Sunao Miyashita

Measurement of the first ionization potential of lawrencium, element 103

The chemical properties of an element are primarily governed by the configuration of electrons in the valence shell. Relativistic effects influence the electronic structure of heavy elements in the sixth row of the periodic table, and these effects increase dramatically in the seventh row—including the actinides—even affecting ground-state configurations. Atomic s and p1/2 orbitals are stabilized by relativistic effects, whereas p3/2, d and f orbitals are destabilized, so that ground-state configurations of heavy elements may differ from those of lighter elements in the same group. The first ionization potential (IP1) is a measure of the energy required to remove one valence electron from a neutral atom, and is an atomic property that reflects the outermost electronic configuration. Precise and accurate experimental determination of IP1 gives information on the binding energy of valence electrons, and also, therefore, on the degree of relativistic stabilization. However, such measurements are hampered by the difficulty in obtaining the heaviest elements on scales of more than one atom at a time. Here we report that the experimentally obtained IP1 of the heaviest actinide, lawrencium (Lr, atomic number 103), is electronvolts. The IP1 of Lr was measured with 256Lr (half-life 27 seconds) using an efficient surface ion-source and a radioisotope detection system coupled to a mass separator. The measured IP1 is in excellent agreement with the value of 4.963(15) electronvolts predicted here by state-of-the-art relativistic calculations. The present work provides a reliable benchmark for theoretical calculations and also opens the way for IP1 measurements of superheavy elements (that is, transactinides) on an atom-at-a-time scale.

Synthesis and detection of a seaborgium carbonyl complex

A carbonyl compound that tips the scales Life is short for the heaviest elements. They emerge from high-energy nuclear collisions with scant time for detection before they break up into lighter atoms. Even et al. report that even a few seconds is long enough for carbon to bond to the 106th element, seaborgium (see the Perspective by Loveland). The authors used a custom apparatus to direct the freshly made atoms out of the hot collision environment and through a stream of carbon monoxide and helium. They compared the detected products with theoretical modeling results and conclude that hexacarbonyl Sg(CO)6 was the most likely structural formula. Science, this issue p. 1491; see also p. 1451 A special apparatus enables synthesis of a compound with carbon bonds to a short-lived element produced via nuclear reaction. [Also see Perspective by Loveland] Experimental investigations of transactinoide elements provide benchmark results for chemical theory and probe the predictive power of trends in the periodic table. So far, in gas-phase chemical reactions, simple inorganic compounds with the transactinoide in its highest oxidation state have been synthesized. Single-atom production rates, short half-lives, and harsh experimental conditions limited the number of experimentally accessible compounds. We applied a gas-phase carbonylation technique previously tested on short-lived molybdenum (Mo) and tungsten (W) isotopes to the preparation of a carbonyl complex of seaborgium, the 106th element. The volatile seaborgium complex showed the same volatility and reactivity with a silicon dioxide surface as those of the hexacarbonyl complexes of the lighter homologs Mo and W. Comparison of the product’s adsorption enthalpy with theoretical predictions and data for the lighter congeners supported a Sg(CO)6 formulation.

Bonding Study on the Chemical Separation of Am(III) from Eu(III) by S-, N-, and O-Donor Ligands by Means of All-Electron ZORA-DFT Calculation.

We performed a theoretical investigation for the selectivity of Eu(III)/Am(III) ions depending on the donor atoms by means of all-electron ZORA-DFT calculation. We estimated their selectivity as the relative stability in the complex formation reaction. The B2PLYP functional reproduced the experimental selectivity in which S- and N-donor ligands favor Am(III) ion, but O-donor ligand favors Eu(III) ion. Mullikens bond overlap population analysis revealed that the contribution of the f orbital to the bonding was small or zero for Eu complex, whereas it was large for Am complex. The bonding nature of the f orbital for Am ion was the bonding type to S- and N-donor ligands, while it was the antibonding type to O-donor ligand. It was suggested that the difference in the bonding nature between the f orbital in the metal and the donor atoms determines the selectivity of Eu(III)/Am(III) by donor ligands.

First successful ionization of Lr (Z = 103) by a surface-ionization technique

We have developed a surface ionization ion-source as part of the JAEA-ISOL (Isotope Separator On-Line) setup, which is coupled to a He/CdI2 gas-jet transport system to determine the first ionization potential of the heaviest actinide lawrencium (Lr, Z = 103). The new ion-source is an improved version of the previous source that provided good ionization efficiencies for lanthanides. An additional filament was newly installed to give better control over its operation. We report, here, on the development of the new gas-jet coupled surface ion-source and on the first successful ionization and mass separation of 27-s (256)Lr produced in the (249)Cf + (11)B reaction.

Decomposition studies of group 6 hexacarbonyl complexes. Part 1: Production and decomposition of Mo(CO)6 and W(CO)6

Abstract Chemical studies of superheavy elements require fast and efficient techniques, due to short half-lives and low production rates of the investigated nuclides. Here, we advocate for using a tubular flow reactor for assessing the thermal stability of the Sg carbonyl complex – Sg(CO)6. The experimental setup was tested with Mo and W carbonyl complexes, as their properties are established and supported by theoretical predictions. The suggested approach proved to be effective in discriminating between the thermal stabilities of Mo(CO)6 and W(CO)6. Therefore, an experimental verification of the predicted Sg–CO bond dissociation energy seems to be feasible by applying this technique. By investigating the effect of 104,105Mo beta-decay on the formation of 104,105Tc carbonyl complex, we estimated the lower reaction time limit for the metal carbonyl synthesis in the gas phase to be more than 100u2009ms. We examined further the influence of the wall material of the recoil chamber, the carrier gas composition, the gas flow rate, and the pressure on the production yield of 104Mo(CO)6, so that the future stability tests with Sg(CO)6 can be optimized accordingly.

Development of a new continuous dissolution apparatus with a hydrophobic membrane for superheavy element chemistry

A new technique for continuous dissolution of nuclear reaction products transported by a gas-jet system was developed for superheavy element (SHE) chemistry. In this technique, a hydrophobic membrane is utilized to separate an aqueous phase from the gas phase. With this technique, the dissolution efficiencies of short-lived radionuclides of 91m,93mMo and 176W were measured. Yields of more than 80xa0% were observed for short-lived radionuclides at aqueous-phase flow rates of 0.1–0.4xa0mL/s. The gas flow-rate had no influence on the dissolution efficiency within the studied flow range of 1.0–2.0 L/min. These results show that this technique is applicable for on-line chemical studies of SHEs in the liquid phase.

Development of a He/CdI2 gas-jet system coupled to a surface-ionization type ion-source in JAEA-ISOL: towards determination of the first ionization potential of Lr (Z = 103)

We report on development of a gas-jet transport system coupled to a surface ionization ion-source in the JAEA-ISOL (Isotope Separator On-Line) system. As a new aerosol material for the gas-jet system, CdI2, which has a low boiling point of 713xa0°C, is exploited to prevent deposition of the aerosol material on the surface of the ion-source. An additional filament is newly installed in the previous ion-source to provide uniform heating of an ionizer. The present system is applied to the measurement of absolute efficiencies of various short-lived lanthanide isotopes produced in nuclear reactions.

Chemical studies of Mo and W in preparation of a seaborgium (Sg) reduction experiment using MDG, FEC, and SISAK

The extraction and reduction behavior of Mo and W, lighter homologs of Sg, was studied in continuous on-line experiments at the JAEA tandem accelerator to develop a new chemistry assembly consisting of a membrane degasser (MDG), a flow electrolytic column (FEC), and the continuous liquid–liquid extraction apparatus (SISAK). Extraction yields of Mo and W from 0.1xa0M HCl/0.9xa0M LiCl into 4-isopropyltropolone (hinokitiol, HT) in toluene were investigated. In the reduction experiment, Mo(VI) was successfully reduced to a lower oxidation state while W(VI) showed no reduction under the given conditions.

In situ synthesis of volatile carbonyl complexes with short-lived nuclides

Rapid in situ formation of metal carbonyl complexes with short-lived nuclides has been demonstrated to be feasible with recoiling ions formed in nuclear fusion and fission reactions. These carbonyl complexes are highly volatile and can be transported rapidly in a gas-stream to counting or chemistry devices. This method was already successfully applied in the chemical investigation of the superheavy element seaborgium (Zxa0=xa0106) and appears promising for various fields of nuclear research. In this article, we give an overview on the current status of metal carbonyl complex studies with short-lived d-element isotopes.

Deposition density of 134 Cs and 137 Cs and particle size distribution of soil and sediment profile in Hibara Lake area, Fukushima: an investigation of 134 Cs and 137 Cs indirect deposition into lake from surrounding area

Indirect deposition process of 134Cs and 137Cs beyond river system into Hibara Lake, Fukushima was investigated by analyzing the deposition density of 134Cs and 137Cs and particle size distribution of soil and sediment. Sediment samples of shallow area of lake adjacent to catchment with different slope were used. The sediment depth profile comparison among sampling areas showed faster 134Cs and 137Cs indirect deposition rate in sediment near steep slope area. 134Cs and 137Cs were concentrated dominantly in fine particle, indicating that the 134Cs and 137Cs incorporated to fine particle were dominant species in indirect deposition process.