Stefan Pollnow

Simulation of intracardiac electrograms around acute ablation lesions

Abstract Radiofrequency ablation (RFA) is a widely used clinical treatment for many types of cardiac arrhythmias. However, nontransmural lesions and gaps between linear lesions often lead to recurrence of the arrhythmia. Intracardiac electrograms (IEGMs) provide real-time information regarding the state of the cardiac tissue surrounding the catheter tip. Nevertheless, the formation and interpretation of IEGMs during the RFA procedure is complex and yet not fully understood. In this in-silico study, we propose a computational model for acute ablation lesions. Our model consists of a necrotic scar core and a border zone, describing irreversible and reversible temperature induced electrophysiological phenomena. These phenomena are modeled by varying the intra- and extracellular conductivity of the tissue as well as a regulating zone factor. The computational model is evaluated regarding its feasibility and validity. Therefore, this model was compared to an existing one and to clinical measurements of five patients undergoing RFA. The results show that the model can indeed be used to recreate IEGMs. We computed IEGMs arising from complex ablation scars, such as scars with gaps or two overlapping ellipsoid scars. For orthogonal catheter orientation, the presence of a second necrotic core in the near-field of a punctiform acute ablation lesion had minor impact on the resulting signal morphology. The presented model can serve as a base for further research on the formation and interpretation of IEGMs.

A phantom with pulsating artificial vessels for non-invasive fetal pulse oximetry

Arterial oxygen saturation of the fetus is an important parameter for monitoring its physical condition. During labor and delivery the transabdominal non-invasive fetal pulse oximetry could minimize the risk for mother and fetus, compared to other existing invasive examination methods. In this contribution, we developed a physical-like phantom to investigate new sensor circuits and algorithms of a non-invasive diagnostic method for fetal pulse oximetry. Hence, the developed artificial vascular system consists of two independent tube systems representing the maternal and fetal vessel system. The arterial blood pressure is reproduced with a pre-pressure and an artificial vascular system. Each pulse wave can be reproduced, by digital control of a proportional valve, adjustable viscoelastic elements, and resistances. The measurements are performed by pressure transducers, optical sensor units, and a coplanar capacitive sensor. Transmission and reflection measurements have shown that the fetal and maternal pulse waves can be reproduced qualitatively. The measured light represents the transabdominal modulated signal on an abdomen of a pregnant woman.

Hyperthermia dependence of cardiac conduction velocity in rat myocardium: Optical mapping and cardiac near field measurements

Hyperthermia during radiofrequency ablation causes reversible and irreversible changes of the electrophysiological properties of cardiac tissue. However, the mechanisms are incompletely understood. We studied changes of conduction velocity (CV) in rat myocardium under hyperthermic conditions from macroscopic to microscopic scale by using simultaneous optical mapping and a miniaturized electrode array. Atrial preparations from five rats were superfused at tissue bath temperatures between 36.7°C and 43.8°C. Optical mapping data showed an elevated median CV by 21% when increasing the temperature from 36.7°C to 42.0°C. CV did not increase above 42.0°C. Electrical measurements revealed a similar temperature dependence of CV between 36.7°C and 42.0°C, i.e. an increase of median CV by 26%. The consolidation of optical and electrical data in this study allowed investigation of excitation during global hyperthermia. Macroscopic optical mapping and microscopic electrical measurements demonstrated that hyperthermia strongly influenced electrical propagation at a microscopic scale.

Atrial Signals – Modeling Meets Biosignal Analysis

Today, patients suffering from atrial arrhythmias like atrial flutter (AFlut) or atrial fibrillation (AFib) are examined in the EP-lab (electrophysiology lab) in order to understand and treat the disease. Multichannel catheters are advanced into the atria in order to measureelectric signals at manyintracardiacpositions simultaneously. Complementary to clinical learning,comprehension of the disease and therapeutic strategies can be improved with computer modeling of the heart. This way, hypotheses about initiation and perpetuation of the arrhythmia can be tested and ablation strategies can be assessed in-silico. Modeling and biosignal analysis can benefit from mutual fertilization. On the one hand, modeling can be improved and personalization can be achieved via high density mapping of the atria. On the other hand, new algorithms for the interpretation of multichannel electrograms can be developed and evaluated with synthetic signals from computer models of the atria. This article illustrates the synergetic potential by examples and highlights challenges to be addressed in the future.

Mini Electrodes on Ablation Catheters: Valuable Addition or Redundant Information?—Insights from a Computational Study

Radiofrequency ablation has become a first-line approach for curative therapy of many cardiac arrhythmias. Various existing catheter designs provide high spatial resolution to identify the best spot for performing ablation and to assess lesion formation. However, creation of transmural and nonconducting ablation lesions requires usage of catheters with larger electrodes and improved thermal conductivity, leading to reduced spatial sensitivity. As trade-off, an ablation catheter with integrated mini electrodes was introduced. The additional diagnostic benefit of this catheter is still not clear. In order to solve this issue, we implemented a computational setup with different ablation scenarios. Our in silico results show that peak-to-peak amplitudes of unipolar electrograms from mini electrodes are more suitable to differentiate ablated and nonablated tissue compared to electrograms from the distal ablation electrode. However, in orthogonal mapping position, no significant difference was observed between distal electrode and mini electrodes electrograms in the ablation scenarios. In conclusion, catheters with mini electrodes bring about additional benefit to distinguish ablated tissue from nonablated tissue in parallel position with high spatial resolution. It is feasible to detect conduction gaps in linear lesions with this catheter by evaluating electrogram data from mini electrodes.

High-density Mapping Reveals Short-term Reversibility of Atrial Ablation Lesions

Abstract Cardiac arrhythmias such as atrial fibrillation occur frequently in industrialized countries. Radiofrequency ablation (RFA) is a standard treatment if drug therapy fails. This minimally invasive surgery aims at stabilizing the heart rhythm on a permanent basis. However, the procedure commonly needs to be repeated because of the high recurrence rate of arrhythmias. Non-transmural lesions as well as gaps within linear lesions are among the main problems during the RFA. The assessment of lesion formation is not adequate in state of the art procedures. Therefore, the aim of this study is to investigate the short-term reversibility of lesions using human electrograms recorded by a high-density mapping system during an electrophysiological study (EPS). A predefined measurement protocol was executed during the EPS in order to create three ablation points in the left atrium. Subsequently, after preprocessing the recorded signals, electrogram (EGM) paths were formed along the endocardial surface of the atrium. By analyzing changes of peak to peak amplitudes of unipolar EGMs before and after ablation, it was possible to distinguish lesion area and healthy myocardium. The peak to peak amplitudes of the EGMs decreased by 40-61% after 30 seconds of ablation. Furthermore, we analyzed the morphological changes of EGMs surrounding the lesion. High-density mapping data showed that not only the tissue, which had direct contact with the catheter tip during the RFA, but also the surrounding tissue was affected. This was demonstrated by low peak to peak amplitudes in large areas with a width of 14 mm around the center of the ablation lesion. After right pulmonary vein isolation, high-density mapping was repeated on the previous lesions. The outer region of RFA-treated tissue appears to recover as opposed to the central core of the ablation point. This observation suggests that the meaningfulness of an immediate remap after ablation during an EPS may lead the physician to false conclusions

An adaptive spatio-temporal Gaussian filter for processing cardiac optical mapping data

Optical mapping is widely used as a tool to investigate cardiac electrophysiology in ex vivo preparations. Digital filtering of fluorescence-optical data is an important requirement for robust subsequent data analysis and still a challenge when processing data acquired from thin mammalian myocardium. Therefore, we propose and investigate the use of an adaptive spatio-temporal Gaussian filter for processing optical mapping signals from these kinds of tissue usually having low signal-to-noise ratio (SNR). We demonstrate how filtering parameters can be chosen automatically without additional user input. For systematic comparison of this filter with standard filtering methods from the literature, we generated synthetic signals representing optical recordings from atrial myocardium of a rat heart with varying SNR. Furthermore, all filter methods were applied to experimental data from an ex vivo setup. Our developed filter outperformed the other filter methods regarding local activation time detection at SNRs smaller than 3 dB which are typical noise ratios expected in these signals. At higher SNRs, the proposed filter performed slightly worse than the methods from literature. In conclusion, the proposed adaptive spatio-temporal Gaussian filter is an appropriate tool for investigating fluorescence-optical data with low SNR. The spatio-temporal filter parameters were automatically adapted in contrast to the other investigated filters.

Assessment of local high-density mapping for the analysis of radiofrequency ablation lesions in the left atrium

Abstract Recent studies about the development of endocardial radiofrequency (RF) ablation lesions (ALs) tried to identify reliable electrogram (EGM) markers for assessment of lesion transmurality. Additional clinically relevant information for physicians can be provided by examining endocardial EGM parameters like signal morphology, amplitude or time points in the signal. We investigated EGM features of the pulmonary vein ostia before and after RF ablation for three point-shaped lesions. Using high-density (HD) mapping, local activation time (LAT) and voltage maps were created, which provided information about the RF ALs regarding the lesion size and showed activation time delay as well as low-voltage areas with bipolar peak-to-peak voltages smaller than 2mV. The time delay of the depolarization front comparing the activation times anterior and posterior to the RF AL was up to 51.5 ms. In a circular area with 5mm radius around an RF AL the mean peak-to-peak voltage decreased by 62-94% to about 0.12-0.44mV and the mean maximal absolute EGM derivative was reduced by 65-96 %. Comparing the results of this study with EGMs of similar clinical settings confirmed our expectations regarding the low-voltage areas caused by the ablation procedure. An improved understanding of the electrophysiological changes is of fundamental importance to provide more information for enhanced RF ablation assessment.

3D reconstruction of ablation lesions from in-vitro preparations using MRI

Abstract Radiofrequency ablation is the gold standard for treating cardiac arrhythmias. However, the success rate of this procedure depends on numerous parameters. Wet lab experiments provide the opportunity to investigate cardiac electrophysiology under reproducible conditions. To evaluate the electrophysiological changes of ablated myocardium in these studies it is necessary to consider the three-dimensional (3D) geometry of the lesions. For this purpose, we investigated the usage of different magnetic resonance imaging (MRI) sequences as well as an image processing procedure to analyze in-vitro preparations. To differentiate signal intensities between nonablated and ablated tissue we evaluated FISP (fast imaging with steady-state precession; delivering dominantly T1-weighted images) and RARE (rapid acquisition with relaxation enhancement; delivering dominantly T2-weighted images). After image processing, the ablated tissue was segmented in each image slice forming a 3D volume. The geometry of the lesion was modeled by the boundary of this volume. It was generally feasible to distinguish between healthy myocardium and ablated tissue as well as to determine lesion transmurality. The analysis of the reconstructed lesion geometries from FISP and RARE MRI showed a high agreement, however T2-weighted sequences showed larger lesion volumes as well as higher variations in segmentation compared to T1- mapping. FISP with higher quality may be used to reconstruct the 3D geometry of the ablation lesions.

Automatic lung segmentation in the presence of alveolar collapse

Abstract Lung ventilation and perfusion analyses using chest imaging methods require a correct segmentation of the lung to offer anatomical landmarks for the physiological data. An automatic segmentation approach simplifies and accelerates the analysis. However, the segmentation of the lungs has shown to be difficult if collapsed areas are present that tend to share similar gray values with surrounding non-pulmonary tissue. Our goal was to develop an automatic segmentation algorithm that is able to approximate dorsal lung boundaries even if alveolar collapse is present in the dependent lung areas adjacent to the pleura. Computed tomography data acquired in five supine pigs with injured lungs were used for this purpose. First, healthy lung tissue was segmented using a standard 3D region growing algorithm. Further, the bones in the chest wall surrounding the lungs were segmented to find the contact points of ribs and pleura. Artificial boundaries of the dorsal lung were set by spline interpolation through these contact points. Segmentation masks of the entire lung including the collapsed regions were created by combining the splines with the segmentation masks of the healthy lung tissue through multiple morphological operations. The automatically segmented images were then evaluated by comparing them to manual segmentations and determining the Dice similarity coefficients (DSC) as a similarity measure. The developed method was able to accurately segment the lungs including the collapsed regions (DSCs over 0.96).