Tomislav Barić

Infrared Thermography in Energy Audit of Electrical Installations

Subject review Energy Audit of Electrical Installations is an integral part of the overall energy audit of complex technical systems, and infrared thermography is one of the non-destructive testing (NDT) methods for that type of analysis of power distribution subsystems. During the energy audit of the power subsystem by means of a thermal camera, it is necessary to carry out some additional measurements of electrical quantities which are often not performed easily. The paper provides an overview of the standards in the field of thermography and safety criteria of electrical installations based on a thermal image and measured electrical parameters. As a practical example, an analysis of an electric power distribution subsystem of large complex industrial consumers is presented.The procedure of the audit and decision making for future maintenance is described in detail. Recommendations of corrective actions in the maintenance procedure based on the absolute temperature criterion and the delta-T criterion under consideration of the measured load are given as well.

Computer Aided Design of Transformer Station Grounding System Using CDEGS Software

This paper presents a computer-aided design of a transformer station grounding system. Fault conditions in a transformer station can produce huge damage to transformer station equipment if the grounding system is not designed properly. A well designed grounding system is a very important part of the project for transformer station design as a whole. This paper analyses a procedure for transformer grounding system design and spatial distribution of touch and step voltage on the ground surface level, using the CDEGS (Current Distribution Electromagnetic Interference Grounding and Soil Structure Analysis) software. Spatial distribution is needed for checking and finding dangerous step and touch voltages above and around the transformer station. Apparent earth resistivity data is measured and analyzed using the RESAP module of the CDEGS software. Because of the very high current flow into the grounding system during a single line to ground fault or a three phase fault in the transformer station, very high and dangerous potentials can be induced on the metallic structures including the fence, which can cause dangerous situations for people and animals near the station and for the personnel inside the station. The PLOT module of CDEGS is used to view the results of the scalar potential, step and touch voltage on the surface. Graphic displays include equipotent contour lines and potential profiles (gradients) in 3D and 2D perspective and apparent soil resistivity (Wm) versus inter electrode spacing (m). The results of alternative grid designs may be displayed simultaneously for the purpose of comparison.