Stefano Uberti

The influence of suspension components friction on race car vertical dynamics

ABSTRACT This work analyses the effect of friction in suspension components on a race car vertical dynamics. It is a matter of fact that race cars aim at maximising their performance, focusing the attention mostly on aerodynamics and suspension tuning: suspension vertical and rolling stiffness and damping are parameters to be taken into account for an optimal setup. Furthermore, friction in suspension components must not be ignored. After a test session carried out with a F4 on a Four Poster rig, friction was detected on the front suspension. The real data gathered allow the validation of an analytical model with friction, confirming that its influence is relevant for low frequency values closed to the car pitch natural frequency. Finally, some setup proposals are presented to describe what should be done on actual race cars in order to correct vehicle behaviour when friction occurs.

Mechanical steering gear internal friction: effects on the drive feel and development of an analytic experimental model for its prediction

The automotive steering system inevitably presents internal friction that affects its response. This is why internal friction phenomena are carefully monitored either by OEMs and by vehicle manufacturers. An algorithm to predict the mechanical efficiency and the internal friction of a steering gear system has been developed by the ZF-TRW Technical Centre of Gardone Val Trompia and the University of Brescia, Italy. It is focused on mechanical steering gear of the rack and pinion type. The main contributions to the overall friction have been identified and modelled. The work is based on theoretical calculation as well as on experimental measurements carried out on a purpose-built test rig. The model takes into account the materials used and the gear mesh characteristics and enables the prediction of the steering gear friction performance before the very first prototypes are built.

Gölem project: Concept and design of a trekking/hiking wheelchair

This work concerns the growing interest in accessible tourism and describes the early stages of development of Gölem project. In particular, it takes into account accompanying activities of disabled people in mountain areas. Although literature and market analysis highlight the presence of different technical solutions used for the movement of disabled persons on rough terrains, there are only a couple of solutions based on the help of guides: Joëlette© and TrailRider©. Even if the use of these devices is generally satisfactory, our analysis has highlighted the presence of some limitations such as the difficulty of maintaining the lateral balance of the devices (which involves a considerable physical effort for the guides) and their reduced comfort for the passenger. This article describes the activities developed within the Gölem project. Its main goals are to design and to test an improved model of trekking/hiking wheelchair taking into account passengers comfort and better functionality of the device. At this moment, the design and modeling phases with the definition of dynamic parameters and of the suspension system of the device have been completed. The prototype implementation phase is in progress. Future activities will provide validation and field testing of the new solution with users.