcholine (PC), an endogenous phospholipid with excellent in vivo solubilization capacity, as oil phase for the delivery of bioactive carotenoid lutein, by spray drying the SNEDDS (liquid system) containing PC using colloidal silica (Aerosil® 200 VV Pharma) as the inert solid carrier, and to evaluate the enhanced bioavailability (BA) of lutein from S-SNEDDS. The droplet size analyses revealed droplet size of less than 100 nm. The solid state characterization of S-SNEDDS by SEM, DSC, and XRPD revealed the absence of crystalline lutein in the S-SNEDDS. The bioavailability study performed in rabbits resulted in enhanced values of C(max) and AUC for S-SNEDDS. The enhancement of C(max) for S-SNEDDS was about 21-folds and 8-folds compared with lutein powder (LP) and commercial product (CP), respectively. The relative BA of S-SNEDDS compared with CP or LP was 2.74-folds or 11.79-folds, respectively. These results demonstrated excellent ability of S-SNEDDS containing PC as oil phase to enhance the BA of lutein in rabbits. Thus, S-SNEDDS containing PC as oil phase could be a useful lipid drug delivery system for enhancing the BA of lutein in vivo.

Novel self-nanoemulsifying drug delivery system for enhanced solubility and dissolution of lutein

Self-nanoemulsifying drug delivery system (SNEDDS) containing oil (Phosal 53 MCT), surfactant (Labrasol), and cosurfactant (Transcutol-HP or Lutrol-E400) was prepared to enhance solubility and dissolution of lutein. Ternary phase diagram of the SNEDDS was constructed to identify the self-emulsifying regions following which the percentage of oil, surfactant, and cosurfactant in the SNEDDS were optimized in terms of emulsification time and mean emulsion droplet size. The optimized SNEDDS consists of 25% oil, 60% surfactant, and 15% cosurfactant. When measured using USP XXIII dissolution apparatus II, the emulsification time of the SNEDDS prepared with Transcutol-HP as cosurfactant was less than 20 sec, and it was 20–30 sec in the SNEDDS prepared with Lutrol-E400. Mean emulsion droplet size was slightly smaller when Transcutol-HP was used as cosurfactant (80 ± 6 nm), compared to when Lutrol- E400 was used (93 ± 6 nm). Dissolution of lutein from the solid SNEDDS (physical mixture of the optimized SNEDDS and Aerosil 200) took place immediately (less than 5 min) in distilled water, and, once dissolved, no precipitation or aggregation of the drug were observed. In contrast, no drug was released from lutein powder or from the commercial product (Eyelac®) until 3 h of the study duration.

New clopidogrel napadisilate salt and its solid dispersion with improved stability and bioequivalence to the commercial clopidogrel bisulphate salt in beagle dogs

The purpose of this study was to develop a novel clopidogrel napadisilate-loaded solid dispersion with improved stability and bioequivalence to the clopidogrel bisulphate-loaded commercial product. Clopidogrel napadisilate prepared in this study appeared as a white crystalline powder unlike clopidogrel base. However, this salt did not improve the solubility of clopidogrel, even with improved stability compared to clopidogrel bisulphate. To improve the solubility of clopidogrel napadisilate, a novel clopidogrel napadisilate-loaded solid dispersion was prepared by the spray-drying technique using HPMC and colloidal silica, and the physicochemical properties, dissolution and bioavailability in beagle dogs were evaluated compared to the clopidogrel bisulphate-loaded commercial product. The solid dispersion composed of clopidogrel napadisilate, HPMC and colloidal silica at a weight ratio of 11.069/3/3.5 improved solubility by 6.5-fold compared to clopidogrel napadisilate, even if it did not improve drug solubility compared to clopidogrel bisulphate. However, unlike clopidogrel bisulphate, this formulation improved the stability of clopidogrel. Furthermore, the clopidogrel napadisilate solid dispersion-loaded tablet showed similar dissolution to the clopidogrel bisulphate-loaded commercial product and was bioequivalent to the commercial product in beagle dogs. Thus, this clopidogrel napadisilate-loaded solid dispersion could be a promising candidate for improving the stability and bioavailability of clopidogrel.

Physicochemical characterization and skin permeation of liposome formulations containing clindamycin phosphate

This study was undertaken to evaluate the physicochemical properties and skin permeation of liposome formulations containing clindamycin phosphate (CP), especially when charge was imparted to the liposome. Five different liposome formulations were prepared using Phospholipon 85G (PL) and cholesterol (CH) by conventional lipid film hydration technique. Molar ratio of CH to PL was varied in the range of 0.16–1.0. Charged liposomes were prepared in the same way with addition of 1,2-dioleoyl-3-trimethylammonium-propane chloride salt (DOTAP) and 1,2-dimyristoyl-sn-glycero-3-phosphate monosodium salt (DMPA) as charge carrier lipid for cationic or anionic charge of the liposome, respectively. Fresh full-thickness mice skin was taken and used for skin permeation study using Keshary-Chien diffusion cell with 1.77 cm2 diffusion area at 37°C. All liposome formulations prepared showed homogeneous size distribution with mean particle size of about 1 μm or less. Among the five liposome formulations prepared, formulation with the molar ratio of 0.5 showed the best result in the physicochemical properties such as polydispersity index, entrapment efficiency, size evolution, and ability of the liposome to retain CP as of entrapped in the vesicles. Charge-impartation of the formulation with cationic charge carrier lipid resulted in additional benefit in terms of inhibition of size evolution, the ability of the liposome to retain CP in the vesicles, and skin permeation. Steady state flux of the drug through the mice skin in the cationic liposome vesicles was 0.75 ± 0.01 μg/cm2h while that in the control (dissolved into mixed alcohol solution) was 0.17 μg/cm2h. One half molar ratio of CH to PL was optimal in terms of physicochemical properties of the liposome formulation containing CP, and incorporation of cationic charge carrier lipid appeared to provide additional benefits for the stability of the liposome formulation and skin permeation of the drug.

Skin penetration and retention of L-Ascorbic acid 2-phosphate using multilamellar vesicles

Transdermal formulation of L-ascorbic acid 2-phosphate magnesium salt (A2P) was prepared using multilamellar vesicles (MLV). A2P was either physically mixed with or entrapped into three different MLVs of neutral, cationic, and anionic liposome vesicles. For the preparation of neutral MLVs, phosphatidylcholine (PC) and cholesterol (CH) were used. For cationic and anionic MLVs, dioleoyl-trimethylammonium-propane and dimyristoyl glycerophosphate were added as surface charge inducers, respectively, in addition to PC and CH. Particle size of the three A2P-loaded MLVs was submicron, and polydispersity index revealed homogenous distribution of the prepared MLVs except neutral ones. Skin penetration study with hairless mouse skin showed that both physical mixtures of A2P with empty MLVs and A2P-loaded MLVs increased penetration of the drug compared to aqueous A2P solution. During the penetration, however, significant amount of the drug was metabolized into L-ascorbic acid, which has no beneficial effect on stimulation of hair growth. Out of the physical mixtures and A2P-loaded MLVs tested, physical mixture of A2P with empty cationic MLV resulted in the greatest skin penetration and retention in hairless mouse skin.

Preparation and evaluation of Cremophor-free paclitaxel solid dispersion by a supercritical antisolvent process

Objectives  To avoid the major adverse effects induced by Cremophor EL formulated in the commercial paclitaxel products of Taxol.

Mixed micellar nanoparticle of amphotericin b and poly styrene-block-poly ethylene oxide reduces nephrotoxicity but retains antifungal activity

Mixed micellar nanoparticle consisting of amphotericin B (AmB) and poly styrene-block-poly ethylene oxide (PS-block-PEO) was prepared by high pressure homogenizer. Nephrotoxicity of the nanoparticle was investigated along with antifungal activity and self-aggregation status of the drug in the nanoparticle. Nephrotoxicity was markedly reduced when AmB was intravenously administered to rats as mixed micellar nanoparticle with PS-block-PEO in terms of transmission electron microscopy of tubular cells and creatinine clearance. Antifungal activity of AmB was not altered when the drug was in the form of mixed micellar nanoparticle compared to both conventional formulation and AmB micelle treated by same procedure without PS-block-PEO. Self-aggregation status of AmB molecules revealed monomeric in the mixed micellar nanoparticle with PS-block-PEO up to the therapeutic level of the drug (1-3 mM). The reduced nephrotoxicity of AmB in mixed micellar nanoparticle may be associated with the existence of the drug as monomeric form in the nanoparticle. Based on our result, formulation of AmB as mixed micellar nanoparticle with PS-block-PEO may be a promising alternative for the treatment of fungal diseases in patients who are at risk of renal dysfunction.

Physicochemical stability, pharmacokinetic, and biodistribution evaluation of paclitaxel solid dispersion prepared using supercritical antisolvent process

Aim: To investigate the physicochemical stability, pharmacokinetics (PK), and biodistribution of paclitaxel (PTX) from paclitaxel solid dispersion (PSD) prepared by supercritical antisolvent (SAS) process. Methods: Physicochemical stability was performed in accelerated (40°C 70 ± 5% RH) and stress (60°C) storage conditions for a period of 6 months and 4 weeks, respectively. PK and biodistribution studies were performed in rats following i.v. administration of PTX equivalent to 6 and 12 mg/kg formulations. Results: Physical stability of PSD showed excellent stability with no recrystallization of the amorphous form. Chemical stability of PSD in terms of % PTX remaining was 98.2 ± 0.6% at 6 months and 97.9 ± 0.3% at 4 weeks of accelerated and stress conditions, respectively. The PK study showed a nonlinear increase in AUC with increasing dose, that is, 100% increase in dose (from 6 to 12 mg/kg) resulted in 405.90% increase in AUC. Unlike PK study, the organ distribution study of PTX from PSD showed linear relationship with dose escalation. The order of organ distribution of PTX from highest to lowest for both PSD and Taxol® was liver>kidney>lung>brain. Conclusions: This study demonstrated excellent physicochemical stability with insight information on the PK and biodistribution of PTX from PSD prepared by SAS process.

Enhanced oral bioavailability of paclitaxel by solid dispersion granulation

Abstract The main objective of this study was to develop novel orally administrable tablets containing solid dispersion granules (SDG) of amorphous paclitaxel (PTX) prepared by fluid bed technology, and to evaluate its in vitro dissolution and in vivo pharmacokinetics (PK) in beagle dogs. The SDG were prepared using optimized composition by fluid bed technology, and characterized for solid-state properties. The release study of SDG tablet (SDG-T) in simulated gastric fluid showed a rapid release of PTX, reaching maximum dissolution within 20 min. Finally, the PK profile of SDG-T and a reference formulation Oraxol™ (oral solution formulation used in Phase I clinical study) at a dose of 60 mg orally with co-administration of P-gp inhibitor HM38101, and Taxol® at a dose of 10 mg intravenously (i.v.) was investigated in beagle dogs. The mean absolute BA% of PTX following SDG-T and Oraxol™ solution was 8.23 and 6.22% in comparison to i.v. administration of Taxol®. The relative BA% of PTX from SDG-T in comparison to Oraxol™ solution was 132.25% at a dose of 60 mg following oral administration. In conclusion, we have successfully prepared PTX tablets with solid dispersion granules (SDG) of amorphous PTX using fluid bed technology that could provide plasma PTX concentration in the range of 10–150 ng/mL for a period of 24 h following oral administration in dogs with a P-gp inhibitor. Hence, this could be a promising formulation for PTX oral delivery and could be used in our intended clinical studies following pre-clinical efficacy studies.