Theodore G. Camenisch

Saturation recovery EPR and ELDOR at W-band for spin labels.

A reference arm W-band (94 GHz) microwave bridge with two sample-irradiation arms for saturation recovery (SR) EPR and ELDOR experiments is described. Frequencies in each arm are derived from 2 GHz synthesizers that have a common time-base and are translated to 94 GHz in steps of 33 and 59 GHz. Intended applications are to nitroxide radical spin labels and spin probes in the liquid phase. An enabling technology is the use of a W-band loop-gap resonator (LGR) [J.W. Sidabras, R.R. Mett, W. Froncisz, T.G. Camenisch, J.R. Anderson, J.S. Hyde, Multipurpose EPR loop-gap resonator and cylindrical TE(011) cavity for aqueous samples at 94 GHz, Rev. Sci. Instrum. 78 (2007) 034701]. The high efficiency parameter (8.2 GW(-1/2) with sample) permits the saturating pump pulse level to be just 5 mW or less. Applications of SR EPR and ELDOR to the hydrophilic spin labels 3-carbamoyl-2,2,5,5-tetra-methyl-3-pyrroline-1-yloxyl (CTPO) and 2,2,6,6,-tetramethyl-4-piperidone-1-oxyl (TEMPONE) are described in detail. In the SR ELDOR experiment, nitrogen nuclear relaxation as well as Heisenberg exchange transfer saturation from pumped to observed hyperfine transitions. SR ELDOR was found to be an essential method for measurements of saturation transfer rates for small molecules such as TEMPONE. Free induction decay (FID) signals for small nitroxides at W-band are also reported. Results are compared with multifrequency measurements of T(1e) previously reported for these molecules in the range of 2-35 GHz [J.S. Hyde, J.-J. Yin, W.K. Subczynski, T.G. Camenisch, J.J. Ratke, W. Froncisz, Spin label EPR T(1) values using saturation recovery from 2 to 35 GHz. J. Phys. Chem. B 108 (2004) 9524-9529]. The values of T(1e) decrease at 94 GHz relative to values at 35 GHz.

ELECTRON PARAMAGNETIC RESONANCE DETECTION BY TIME-LOCKED SUBSAMPLING

A detection method for electron paramagnetic resonance spectroscopy is described that permits simultaneous acquisition of multiple in- and out-of-phase harmonics of the response to magnetic-field modulation for both dispersion and absorption: (i) conversion of the microwave carrier to an intermediate frequency (IF) carrier; (ii) subsampling of the IF carrier by an analog-to-digital converter four times in K IF cycles where K is an odd integer; (iii) dividing the digital words into two streams, odd indexes in one and even in the other, followed by sign inversion of every other word in each stream; and (iv) feeding the two streams to a computer for the digital equivalent of phase-sensitive detection (PSD). The system is broadbanded, in the frequency domain, with narrow banding for improved signal-to-noise ratio occurring only at the PSD step. All gains and phases are internally consistent. The method is demonstrated for a nitroxide spin label. A fundamental improvement is achieved by collecting more informa...

Multipurpose EPR loop-gap resonator and cylindrical TE011 cavity for aqueous samples at 94GHz

A loop-gap resonator (LGR) and a cylindrical TE(011) cavity resonator for use at W band, 94 GHz, have been designed and characterized using the Ansoft (Pittsburgh, PA) high frequency structure simulator (HFSS; Version 10.0). Field modulation penetration was analyzed using Ansoft MAXWELL 3D (Version 11.0). Optimizing both resonators to the same sample sizes shows that EPR signal intensities of the LGR and TE(011) are similar. The 3 dB bandwidth of the LGR, on the order of 1 GHz, is a new advantage for high frequency experiments. Ultraprecision electric discharge machining (EDM) was used to fabricate the resonators from silver. The TE(011) cavity has slots that are cut into the body to allow penetration of 100 kHz field modulation. The resonator body is embedded in graphite, also cut by EDM techniques, for a combination of reasons that include (i) reduced microwave leakage and improved TE(011) mode purity, (ii) field modulation penetration, (iii) structural support for the cavity body, and (iv) machinability by EDM. Both resonators use a slotted iris. Variable coupling is provided by a three-stub tuning element. A collet system designed to hold sample tubes has been implemented, increasing repeatability of sample placement and reducing sample vibration noise. Initial results include multiquantum experiments up to 9Q using the LGR to examine 1 mM 2,2,6,6-tetramethylpiperidine-1-oxyl (TEMPO) in aqueous solution at room temperature and field modulation experiments using the TE(011) cavity to obtain an EPR spectrum of 1 microM TEMPO.

Detection of undistorted continuous wave (CW) electron paramagnetic resonance (EPR) spectra with non-adiabatic rapid sweep (NARS) of the magnetic field

A continuous wave (CW) electron paramagnetic resonance (EPR) spectrum is typically displayed as the first harmonic response to the application of 100 kHz magnetic field modulation, which is used to enhance sensitivity by reducing the level of 1/f noise. However, magnetic field modulation of any amplitude causes spectral broadening and sacrifices EPR spectral intensity by at least a factor of two. In the work presented here, a CW rapid-scan spectroscopic technique that avoids these compromises and also provides a means of avoiding 1/f noise is developed. This technique, termed non-adiabatic rapid sweep (NARS) EPR, consists of repetitively sweeping the polarizing magnetic field in a linear manner over a spectral fragment with a small coil at a repetition rate that is sufficiently high that receiver noise, microwave phase noise, and environmental microphonics, each of which has 1/f characteristics, are overcome. Nevertheless, the rate of sweep is sufficiently slow that adiabatic responses are avoided and the spin system is always close to thermal equilibrium. The repetitively acquired spectra from the spectral fragment are averaged. Under these conditions, undistorted pure absorption spectra are obtained without broadening or loss of signal intensity. A digital filter such as a moving average is applied to remove high frequency noise, which is approximately equivalent in bandwidth to use of an integrating time constant in conventional field modulation with lock-in detection. Nitroxide spectra at L- and X-band are presented.

W-band frequency-swept EPR

This paper describes a novel experiment on nitroxide radical spin labels using a multiarm EPR W-band bridge with a loop-gap resonator (LGR). We demonstrate EPR spectroscopy of spin labels by linear sweep of the microwave frequency across the spectrum. The high bandwidth of the LGR, about 1 GHz between 3 dB points of the microwave resonance, makes this new experiment possible. A frequency-tunable yttrium iron garnet (YIG) oscillator provides sweep rates as high as 1.8x10(5) GHz/s, which corresponds to 6.3 kT/s in magnetic field-sweep units over a 44 MHz range. Two experimental domains were identified. In the first, linear frequency sweep rates were relatively slow, and pure absorption and pure dispersion spectra were obtained. This appears to be a practical mode of operation at the present level of technological development. The main advantage is the elimination of sinusoidal magnetic field modulation. In the second mode, the frequency is swept rapidly across a portion of the spectrum, and then the frequency sweep is stopped for a readout period; FID signals from a swept line oscillate at a frequency that is the difference between the spectral position of the line in frequency units and the readout position. If there is more than one line, oscillations are superimposed. The sweep rates using the YIG oscillator were too slow, and the portion of the spectrum too narrow to achieve the full EPR equivalent of Fourier transform (FT) NMR. The paper discusses technical advances required to reach this goal. The hypothesis that trapezoidal frequency sweep is an enabling technology for FT EPR is supported by this study.

Electron paramagnetic resonance Q‐band bridge with GaAs field‐effect transistor signal amplifier and low‐noise Gunn diode oscillator

A Varian Q‐band E‐110 microwave bridge for electron paramagnetic resonance (EPR) spectroscopy has been modified by addition of a low‐phase noise Gunn diode oscillator of our own design, a low‐noise GaAs field‐effect transistor microwave signal amplifier, and a balanced mixer requiring high input power (10 mW) at the local oscillator port. The oscillator has previously been found to have −129 dBc/Hz phase noise, 22 dB lower than for the original klystron. Noise measurements indicate that the microwave amplifier and mixer reduce the overall receiver noise figure by 24.6 dB, a very significant improvement. It is shown that reduction of both phase noise and receiver noise are required in order to achieve full improvement in signal‐to‐noise ratio over the full range of available microwave power. Spectra of 1.6×10−6 M 15N‐perdeutero TEMPONE (1‐oxyl‐2,2,6,6‐tetramethyl‐4‐piperidone) and of 10−6 M Mn2+ are shown in order to demonstrate sensitivity.

Spin-label saturation-recovery EPR at W-band: applications to eye lens lipid membranes.

Saturation-recovery (SR) EPR at W-band (94 GHz) to obtain profiles of the membrane fluidity and profiles of the oxygen transport parameter is demonstrated for lens lipid membranes using phosphatidylcholine (n-PC), stearic acid (n-SASL), and cholesterol analog (ASL and CSL) spin labels, and compared with results obtained in parallel experiments at X-band (9.4 GHz). Membranes were derived from the total lipids extracted from 2-year-old porcine lens cortex and nucleus. Two findings are especially significant. First, measurements of the spin-lattice relaxation times T1 for n-PCs allowed T1 profiles across the membrane to be obtained. These profiles reflect local membrane properties differently than profiles of the order parameter. Profiles obtained at W-band are, however, shifted to longer T1 values compared to those obtained at X-band. Second, using cholesterol analog spin labels and relaxation agents (hydrophobic oxygen and water-soluble NiEDDA), the cholesterol bilayer domain was discriminated in membranes made from lipids of the lens nucleus. However, membranes made from cortical lipids show a single homogeneous environment. Profiles of the oxygen transport parameter obtained from W-band measurements are practically identical to those obtained from X-band measurements, and are very similar to those obtained earlier at X-band for membranes made of 2-year-old bovine cortical and nuclear lens lipids (M. Raguz, J. Widomska, J. Dillon, E.R. Gaillard, W.K. Subczynski, Biochim. Biophys. Acta 1788 (2009) 2380-2388). Results demonstrate that SR EPR at W-band has the potential to be a powerful tool for studying samples of small volume, ∼30 nL, compared with the sample volume of ∼3 μL at X-band.

Spin-label oximetry at Q- and W-band

Spin-lattice relaxation times (T₁s) of small water-soluble spin-labels in the aqueous phase as well as lipid-type spin-labels in membranes increase when the microwave frequency increases from 2 to 35 GHz (Hyde, et al., J. Phys. Chem. B 108 (2004) 9524-9529). The T₁s measured at W-band (94 GHz) for the water-soluble spin-labels CTPO and TEMPONE (Froncisz, et al., J. Magn. Reson. 193 (2008) 297-304) are, however, shorter than when measured at Q-band (35 GHz). In this paper, the decreasing trends at W-band have been confirmed for commonly used lipid-type spin-labels in model membranes. It is concluded that the longest values of T₁ will generally be found at Q-band, noting that long values are advantageous for measurement of bimolecular collisions with oxygen. The contribution of dissolved molecular oxygen to the relaxation rate was found to be independent of microwave frequency up to 94 GHz for lipid-type spin-labels in membranes. This contribution is expressed in terms of the oxygen transport parameter W=T₁⁻¹(Air)-T₁⁻¹(N₂), which is a function of both concentration and translational diffusion of oxygen in the local environment of a spin-label. The new capabilities in measurement of the oxygen transport parameter using saturation-recovery (SR) EPR at Q- and W-band have been demonstrated in saturated (DMPC) and unsaturated (POPC) lipid bilayer membranes with the use of stearic acid (n-SASL) and phosphatidylcholine (n-PC) spin-labels, and compared with results obtained earlier at X-band. SR EPR spin-label oximetry at Q- and W-band has the potential to be a powerful tool for studying samples of small volume, ~30 nL. These benefits, together with other factors such as a higher resonator efficiency parameter and a new technique for canceling free induction decay signals, are discussed.

Pulse saturation recovery, pulse ELDOR, and free induction decay electron paramagnetic resonance detection using time-locked subsampling

Time locked subsampling (TLSS) in electron paramagnetic resonance (EPR) involves the steps of (i) translation of the signal from a microwave carrier to an intermediate frequency (IF) carrier where the (IF) offset between the signal oscillator and local oscillator frequencies is synthesized, (ii) sampling the IF carrier four times in an odd number of cycles, say 4 in 3, where the analog-to-digital (A/D) converter is driven by a frequency synthesizer that has the same clock input as the IF synthesizer, (iii) signal averaging as required for adequate signal to noise, (iv) separating the even and odd digitized words into two separate signal channels, which correspond to signals in phase and in quadrature with respect to the IF carrier, i.e., I and Q, and (v) detecting the envelope of I and also of Q by changing the signs of alternate words in each of the two channels. TLSS detection has been demonstrated in three forms of pulse EPR spectroscopy at X band: saturation recovery, pulse electron–electron double re...

Digital Detection by Time-Locked Sampling in EPR

All frequencies in a magnetic resonance spectrometer should be phase-locked to a single master oscillator. Departure from this principle leads to degraded instrument performance. The use of digital technology is making superheterodyne detection increasingly attractive, relative to homodyne detection, which has been used in most “modern” EPR spectrometers. The signal modulation frequency, the sampling, frequency, and the intermediate frequency (from the signal down-converter) are all locked to the same clock, so the method is called “time-locked.” The sampling of the analog signal to digitize it is done four times in an odd number of cycles, typically 3, 5, or 7, so this is “sub-sampling” relative to the Nyquist criterion. Hence, the name time-locked subsampling (TLSS). An essential feature of TLSS is broad-bandedness followed by digital filtering with internal consistency between the two quadrature detection channels. This type of broad-band acquisition followed by digital analysis permits, for example, study of multiple harmonics of the field modulated signal.